• Analytical Science and Technology
• /
• v.14 no.1
• /
• pp.21-27
• /
• 2001

In this work, analytical performance of a laboratory built double membrane desolvator (DMD) was studies using perfluoroalkoxy (PFA) nebulizer and microconcentirc nebulizer (MCN) in inductively coupled plasma atomic emission spectrometry. Compared with MCN, PFA nebulizer coupled to DMD showed similar analytical sensitivity for aqueous solution and better sensitivity for isopropyl alcohol. Since PFA resisted various acids, HCI, $H_2SO_4$ and HF solution were analyzed with less than 2% RSD. Rinse-out time for the signal reduction to 1% was obtained to be 35 s for PFA but about 45 s for MCN.

• Journal of the Korean Ceramic Society
• /
• v.43 no.1 s.284
• /
• pp.33-37
• /
• 2006

For producing the fine ribs structure of plasma display panel, the metal ions of barrier materials during the etching process should be understood on the etching mechanism with etching conditions. Etching was done on bulk glasses of the $BaO_B_2O_3-ZnO$ system with $HNO_3$ solution at $40^{\circ}C$. The surface structure of glasses and ion dissolution were analyzed by ICP (Inductive Coupled Plasma measurement). The structure and surface of the etched bulk glass were investigated by using scanning electron microscopy and nanoindenter. As a result, Ba (3-35 ppm/min) and Zn (2-27 ppm/min) ions as major components were leached in the solution and the leached layers were found to be phosphor-rich surface layers. A decrease of the bridge oxygen and relative increase of non bridge oxygen in the etched glass were found by X-ray photoelectron spectroscopy.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.11a
• /
• pp.115-116
• /
• 2008

The ferroelectric vinylidene fluoride-trifluoroethylene ($VF_2$-TrFE) and $Al_2O_3$ passivation layer for the Metal/Insulator/Ferroelectric/Semiconductor (MIFS) structure were deposited using spin coating and remote plasma atomic layer deposition (RPALD), respectively. A 2.5 ~ 3 wt % diluted solution of purified vinylidene fluoride-trifluoroethylene ($VF_2$: TrFE=70:30) in a DMF solution were prepared and deposited on silicon wafer at a optimized spin speed. After annealing in a vacuum ambient at 150 ~ $200^{\circ}C$ for 60 min, upper insulator layer were deposited at temperature ranging from 100 ~ $150^{\circ}C$ by RPALD. We described electrical and structural properties of MIFS fabricated by spin coating and RPALD methods.

• Archives of Pharmacal Research
• /
• v.28 no.9
• /
• pp.1092-1096
• /
• 2005

Huperzine A-loaded microspheres composed of poly(D,L-lactide-co-glycolide) were prepared by an O/w emulsion solvent evaporation method. The characterization of the microspheres such as drug loading, size, shape and release profile was described. The in vitro release in the initial 7 days was nearly linear with $10\%$ released per day. Thereafter drug release rate became slow gradually and about $90\%$ drug released at day 21. The in vitro release rate determined by dialysis bag method had a good correlation with the in vivo release rate. Huperzine A aqueous solution was intramuscularly injected (i.m.) at 0.4mg/kg and microspheres were intra­muscularly injected at 8.4 mg eq huperzine A/kg in rats. The maxium plasma concentration $(C_{max})$ after i.m. microspheres was only $32\%$ of that after i.m. solution. Drug in plasma could be detectd until day 14 and about $5\%$ of administered dose was residued at the injection site at day 14. The relative bioavailability of huperzine A microspheres over a period of 14 days was $94.7\%$. Inhibition of acyecholinesterase activity (AchE) in rat's cortex, hippocampus and striatum could sustain for about 14 days. In conclusion, huperzine A-loaded microspheres possessed a prolonged and complete drug release with significant inhibition of AchE for 2 weeks in rats.

• Applied Science and Convergence Technology
• /
• v.26 no.2
• /
• pp.21-25
• /
• 2017

The shape of the reflection spectrum is complex and appears to overlap with several signals, because the surface state is uneven due to the natural oxide film, so that the spectrum becomes a complicated signal shape divided into regions 1 and 2 due to diffuse reflection. On the other hand, it is seen that the reflection spectrum after PEO surface treatment is overlapped with several signals. In addition, the reflectance of the energy band varies from 1.32 to 1.46 eV. Usually, the MgO-type oxide film was observed at an energy band of ~4.2 eV. The thickness of the oxide film was increased as the DC voltage was increased by the thin film thickness meter (QuaNix; 7500M) after Plasma Electrolytic Oxidation (; PEO) surface treatment. This is because the higher the DC voltage, the easier the binding of the $OH^-$ ions in the solution solution and the $Mg^+$ ions of the magnesium alloy. An important part of the bonding of ordinary ions is the energy source (plasma) which can promote bonding. However, when a certain threshold voltage or more is applied, the material is adversely affected. The oxide film of the surface may be destroyed without increasing the thickness of the oxide film, that is, whitening of the material may occur.

• Biomolecules & Therapeutics
• /
• v.4 no.2
• /
• pp.154-161
• /
• 1996

General pharmacological properties of LB-00014, an erythropoietin which was produced by recombinant DNA technique in Biotech Research Institute, LG Chemical Ltd. were examined. The administration of LB-00014 (60, 600, 6000 IU/kg, iv) in mice had no effect in general behavior and central nervous system, and no influences on normal body temperature, writhing syndromes induced by 0.7% acetic acid solution and chemoshock produced by strychnine and pentetrazole solution. LB-00014 (60, 600, 6000 IU/kg, iv) given to anesthetized rabbits showed no effect on blood pressure of carotid artery and respiration rates, and it did not influence the responses produced by injection of acetylcholine or epinephme. The administration of LB-00014 (601, 600, 6000 IU/kg, iv) in rats had no effect on the plasma prothrombin time, activated partial thromboplastin time and hemolytic action. The platelet aggregation induced by collagen in human plasma was not influenced by LB-00014 (10, 100, 1000 lU/kg, iv). It showed no direct effect at 100 and 1000IU/m1 in isolated stomach fundus and uterus of rats and ileum of guinea-pig, and it also had no inhibition of contraction produced by acetylcholine, oxytocin, serotonin and histamine in the above-mentioned preparations. It did not influence gastric secretion, pH and acid output at 6000 IU/kg, iv in rats, but showed a significant increase in intestinal propulsion of mice at 6000 IU/kg, iv. Its administration (60, 600, 6000 lU/kg, iv) caused no effect on urine and electrolyte excretion in rats. These results indicate that LB-00014 does not exsert any of serious pharmacological effects.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.21 no.1
• /
• pp.43-53
• /
• 2023

Sulfide concentrations critically affect worker safety and the integrities of underground facilities, such as deep geological repositories for spent nuclear fuel. Sulfide is highly sensitive to oxygen, which can oxidize sulfide to sulfate. This can hinder precise measurement of the sulfide concentration. Hence, a literature review was conducted, which revealed that two methods are commonly used: the methylene blue and sulfide ion-selective electrode (ISE) methods. Inductively coupled plasma optical emission spectroscopy (ICP-OES) was used for comparison with the two methods. The sulfide ISE method was found to be superior as it yielded results with a higher degree of accuracy and involved fewer procedures for quantification of the sulfide concentration in solution. ICP-OES results can be distorted significantly when sulfide is present in solution owing to the formation of H₂S gas in the ICP-OES nebulizer. Therefore, the ICP-OES must be used with caution when quantifying underground water to prevent any distortion in the measured results. The results also suggest important measures to avoid problems when using ICP-OES for site selection. Furthermore, the sulfide ISE method is useful in determining sulfide concentrations in the field to predict the lifetime of disposal canisters of spent nuclear fuel in deep geological repositories and other industries.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.254-254
• /
• 2016

Tin dioxide (SnO2) thin film is one of the most important n-type semiconducting materials having a high transparency and chemical stability. Due to their favorable properties, it has been widely used as a base materials in the transparent conducting substrates, gas sensors, and other various electronic applications. Up to now, SnO2 thin film has been extensively studied by a various deposition techniques such as RF magnetron sputtering, sol-gel process, a solution process, pulsed laser deposition (PLD), chemical vapor deposition (CVD), and atomic layer deposition (ALD) [1-6]. Among them, ALD or plasma-enhanced ALD (PEALD) has recently been focused in diverse applications due to its inherent capability for nanotechnologies. SnO2 thin films can be prepared by ALD or PEALD using halide precursors or using various metal-organic (MO) precursors. In the literature, there are many reports on the ALD and PEALD processes for depositing SnO2 thin films using MO precursors [7-8]. However, only ALD-SnO2 processes has been reported for halide precursors and PEALD-SnO2 process has not been reported yet. Herein, therefore, we report the first PEALD process of SnO2 thin films using SnCl4 and oxygen plasma. In this work, the growth kinetics of PEALD-SnO2 as well as their physical and chemical properties were systemically investigated. Moreover, some promising applications of this process will be shown at the end of presentation.

• Korean Journal of Materials Research
• /
• v.24 no.11
• /
• pp.639-643
• /
• 2014

Hydrophilic $SiO_2$ layers were obtained by the atmospheric-pressure plasma treatment. Superhydrophobic $SiO_2$ layers were first deposited by the electrospray deposition method. The electrospunable solution that was prepared based on the solgel method was sprayed on Si (100) substrates. The surface of the electrosprayed $SiO_2$ layers consisted of the agglomeration of nano-sized grains, which led to a very high roughness and revealed a very high contact angle to water droplets over $162^{\circ}$. After having been exposed to the atmospheric $Ar/O_2$ plasma, the observed superhydrophobicity of the $SiO_2$ layers were greatly changed: a dramatic variation of the water contact angle from $162^{\circ}$ to $3^{\circ}$, namely realization of superhydrophillicity. Interestingly, the surface microstructure was almost preserved. According to the XPS analysis, it is more likely that thanks to the plasma exposure, the surface of $SiO_2$ layers will be cleaned in terms of organic species that are hydrophobic-inducing, consequently leading to the hydrophilic nature observed for the plasma-exposed $SiO_2$ layers.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.39 no.6
• /
• pp.466-471
• /
• 2006

We investigated the changes in body weight (BW), plasma sex steroid hormone profiles, and testicular development of cultured male eel Anguilla japonica during an artificial maturation process. Eels that received weekly intraperitoneal injections of eel's ringer solution containing human chronic gonadotropin (HCG) were examined. In the ringer-treated control, BW changes decreased slowly during the experimental period. Plasma testosterone (T), 11-ketotestosterone (11-KT) and $17{\alpha},\;20{\beta}$-dihydroxy-4-pregnen-3-one (DHP) levels In the control remained low and did not show significant changes. Moreover, all germ cells in the testes of the control were spermatogonia. In the HCG-treated male eels, however, BW changes increased gradually from the fifth week and then decreased slowly. The plasma T level increased rapidly (p<0.05) in the second week and then decreased slowly. The plasma 11-KT level increased dramatically (p<0.05) in the second week and was maintained until the end of the experiment. The plasma DHP level increased progressively from the second week and peaked in the eighth week (p<0.05). The testes of HCG-treated male eels were more developed than those of the control; most were at the spermatozoa and spermatid stages and showed active spermiation. Thus, spermatogenesis and spermiation in the cultured eel can be induced by repeated injections of HCG.