• Journal of the Korean Wood Science and Technology
• /
• v.25 no.1
• /
• pp.15-22
• /
• 1997

The effectiveness of presteaming for improving CCA treatability on refractory Japanese larch heartwood was investigated in this study. Presteaming was effective on improving treatability, and the extent of improvement was dependent on moisture contents of wood specimen and steaming conditions. Green wood showed higher average value in both preservative retention and penetration than dry wood, and steaming under pressure conditions also had higher treatability than steaming at atmospheric conditions. The degree of improvement for treatability was increased with the extension of steaming period. Treatability of dry wood pres teamed under pressure conditions more than 6 hours and green wood for 3 hours was similar to that enhanced by conventional incising. Presteaming green wood under pressure conditions more than 6 hours was more effective than conventional incising in improvement of CCA treatability, and resultant treatability satisfied a minimum value required for CCA-treated wood for being used at the regions of hazard class H3 and H4. In addition, an improvement of treatability by presteaming was due to an increase in permeability resulted from the degradation of hemicelluloses within aspirated pit membrane and cell wall, not the removal of extractives from pit membrane. The reduction in strength, measured as longitudinal compressive strength, due to pres teaming was related with the degradation of hemicelluloses, and was increased as steaming conditions were severe. The degree of strength reduction associated with presteaming treatment to obtain required treatability could be quantified from the relatively good relation between the increase in treatability and the decrease in strength.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.33 no.4
• /
• pp.7-14
• /
• 2001

Recycled fibers usually give slow drainage in the paper forming process, which limits the application of more refining to the recycled fibers for improving paper strength and formation. To use recycled fibers more effectively, especially OCC, developing very efficient handling technique of short fibers and fines is inevitable. We tried to make hard flocs of fractionated short fibers and fines, which were the main cause of slow drainage, by adding excessive amount of retention aid selectively on them. This technique was proved to increase drainage considerably, but to decrease strength properties, compared to the conventional technique of adding the same amount of polymers to the whole furnish in the lab test. The bonding capability of short fibers and fines in Korean OCC was very poor. Various chemical treatment on the short fibers and fines of the Korean OCC did not improve their bonding and optical properties. One of the reasons of no improvement in their properties was their high amount of ashes.

• Korean Journal of Agricultural Science
• /
• v.46 no.3
• /
• pp.569-577
• /
• 2019

The current experiment was conducted to compare nutrient utilization in the aged laying hens with different eggshell strengths or different intensities of brown eggshell color. Two metabolic trials with 96-week-old Hy-Line Brown laying hens were conducted. Twelve hens with a strong eggshell strength (SES) and 12 hens with a weak eggshell strength (WES) were selected and used in the first experiment, whereas 12 hens with dark brown eggshells (DBE) and 12 hens with light brown eggshells (LBE) were selected and used in the second experiment. All hens were fed a common commercial layer diet. Diets included chromic oxide as an indigestible marker to determine the apparent total tract retention (ATTR) of the gross energy (GE), dry matter, acid-hydrolyzed ether extract, nitrogen, neutral detergent fiber, acid detergent fiber, ash, and minerals. The results indicate that the ATTR of Ca in the aged laying hens with SES (59.7%) was greater (p < 0.05) than in the aged laying hens with WES (48.6%). However, the ATTR of the GE and other nutrients was not different between the hens with SES or WES. There were no differences in the ATTR of GE and nutrients between the hens with DBE or LBE. In conclusion, aged laying hens with SES have a greater ability to utilize dietary Ca than those with WES, indicating that the extent of dietary Ca utilization determines the eggshell strength of aged laying hens. However, nutrient utilization in diets may have little impact on eggshell brown coloration in aged laying hens.

• Korean journal of food and cookery science
• /
• v.12 no.4
• /
• pp.571-576
• /
• 1996

The moisture-dependent gelation characteristics of five different proteins are evaluated to understand the modification of gel strength when they are added in surimi gel. Compressive force and penetration force of protein gels gradually decreased with increase of moisture level, with showing markedly decrease at certain point of moisture level called critical moisture level. The critical moisture level for gelation of SPI-1, SPI-2, EW, WPC and LA were 79.4%, 81.6%, 91.4％, 87,8% and 84.7%, respectively. Beyond this critical level of water, protein gel matrix begins to lose its water binding and structural integrity. The mnisture that was not re tained by a protein was available to diluting the protein matrix and eventually weakened the overall gel strength. EW and MPI showed higher water retention than those of SPI, WPC and LA. The compressive force of SPI, WPC and LA-incorporated surimi gel at the varying moisture levels strongly correlated with the amount if water retained at corresponding moisture level within those protein (r=0.99).

• The Journal of Advanced Prosthodontics
• /
• v.7 no.3
• /
• pp.249-256
• /
• 2015

PURPOSE. The aim of this study was to evaluate the effects of atmospheric plasma (APL) versus conventional surface treatments on the adhesion of self-adhesive resin cement to Ti-6Al-4V alloy. MATERIALS AND METHODS. Sixty plates of machined titanium (Ti) discs were divided into five groups (n=12): 1) Untreated (CNT); 2) Sandblasted (SAB); 3) Tribochemically treated (ROC); 4) Tungsten CarbideBur (TCB); 5) APL treated (APL). SEM analysis and surface roughness (Ra) measurements were performed. Self-adhesive resin cement was bonded to the Ti surfaces and shear bond strength (SBS) tests, Ra and failure mode examinations were carried out. Data were analyzed by one-way analysis of variance and chi-squared test. RESULTS. The lowest SBS value was obtained with CNT and was significantly different from all other groups except for APL. The ROC showed the highest SBS and Ra values of all the groups. CONCLUSION. It was concluded that the effect of APL on SBS and Ra was not sufficient and it may not be a potential for promoting adhesion to titanium.

• Textile Coloration and Finishing
• /
• v.17 no.4 s.83
• /
• pp.35-40
• /
• 2005

Researches to preserve and restore the excavated cellulose fabrics as costume heritages have been carried out. In this study, in order to artificially restore an excavated cellulose fabrics, acid-treated cellulose fabrics were prepared. Three kinds of cellulose fabrics were used for an experiment. Three kinds of cellulose fabrics were treated by the acid aqueous solution for the various strength retention ($100\%,\;80\%,\;60\%,\;40\%,\;20\%$). The fine structure and physical properties of acid treated cellulose fabrics were investigated with various techniques such as wide-angle X-ray diffraction, tensile test, weight loss, shrinkage, SEM etc. Tensile strength and strain of cellulose fabrics decreased with increasing acid treatment time. However, weight loss and shrinkage increasing slightly. The crystal diffraction intensity was not changed. SEM results of acid-treated cellulose fabrics show that the surface was damaged.

• Textile Coloration and Finishing
• /
• v.17 no.4 s.83
• /
• pp.41-47
• /
• 2005

Costume heritages of an excavated silk fabrics should be preserved without damage. In order to artificially restore the excavated silk fabrics, alkaline aqueous solution, as a simulated corpse, and two kinds of silk fabrics were used. Two kinds of silk fabrics were treated by aqueous alkaline solution according to strength retention value(100, 80, 60, 40, 20$\%$). The fine structure and physical properties of alkaline treated silk fabrics were investigated with various techniques such as wide-angle X-ray diffraction, tensile test, weight loss, shrinkage, SEM. and yellowness. As the alkaline treatment time increased tensile strength of silk fabrics decreased. However, weight loss and shrinkage slightly increased. The diffraction intensity of $\beta-form$ crystal declined and $\alpha-form$ crystal diffraction intensity disappeared with the treatment.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.25 no.1
• /
• pp.144-153
• /
• 2001

The effect of crosslinking on hand of the cellulase treated Tencel fabrics was investigated. Tencel fabrics were crosslinked with DMDHEU, mechanically prefibrillated, hydrolyzed by cellulase, and treated with softener. The treated fabrics were characterized by add-on, weight loss, DP rating, WRA, strength, SEM analysis and hand measurement. As DMDHEU concentration increased, weight loss of DMDHEU/cellulase treated fabrics decreased. However, cellulase treatment decreased DP properties and strength retention. Less fibrils were observed in the cellulase treated fabrics after DMDHEU treatment than the cellulase treated ones. It was confirmed that crosslinking with DMDHEU treatment was effective to control fibrillation. At 5% of DMDHEU concentration, DMDHEU/cellulase treated fabrics showed softer, smoother and bulkier hand compared with other treated fabrics. Among mechanical properties, bending and shearing properties were decreased progressively through DMDHEU, cellulase, and softener treatment. DMDHEU treatment contributed to impart resilience, cellulase treatment to bulkiness and softener treatment to smoothness. As the treatment of DMDHEU, cellulase, and softener progressed NUMREI, FUKURAMI, and THV increased with the exception of KOSHI.

• Journal of Korean Society of Water and Wastewater
• /
• v.30 no.3
• /
• pp.263-270
• /
• 2016

Recent Engineered nanoparticles were increasingly exposed to environmental system with the wide application and production of nanomaterials, concerns are increasing about their environmental risk to soil and groundwater system. In order to assess the transport behavior of silver nanoparticles (AgNPs), a saturated packed column experiments were examined. Inductively coupled plasma-mass spectrometry and a DLS detector was used for concentration and size measurement of AgNPs. The column experiment results showed that solution chemistry had a considerable temporal deposition of AgNPs on the porous media of solid glass beads. In column experiment, comparable mobility improvement of AgNPs were observed by changing solution chemistry conditions from salts (in both NaCl and $CaCl_2$ solutions) to DI conditions, but in much lower ionic strength (IS) with $CaCl_2$. Additionally, the fitted parameters with two-site kinetic attachment model form the experimental breakthrough curves (BTCs) were associated that the retention rates of the AgNPs aggregates were enhanced with increasing IS under both NaCl and $CaCl_2$ solutions.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.32 no.3
• /
• pp.25-31
• /
• 2000

It is required to use substantial amount of wet strength resin for producing multi-functional mulch papers since these paper products shold maintain its strength properties when they exposed to outdoor weather for several months. While producing mulch papers it is usual to observe significant amount of foam at white water silo. Thus it is imperative to use defoaming or antifoaming agents. In this study diverse defoaming and antifoaming agents have been tested for their effective-ness in eliminating foams that produced. It was shown that combined use of a silicone type defoamer and a fatty acid type anti-foaming agent was msot effective in eliminating foams. These chemicals were used in trial production of mulch papers and their influence on paper-making wet end system was examined including one pass retention cationic demand con-ductivity pH etc. It was found that the defoaming agents were very effective for removing foams in trial production. Tensile strengths of the mulch papers produced were significantly greater than commericial mulch papers produced in Japan.