• Journal of Environmental Science International
• /
• v.5 no.2
• /
• pp.141-152
• /
• 1996

This study is an attempt to investigate the chemical components of precipitation and its variation according to surface wind. Precipitation samples were collected by an wet-only precipitation sampler during the period of October 1994 to September 1995 at Kyungsan in Korea. The results obtained in t체s study are summerized as follows. The annual average of precipitation pH is 5.0, the highest month of pH is July of 5.5, and the lowest month of pH is December of 4.4. The most frequent appearance is in the range of pH 5.0 to 5.5 and its rate is 56.8%, The order of ion concentration In precipitation is SO42->NO3->Cl- in case of anion and $Ca^{2+}$>$NH_4^{+}$>$Na^+$>$Mg^{2+}$ in case of cation. It is found from our analysis that the correlation coefficient among the precipitation pH and ion components is below r=0.3, while the correlation coefficient between $SO_4^{2-}$ and NO_3^{-}$, $Na^+$ and $Cl^+$ is above r=0.8, respectively. The mean pH of precipitation is 4.8 under the westerly wind and 5.2 under the easterly wind. The concentrations of anion and cation under the westerly wind are more than the concentrations under the easterly wind. In autumn, the concentration of Na+ and $Cl^+$ under the easterly wind are higher than the concentration under the westerly wind. The correlation coefficients between wind speed and pH, ion components show very low correlation of -0.41 r 0.2. But the present study show that the correlation coefficient between wind speed and pH of precipitation is positive and the correlation coefficients between wind speed and ion concentration is negative.

• Spatial Information Research
• /
• v.19 no.1
• /
• pp.13-19
• /
• 2011

As an urbanization is in progress, the change of the planimetric features and topography including high-rise residential buildings commonly occur. The change of the planimetric features and topography causes occurrence of the strong wind and wind speed increase or decrease due to the effect of planimetric features and topography on the windward side even though the wind blows with the same speed. In the design standard, this change by wind speed is defined as the velocity pressure exposure coefficient, the value of coefficient is estimated and reflected by ground surface roughness, but in a reality, ground surface roughness is determined in accordance with the subjective judgement of designer and then the velocity pressure exposure coefficient is estimated, moreover the research and data for classification of ground surface roughness are insufficient. In this paper, we will estimate the velocity pressure exposure coefficient by the quantified method for classifying ground surface roughness by using GIS according to the height of a building targeting area where high-rise residential buildings are built lately. When the structure subjected to wind load is designed, reasonability of design and safety of structure will be more improved by using the estimation method of velocity pressure exposure coefficient presented in this study.

• The Journal of the Acoustical Society of Korea
• /
• v.27 no.3E
• /
• pp.69-76
• /
• 2008

Measurements of bubble size and distribution in the surface layer of the sea, wind speed, and variation of ocean environments were made continually over a four-day period in an experiment conducted in the South Sea of Korea during 17-20 September 2007. Theoretical background of bubble population model indicates that bubble population is a function of the depth, range and wind speed and bubble effects on sound speed shows that sound speed varies with frequency. Observational evidence exhibited that the middle size bubble population fit the model very well, however, smaller ones can not follow the model probably due to their short lifetime. Meanwhile, there is also a hysteresis effect of void fraction. Observational evidence also indicates that strong changes in sound speed are produced by the presence of swarms of micro bubbles especially from 7 kHz to 50 kHz, and calculation results are consistent with the measured data in the high frequency band, but inconsistent in the low frequency band. Based on the measurements of the sound speed and high frequency transmission configuration in the bubble layer, we present an estimation of underwater acoustic channel capacity in the bubble layer.

• Journal of Environmental Science International
• /
• v.15 no.8
• /
• pp.745-757
• /
• 2006

We focus on the improvement of accuracy of sea surface wind over complex coastal area doling the warm season. Local Analysis Prediction System (LAPS) was used to improve the initial values in Mesoscale Meteorological model (MM5). During the clear summer days with weak wind speed, sea surface wind simulated with LAPS was compared with the case without LAPS. The results of modeling with LAPS has a good agreement mesoscale circulation such as mountain and valley winds on land and in case of modeling without LAPS, wind speed overestimated over the sea in the daytime. And the results of simulation with LAPS indicated similar wind speed values to observational data over the sea under influence of data assimilation using BUOY, QuikSCAT, and AMEBAS. The present study suggests that MM5 modelling with LAPS showed more improved results than that of without LAPS to simulate sea surface wind over the complex coastal area.

• Atmosphere
• /
• v.20 no.1
• /
• pp.13-26
• /
• 2010

The Urban Canopy Model (UCM) implemented in WRF model is applied to improve urban meteorological forecast for fine-scale (about 1-km horizontal grid spacing) simulations over the city of Seoul. The results of the surface air temperature and wind speed predicted by WRF-UCM model is compared with those of the standard WRF model. The 2-m air temperature and wind speed of the standard WRF are found to be lower than observation, while the nocturnal urban canopy temperature from the WRF-UCM is superior to the surface air temperature from the standard WRF. Although urban canopy temperature (TC) is found to be lower at industrial sites, TC in high-intensity residential areas compares better with surface observation than 2-m temperature. 10-m wind speed is overestimated in urban area, while urban canopy wind (UC) is weaker than observation by the drag effect of the building. The coupled WRF-UCM represents the increase of urban heat from urban effects such as anthropogenic heat and buildings, etc. The study indicates that the WRF-UCM contributes for the improvement of urban weather forecast such nocturnal heat island, especially when an accurate urban information dataset is provided.

• The Journal of the Acoustical Society of Korea
• /
• v.15 no.2E
• /
• pp.45-49
• /
• 1996

From the reverberation signals received in the shallower water, the surface scattered signals are identified by using the multipath eigneray model that provides launch angles, grazing angles and transmission loss from the high frequency directional source to and from the rough surface. For small scale surface waves, the perturbation method is used to compute the backscattering strength for various grazing angles and wind speeds. A scheme to inversely estimate the wind speed, by which the observed surface reverberation levels are produced, has been tested. In result, for low grazing angles the perturbation method can be used to predict the backscattering stregth, thereby the surface wind can be indirectly estimated.

• Journal of Korean Society for Atmospheric Environment
• /
• v.23 no.6
• /
• pp.640-652
• /
• 2007

The MM5, RAMS and WRF, meteorological models have provided the dynamical parameters as inputs to air quality model. A major content of this study is that significant characteristics of three models for high-ozone occurrence analyze for surface wind and air temperature fields and compare with observation data in Seoul metropolitan area. An analysis of air temperature field revealed that location of core in high temperature of MM5 and WRF differed from that of RAMS. MM5 and WRF indicated high temperature in Seoul but RAMS represented it on the outskirts of Seoul. MM5 and WRF were underestimated maximum temperature during daytime but RAMS simulated similar value with observation data. Surface wind field with three models, it was shown many differences at horizontal distribution of wind direction. RAMS indicated weak wind speed in land and strong sea breeze at coastal areas than MM5 and WRF. However wind speed simulated by three model were overestimated during both daytime and nighttime.

• Asian Journal of Atmospheric Environment
• /
• v.10 no.2
• /
• pp.80-89
• /
• 2016

In the complex terrain where local wind systems are formed, accurate understanding of regional wind variability is required for wind resource assessment. In this paper, cluster analysis based on the similarity of time-series wind vector was applied to classify wind regions with similar wind characteristics and the meteorological validity of regionalization method was evaluated. Wind regions in Jeju Island and Busan were classified using the wind resource map of Korea created by a mesoscale numerical weather prediction modeling. The evaluation was performed by comparing wind speed, wind direction, and wind variability of each wind region. Wind characteristics, such as mean wind speed and prevailing wind direction, in the same wind region were similar and wind characteristics in different wind regions were meteor-statistically distinct. It was able to identify a singular wind region at the top area of Mt. Halla using the inconsistency of wind direction variability. Furthermore, it was found that the regionalization results correspond with the topographic features of Jeju Island and Busan, showing the validity.

• Journal of the Korean earth science society
• /
• v.39 no.2
• /
• pp.139-153
• /
• 2018

The sea surface wind field has long been obtained from satellite scatterometers or passive microwave radiometers. However, the importance of satellite altimeter-derived wind speed has seldom been addressed because of the outstanding capability of the scatterometers. Satellite altimeter requires the accurate wind speed data, measured simultaneously with sea surface height observations, to enhance the accuracy of sea surface height through the correction of sea state bias. This study validates the wind speeds from the satellite altimeters (GFO, Jason-1, Envisat, Jason-2, Cryosat-2, SARAL) and analyzes characteristics of errors. In total, 1504 matchup points were produced using the wind speed data of Ieodo Ocean Research Station (IORS) and of Korea Meteorological Administration (KMA) buoys at Marado and Oeyeondo stations for 10 years from December 2007 to May 2016. The altimeter wind speed showed a root mean square error (RMSE) of about $1.59m\;s^{-1}$ and a negative bias of $-0.35m\;s^{-1}$ with respect to the in-situ wind speed. Altimeter wind speeds showed characteristic biases that they were higher (lower) than in-situ wind speeds at low (high) wind speed ranges. Some tendency was found that the difference between the maximum and minimum value gradually increased with distance from the buoy stations. For the improvement of the accuracy of altimeter wind speed, an equation for correction was derived based on the characteristics of errors. In addition, the significance of altimeter wind speed on the estimation of sea surface height was addressed by presenting the effect of the corrected wind speeds on the sea state bias values of Jason-1.

• 한국해양학회지
• /
• v.19 no.2
• /
• pp.210-216
• /
• 1984

Diurnal variations of coastal surface wind speed are analyzed with five years of hourly wind from Port Aransas, Texas. These data reveal the highest frequency of occurrence of the nighttime wind maximum near midnight, especially during those seasons when onshore flow prevails. Nighttime wind maxima with a southerly component occurred approximately three times more frequently than with a northerly component on the annual average. The neutral atmospheric stability prevails near the coast. Thus it allows downward transfer of momentum from the nocturnal low level jet under the onshore wind situation and strong wind shear between an elevated frontal and ground-based inversion for offshore wind, resulting in the nocturnal coastal surface wind maximum.