• Journal of Korea Water Resources Association
• /
• v.41 no.2
• /
• pp.212-228
• /
• 2008

Five representative reference evapotranspiration(RET) equations were selected, and these equations were compared with pan evaporation by correlation analysis. Pan coefficients were also estimated. Furthermore, five selected RET equations were compared to find the similarity among those at the 21 meteorological stations located in South Korea. Five RET equations selected from 4 different category were Penman(combination approach), FAO Penman-Monteith(FAO P-M) (single source approach), Makkink and Priestley-Taylor (radiation approach) and Hargreaves(temperature approach) equations. In this study, the geographical and topographical conditions were considered for the selection of study stations. The daily meteorological data measured from 1970 at an interval of 5 years were applied in this study. The evapotranspiration estimates obtained by applying evapotranspiration equations were evaluated with numerical and graphical methods. The correlation coefficients between pan evaporation and RET in study stations were above 0.9 indicating very high correlation; however, the slopes of the individual regression lines show the values greater or less than 1.0. Hargreaves equation(temperature approach) shows the most similar evapotranspiration estimates to those of FAO P-M equation from 12 study stations, which are located near to seashore except Daegu station. On the other hand, Priestley-Taylor equation(radiation approach) shows the most similar evapotranspiration estimates to those of FAO P-M equation from 8 study stations, which are located in inland.

• Journal of Environmental Impact Assessment
• /
• v.23 no.5
• /
• pp.393-405
• /
• 2014

In this study, the nonpoint sources were evaluated by calculating the Nadonggang basin regional water quality and nonpoint source pollution load discharged. And were selected the banks of first administration based on the results and the direction of the next administration. As a results of estimating the water quality about BOD concentration in the mid influence area in the Nakdonggang basin, it was founded that 10 sites for 'Ia' water quality level, 6 sites for 'lb' water quality level, 5 sites for 'II' water quality level, 1 sites for 'I' water quality level. The estimation of COD concentration in the mid influence area, It showed that 9 sites for 'Ib' water quality level, 6 sites for 'II' water quality level, 6 sites for 'III' water quality level, 1 site for 'IV' water quality level. The assessment of water quality made Mid influence area of Gumhogang, Nakdong Goryung, Nakdong Milyang and Namgang selected as the mid influence area of high pollution. And delivery loads of nonpoint sources were calculated for mid influence area in Nakdonggang basin(max delivery load : 17,706.7 kg/day for Gumhogang influence area). As the result of calculating NPS(nonpoint sources) delivery load and water quality at influence area in Nakdonggang basin, Gumhogang influence area was selected as an area for management priority among nonpoint sources.

• Journal of KIISE:Computing Practices and Letters
• /
• v.10 no.2
• /
• pp.174-188
• /
• 2004

In the life environment changed with not only the quality and the price of the products but also the material abundance, it is the most crucial factor for the strategy of product sales to investigate consumer's sensibility and preference degree. In this perspective, it is necessary to design and merchandise the products in cope with each consumer's sensibility and needs as well as its functional aspects. In this paper, we propose the Fashion Design Recommender Agent System (FDRAS-pro) for textile design applying collaborative filtering personalization technique as one of the methods of material development centered on consumer's sensibility and preference. For a collaborative filtering system based on textile, Representative-Attribute Neighborhood is adopted to determine the number or neighbors that will be used for preferences estimation. Pearson's Correlation Coefficient is used to calculate similarity weights among users. We build a database founded on the sensibility adjectives to develop textile designs by extracting the representative sensibility adjectives from users' sensibility and preferences about textile designs. FDRAS-pro recommends textile designs to a customer who has a similar propensity about textile. To investigate the sensibility and emotion according to the effect of design factors, fertile designs were analyzed in terms of 9 design factors, such as, motif source, motif-background ratio, motif variation, motif interpretation, motif arrangement, motif articulation, hue contrast, value contrast, chroma contrast. Finally, we plan to conduct empirical applications to verify the adequacy and the validity of our system.

• Journal of KIISE:Computer Systems and Theory
• /
• v.33 no.8
• /
• pp.536-546
• /
• 2006

Painterly animation is a method that expresses painterly images with a hand-painted appearance from a video, and the most crucial element for it is the temporal coherence of brush strokes between frames. A motion map is proposed in this paper as a solution to the issue of maintaining the temporal coherence in the brush strokes between the frames. A motion map is the region that frame-to-frame motions have occurred. Namely, this map refers to the region frame-to-frame edges move by the motion information with the motion occurred edges as a starting point. In this paper, we employ the optical flow method and block-based method to estimate the motion information. The method that yielded the biggest PSNR using the motion information (the directions and magnitudes) acquired by various methods of motion estimation has been chosen as the final motion information to form a motion map. The created motion map determine the part of the frame that should be re-painted. In order to express painterly images with a hand- painted appearance and maintain the temporal coherence of brush strokes, the motion information was applied to only the strong edges that determine the directions of the brush strokes. Also, this paper seek to reduce the flickering phenomenon between the frames by using the multiple exposure method and the difference map created by the difference between images of the source and the canvas. Maintenance of the coherence in the direction of the brush strokes was also attempted by a local gradient interpolation to maintain the structural coherence.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.24 no.2
• /
• pp.246-252
• /
• 2018

In this paper, the friction drag force of 3D submerged body is investigated by considering the surface roughness, the first grid height, and the Reynolds number using open CFD source code, OpenFOAM 4.0. A procedure for estimating drag components by CFD code is set up and suggested in this study. In the 3D submerged body, because of the form factor in the 3D computations, the friction resistance with the small roughness of $12{\mu}m$ obtains different result with the smooth wall. As the Reynolds number increased, the boundary layer becomes thinner and the fiction resistance tends to decrease. In the computations for the effect of y+, the friction resistance and wall shear stress are excessively predicted when the y+ value deviates from the log layer. This is presumably because the boundary layer becomes thicker and the turbulence energy is excessively predicted in the nose due to the increase in y+ value. As the roughness increases, the boundary layer becomes thicker and the turbulence kinetic energy on the surface increases. From this study, the drag estimation method, considering the roughness by numerical analysis for ships or offshore structures, can be provided by using the suggested the y+ value and surface roughness with wall function.

• The Journal of the Acoustical Society of Korea
• /
• v.31 no.6
• /
• pp.373-383
• /
• 2012

The performance of underwater acoustic communication system is sensitive to the Doppler shift and ISI(Inter-Symbol Interference). Therefore, the simulation algorithm needs to consider time-spread due to multipath arrivals which cause the ISI, and time-varying Doppler shift along with moving source and receiver. For this purpose, VirTEX(Virtual Time series EXperiment) based on Ray model has been developed. In this paper, VirTEX is used to compare the characteristics of ocean waveguide from the experimental data and illustrate the performance. The CIR(Channel Impulse Response) that characterizes the multipath arrivals with representative time-spread due to multipath arrivals is compared between numerically simulated and experimental probe signal. Also, the communication performance analysis for BER(Bit Error Rate) is compared between numerically simulated and experimental data signal. As a result, VirTEX can be useful as a simulation tool for evaluating the performance of underwater acoustic communication system.

• Proceedings of the Population Association of Korea Conference
• /
• 2006.12a
• /
• pp.113-128
• /
• 2006

The main theme of this paper was to investigate the role of education as a source of economic growth in Korea. In this study, first, the objective mode was built by extending neoclassical Solow growth theory. Second, the capital deepening typical of an endogenous economic per-capita growth model was developed empirically for seven East-Asian economies as for the medium term, during $1975{\sim}2004$. And then we found the meaning of coefficients of growth factors, direct relative contribution of each input to per-capita growth in seven East-Asian countries, relative indirect contribution of education to per-capita growth in Korea, accounting for difference due to accumulation in Korea. The indirect relative contributions of secondary and higher education and R&D to per-capita growth change the results somewhat. Secondary education is still the largest single contributor 83.6 percent of predicted growth is due to secondary school enrollment in Korea. Primary education comes second with 37.5 percent and followed by higher education at -52.9 percent. Physical investment gives 62.3 percent and unimproved raw labor contributes only -1.4 percent.

• The Journal of Korean Medicine
• /
• v.28 no.1 s.69
• /
• pp.72-86
• /
• 2007

Objectives : The purpose of this study was to evaluate and compare the cost-effectiveness of Eastern, Western, and collaborative treatments and suggest a cost-effective approach for patients with frozen shoulder pain. Methods : Using the data of fifty-two patients, treatment effectiveness was measured by CSA, SPABI, and ROM scales and changes from the baseline score were evaluated. Data source for cost estimation was based on the national health insurance (NHI) payment system. Because the price in NHI was differentiated by health care institutions, five collaborative types were considered in assessing costs. Cost-effective ratios were computed for economic evaluation. Results : Compared with Eastern treatment, collaborative and Western treatments showed better effects on CSA scale after 4 weeks' treatment. The collaborative approach was also the most effective treatment on SPADI and ROM scales. The direct cost per patient receiving Eastern treatment was less than other treatments. In general, collaborative treatment dominated Eastern and Western treatments in cost-effectiveness an analysis. However, the cost-effectiveness ratio of Eastern treatment resulted in \9,000 compared to \29,000 of collaborative treatment on SPADI. Four different indicators of ROM scales resulted in different approaches as the cost-effective treatment. Conclusions : Considering cost-effectiveness ratios, collaborative treatment was the best treatment on CSh and SPADI scales after 4 weeks' treatment. As for ROM scales, the recommended alternatives were Eastern treatment for patients with abduction and adduction disabilities, Western treatment for those with flexion disability, and collaborative approach fir those with extension disabiliry.

• Journal of Korean Society of Environmental Engineers
• /
• v.34 no.6
• /
• pp.373-381
• /
• 2012

An automatic flow and water quality monitoring system was applied to estimate pollutant loads to an urban stream during storm events in DTV (Daeduk Techno Valley), Daejeon, Korea. The monitoring system consists of rainfall gage, ultrasonic water level meter, water quality sensors for DO, temperature, pH, conductivity, turbidity and automatic water sampler for further laboratory analysis. All data are transmitted through on-line system and the monitoring system is designed to be controlled manually in the field and remotely from laboratory computer. Flow rates were verified with field measurements during storm events and showed good agreements. Automatic sampler was used to collect real time samples and analyzed for BOD, COD, TN, TP, SS and other pollutant concentrations in the laboratory. SWMM (Storm Water Management Model) urban watershed model was applied and calibrated using the observed flow and water quality data for the study area. While flow modeling results showed good agreement for all events, water quality modeling results showed variable levels of agreement. These results indicate that current options in the SWMM model to predict pollutant build up and wash-off effects are not sufficient to satisfy modeling of all the rainfall events under study and thus need further modification. This study showed the automatic monitoring system can be used to provide data to assist further refinement of modeling accuracy. This automatic stormwater monitoring and modeling system can be used to develop basin scale water quality management strategies of urban streams in storm events.

• Journal of Korean Society of Environmental Engineers
• /
• v.32 no.2
• /
• pp.209-218
• /
• 2010

The fifty six components of volatile organic compounds(VOCs) were continuously measured by the hour to see the distributions their of its concentration and the ozone creating contribution of nitric oxides and VOCs in Gamjeon Odor and VOCs Monitoring Network from April to September, 2008. Aromatics occupied 51.3% of VOCs and paraffins, alkanes and olefins came in order. The monthly concentration of VOCs in Gamjeon was high in July and low in September. As for hourly concentration of ozone and nitric oxides, ozone started to increase since 10am having the highest in the daytime, and nitric oxides had the different trend from that of ozone, showing the lowest in the daytime. The photochemical ozone creating potentials(POCPs) of toluene, propane, m/p-xylene, ethylbenzene, and 1,2,4-trimethylbenzene were 30.6%, 10.2%, 9.4%, 7.4% and 5.2% respectively. These five components occupied 62.8% of total POCPs, which means they contributed to the ozone creation mainly. Related with the ozone creating contribution, the ratio of VOCs to NOx was generally under 6 occupied 72.0%, which came under the area coexisting the limit of VOCs. Therefore it is thought that the management of emission source of VOCs is very important for the reduction of ozone.