• Proceedings of the Korean Society of Medical Physics Conference
• /
• 2002.09a
• /
• pp.385-388
• /
• 2002

We measured and evaluated digital, pre-sampling and overall imaging properties (characteristic curves, Modulation Transfer Function (MTF), Wiener spectra (WS), Noise Equivalent Quanta (NEQ) and Detective Quantum Efficiency (DQE)) for the direct type and indirect type of Flat-Panel Detector (FPD). First, the digital and overall characteristic curves of the both types of FPD had more wide dynamic range than that of the S/F system. Second, the pre-sampling and overall MTF of the direct-type FPD were superior to those of the indirect-type FPD. Third, for identical exposures, the digital and overall WS of the direct-type FPD were similar or worse than those of the indirect-type FPD, and for larger exposure, the digital WS of the both types of FPD were smaller, but overall WS of the both types of FPD were larger. Fourth, the digital and overall NEQ and DQE of the direct-type FPD were worse than both NEQ and DQE of the indirect-type FPD at lower spatial frequencies, but were better at higher spatial frequencies.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.32 no.1
• /
• pp.47-55
• /
• 2012

A structural health monitoring technique for locating impact position in a plate structure is presented in this paper. The method employs a single sensor and spatial focusing of time reversal (TR) acoustics. We first examine the TR focusing effect at the impact position and its surroundings through simulation and experiment. The imaging results of impact points show that the impact source location can be accurately estimated in any position of the plate. Compared to existing techniques for locating impact or acoustic emission source, the proposed method has the benefits of using a single sensor and not requiring material properties and geometry of structures. Furthermore, it does not depend on a particular mode of dispersive Lamb waves that is frequently used in other ultrasonic testings of plate-like structures.

• Applied Microscopy
• /
• v.38 no.3
• /
• pp.185-193
• /
• 2008

An experimental comparison of the detection properties between imaging plate and film for recording the electron diffraction pattern was carried out on a radiation-sensitive material, an aluminum trihydroxide(gibbsite, ${\gamma}-Al(OH)_3$), through the electron beam irradiation. Because the imaging plate has a wide dynamic range sufficient for recording extremely low- and high-electron intensities, the range of spatial frequency for the diffraction pattern acquired by the imaging plate was extended to two times larger than the range by the film, especially at a low electron dose condition(${\leq}0.1\;e^-/{\mu}m^2$). It is also demonstrated that the imaging plate showed better resolving power for discriminating fine intensity levels even in saturated transmitted beam. Hence, in the respect of investigating the structures of radiation-sensitive materials and cryo-biological specimens, our experimental demonstrations suggest that the imaging plate technique may be a good choice for those studies, which have to use an extremely low electron intensity for recording.

• Journal of Korea Multimedia Society
• /
• v.20 no.7
• /
• pp.1038-1045
• /
• 2017

The increase in frequency and scale of natural disasters is the typical negative examples of the global climate change and the change of the human living environment. The damage caused by natural disasters in particular including human and physical damage is directly linked to the safety and properties of citizens. Besides, damage occurs directly or indirectly to the SOC facility, and the damaged SOC facility violates the citizens' safety rights. Therefore, a plan to provide prompt and effective risk map information by linking a 3D disaster information display system, which handles the information of the damage that may occur to SOC facilities at the time of disasters, with an on-site assistance application is suggested in this study. The prompt provision of risk map information is defined as a dynamic expression technology in this study. It also processes and compresses the system to display disaster information, a spreading system that can utilize on-site information, and a module developed to organically link with the DB system that builds information and relationships. Based on the module, the effective disaster information compression plan will be prepared, and the prompt information transmission system will be secured.

• Korean Institute of Interior Design Journal
• /
• v.17 no.5
• /
• pp.166-174
• /
• 2008

As the use of virtual environment for decision-making interior or architectural design has been increasingly broaden, the choice of media form-physical, objective properties of a display medium-became and important issue to take into consideration. This research deals with the effects and differences between two types of media for a virtual environment; wall projection screen(120") and PC monitor(17"). In addition, efficient adoption of the two media forms was also proposed in this research. A total of 90 subjects participated in pre-designed three experimental groups(A group: experiment with a wall projection screen, B group: experiment with PC monitor, C group: both) and answer the seating preferences, the presence inventory, and the decision confidence using a simulated virtual restaurant environment. The results are as follows: (1) seating preferences for the tables located in frequent traffic area and near other spaces such as restroom and th kitchen are significantly different by the media form. While there is no significant difference found in seating preferences for most tables except high traffic areas near entrances between the two media. This result demonstrates the effects of media type or screen size on user perception for the areas near structural or interior design elements. (2) The presence measure in this research consist of in this research consist of four factors: 'spatial presence,' 'object presence,' 'positive effects,' and 'the factor of negative effects. 'The mean values of the items involving engagement or interaction in the spatial presence factor and the object presence factor are significantly different by the media form. A higher sense of presence of presence was observed in the wall projection screen. (3) PC monitor condition was shown to provide a higher level of decision confidence. Based on the research finding, conclusions and implications are discussed.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.8C
• /
• pp.767-774
• /
• 2007

A new transmit antenna selection and shuffling($AS^2$) method for spatially correlated double space time transmit diversity(DSTTD) systems is proposed. The proposed method allows dumb antennas and the superposition of multiple signals at the same transmit antenna, whereas the conventional methods consider the antenna shuffling(AS) only. According to the simulation result, the proposed method provides a 1.8 dB signal-to-noise ratio(SNR) gain over the conventional methods for spatially correlated transmit antennas. Although the number of candidates for $AS^2$ is much higher than that of AS, it is found that the number of candidates for $AS^2$ can be reduced to 36 by using the characteristics and properties of preprocessing matrices, and among them, only 6 candidates are almost always chosen. Next, we empirically compare the bit-error-rate (BER) performance of the proposed method with the conventional spatial multiplexing(SM) technique with antenna selection. Simulation results show that the proposed method outperforms the SM technique.

• Journal of Korean Society for Geospatial Information Science
• /
• v.13 no.1 s.31
• /
• pp.45-53
• /
• 2005

Korea is formed a mountainous district at 70% of country. Damages are occurred by landslide. It is increased annually by industrial development and extension of urban area. Serious damages occurred in Kangreng area of Gangwondo by typoon Rusa in August, 2002. Landslide hazard mapping needs to forecast and to manage landslide hazard area. GIS fits landslide hazard mapping, to reduce of time, manpower and costs, to investigate a board area, to do a spatial forecast model in study site. Variety of methods is for landslide hazard mapping. A study use root strength reinforcement model. This model use factors such as topography of slope, soil depth, soil properties, and vegetation of slope. Landslide hazard map is made by this model.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.3 no.1
• /
• pp.12-22
• /
• 2000

Recently urbanization and industrialization around the Nak-dong river watershed have lead to the regional environmental problems. In this viewpoint, we took up variables which were related to watershed environment, and found out spatial and environmental properties of the Nak-dong river using factor analysis, ANOVA test and geographic information system. The results may be summarized as follows; three common factors which were named as urban, agricultural and industrial pollutant factor extracted from statistical methods. Spatial distribution of watershed environment could be found by connection attributes of factor scores derived from factor analysis to digital map using GIS. According to the results, distribution of pollutant sources were concentrated in the main stream of the Nak-dong river and its tributaries, Kum-ho river. So it is necessary to manage the watershed environment in due consideration of environmental carrying capacity.

• Journal of Broadcast Engineering
• /
• v.2 no.1
• /
• pp.45-55
• /
• 1997

In this paper, we propose a fast algorithm with adaptive thresholding for the wavelet transform (WT) based blocking artifact reduction. In the fast algorithm, all processings that are equivalent to the processing in WT domain of the first and second scale are performed in spatial domain. In the adaptive thresholding, the threshold values used to classify the block boundary are selected adaptively according to each input image by using the statistical properties of the WT of the coded signal at block boundary and at block center, which can be obtained in spatial domain. Experimental results showed that the proposed fast algorithm is about 10 times faster than the WT-based algorithm. It also was found that the postprocessing with proposed adaptive thresholding yields some PSNR improvement and better subjective quality over that with nonadaptive thresholding which has best performance at high compression ratios of a certain .image, even at low compression ratios.

• Korean Journal of Remote Sensing
• /
• v.31 no.4
• /
• pp.281-291
• /
• 2015

Sun glint correction methods of hyperspectral data that have been developed so far have not considered the various situations and are often adequate for only certain conditions. Also there is an inaccurate assumption that the signal in NIR wavelength is zero. Therefore, this study attempts to analyze the NIR spectral properties of sun glint effect in coastal waters. For the analysis, CASI-1500 airborne hyperspectral data, bathymetry data and in-situ data obtained at coastal area near Sin-Cheon, Jeju Island, South Korea were used. The spectral characteristics of radiance and reflectance at the five NIR wavelengths (744 nm, 758 nm, 772 nm, 786 nm, and 801 nm) are analyzed by using various statistics, spatial and spectral variation of sun-glinted area under conditions of the bottom types of benthos, barren rocks and sand with similar water depth. Through the quantitative analysis, we found that the relation of water depth or bottom type with sun glint is relatively less which is a similar result with the previous studies. However the sun glint are distributed similarly with the patterns of the direction of wave propagation. It is confirmed that the areas with changed direction of wave propagation were not affected by the sun glint. The spatial and spectral variations of radiance and reflectance are mainly caused by the effect of sun glint and waves. The radiance or reflectance of more sun-glinted areas are increased approximately 1.5 times and the standard deviations are also increased three times compared to the less sun glinted areas. Through this study, the further studies of sun glint correction method in coastal water using the patterns of wave propagation and diffraction will be placed.