• Journal of Electrical Engineering and Technology
• /
• v.9 no.5
• /
• pp.1454-1470
• /
• 2014

This paper propose a new power conditioner topology with intelligent power management controller that integrates multiple renewable energy sources such as solar energy, wind energy and fuel cell energy with battery backup to make best use of their operating characteristics and obtain better reliability than that could be obtained by single renewable energy based power supply. The proposed embedded controller is programmed for maintaining a constant voltage at PCC, maximum power point tracking for solar PV panel and WTG and power flow control by regulating the reference currents of the controller on instantaneous basis based on the power delivered by the sources and load demand. Instantaneous variation in reference currents of the controller enhances the controller response as it accommodates the effect of continuously varying solar insolation and wind speed in the power management. The power conditioner uses a battery bank with embedded controller based online SOC estimation and battery charging system to suitably sink or source the input power based on the load demand. The simulation results of the proposed power management system for a standalone solar/WTG/fuel cell fed hybrid power supply with real time solar radiation and wind velocity data collected from solar centre, KEC for a sporadically varying load demand is presented in this paper and the results are encouraging in reliability and stability perspective.

• Ocean Systems Engineering
• /
• v.8 no.3
• /
• pp.313-327
• /
• 2018

Meeting the touchdown point (TDP) target box is one of the challenges during catenary riser installation, especially for deep water or ultra-deep water riser systems. TDP location mismatch compared to the design can result in variation of riser configuration, additional hang-off misalignment, and extra bending loads going into the hang-off porch. A good understanding of the key installation parameters can help to minimize this mismatch, and ensure that the riser global response meets the design criteria. This paper focuses on investigating the potential factors that may affect the touchdown point location, and addressing the challenges both in the design stage and during installation campaign. Conventionally, the vessel offset and current are the most critical factors which may affect the TDP movement during installation. With the offshore exploration going deeper and deeper in the sea (up to 10,000ft), other sources such as the seabed slope and seabed soil stiffness are playing an important role as well. The impacts of potential sources are quantified through case studies for steel catenary riser (SCR) and lazy wave steel catenary riser (LWSCR) in deep water application. Investigations through both theoretical study and numerical validation are carried out. Furthermore, design recommendations are provided during execution phase for the TDP mismatch condition to ensure the integrity of the riser system.

• Journal of Environmental Health Sciences
• /
• v.26 no.2
• /
• pp.108-115
• /
• 2000

The mass fraction of PM10 had a bimodal distribution in the middle of between 2.1 ${\mu}{\textrm}{m}$, and the average mass fraction of particles less than 2.1~3.1 ${\mu}{\textrm}{m}$ was 54.1% for Pb and 890.8 ng/㎥ for Fe, respectively. For the concentration of PM10 and metallic elements by seasonal variation, PM10 showed bimodal distribution, while metallic elements showed different distributions by their sources. The ratios of fine particles to total mass were 0.45 for PM10, 0.41 for Cr, and 0.20 for Fe, 0.57 for Zn, 0.68 for Cd and 0.63 for Pb, respectively. That facts indicated that PM10, Zn, Cd, Cr and Pb were from anthropogenic sources, and Fe was from natural source. The geometric means and geometric standard deviations by seasonal variations were 3.6 ${\mu}{\textrm}{m}$ , 2.31 ${\mu}{\textrm}{m}$ in winter, 3.0 ${\mu}{\textrm}{m}$ , 2.49 ${\mu}{\textrm}{m}$ in spring, 2.7 ${\mu}{\textrm}{m}$ , 2.03 ${\mu}{\textrm}{m}$ in summer respectively. And, total efficiency of cascade impactor by seasonal variations were 49.6% in winter, 45.9% in spring and 44.5% in summer.

• Journal of Environmental Science International
• /
• v.9 no.6
• /
• pp.443-447
• /
• 2000

Chonan and Asan city have been a focal point due to rapid development as the first station for Express Railroad and key cities West Coast Development Region. Gokgyo stream adjacent to the cities plays an important role as a drainage channel for an agriculture and a discharger of urban storm water. Waster quality of the stream has been deteriorating caused by pollution sources such as a untreated wastewater discharge and runoff from the watershed. In the study, we conducted 4 surveys in April, May, July, and September to understand the current state of water quality for the stream and to make it possibe to predict future water-quality variation for future development. The system runs on a personal computer under the windows enviroment and provides extensive graphic user interface(GUI) for user-friendly assessment. Using the pull-down menus provided by the GUI panel, the user is able to operate the system by pointing and clicking the icon to identify the state of water-quality at locations concerned. Furthermore, we developed an integrated watershed management system. The constructed system could be a useful tool as a decesion maker for pollution source control strategy.

• Proceedings of the KSME Conference
• /
• 2003.11a
• /
• pp.810-815
• /
• 2003

Flow-induced noise propagated from flow over a sphere is numerically investigated for laminar flow at Re = 300 and 425, and for turbulent flow at Re = 3700 and $10^4$, where the Reynolds number is based on the freestream velocity and the sphere diameter. The numerical method used for obtaining the flow over a sphere is based on an immersed boundary method in a cylindrical coordinate system. The Curle’s solutions of the Lighthill’s acoustic analogy with and without the far-field and compact-source approximation are used in order to investigate the noise field from flow over a sphere. Since the drag and lift forces change irregularly in time at Re = 425, 3700 and $10^{4}$, the noise propagates in a complicated manner. At Re = 300, 425 and $10^{4}$, the noise from dipole sources is much larger than that from quadrupole sources. On the other hand, at Re = 3700, the quadrupole source becomes dominant. The temporal variation of the flow-induced noise around a sphere is obtained at some observation points, which shows that the peak frequency corresponds to the Strouhal number associated with the wake instability.

• Journal of KIISE
• /
• v.43 no.4
• /
• pp.399-403
• /
• 2016

Deferred Shading is a shading technique that postprocesses pixels in the screen space, following geometry-only rendering passes with depth buffering. Unlike typical shadow mapping techniques, this technique allows us to render shadows from multiple light sources without changing the structure of the rendering pipelines. This paper presents a deferred shadow mapping technique and its extension to soft shadows using mipmapping. Our technique first generates visibility maps from light sources, and blurs the visibility maps for deferred shading. This strategy leads to efficient soft-edged shadows, but does not incorporate depth variation, producing light bleeding to some extent. In order to suppress the light-bleeding artifacts, we also propose a depth-adaptive mipmap sampling technique in the screen space.

• Korean Journal of Microbiology
• /
• v.12 no.4
• /
• pp.159-179
• /
• 1974

In order to investigate morphological and cultural characteristics of strains in species, Flammulina velutipes, the author collected isolates of Flammultina velutipes at 49 locations in Korea and cultivated these isolates on the various kinds of solid media. After investigating the cultural characteristics, appeared on the various media, he obtained the following results : 1. The variation of colors in the fruit bodies is connected with the variation of climatic environments(composite effects between mean temperature in January and number of rain days of 1mm and over precipitation). The author, therfore, can find out the trend that brown type is distributed in the midland climatic region and yellow type in the southern climatic regoin. 2. Two types can be classified into several strains respectively : the strain of abundant or insufficient productivity, and strain of selectivity or non-selectivity of media. 3. According to the results of mutual comparison of soluble mycelial proteins by disc electrophoresis using polyacrylamide gels, each type has special common protein fractions(brown type : band located at 26..5mm position from surface of gel, yellow type : band located at 24.5mm position from surface of gel), and each strain has special protein fractions too. Therefore this phenomenon seems to support the results obtained by the above-stated morphological and cultural studies. 4. In the adaptability of strains to the temperature, every strain has the nature of growing in lower temperature(the optimum temperature of 20.deg.C to 25.deg.C) except that YI-1 strain has the optimum temperatue of $25^{\circ}C$-26^{\circ}C. And mycelial growth of every strain is discontinued at $35^{\circ}C.$ 5. In the adaptability of strains to the H-ion concentration, every strain has wide adaptable range of H-ion concentration, and has optimum range of pH 5.5 to 6.6 in mycelial growth excepting YA01, BI-2 and YI-1. 6. In the utility of carbon sources, the mycelial growth of every strain is very poor on the media containing xylose(average diameter of mycelial growth : 18mm), and most strains utilize favorably sucrose(39mm), maltose(37mm) and dextrose(35mm) in mycelial growth. In the utility of nitrogen sources, every strain utilizes favorably organic nitrogens(36 mm)more than inorganic nitrogens (25 mm), and utilizes fully peptone nad asparagine in organic nitrogens. Especially BA-1, BIK-2 and YA-1 strains grow vigorously on each media containing various carbon and nitrogen sources. 7. The characteristic tests of the number of days required for mycelial growth, the number of days requried for sprout of young bodies, the length of stipe and the number of fruit bodies formation seem to be useful methods in the early selection of the strain of the abundant productivity.

• The Korean Journal of Mycology
• /
• v.23 no.4 s.75
• /
• pp.325-331
• /
• 1995

The effect of cultural conditions on mycelial growth, polysaccharide production in Phellinus linteus and its monosaccharide composition was studied. P. linteus showed the highest growth (0.9 g/100 ml) on glucose but the polysaccharide production was the highest (13.7%) on mannose. The fungus grew very well at neutral pH (0.9 g/100 ml) but the growth was reduced to 0.47 g per 100 ml at alkaline pH. For the different pH, the yield of polysaccharide was in the range of $5{\sim}8%$. The highest yield of 7.94% was obtained at pH 5. Also a variation in monosaccharide composition was observed for different carbon sources and pH. The composition ranges of glucose, mannose, and galactose of polysaccharide were $80{\sim}95%,\;3{\sim}12%,\;and\;2{\sim}10%$ depending on carbon sources, respectively. In contrast, the variation of composition range of three monosaccharides was narrower for different pH than that for carbon sources. These results suggested the possibility of the improvement of production and the physiological modification of the polysaccharide.

• Journal of Environmental Science International
• /
• v.25 no.8
• /
• pp.1065-1076
• /
• 2016

This study analyzes the $PM_{10}$ characteristics (particulate matter with aerodynamic diameter less than $10{\mu}m$), concentration, and emissions in eight large South Korean cities (Seoul, Incheon, Daejeon, Daegu, Gwangju, Ulsan, Busan, Jeju). The annual median of $PM_{10}$ concentration showed a decline of $0.02{\sim}1.97{\mu}g/m^3$ in the regions, except for Incheon, which recorded an annual $0.02{\mu}g/m^3$ increase. The monthly distribution levels were high in spring, winter, fall, and the summer, but were lower in summer for all regions except for Ulsan. These differences are thought to be due to the dust in spring and the cleaning effect of precipitation in summer. The variation in concentrations during the day (diurnal variation) showed that $PM_{10}$ levels were very high during the rush hour and that this was most extreme in the cities (10.00 and 18.00-21.00). The total annual $PM_{10}$ emissions analysis suggested that there had been a general decrease, except for Jeju. On-road mobile (OM) sources, which contributed a large proportion of the particulates in most regions, decreased, but fugitive dust (FD) sources increased in the remaining regions, except for Daegu. The correlation analysis between $PM_{10}$ concentrations and emissions showed that FD could be used as a valid, positive predictor of $PM_{10}$ emissions in Seoul (74.5% (p<0.05)), Dajeon (47.2% (p<0.05)), and Busan (59.1% (p<0.01)). Furthermore, industrial combustion (IC) was also a significant predictor in Incheon (61.7% (p<0.01)), and on-road mobile (OC) sources were a valid predictor in Daegu (24.8% (p<0.05)).

• Asian Journal of Atmospheric Environment
• /
• v.12 no.1
• /
• pp.59-66
• /
• 2018

This study aims to evaluate the performance of the Air Quality Model (AQM) for the seasonal and spatial distribution of the $NH_3$ concentration in the atmosphere. To obtain observational data for the model validation, observations based on biweekly sampling have been conducted using passive samplers since April 2015 at multiple monitoring sites in the Tokyo metropolitan area. AQM, built based on WRF/CMAQ, was applied to predict the $NH_3$ concentration observed from April 2015 to March 2016. The simulation domain includes the Kanto region, which is the most densely populated area in Japan. Because the area also contains large amount of livestock, especially in its northern part, the density of the $NH_3$ emissions derived from human activities and agriculture there are estimated to be the highest in Japan. In the model validation, the model overestimated the observed $NH_3$ concentration in the summer season and underestimated it in the winter season. In particular, the overestimation in the summer was remarkable at a rural site (Komae) in Tokyo. It was found that the overestimation at Komae was caused by the transportation of $NH_3$ emitted in the northern part of the Kanto region during the night. It is suggested that the emission input used in this study overestimated the $NH_3$ emission from human sources around the Tokyo suburbs and agricultural sources in the northern part of the Kanto region in the summer season. In addition, the current emission inventories might overestimate the difference of the agricultural $NH_3$ emissions among seasons. Because the overestimation of $NH_3$ in the summer causes an overestimation of $NO_3{^-}$ in $PM_{2.5}$ in the AQM simulation, further investigation is necessary for the seasonal variation in the $NH_3$ emissions.