• Proceedings of the KSME Conference
• /
• 2003.11a
• /
• pp.1139-1144
• /
• 2003

This paper addresses a theoretical study to calculate the amount of the stored energy due to vacancies during high-strain-rate deformation. The study concerns the role of excess vacancies, which can play an important role to increase the amount of stored energy. Molecular dynamics simulation using a 3D model is carried out and the result clearly shows that the excess vacancies are credited to generation of the stored energy.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.28 no.9
• /
• pp.1306-1313
• /
• 2004

This paper addresses a theoretical approach to calculate the amount of the stored energy during high strain-rate deformations using atomistic level simulation. The dynamic behavior of materials at high strain-rate deformation are of great interest. At high strain-rates deformations, materials generate heat due to plastic work and the temperature rise can be significant, affecting various properties of the material. It is well known that a small percent of the energy input is stored in the material, and most of input energy is converted into heat. However, microscopic analysis has not been completed without construction of a material model, which can simulate the movement of dislocations and vacancies. A major cause of the temperature rise within materials is traditionally credited to dislocations, vacancies and other defects. In this study, an atomistic material model for FCC such as copper is used to calculate the stored energy.

• Journal of Biosystems Engineering
• /
• v.19 no.3
• /
• pp.222-231
• /
• 1994

The efficient use of solar energy for greenhouse heating is one of the most obvious applications to save the heating energy for greenhouse culture. To increase the efficiency of solar energy utilization in plastic greenhouse, underground heat exchange system was installed. Characteristics of the stored and released thermal enery in plastic greenhouse with underground heat exchange system was analyzed. The average stored and released thermal energy in this system were 1,484 $kJ/m^2$ day and 555 $kJ/m^2$ day, respectively. The average coefficient of performance of heat exchange system was found to be 2.86. Also an attempt was made to predict the air temperature in plastic greenhouse. The agreement between the results of prediction and that of measurement was relatively good.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.30 no.2
• /
• pp.101-105
• /
• 2017

In this paper, the magnetization characteristics and the stored energy of magnetically coupled superconducting fault current limiter (SFCL)s using single and double high-Tc superconducting (HTSC) elements were compared. To analyze the magnetization characteristics and the stored energy, the magnetizing current and the flux linkage, which were derived from the electrical equivalent circuit of the SFCL using single and double HTSC elements, were calculated from the voltages and the current measured in the short-circuit tests. Through the comparative analysis on the magnetization characteristics and the stored energy for SFCL using sing and double HTSC elements, the magnetically coupled SFCL using double HTSC elements was shown to be more effective than the SFCL using single HTSC element from the point of view of the magnetic saturation.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.31 no.8
• /
• pp.880-888
• /
• 2007

This article describes the load capability of bending piezoelectric actuators with a thin sandwiched PZT plate in association with the stored elastic energy induced by an increased dome height after a curing process. The stored elastic energy within the actuators is obtained via a flexural mechanical bending test. The load capability is evaluated indirectly in terms of an actuating displacement with a load of mass at simply supported and fixed-free boundary conditions. Additionally, a free displacement under no load of mass is measured for a comparison with an actuating displacement. The results reveal that an actuator with a top layer having a high elastic modulus and a low coefficient of thermal expansion exhibits a better performance than the rest of actuators in terms of free displacement as well as actuating displacement due to the formation of the large stored elastic energy within the actuator system. When actuators are excited at AC voltage, the actuating displacement is rather higher than the free displacement for the same actuating conditions. In addition, the effect of PZT ceramic softening results in a slight reduction in the resonance frequency of each actuator as the applied electric field increases. It is thus suggested that the static and dynamic actuating characteristics of bending piezoelectric composite actuators with a thin sandwiched PZT plate should be simultaneously considered in controlling the performance.

• Korean Journal of Environmental Agriculture
• /
• v.24 no.1
• /
• pp.61-65
• /
• 2005

This study was to evaluate whether ionizing gamma radiation could be applied to break the dormancy of a potato minituber. The respiration rate of the minitubers was significantly affected by the storage temperature and a low dose gamma radiation. Ionizing radiation of 8 Gy enhanced the respiration rate of the potato tuber stored at $10^{\circ}C$ for 20 days. The potato tuber subjected to 4 and 8 Gy after 40 days storage at 10 and $20^{\circ}C$ exhibited higher respiration rates compared to the control (non-irradiated), but not at st. However, the ionizing radiation did not exhibit on significant effect on the respiration rate of the potato tuber stored for 60 days. It was observed that minitubers stored for 20 days had significant response to the storage temperature in terms of the total sugar content the higher the storage temperature, the lower the total sugar content. It was measured that the reducing sugar content was increased under the storage conditions both 5 and $10^{\circ}C$ for 40 days, but not to $20^{\circ}C$. The total sugar contents in the minituber stored for 60 days were similar to those stored for 40 days. The data was discussed on the relationships among the storage duration, temperature and ionizing radiation.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.32 no.7
• /
• pp.60-68
• /
• 2004

High velocity impacts are accompanied with large deformations, which generate a large amount of heat due to plastic works, resulting in a significant temperature rise of the material. Because the elevated temperature affects the dynamic properties of materials, it is important to predict the temperature rise during high-stram-rate deformations. Both existing vacancies and excess vacancies are credited to the stored energy, yet it is difficult to distinguish one from another in contribution to the stored energy using macroscopic level materials models. In this study, an atomistic material model for fee materials such as copper is set up to calculate the stored energy using molecular dynamics (MD) simulations. It is concluded that excess vacancies play an important role for the stored energy during a high-strain-rate deformation.

• Proceedings of the KIPE Conference
• /
• 2005.07a
• /
• pp.526-528
• /
• 2005

Nowadays, more than ever before, many researchers are paying attention to raising the efficiency of a Power converter. In Flyback converter, the resistor of RCD snubber consumes the stored energy in leakage inductor. It play a role in degrading the overall system efficiency Thus, In this paper, a novel energy recovery circuit of Flyback converter is proposed to improve the efficiency. The operational principle of the proposed circuit is explained in detail. And, it is verified through the simulation results.

• Progress in Superconductivity and Cryogenics
• /
• v.19 no.3
• /
• pp.49-53
• /
• 2017

The superconducting magnets have a large inductance as well as high operating current. Therefore, mega-joule scale energy can be stored in the magnet. The energy stored in the magnet is sufficient to damage the magnet when a quench occurs. Quench heater and dump resistor can be used to protect the magnet. However, using quench heater to create quench resistors through heat transfer can be slower than instantly switching resistors. Also, electrical short, overheating and breakdown can occur due to quench heater. Moreover, the number of dump resistor should be limited to avoid large terminal voltage. Therefore, in this paper, we propose a quench protection method for extracting the energy stored in a magnet by charging and discharging energy through a capacitor switching without increasing resistance. The simulation results show that the proposed system has a faster current decay within the allowable voltage level.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2017.10a
• /
• pp.421-424
• /
• 2017

This paper describes a full-wave rectifiers for energy harvesting circuit using vibration detector. The designed circuit operates only when the vibration is detected through the vibration detector and the active diode. When there is no vibration, the comparator is turned off to prevent leakage of energy stored in the $C_{STO}$. The energy stored in the capacitor is used to drive the level converter and the active diode. The energy stored in the capacitor is supplied to an active diode designed as an output power. The vibration detector is implemented with Schmitt Trigger and Peak Detector with Hysteresis function. The proposed circuit is designed in a CMOS 0.35um technology and its functionality has been verified through extensive simulations. The designed chip occupies $590{\mu}m{\times}583{\mu}m$.