• Molecules and Cells
• /
• 제26권2호
• /
• pp.212-215
• /
• 2008

The GC-rich discriminator sequence between the -10 region and the transcription start site of the rnpB promoter is responsible for stringent control of M1 RNA synthesis. The rnpB promoter also contains a G nucleotide at the previously identified transcription start site. In this study, we examined by mutagenesis of G to A whether this +1G nucleotide is involved in the stringent response. We found that the change did not alter the stringent response. Since the +1 mutation might alter transcription initiation, we compared the transcription start sites of the wt and mutant promoters by primer extension analysis. Surprisingly, we found that wild type rnpB transcription starts at both the +1G position (70%) and the -1C position (30%), and that the +1A mutation led to transcription initiation exclusively at the -1C position. We also generated two transversion mutations at the -1 position, both of which led to transcription starting exclusively at that position. The -1G mutant promoter gave a stringent signal similar to the wild-type, whereas the -1A mutant generated a significantly less stringent signal. Base on these results, we propose that a short sequence, up to 7 bp downstream of the -10 region, is involved in the stringent response of the rnpB promoter.

• 한국산학기술학회논문지
• /
• 제21권10호
• /
• pp.317-324
• /
• 2020

천연가스를 연료로 사용하는 복합화력발전소는 석탄화력 대비 기동 및 정지가 용이하고 오염물질의 배출에 대한 부하가 적어 국내 발전설비 중 차지하는 비중이 꾸준히 상승하고 있다. 그러나 복합화력발전소는 가스터빈의 기동초기 및 저부하 운전 영역에서 황연현상을 일으키는 이산화질소(NO2)의 농도가 높은 특성을 가지고 있어 민원의 원인이 되며, 이의 제어 기술로서 황연제거설비가 2000년대 중반에 개발되어 운영되어 지고 있었다. 하지만 이 기술은 가스터빈 냉간기동 조건에서 기동초기 약 10~20분 동안은 기화시스템의 예열이 충분하게 이루어 지지 않아 황연현상을 제어할 수가 없는 실정이었다. 이에 본 연구에서는 환원제를 기화기를 사용하지 않고 액상의 상태로 가스터빈 Exhaust Duct에 직접 분사하여 황연현상을 제어하는 기술의 도출을 위해 CFD 해석 및 실증시험을 수행하였다. 가스터빈 Exhaust Duct에 위치에 있는 Diffuser에 의해 Duct의 외곽으로 형성된 배기가스에 액상의 환원제를 직분사하는 방안으로 배기가스 조건에 따라 5가지 Case로 분류하여 CFD를 수행하였으며, 그 결과 5가지 Case 모두에서 RMS가 15%이하로 양호한 혼합도를 보였다. 이를 바탕으로 실증설비를 설치 및 시험을 실시한 결과, 기존 기상주입방식에서 제어할 수 없었던 기동 초기 약 10~20분 구간의 황연현상도 완벽하게 제어할 수 있었다.

• 대한기계학회논문집B
• /
• 제26권6호
• /
• pp.788-794
• /
• 2002

In liquid rocket engine, propellant feed rate is proportional to approximately square root of the pressure difference between injector head and combustion chamber. This ΔP depends on the engine design, but in general on the order of 50psi. However, during ignition period, especially for the pressurized feed system, combustion chamber pressure is almost atmospheric and large ΔP causes over flow of propellants which may lead to catastrophic accident due to hard start. Hard start may be prevented by applying cavitating venturi or/and two step ignition. In cavitating venturi, evaporated propellants near the venturi throat become chocked and flow rate depends on only upstream condition. In two step ignition propellants are supplied to the liquid engine in two different flow rate. First step, to avoid hard start, small amount of propellants are supplied to build up chamber pressure in safe zone, then full propellants to ensure design pressure. In this study, both cavitating venturi and two step ignition method were used for the hot test and hard start problem was completely solved.

• 한국항공우주학회지
• /
• 제34권5호
• /
• pp.65-73
• /
• 2006

위성이 발사체로부터 분리될 때 초기 각속도가 발생한다. B-dot 로직은 일반적으로 위성의 초기각속도 제어에 사용되나, 상대적으로 제어시간이 많이 소요된다는 단점이 있다. 이런 문제를 해결하기 위해 본 논문에서는 피치 바이어스 모멘텀 방식을 사용하는 초소형 위성에 적용 가능한 디텀블링(detumbling) 방식을 새롭게 제안하였다. 제안된 디텀블링 방식은 제어시간이 약 20분 이내로 기존의 방식에 비해 상당한 시간을 줄일 수 있다. 본 논문에서 제안한 디텀블링 방식을 사용할 경우 기존의 모멘텀 휠 초기구동 방식을 사용할 수 없다. 따라서 휠의 속도를 안정적으로 공칭 속도까지 증가시키는 방식을 제안하고 시뮬레이션을 통해 비교, 검증하였다. 시뮬레이션 결과 기존의 방식과 비교했을 때 제어시간을 단축할 수 있었으며 휠의 공칭 속도와 3축 안정화를 이룰 수 있었다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1987년도 전기.전자공학 학술대회 논문집(II)
• /
• pp.1003-1007
• /
• 1987

The system start-up function of TDX-1A that should be executed during installation or emergency has been designed to meet requirements of the distributed real time control system. It is performed in a centralized manner by the dedicated processor according to the maintenance and administration mechanism of the system. Upon execution, it provides information on the system state for the ESS personal. In additions, it protects the loss the charging and statistics data, and minimizes the effect on the customer service. This paper describes the design concept of the system startup function and its implementation method and also calculates its the execution time.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 1986년도 한국자동제어학술회의논문집; 한국과학기술대학, 충남; 17-18 Oct. 1986
• /
• pp.200-204
• /
• 1986

Particle size distribution in a Continuous Mixed Suspension Mixed Crystal Removal (CMSMPR) crystallizer has been analyzed using the Population Balance (PB) model. This method presents difficulties when the growth rate of crystal depends on the crystal size. Recent studies indicate that in many cases the growth rate is dependent on size when the crystal sizes are small. In this study, a Residence Time Distribution(RTD) model was proposed to take the size dependence into account together with an appropriate numerical scheme. When compared with the approximate results based on PB model, RTD model results showed improvements also a nucleation effect which is normally unimportant for steady state analysis. Start-up data for NaCl-Water-Ethanol system was compared with computed values.

• Journal of Power Electronics
• /
• 제5권3호
• /
• pp.240-246
• /
• 2005

Considering the start-up and economical efficiency, the optical sensor technique using a slotted-disk and an opto-interrupter are appropriate, however, this method needs three opto-interrupters and a slotted-disk when driving the 6/4 pole SRM(switched reluctance motor). In this paper, we propose an economic method by replacing the conventional opto-interrupter and slotted-disk with only optical sensor which enables the motor to start up and forward and reverse operation. Also the control circuit includes only analog devices, which makes the process more economical.

• Journal of Information Technology Applications and Management
• /
• 제28권2호
• /
• pp.17-33
• /
• 2021

Korean society is changing into multicultural society with increasing international marriage and immigrant influx. The increasing number of immigrants in Korean society suggests the necessity of social and economic integration of people with diverse cultural backgrounds. We study the entrepreneurial intention of multicultural immigrant. Cultural intelligence is closely related with sustainable value and belief to their eagerness in surviving of the 2nd country. Cultural intelligence is the individual's capability to function or manage effectively in different cultural settings or in multicultural settings. It is assumed that the cultural intelligence of multicultural immigrant might affect the entrepreneurial intention. Based on the theory of planned behavior, we set up the research model. 243 usable responses of multicultural immigrants in Korea were analyzed. Our findings suggest that cultural intelligence positively affected entrepreneurial intention by affecting subjective norm and perceived behavior control. This study contributed the study of the entrepreneurial intention and multicultural immigrant.

• 한국생산제조학회지
• /
• 제8권4호
• /
• pp.112-122
• /
• 1999

In realistic control systems the nonlinear saturation attributes of the control actuator due to physical limitations should be taken into account This nonlinear saturation of actuators may cause not only deterioration of the control performance but also a large overshoot during start-up and shut-down. As the overshoot increases the system may become oscillatory unstable. in this paper the supervisor implementation which guarantees good performance for saturation operation and prevents reset wind up is presented, Moreover the sufficient conditions of the stability for saturated system using supervisory control with a dynamic controller are provided in the continuous-time and in the discrete-time domain Numerical example is illustrated to depict the efficiency of supervisory control for a typical satuaurated production-distribution system controlled by a discrete-time dynamic controller and to validate basic results by simulation.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 2003년도 ICCAS
• /
• pp.1371-1376
• /
• 2003

In the thermal power plant, the main steam temperature is typically regulated by the fuel flow rate and the spray flow rate, and the reheater steam temperature is regulated by the gas recirculation flow rate. However, Strictly maintaining the steam temperature can be difficult due to heating value variation to the fuel source, time delay changes in the main steam temperature, the change of the dynamic characteristics in the reheater. Up to the present time, PID Controller has been used to operate this system. However, it is very difficult to achieve an optimal PID gain with no experience, since the gain of the PID controller has to be manually tuned by trial and error. This paper focuses on tuning of the 2-DOF PID Controller on the DCS for steam temperature control using immune based multiobjective approach. The stable range of a 2-DOF parameter for only this system could be found for the start-up procedure and this parameter could be used for the tuning problem. Therefore tuning technique of multiobjective based on immune network algorithms in this paper can be used effectively in tuning 2-DOF PID controllers.