• Nuclear Engineering and Technology
• /
• v.42 no.5
• /
• pp.568-575
• /
• 2010

Flow Accelerated Corrosion is an active degradation mechanism of CANDU feeder. The tight bend downstream to Gray loc weld connection, close to reactor face, suffers significant wall thinning by FAC. Extensive in-service inspection of feeder wall thinning is very difficult because of the intense radiation field, complex geometry, and space restrictions. Development of a knowledge-based inspection program is important in order to guarantee that adequate wall thickness is maintained throughout the whole life of feeder. Research results and plant experiences are reviewed, and the plant inspection databases from Wolsong Units One to Four are analyzed in order to support developing such a knowledge-based inspection program. The initial thickness before wall thinning is highly non-uniform because of bending during manufacturing stage, and the thinning rate is non-uniform because of the mass transfer coefficient distributed non-uniformly depending on local hydraulics. It is obvious that the knowledge-based feeder inspection program should focus on both fastest thinning locations and thinnest locations. The feeder wall thinning rate is found to be correlated proportionately with QV of each channel. A statistical model is proposed to assess the remaining life of each feeder using the QV correlation and the measured thicknesses. W-1 feeder suffered significant thinning so that the shortest remaining life barely exceeded one year at the end of operation before replacement. W-2 feeder showed far slower thinning than W-1 feeder despite the faster coolant flow. It is believed that slower thinning in W-2 is because of higher chromium content in the carbon steel feeder material. The average Cr content of W-2 feeder is 0.051%, while that value is 0.02% for W-1 feeder. It is to be noted that FAC is reduced substantially even though the Cr content of W-2 feeder is still very low.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.7B
• /
• pp.477-487
• /
• 2008

Congestion control of the TCP reduces transmission rate when it detects packet loss because packet loss origines from congestion in the wired network. In the wireless network, packet loss comes from channel errors. Wired TCP degrades performance when there are wireless losses because it does not classify type of loss. These day, there are many researches which classify type of loss between congestion loss and wireless loss for wired-wireless hybrid network. For wireless TCP, many of existing algorithms are based on the estimated bandwidth or variations of packet arrival time. In this paper, we propose a new TCP scheme to distinguish the wireless packet losses from the congestion packet losses using MIB of the IEEE 802.11 MAC. We perform excessive simulations using the NS-2 network simulator and analyze the simulation results to compare the performance of the proposed algorithm to other well-known algorithms. From simulation results, we know that proposed algorithm improves performance about 12% and 32% compared with Spike algorithm and mBiaz algorithm, respectively.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.49 no.7
• /
• pp.23-31
• /
• 2012

Resource allocation, such as joint rate control and scheduling, is an important issue in cognitive radio networks. However, it is difficult to jointly consider the rate control and scheduling problem due to the stochastic behavior of channel availability in cognitive radio networks. In this paper, we propose an asymmetric joint rate control and scheduling technique under reliability constraints in cognitive radio networks. The joint rate control and scheduling problem is formulated as a convex optimization problem and substantially decomposed into several sub-problems using a dual decomposition method. An algorithm for secondary users to locally update their rate that maximizes the utility of the overall system is also proposed. The results of simulations revealed that the proposed algorithm converges to a globally optimal solution.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.4
• /
• pp.379-386
• /
• 2004

OFDM(orthogonal frequency division multiplexing) communications system is very attractive for the high data rate transmissionin the frequency selective fading channel. Since OFDM has high PAPR(peak-to-average power ratio), OFDM signal may be distorted by the nonlinear HPA(high power amplifier). In this paper, we propose an improved dummy sequence scheme for reducing the PAPR in OFDM communication system. This method inserts each different dummy sequence at the predefined sub-carriers fur PAPR reduction. After IFFT, the OFDM data signal with the lowest PAPR is selected to transmit. The complementary sequence is used as dummy sequence. So, it can cut down the computation time and quantity because it dose not require the peak value optimization for finding the phase rotation factor and the transmission of the side information about the rotation factor unlike the PTS method.

• KSBB Journal
• /
• v.19 no.2
• /
• pp.159-163
• /
• 2004

The X-ray structure of the cydodextrin-glucanotransferase of Bacillus macerans was solved by molecular replacement at 2.0 ${\AA}$ resolution. The refined structure has a crystallographic R-factor of 16.6%, (R$\sub$free/ = 20.5%). A new metal binding site occupied by two Ca$\^$2+/-ions was found at an accession channel of the active site. There is a large accumulation of negative charges that bind these Ca$\^$2+/-ions, thereby connecting segment ${\beta}$13-${\alpha}$G (residue 254-276) to the main body of domain A (at ${\alpha}$H, residue 283-297). The segment 313-${\alpha}$G contains the catalytic residue Glu258 between subsite 1 and -1 and Tyr260 (subsite 2) which is located at the entrance of the active site. The Ca$\^$2＋/-site 3a,b may have a major role for the activity and specificity of this CGTase, although it is not even conserved for the a-subclass of CGTases.

• ETRI Journal
• /
• v.38 no.5
• /
• pp.981-987
• /
• 2016

We present a cost-effective dual polarization quadrature phase-shift coherent receiver module using a silica planar lightwave circuit (PLC) hybrid assembly. Two polarization beam splitters and two $90^{\circ}$ optical hybrids are monolithically integrated in one silica PLC chip with an index contrast of $2%-{\Delta}$. Two four-channel spot-size converter integrated waveguide-photodetector (PD) arrays are bonded on PD carriers for transverse-electric/transverse-magnetic polarization, and butt-coupled to a polished facet of the PLC using a simple chip-to-chip bonding method. Instead of a ceramic sub-mount, a low-cost printed circuit board is applied in the module. A stepped CuW block is used to dissipate the heat generated from trans-impedance amplifiers and to vertically align RF transmission lines. The fabricated coherent receiver shows a 3-dB bandwidth of 26 GHz and a common mode rejection ratio of 16 dB at 22 GHz for a local oscillator optical input. A bit error rate of $8.3{\times}10^{-11}$ is achieved at a 112-Gbps back-to-back transmission with off-line digital signal processing.

• International Journal of Naval Architecture and Ocean Engineering
• /
• v.8 no.4
• /
• pp.330-343
• /
• 2016

This paper presents results of an experimental investigation of vortex-induced vibration (VIV) of a flexibly mounted and rigid cylinder with two-degrees-of-freedom with respect to varying ratio of in-line natural frequency to cross-flow natural frequency, $f^*$, at a fixed low mass ratio. Combined in-line and cross-flow motion was observed in a sub-critical Reynolds number range. Three-dimensional displacement meter and tension meter were used to measure dynamic responses of the model. To validate the results and the experiment system, x and y response amplitudes and ratio of oscillation frequency to cross-flow natural frequency were compared with other experimental results. It has been found that the higher harmonics, such as third and more vibration components, can occur on a certain part of steel catenary riser under a condition of dual resonance mode. In the present work, however, due to the limitation of a size of circulating water channel, the whole test of a whole configuration of the riser at an adequate scale for VIV phenomenon was not able to be conducted. Instead, we have modeled a rigid cylinder and assumed that the cylinder is a part of steel catenary riser where the higher harmonic motions could occur. Through the experiment, we have found that even though the cylinder was assumed to be rigid, the occurrence of the higher harmonic motions was observed in a small reduced velocity ($V_r$) range, where the influence of the in-line response is relatively large. The transition of the vortex shedding mode from one to another was examined by using time history of x and y directional displacement over all experimental cases. We also observed the influence of in-line restoring force power spectral density with $f^*$.

• Journal of Positioning, Navigation, and Timing
• /
• v.5 no.1
• /
• pp.11-20
• /
• 2016

In this paper, a system that can collect GPS L1 C/A, GLONASS G1, and BDS B1I signals with single front-end receiver was implemented using a universal software radio peripheral (USRP) and its performance was verified. To acquire the global navigation satellite system signals, hardware was configured using USRP, antenna, external low-noise amplifier, and external oscillator. In addition, a value of optimum local oscillator frequency was selected to sample signals from three systems with L1-band with a low sampling rate as much as possible. The comparison result of C/N0 between the signal collection system using the proposed method and commercial receiver using double front-end showed that the proposed system had 0.7 ~ 0.8dB higher than that of commercial receiver for GPS L1 C/A signals and 1 ~ 2 dB lower than that of commercial receiver for GLONASS G1 and BDS B1I. Through the above results, it was verified that signals collected using the three systems with a single USRP had no significant error with that of commercial receiver. In the future, it is expected that the proposed system will be combined with software-defined radio (SDR) and advanced to a receiver that has a re-configuration channel.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.11 no.2
• /
• pp.121-129
• /
• 2011

It is progressing as new advents and remarkable developments of mobile device every year. On the upper line reason, NAND FLASH large density memory demands which can be stored into portable devices have been dramatically increasing. Therefore, the cell size of the NAND Flash memory has been scaled down by merely 50% and has been doubling density each per year. [1] However, side effects have arisen the cell distribution and reliability characteristics related to coupling interference, channel disturbance, floating gate electron retention, write-erase cycling owing to shrinking around 20nm technology. Also, FLASH controller to manage shrink effect leads to speed and current issues. In this paper, It will be introduced to solve cycling, retention and fail bit problems of sub-deep micron shrink such as Virtual negative read used in moving read, randomization. The characteristics of retention, cycling and program performance have 3 K per 1 year and 12.7 MB/s respectively. And device size is 179.32 $mm^2$ (16.79 mm ${\times}$ 10.68 mm) in 3 metal 26 nm CMOS.

• Journal of IKEEE
• /
• v.16 no.2
• /
• pp.138-144
• /
• 2012

In this paper, a semi-analytical approach is proposed for DSF(Decode and Selective Forward)-Relay MC-CDMA(MultiCarrier-Code Division Multiple Access) systems over multipath Rayleigh fading channels. Considering BER(bit error rate) performance and complexity, the MMSE-C(Minimum Mean squared Error-per subCarrier) is used as the combining method for MC-CDMA systems. At first, the analytical method based on error-events at relay nodes for DSF-Relay schemes is utilized in order to derive the averaged BER. Then, the averaged BER is expressed as the form considering possible all error-events. Also, proposed semi-analytical expressions have been verified by comparing with simulation results. Finally, it is verified that the derived analytical expressions can be a frame work to cover different multipath Rayleigh fading channel conditions and to measure the upper performance for DSF-Relay MC-CDMA systems.