• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 2000년도 제15차 학술회의논문집
• /
• pp.233-233
• /
• 2000

Direct torque control (DTC) scheme provides a very quick torque response without the complex field-orientation block and inner current regulation loop. DTC is known as an appropriate scheme for high power induction motet drives because it can be used at lower switching frequency. There are two major drawbacks with the application of DTC schemes : one is large current harmonics due to flux drooping in a low speed range, the other is that the inverter switching frequency is varying according to motor parameters and operating speed. Switching devices in the power electronics drives should be supported for relatively high switching frequency. In this paper, a P-type fuzzy controller to realize the variable switching sector scheme and a PID-type fuzzy switching frequency regulator are adopted. A meaningful contribution of this paper is to propose a simple realization scheme of the fuzzy switching frequency regulator. Simulation results show the effectiveness of those propositions.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1997년도 전력전자학술대회 논문집
• /
• pp.454-459
• /
• 1997

The good features of a switched reluctance motor(SRM) are appreciated by the appliance manufactures. And it is spread into a commercial and industries market. The few disadvantage of the motor is higher torque ripple and noise. This paper proposes an instantaneous torque control scheme to control a speed precisely. It adapts phase-locked loop (PLL) technique to control speed precisely. In this control scheme, the phase detector signal of the PLL regulates the switching dwell angle flexibly and the loop filter's signal controls adaptively the instantaneous switching voltage. Experimental results show that drive performance is good with low torque ripple.

• Journal of Power Electronics
• /
• 제2권4호
• /
• pp.288-296
• /
• 2002

In this paper, a high frequency transformer - assisted auxiliary active resonant commutated snubber (HFTA-ARCS) for voltage source soft switching pulse width modulated power conversion circuits is presented. A three phase voltage source type soft switching inverter incorporating HFTA-ARCS circuits in its three bridge legs can reduce current rating of auxiliary active power switches and has sensorless simplified control scheme which any specified boost current management is not required for soft switching. Its operation principle and digital control scheme are described and a practical design method of circuit parameters on this HFTA-ARCS circuit is also introduced on the basis of computer simulation. Moreover, this space voltage vector modulated soft switching inverter system with DSP-based digital control scheme Is discussed and its effectiveness is proved on the basis of performance evaluations. The operating performances of this inverter system are also compared with those of conventional three-phase hard switching inverter under practical conditions of specified parameters.

• Journal of Power Electronics
• /
• 제17권6호
• /
• pp.1563-1576
• /
• 2017

This paper presents a novel switching pattern current control (SP-CC) scheme, which is applied in three-phase voltage-source converters (VSCs). This scheme can select the optimal output switching pattern (SP) by referring the basic principle of space vector modulation (SVM). Moreover, SP-CC is a method without a carrier wave. Thus, the implementation process is concise and easy. When compared with the conventional hysteresis current control (C-HCC) and the space vector-based hysteresis current control (SV-HCC), the SP-CC has the performances of faster dynamic response of C-HCC and less switching number (SN) of SV-HCC. In addition, it has less harmonic contents in the three-phase current, along with a lower switching loss and a higher efficiency. Moreover, the hysteresis bandwidth and Clarke conversion are not required in the SP-CC. The effectiveness of the presented SP-CC is verified by simulation and experimental test results. In addition, the advantages of the SP-CC, when compared with the C-HCC and SV-HCC, are verified as well.

• 대한전기학회논문지
• /
• 제45권4호
• /
• pp.526-529
• /
• 1996

A novel control scheme for a Switched Reluctance Motor(SRM) drive is described. To increase torque, and to commutate easily, flat-topped phase current and fixed switching angle control is proposed. The conditions for flat-topped phase current are analyzed. It is achieved by voltage control with fixed switching angle. The proposed control system was tested to verify this suggestion. (author). refs., figs., tab.

• Journal of Power Electronics
• /
• 제3권1호
• /
• pp.1-9
• /
• 2003

This paper presents a performance analysis of typical Auxiliary Resonant Commutation Snubber-assisted three phase voltage source soft switching inverter which can operate under a condition of Zero Voltage Switching (ZVS) using a digital control scheme which is suitable for high power applications compared with resonant DC link snubber assisted soft switching inverter. The system performances of this inverter are illustrated and evaluated on the basis of experimental results.

• 전력전자학회논문지
• /
• 제7권2호
• /
• pp.137-148
• /
• 2002

직접토크제어 기법은 벡터제어계 설계 및 운전시 요구되는 복잡한 좌표변환과 전류제어루프가 불필요하며, 빠른 토크응답을 얻을 수 있기 때문에 벡터제어 기법에 버금가는 유도전동기의 고성능 제어기법으로 인정되고 있다. 본 논문에서는 직접토크제어 기법 적용시 중요한 어려움의 하나로 지적되고 있는 저속영역에서의 자속저하 및 이로 인한 전류고조파의 증가 문제를 해결하기 위한 대책으로서 퍼지 가변 스위칭섹터 기법과 이 기법의 실시간 적용을 위한 실현방법을 제안하였다. 제안된 스위칭섹터 기법을 포함한 유도전동기 제어시스템의 실험적 성능을 고찰하기 위하여 DSP를 이용한 제어보드를 제작하였다. 시뮬레이션과 실험 결과는 제안된 퍼지 가변스위칭 섹터 기법을 도입함으로서 유도전동기 드라이브의 성능이 현저히 개선됨을 보여준다.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 1996년도 한국자동제어학술회의논문집(국내학술편); 포항공과대학교, 포항; 24-26 Oct. 1996
• /
• pp.241-244
• /
• 1996

This paper discusses the general properties and the design procedures of Internal Model Control(IMC) scheme for nonlinear plants. Also we propose new nonlinear IMC(NIMC) design method using linear IMC. Although all IMC controllers can be thought simple 'inverse controller', its nonlinear realization is not easy. Propose NIMC is composed multiple linear models, IMC controllers, and switching scheme. The advantages of this method are we can use simple linear IMC design method and need not nonlinear modelings.

• 한국항공우주학회지
• /
• 제36권6호
• /
• pp.574-580
• /
• 2008

이 논문에서는 최근에 개발한 무충돌 전환 구현 알고리즘을 사용하여 전비행영역 제어를 위한 제어기 교체법을 제시한다. 이 교체법은 비행기의 속도와 고도에 따라 제어기를 교체하는 일반적인 방법과 제어기 교체 기준으로 충돌 현상에 관계된 가격함수를 사용하는 최적화 방법을 적절한 규칙에 의해 결합한 것이다. 제안된 제어기 교체법의 성능을 확인하기 위해 시험표준 문제로 고성능 비행체에 적용하여 넓은 비행영역에서 모의실험을 수행하고 제어성능이 향상됨을 예시한다.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 2000년도 제15차 학술회의논문집
• /
• pp.356-356
• /
• 2000

For irregular nonlinear systems, switching controlk form is proposed recently. This control law is designed to overcome the singularities through the scheme that switches between an approximate tracking law close to the singularities, and an exact tracking law away from the singularities. But, that form has problems which may break the system's stability through unstable control input value at switching procedure. In this paper, We propose new switching control law which supervises approximate tracking control law and exact tracking control law by fuzzy rules to overcome unstability problem in switching procedure.