• Particle and aerosol research
• /
• v.6 no.2
• /
• pp.91-103
• /
• 2010

Size-segregated number concentration and scattering coefficient of urban aerosols were measured using an SMPS (scanning mobility particle sizer) and a nephelometer, respectively in Seoul, Korea, during the winter season of 2003. The average number concentrations of ultrafine particles (20~100 nm) and accumulation mode particles (100~600 nm) were $2,170\;particles\;cm^{-3}$ and $1,521\;particles\;cm^{-3}$, respectively. The scattering coefficient at the wavelength of 550 nm ranged from $62.6Mm^{-1}$ to $330.1Mm^{-1}$ and average value was $163.4Mm^{-1}$. The peak concentrations of ultrafine particles and accumulation mode particles were simultaneously recorded between 6:00 and 9:00 A.M., indicating the effect of vehicle emissions which are major air pollution sources in the urban atmosphere. On average, the number concentration of ultrafine particles was 1.4 times higher than that of accumulation mode particles, although it was a little higher during the morning peak time. The variation of aerosol scattering coefficient was in good agreement with that of accumulation mode particle number concentration rather than that of ultrafine particle number concentration.g coefficient was in good agreement with that of accumulation mode particle number concentration rather than that of ultrafine particle number concentration.

• Journal of Advanced Navigation Technology
• /
• v.20 no.2
• /
• pp.134-140
• /
• 2016

This paper analyzed flight trajectory characteristics of ballistic missiles considering effects of drag forces. It is difficult to intercept ballistic missiles which fly over atmosphere with supersonic speeds and small radar cross section (RCS). In particular, the velocities in the phases of boost and terminal are changed significantly due to the steep variation of the drag force. Therefore, in order to build up a successful ballistic missile defense systems, the effects of the drag forces should be considered in the analysis of ballistic missile trajectory characteristics. In this point of view, this work analyzed the effects of drag forces and derived the flight trajectory characteristics of Scud B, C and Nodong missiles. Model of the ballistic missile flight trajectory is considered the effects of Coriolis and centrifugal forces, and specifications of the missiles are open sources.

• Clean Technology
• /
• v.26 no.1
• /
• pp.79-87
• /
• 2020

The bio-oil produced from the fast pyrolysis of lignocellulosic biomass contains a high amount of oxygenates, causing variation in the properties of bio-oil, such as instability, high acidity, and low heating value, reducing the quality of the bio-oil. Consequently, an upgrading process should be recommended ensuring that these bio-oils are widely used as fuel sources. Catalytic fast pyrolysis has attracted a great deal of attention as a promising method for producing upgraded bio-oil from biomass feedstock. In this study, the fast pyrolysis of tulip tree was performed in a bubbling fluidized-bed reactor under different reaction temperatures, with and without catalysts, to investigate the effects of pyrolysis temperature and catalysts on product yield and bio-oil quality. The system used silica sand, ferric oxides (Fe₂O₃ and Fe₃O₄), and H-ZSM-5 as the fluidized-bed material and nitrogen as the fluidizing medium. The liquid yield reached the highest value of 49.96 wt% at 450 ℃, using Fe₂O₃ catalyst, compared to 48.45 wt% for H-ZSM-5, 47.57 wt% for Fe₃O₄ and 49.03 wt% with sand. Catalysts rejected oxygen mostly as water and produced a lower amount of CO and CO₂, but a higher amount of H₂ and hydrocarbon gases. The catalytic fast pyrolysis showed a high ratio of H₂/CO than sand as a bed material.

• Journal of Environmental Science International
• /
• v.25 no.6
• /
• pp.865-875
• /
• 2016

In this study, mass concentrations and chemical compositions of $PM_{2.5}$, including water-soluble ions and elements were determined at the 1,100 m-highland of Mt. Hallasan in Jeju Island across four seasons from August 2013 to August 2014. The average mass concentration of $PM_{2.5}$ was $12.5{\pm}8.41{\mu}g/m^3$ with 45.8% of the contribution from eight water-soluble ionic species. Three ionic species ($SO{_4}^{2-}$, $NH{_4}^+$, and $NO{_3}^-$) comprised 96.2% of the total concentration of ions contained in $PM_{2.5}$ and were the dominant ions, accounting for 43.5% of the $PM_{2.5}$ mass at Mt. Hallasan. On the basis of the mass concentration level, seasonal variation, enrichment factor, and relationship among elements, we can presume that Mg, K, Ca, Mn, Fe, Co, Sr, Ba, Nd, and Dy originated mainly from crust or soil and that V, Cr, Ni, Cu, Zn, As, Cd, and Pb were significantly enriched in $PM_{2.5}$ owing to the effects of the anthropogenic emissions. These results and the local distribution of emission sources and topographic characteristics near this sampling site suggest that the compositions of $PM_{2.5}$ collected at the 1100 m-highland of Mt. Hallasan were largely influenced by inflow from outside of Jeju Island.

• The Bulletin of The Korean Astronomical Society
• /
• v.37 no.1
• /
• pp.31.2-31.2
• /
• 2012

We present the Yonsei Evolutionary Population Synthesis (YEPS) models for spectroscopic and photometric evolutions of simple and composite stellar populations. The models are based on the most up-to-date Yonsei-Yale stellar evolutionary tracks and BaSel 3.1 flux libraries, and provide integrated spectroscopic quantities of Lick/IDS system including high-order Balmer absorption-lines. Special care has been taken to incorporate the systematic variation of horizontal branch (HB) morphology as functions of metallicity, age, alpha-element mixture, and helium abundance of simple stellar populations. Our models for normal-helium stellar populations indicate that the realistic modeling of HB and alpha-element brings about 5 Gyr and 0.1 dex differences in age and metallicity estimations, respectively, compared to those without these effects. The HB effect does not depend on the specific choice of stellar libraries and alpha-element enhancements, and this effect is non-negligible even in the metal sensitive absorption indices, such as Mg2 and Mg b. Comparison of the models to observations reveals that the HB and alpha-element effects are critical in understanding otherwise inexplicable phenomena found in globular cluster systems in the Milky Way and nearby galaxies, including the observed bimodality of the line strengths of globular clusters in massive galaxies. In addition, we found that helium-enhanced stellar populations, which are the major sources of extreme HB stars, bring about increased FUV, NUV fluxes, and thus the model colors of those filters become extremely blue. Age dating based on the YEPS model with normal-helium stellar populations reveals that the evidence for 'downsizing' of elliptical galaxies is found not only in the local field but also in Coma cluster, and that the mean age of elliptical galaxies in Coma cluster is about 1.4 Gyr younger than the mean age of those in the local field. We also find that our models with helium-enhanced subpopulations can naturally reproduce the strong UV-upturns observed in giant elliptical galaxies assuming an age similar to that of old GCs in the Milky Way.

• Journal of the Korean Geotechnical Society
• /
• v.33 no.2
• /
• pp.35-47
• /
• 2017

Thermal behavior of soils is mainly focused on thermal conduction, and the study of natural convection is very limited. Increase of soil temperature causes natural convection due to buoyancy from density change of pore water. The limitations of the analysis using fluid dynamics for natural convection in the porous media is discussed and a new numerical analysis is presented for natural convection in porous media using THM governing equations fully coupled in the macroscopic view. Numerical experiments for thermal probe show increase in the uncertainty of thermal conductivity estimated without considering natural convection, and suggest appropriate experimental procedures to minimize errors between analytical model and numerical results. Burial of submarine power cable should not exceed the temperature changes of $2^{\circ}C$ at the depth of 0.2 m under the seabed, but numerical analysis for high permeable ground exceeds this criterion. Temperature and THM properties of the seafloor are important design factors for the burial of power cable, and in this case effects of natural convection should be considered. Especially, in the presence of heat sources in soils with high permeability, natural convection due to the variation of density of pore water should be considered as an important heat transfer mechanism.

• Journal of Korean Society of Rural Planning
• /
• v.24 no.4
• /
• pp.99-119
• /
• 2018

Unit load factor, which is used for the quantification of non-point pollution in watersheds, has the limitation that it does not reflect spatial characteristics of soil, topography and temporal change due to the interannual or seasonal variability of precipitation. Therefore, we developed the method to estimate a watershed-scale non-point pollutant load using seasonal forecast data that forecast changes of precipitation up to 6 months from present time for watershed-scale water quality management. To establish a preemptive countermeasure against non-point pollution sources, it is possible to consider the unstructured management plan which is possible over several months timescale. Notably, it is possible to apply various management methods such as control of sowing and irrigation timing, control of irrigation through water management, and control of fertilizer through fertilization management. In this study, APEX-Paddy model, which can consider the farming method in field scale, was applied to evaluate the applicability of seasonal forecast data. It was confirmed that the rainfall amount during the growing season is an essential factor in the non-point pollution pollutant load. The APEX-Paddy model for quantifying non-point pollution according to various farming methods in paddy fields simulated similarly the annual variation tendency of TN and TP pollutant loads in rice paddies but showed a tendency to underestimate load quantitatively.

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.18 no.3
• /
• pp.33-40
• /
• 2019

FDM 3D printers have become widespread, and investment in the 3D printer industry is increasing. Therefore, many 3D printers are released and the functions of products are emphasized. However, to lower unit prices, open-type 3D printers are sold in kit form, and their performance is very low. If the 3D printer has many heat sources and is sealed, there is the possibility that the main accessories (the main board, power supply, and motor) will be damaged by trapped heat. At the same time, if the ambient temperature is low due to the properties of the material, the output quality deteriorates. In this study, we analyzed the temperature rise of the main accessories and the quality of the output by the heat bed when a chamber was added to an open-type 3D printer. We also compared the quality of the output due to the air flow with the temperature rise of the main accessories. Moreover, we found the optimal value. As a result of the quality analysis, it was finally confirmed that the case with the chamber at $95^{\circ}C$ was the best for the printing condition. In addition, in the absence of the chamber, the bending of the specimen was found to be large, and in the case of the chamber, the degree of bending was slightly decreased by 0.05 mm.

• Asian-Australasian Journal of Animal Sciences
• /
• v.20 no.1
• /
• pp.19-24
• /
• 2007

Covariance components and genetic parameters of weekly live body weight from hatching to six weeks of age and age of sexual maturation were estimated in a laying type Japanese quail line. The univariate and bivariate animal model analysis included hatching group and sex as fixed effects. Each trait was analysed with animal as random effect to fit the additive direct effect. Additional random effects incorporated in the models were changed according to the trait examined. The best model for a trait was chosen based on a likelihood ratio test, comparing the models with and without maternal additive genetic and maternal permanent environmental effects. Heritability estimates of live-weight at hatch and one to six weeks of age with their standard errors were 0.22${\pm}$0.088, 0.39${\pm}$0.099, 0.31${\pm}$0.086, 0.38${\pm}$0.056, 0.46${\pm}$0.055, 0.50${\pm}$0.059, and 0.56${\pm}$0.062, respectively. Direct heritability value of age of sexual maturation was moderate (0.24${\pm}$0.055). The variances due to permanent environmental effect of dam after one week of age and maternal genetic effect after two weeks of age were not important sources of variation. The correlations between direct and maternal genetic effects were negative and ranged from high to moderate values (-0.21 to -0.83). Among the weekly live weights, genetic correlations were generally high between not only successive but also early and late weightings. It suggests that selection for final weight may be based on early weight records. Genetic correlations between age of sexual maturation and live weights were low, favourable but had high standard errors. These results indicate that selection for high weight will potentially result in lower age of sexual maturation only with accurate determination of breeding values.

• Journal of Environmental Health Sciences
• /
• v.30 no.5 s.81
• /
• pp.455-468
• /
• 2004

The purpose of this paper is to understand the time series and origin of a chemical component and to compare the difference during yellow sand episodes for analysis $PM_{10}$ chemical components in the region of west in Korean Peninsula, 1999-2001. An annual mean concentration of $PM_{10}$ is $29.1\;{\mu}g/m^3$. A monthly mean and standard deviation of $PM_{10}$ concentration are very high in spring but there is no remarkably seasonal variation. Also, water soluble ionic component of $PM_{10}$ be influenced by double more total anion than total cation, be included $NO_{3}^-\;and\;SO_{4}^{2-}$ for the source of acidity and $NH_{4}^+$ to neutralize. Tracer metals of $PM_{10}$ slowly increases caused by emitted for soil and ocean (Fe, Al, Ca, Mg, Na) and Zn, Pb, Cu, Mn for anthropogenic source. According to method of enrichment factor (E.F) and statistics, assuming that the origin of metal component in $PM_{10}$ most of element in the Earth's crust e.g. Mg, Ca, Fe originates soil and Cu, Zn, Cd, Pb derives from anthropogenic sources. The ionic component for $Na^{+}\;Cl^-,\;Mg^{2+}\;and\;Ca^{2+}$ and Mg, Al, Ca, Fe originated by soil component largely increase during yellow sand period and then tracer metal component as Pb, Cd, Zn decrease. According to factor analysis, the first group is ionic component ($Na^+,\;Mg^{2+},\;Ca^{2+}$) and metal component (Na, Fe, Mn and Ni) be influenced by soil. The second group, Mg, Cr also be influenced by soil particle.