• 대한원격탐사학회:학술대회논문집
• /
• 대한원격탐사학회 2003년도 Proceedings of ACRS 2003 ISRS
• /
• pp.825-827
• /
• 2003

Multi-Spectral Camera(MSC) is a payload on the KOMPSAT-2 satellite to perform the earth remote sensing. The instrument images the earth using a push-broom motion with a swath width of 15 km and a ground sample distance (GSD) of 1 m over the entire field of view (FOV) at altitude 685 Km. The instrument is designed to have an on-orbit operation duty cycle of 20% over the mission lifetime of 3 years with the functions of programmable gain/ offset and on-board image data compression/storage. The MSC instrument has one(1) channel for panchromatic imaging and four(4) channel for multi-spectral imaging covering the spectral range from 450nm to 900nm using TDI CCD Focal Plane Array (FPA). In this paper, the architecture and function of MSC hardware including electrical interface and the operation concept which have been established based on the mission requirements are described. And the design and the preparation of MSC system operation are analyzed and discussed.

• Korean Journal of Geomatics
• /
• 제4권1호
• /
• pp.1-8
• /
• 2004

In the middle-resolution remote sensing, the Ground Sampled Distance (GSD) that the detector senses and samples is generally larger than the actual size of the objects (or materials) of interest, and so several objects are embedded in a single pixel. In this case, as it is impossible to detect these objects by the conventional spatial-based image processing techniques, it has to be carried out at sub-pixel level through spectral properties. In this paper, we explain the sub-pixel analysis algorithm, also known as the Linear Spectral Mixing (LSM) model, which has been experimented using the Hyperion data. To find Endmembers used as the prior knowledge for LSM model, we applied the concept of the convex geometry on the two-dimensional scatter plot. The Atmospheric Correction and Minimum Noise Fraction techniques are presented for the pre-processing of Hyperion data. As LSM model is the simplest approach in sub-pixel analysis, the results of our experiment is not good. But we intend to say that the sub-pixel analysis shows much more information in comparison with the image classification.

• 항공우주기술
• /
• 제1권2호
• /
• pp.66-74
• /
• 2002

위성 영상 품질 인자들 중에서 위성 영상 탑재체에 의해 결정되는 인자들의 특성을 조사하였고 그들의 특성을 연구하였다. 위성 영상은 일차적으로 위성영상탑재체에 의해 생성되므로 위성 영상의 품질은 위성영상탑재체의 성능에 크게 의존한다. 따라서 위성 영상품질 인자로서 탑재체 성능 인자를 고려하여야 한다. 탑재체 성능 인자는 대략적으로 관측파장대역(Spectral Band), 지상화소거리(Ground Sample Distance: GSD) 결정 인자, 관측폭 결정 인자, 탑재체 Modulation Transfer Function (MTF), 탑재체 신호대잡음비(Signal to Noise Ratio: SNR), 여러 탑재체 복사 응답 특성 인자, Pixel Registration, 탑재체 보정 등이 있다.

• 한국방송∙미디어공학회:학술대회논문집
• /
• 한국방송공학회 2003년도 정기총회 및 학술대회
• /
• pp.215-218
• /
• 2003

본 논문에서는 MPEG-7에 정의된 오디오 서술자를 이용한 오디오 특징을 기반으로 한 음악 검색 알고리즘을 제안한다. 특히 timbral 특징들은 음색 구분을 용이하게 할 수 있어 음악 검색뿐만 아니라 음악 장르 분류 또는 Query by humming에 이용 될 수 있다. 이러한 연구를 통하여 오디오 신호의 대표적인 특성을 표현 할 수 있는 특징벡터를 구성 할 수 있다면 추후에 멀티모달 시스템을 이용한 검색 알고리즘에도 오디오 특징으로 이용 될 수 있을 것이다 본 논문에서는 방송 시스템에 적용 할 수 있도록 검색 범위를 특정 컨텐츠의 O.S.T 앨범으로 제한하였다. 즉, 사용자가 임의로 선택한 부분적인 오디오 클립만을 이용하여 그 컨텐츠 전체의 O.S.T 앨범 내에서 음악을 검색할 수 있도록 하였다. 오디오 특징벡터를 구성하기 위한 MPEG-7 오디오 서술자의 조합 방법을 제안하고 distance 또는 ratio 계산 방식을 통해 성능 향상을 추구하였다. 또한 reference 음악의 템플릿 구성 방식의 변화를 통해 성능 향상을 추구하였다. Classifier로 k-NN 방식을 사용하여 성능 평가를 수행한 결과 timbral spectral feature들의 비율을 이용한 IFCR(Intra-Feature Component Ratio) 방식이 Euclidean distance 방식보다 우수한 성능을 보였다.

• 한국지진공학회논문집
• /
• 제25권1호
• /
• pp.33-42
• /
• 2021

The design response spectrum presented in the seismic design standard reflects the characteristics of the tectonic environment at a site. However, since the design response spectrum does not represent the ground motion with a specific earthquake magnitude or distance, input ground motions for response history analysis need to be selected reasonably. It is appropriate to use observed ground motions recorded in Korea for the seismic design. However, recently recorded ground motions in the Gyeongju (2016) or Pohang (2017) earthquakes are not compatible with the design response spectrum. Therefore, it is necessary to convert the recorded ground motion in Korea to a model similar to the design response spectrum. In this study, several approaches to adjust the spectral acceleration level at each period range were tested. These are the intrinsic and scattering attenuation considering the earthquake environment, magnitude, distance change by the green function method, and a rupture propagation direction's directivity effect. Using these variables, the amplification ratio for the representative natural period was regressed. Finally, the optimum condition compatible with the design response spectrum was suggested, and the validation was performed by converting the recorded ground motion.

• Geomechanics and Engineering
• /
• 제20권2호
• /
• pp.131-146
• /
• 2020

Evaluation of earthquake impacts in settlements with a high risk of earthquake occurrence is important for the determination of site-specific dynamic soil parameters and earthquake-resistant structural planning. In this study, dynamic soil properties of Karliova (Bingol) city center, located near to the intersection point of the North Anatolian Fault Zone and the East Anatolian Fault Zone and therefore having a high earthquake risk, were investigated by one-dimensional equivalent linear site response analysis. From ground response analyses, peak ground acceleration, predominant site period, 0.2-sec and 1-sec spectral accelerations and soil amplification maps of the study area were obtained for both near-field and far-field earthquake effects. The average acceleration spectrum obtained from analysis, for a near-field earthquake scenario, was found to exceed the design spectra of the Turkish Earthquake Code and Eurocode 8. Yet, the average acceleration spectrum was found to remain below the respective design spectra of the two codes for the far-field earthquake scenario. According to both near- and far-field earthquake scenarios in the study area, the low-rise buildings with low modal vibration durations are expected to be exposed to high spectral acceleration values and high-rise buildings with high modal vibration durations will be exposed to lower spectral accelerations. While high amplification ratios are observed in the north of the study area for the near-distance earthquake scenario, high amplification ratios are observed in the south of the study area for the long-distance earthquake scenario.

• 한국항행학회논문지
• /
• 제28권1호
• /
• pp.123-128
• /
• 2024

전체 전송 거리의 중간에서 위상 공액파로 반전시키는 MSSI (mid-span spectral inversion)을 분산 제어 링크에 결합시키면 색 분산과 비선형 효과에 의한 파장 분할 다중 (WDM; wavelength division multiplexed) 신호의 왜곡 보상에 매우 효과적이다. 이러한 MSSI 결합 분산 제어 링크에서 분산 맵의 모양, 채널의 데이터율, 채널 파장과 파장 간격 등은 보상 정도에 영향을 미치고, 결과적으로 WDM 신호의 전송 거리와 용량을 결정하게 한다. 본 논문에서는 MSSI 결합 분산 제어 링크에서 WDM 신호를 구성하는 RZ (return-to-zero) 펄스의 소광비에 따른 보상 특성을 분석하였다. 시뮬레이션 결과 소광비가 커질수록 '1'과 '0' 신호의 전력 차이가 증가하여 수신 성능이 좋아지는 일반적인 광전송 시스템에서의 결과가 아닌 분산 맵의 형태와 분산 맵의 구체적 모양을 결정하는 광섬유 스팬 당 잉여 분산의 크기에 따라 최상의 보상을 얻을 수 있는 소광비가 결정되어야 한다는 것을 알 수 있었다.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2005년도 춘계학술대회 논문집
• /
• pp.569-572
• /
• 2005

Technological feasibility of using recently-available femtosecond ultra short pulse lasers for advanced precision length metrology is investigated with emphasis on absolute distance measurements with $10{\mu}m$ ??resolution over extensive ranges. The idea of using femtosecond lasers for the measurement of absolute distances is based on the fact that a short pulse train is a mode-locked combination of discrete monochromatic light components spanning a wide spectral bandwidth. The synthetic wavelength is created from the repetition frequency, $f_r$ of the femtosecond laser and for more precise resolution, higher-order harmonics of the repetition frequency may be selected as the synthetic wavelength by using appropriate electronic filters.

• Structural Engineering and Mechanics
• /
• 제48권3호
• /
• pp.333-350
• /
• 2013

This paper deals with the development of expressions relating structural seismic response parameters to the epicentral distances of an earthquake and the natural period of several reinforced concrete buildings (6, 9 and 12 storey), with three floor plans: symmetric, monosymmetric, and unsymmetric. These structures are subjected to seismic spectrum of accelerations collected during the Boumerdes earthquake (Algeria, May $21^{st}$, 2003, Mw=6.8) at different epicentral distances. The objective of this study is to develop relations between structural responses namely: base shear, storey displacements, interstory drifts and epicentral distance and fundamental period for a given earthquake. The seismic response of the buildings is carried out in both longitudinal transverse and directions by the response spectrum method (modal spectral approach).

• 한국수산과학회지
• /
• 제42권6호
• /
• pp.711-720
• /
• 2009

Characteristics of spectral irradiance based on the distance from the light source, which combined metal halide lamp and high-luminance light-emitting diode (LED) light, were studied to investigate a suitable operating method for fishing lamps of the next generation. A 380-780 nm wavelength radiation was superior when using 1 W electrical power in the order of metal halide lamp, blue LED, white LED, and combined LED lights. The wavelengths at which the irradiance was at a maximum were fixed to 581 nm for the light source, which was combined for each ratio. If the irradiance characteristics at 300-1100 nm wavelengths were set as 100%, the irradiance rates at 400-599 nm were 100%, 72.7%, 88.9%, and 69.5% for the blue, white, combined LED lights, and metal halide lamp, respectively. This indicated that the color rendering of the LED lights was dependent on the metal halide lamp light source. When the horizontal profiles (450-550 nm wavelength) of irradiances were compared to a different type of light source in the ratio white LED: combined LED lights: blue LED: metal halide lamp, the irradiated area of more than $0.01\;{\mu}mol/s/m^2/nm$ was in the ratio 1.0 : 1.3 : 1.7 : 37.3, respectively. Based on the radiation characteristics and irradiance according to the distance from the light source, LED lights have an estimated economic efficiency if used before and after operation of a metal halide lamp.