• Journal of Periodontal and Implant Science
• /
• v.35 no.2
• /
• pp.491-510
• /
• 2005

This study was performed to evaluate the effect of inorganic polyphosphate on bone formation in the calvaria of rabbit in the procedure of guided bone regeneration with bovine cancellous bone graft and titanium reinforced expanded polytetrafluoroethylene(TR-ePTFE) membrane. The rabbits were divided into four groups. Control group I used only TR-ePTFE membrane, control group II used TR-ePTFE membrane and deproteinized bovine bone mineral soaked in saline, experimental group III and IV used TR-ePTFE membrane and deproteinized bovine bone mineral soaked in 1% or 2% inorganic polyphosphate respectively. After decortication in the calvaria, GBR procedure was performed on 12 rabbits with titanium reinforced ePTFE membrane filled with deproteinized bovine bone mineral soaked in saline or inorganic polyphosphate. The animals were sacrificed at 2 weeks, 4 weeks, and 8 weeks after the surgery. Decalcified and non-decalcified specimens were processed for histologic and immunohistochemistric analysis. 1. Titanium reinforced ePTFE(TR-ePTFE) membrane showed good spacemaking and cell occlusiveness capability, but it showed poor wound stabilization. 2. The deproteinized bovine bone mineral did not promote bone regeneration, but it acted as a space filler. 3. There was no complete resorption of the deproteinized bovine bone mineral within 8 weeks. 4. 1% inorganic polyphosphate did not promote bone formation, but 2% inorganic polyphosphate promoted bone formation. Within the above results, 2% inorganic polyphosphate could be used effectively for bone regeneration.

• Tunnel and Underground Space
• /
• v.33 no.3
• /
• pp.126-140
• /
• 2023

In this study, the cause of subsidence in limestone mine was analyzed using a LiDAR-based geometry model. Using UAV and ground-based LiDAR systems, a precise geometry model was constructed for the subsidence surface and mine tunnel, and the results of on-site geological survey and rock mass classification were utilized. Through the geometry model, distribution of thickness of crown pillar and faults around the subsidence area, calculation of the volume of the subsidence area and subsidence deposit, and analysis of the subsidence surface inclination were conducted. Through these analyzes, the causes of ground subsidence were identified.

• Tunnel and Underground Space
• /
• v.10 no.3
• /
• pp.309-315
• /
• 2000

For proper sampling of a rock and preparation of specimens, the representative elementary volume (REV) should be determined in rock mechanical test and numerical analysis. Mechanical properties of a rock, in general, would be strongly affected by mineral composition. In this reason REV of Youngju granite is determined by using stereoscopic microscope observation and homogenization numerical analysis. As the area of analysis model exceeds approximately 702$\textrm{mm}^2$(900 elements), the change of the mineral composition is not observed. The calculated results indicate that Young's modulus is fluctuated with increase of the number of elements in homogenization numerical analysis mesh. However, as the number of elements exceeds 1156 (area of about 900$\textrm{mm}^2$), Young's modulus does not change apparently.

• Journal of Periodontal and Implant Science
• /
• v.34 no.3
• /
• pp.683-698
• /
• 2004

One of the bone substitutes now in routine use, deproteinized bovine bone mineral(DBBM), is regarded as resorbable and osteoconductive, but some studies refute this. The present study was performed to evaluate the effects of DBBM on guided bone regeneration using titanium membrane on the calvaria of rabbit. At 2 weeks, 4 weeks, 8 weeks, and 12 weeks after surgery, the animal was scrificed. Non-decalcified specimens were produced for histologic analysis. The results of this study were as follows : 1. Titanium membrane was biocompatible and capable of space-maintaining, but there was ingrowth of soft tissue through the pore of titanium membrane. 2. There was no resorption or reduction of DBBM with time. 3. Some of the DBBM particles were combined with newly formed bone. But, apart from host bone, a great part of the particles were surrounded by connective tissue. 4. The bone formation was slight vertically and restricted to superficial area of host bone. Whithin the above results, DBBM dose not appear to contribute to bone formation. DBBM may disturb the migration and proliferation of mesenchymal cell derived from host bone and increase the growth of connective tissue. Therefore, careful caution is needed on selection of bone graft material and surgical protocol at guided bone regeneration for implant placement.

• Journal of Forest and Environmental Science
• /
• v.27 no.2
• /
• pp.73-79
• /
• 2011

The Barind tract is threatened by desertification and undergoing rapid change. In view of this fact it is very much essential to manage this barind tract under proper land-use plan. The present study evaluates the effectiveness of high-resolution satellite data and computer aided GIS techniques in assessing land-use change detection for the period 1990 to 2007 within the study area, which is very much essential to manage this barind tract under proper land-use plan, and for proper land-use plan it is necessary to get reliable information. The present study found five major land-use such as current fallow, current agriculture, settlement, irrigation water and water bodies. From the result, it is found that current fallow and water bodies decrease while settlement and current agriculture increase. Study concludes that as Barind tract is threatened by desertification, decrease of water bodies is not a good sign for the study area.

• Economic and Environmental Geology
• /
• v.48 no.4
• /
• pp.313-324
• /
• 2015

This study constructed a 3D geological model for Uggi Nuur Fe-Mn mineralization zone in Mongolia, and the 3D geological distribution is cross-analyzed with magnetic anomaly distribution to figure out relationship between ore zone and subsurface geology. As a result of 4 step 3D modeling procedures including geological cross section, surface modeling, foliation modeling and solid modeling, the geology of the both study area is bordered by faults in NW direction with Munguntessj formation being located in the west side of the fault while Yashill formation is located on the other side of the fault. Moreover, the strike direction of foliation in the both formation shows same directional pattern with the NW faults. The magnetic anomaly distribution reveals that higher anomaly values are concentrated to near the ground surface. The analyses of 3 dimensional distribution between subsurface geology and magnetic anomaly indicates that higher anomaly is mainly distributed over the Munguntessj formation as a elongated lens bodies whereas the magnetic anomaly is evenly found in the both of Munguntessj formation and Yashill formation in the study area 2. It infers that volcanic activities associated mineralization occurred during silurian period, and the mineralized zone is thought to be realigned along the geological structures caused by later stage tectonic activities.

• Korean Journal of Soil Science and Fertilizer
• /
• v.41 no.6
• /
• pp.379-386
• /
• 2008

Calcined clay granules (pellet) have been used as a soil conditioner. The space among the pellets can secure drainage of water in soil and, simultaneously, can keep water for plants in the inner pore of that. However, the usage of the pellet has been restrained because fabrication of that requires a high energy and cost for heating over the temperate of $1000^{\circ}C$. Recently, SCS(Self-propagating Combustion and Sintering) method was developed and this method use the combustion energy of the preliminary mixed combustible. The SCS method is suitable to fabrication of small porous aggregate and requires a very low cost. This research applied the SCS method to coal refuses for fabrication of soil conditioner pellets. The coal refuses were pulverized under the size of $100{\mu}m$ and the pulverized powders were pelletized to the size of 4~6mm. The pellets were heated at the temperature of $1200^{\circ}C$ in the SCS furnace that was specially prepared for this research. Characteristics of the pellets were investigated and were compared with that of ordinary calcined clay pellet of kaolin; porosity, pore size distribution, bulk density, pH and etc.. Characteristics of the moisture retention in the pellets were measured by the centrifugal method: ASTM D425-88. The pellets of the coal refuses showed the higher values of the field capacity and the plant-available water than that of kaolin pellet. These results suggest the very low cost process that can utilize the coal refuses and can fabricate the lightweight porous soil conditioner of the very high plant-available water.

• Proceedings of the Computational Structural Engineering Institute Conference
• /
• 2008.04a
• /
• pp.160-165
• /
• 2008

Kriging interpolation technique has been proposed by Danny Krige of South Africa to find the mineral distribution grade from information of geography and space. It is one of the generally used prediction technique for the mineral distribution grade and underground water level in wide scope also used in computer graphics fields by the ability for the surface regeneration This paper comprises two specific objectives. The first is to examine the applicability of Ordinary Kriging interpolation(OK) to finite element method that is based on variogram modeling in conjunction with different allowable limits of separation distance. The second is to investigate the accuracy according to theoretical variogram such as polynomial, Gauss, and spherical models.

• Advanced Composite Materials
• /
• v.18 no.2
• /
• pp.167-185
• /
• 2009

Environmental problems caused by extensive use of polymeric materials arise mainly due to lack of landfill space and depletion of finite natural resources of fossil raw materials like petroleum or natural gas. The substitution of synthetic petroleum-based resins with natural biodegradable resins appears to be one appropriate measure to remedy the above-mentioned situation. This study presents the development of a composite that uses environmentally degradable starch-based resin as matrix and natural mineral basalt fibres as reinforcement, and investigates the fibre's and the composite's mechanical properties. The tensile strength of single basalt fibres was verified by means of single fibre tensile tests and statistically investigated by means of a Weibull analysis. Prepreg sheets were manufactured by means of a modified doctor blade system and hot power press. The sheets were used to manufacture specimens with fibre volume contents ranging from 33% to 61%. Specimens were tested for tensile strength, flexural strength and interlaminar shear strength. Composites manufactured during this study exhibited tensile and flexural strength of up to 517 MPa and 157 MPa, respectively.

• The Journal of the Petrological Society of Korea
• /
• v.19 no.4
• /
• pp.245-254
• /
• 2010

Technology of surface investigation using X-ray is one of widely used technology nowadays. This technique has been numerously used for planetary surface investigations for both orbital and rover scientific instruments. Korea has a plan to send an orbiter and lander to the Moon by the early 2020s. Therefore, the time has come for Korean researchers to develop major scientific instruments and start to do research on basic research for the Moon. Because of this situation, we firstly investigate X-ray technology, which is essential as one of core techniques of planetary remote sensing from the orbit and ground. This paper presents the current status of planetary exploration using X-ray techniques and new development of worldwide X-ray technology which could be adapted for prospective planetary missions.