• 태양에너지
• /
• 제11권3호
• /
• pp.44-52
• /
• 1991

본 연구의 목적은 주거용 태양열 온수이용에 있어서 성층저장의 잠점을 평가하고 최적의 설계변수를 제시하되 실험이 아닌 시뮬레이션을 통한다는 것이다. 그 결과는 다음과 같으며 실험의 결과들과 잘 일치함을 보였다. 1. 탱크의 성층분활이 증가함에 따라서 태양부하율이 증가함을 보여 주었고 본 연구에서는 평균 10% 정도 증가함을 나타내었다. 2. 저장탱크의 높이 대 지름의 비가 3정도일 때가 태양부하율이 최대가 되었으며 그 이상이 되면 감소하는 경향을 나타내었다. 3. 집열기로 부터 저장탱크로 유입되는 온수의 유동율이 증가할 수록 완전혼합저장에서는 태양부하율이 증가하지만 성충저장에서는 유입율이 감소하는 것이 태양부하율을 증가시키는 결과가 되었다. 4. 이와 같은 결과로 성층축열시스템 전체적으로는 약 17%의 성능 향상을 기대할 수 있다.

• 한국태양에너지학회 논문집
• /
• 제22권4호
• /
• pp.1-9
• /
• 2002

This study is on the design and evaluation of Zero Energy Solar House(ZeSH) including active solar heating system. Various innovative technologies such as super insulation, passive solar systems, super window, ventilation heat recovery system...etc were analyzed by individual and combination for the success of ZeSH. The ESP-r simulation program was used for this. Simulation results shows that almost 77% of heating load can be reduced with the following configuration of 200mm super insulation, super windows, passive solar system and 0.3 ventilation rate per hour. Active solar heating system (ASHS) was designed for the rest of the heating load including hot water heating load. The solar assisted heat pump is used for the auxiliary heating device in order to use air conditioner but not included in this study. The yearly solar fraction is 87% with a solar collector area of $28m^2$. The parametric studies as the influence of storage volume and collector area on the solar fraction was analyzed.

• 스마트미디어저널
• /
• 제12권10호
• /
• pp.63-70
• /
• 2023

최근 스마트팜 에너지 비용 중 35% 낸난방비 에너지 소비가 증가되어 에너지 소비 효율화가 요구되며, 전기료 현실화에 대한 우려로 신재생 에너지 중요성이 증가하고 있다. 신재생 에너지는 수력, 풍력, 태양광 등에 속하며, 이중 태양광 에너지는 전기에너지로 변환하는 발전기술로, 이 기술은 에너지원이 환경에 미치는 영향이 적고, 유지 보수가 간편하다는 특징을 갖고 있다. 본 연구에서는 온실 축열조, 히트펌프 데이터 기반으로 축열조 영향을 많이 미치는 요소를 선정하고 축열조 공급 온도예측 모델을 개발하고자 한다. 시계열 데이터 분석 및 예측에 효과적인 LSTM(Long Short-Term Memory)과 다른 앙상블 학습 기법보다 뛰어난 XGBoost 모델을 이용하여 예측한다. 히트펌프 축열조 온도를 예측함으로써 에너지 소비를 최적화하여 시스템 운영을 최적화할 수 있다. 또한, 태양광 활용에 따른 냉난방비 절감 및 농가의 에너지 자립도 개선 등 스마트팜 에너지 통합 운영 시스템에 연계하고자 한다. 플랫폼을 통해 폐열 에너지의 공급을 관리하고 최대 난방부하 및 계절, 시간별 작물생장에 필요한 에너지값을 도출하여 이를 기반으로 최적 에너지 운용방안을 도출하고자 한다.

• Journal of Biosystems Engineering
• /
• 제3권1호
• /
• pp.64-76
• /
• 1978

A dimensional supply of petroleum fuels and increased competition for petroleum products has made the conservation of energy in grain drying an important cost and management factor. Research on solar grain drying is directed toward utilization of a renewable energy source as an alternative to petroleum fuels for drying. There are many technical and economic problems in accepting and adopting solor energy as a new energy source for grain drying. The purpose of this study are to assess the state of the art of solar grain drying and to find out the problems by reviewing literatures available. The results obtained may be summarized as follows; 1.It may be considered that the weather conditions in October of Korea was satisfactory for the forced natural air and solar heated air drying. 2. Solar energy is considered more applicable to low-temperature, In-storage drying systems than to high-temperature, high-speed drying systems. In-storage drying systems require low levels of heat input. The costs of collector systems to provide low temperature are considerably cheaper than for high-temperature systems. 3. Tubular type collector made of polyvinyle film seems to be the most practical at this stage of development and black-painted bare-plate collectors mounted on the outside of a typical, round, low-temperature drying bin can supply an appreciable amount of the energy efficiently needed for low-temperature grain drying at a lower cost. 4. All of the grains in solar drying tests was successfully dried up to safe storaged moisture levels without significant spoilage. Drying rates with solar system were faster than natural air drying systems, and usually a little slower than similar low-temperature electric drying systems. 5. Final grain moisture levels were lower in solar tests than in natural air tests, and generally higher than in tests with continuous heated air. 6. Savings of energy by use of solar collectors ranged from 23% to 55%, compared to the natural and electric ileated air drying systems. However, total drying cost effectiteness tvas not significant. Therefore, it is desirable that solar grain dry-ing sIFstems tvhich could be suitable for multiple heating purposes on farms shouldbe developed. 7. Supplemental heat with solar radiation did little to reduce air flow requirementsbut refuced drying time and increased the p\ulcornerobability of successful drying duringdrying poriod.

• 한국태양에너지학회 논문집
• /
• 제22권1호
• /
• pp.9-21
• /
• 2002

To develope chemical heat pump using available energy sources, solar heat and other kinds of waste thermal energy, we have studied the heat transfer rate in cylindrical bed reactor packed with calcined Dolomite. Two dimensional (radial and circumferential) Partial differential equations, concerning heat and mass transfer in packed bed of calcined Dolomite, are solved numerically to describe the characteristics of the reaction of calcined Dolomite and heat transfer. The results obtained by numerical analysis about two dimensional profiles of temperature and conversion of reactant in the packed bed reactor and the amount of exothermic heat released from the reactor are follows. It was found that all of calcined Dolomite packed bed kept the reaction temperature of about 750K throughout the entire part of the bed, immediately after the steam was introduced exothermic reaction of hydration was proceeded from the packed bed inpu to output and from wall side to center. The rate of thermochemical reaction depends on the temperature and concentration and it is also governed by the boundary conditions and heat transfer rate in the particle packed bed.

• 한국시뮬레이션학회논문지
• /
• 제27권2호
• /
• pp.25-33
• /
• 2018

군용 장비 개발 시 운용자가 안정적인 환경에서 운용할 수 있도록 온도조건을 고려하여 설계하여야 한다. 각종 군용 장비를 보관하는 쉘터는 다양한 환경에서 운용되고 있다. 시험장비 및 수리부속품의 저장온도 및 운용 요구조건은 $-32^{\circ}C{\sim}50^{\circ}C$로 쉘터 내부는 저장온도 및 운용 요구조건을 충족할 수 있도록 설계되어야 한다. 본 연구에서는 MIL-STD-810G의 기준을 고려하여 고온 및 태양열 조건에서 군에서 운용중인 2.5톤의 군용쉘터의 열해석을 수행하였다. 열해석은 열저항 및 열회로개념을 활용하여 적용하였으며 해석결과를 검증하기 위해 실제 제작된 군용쉘터에 대한 태양열 시험을 실시하여 결과를 비교하여 제시하였다.

• 한국환경과학회지
• /
• 제24권6호
• /
• pp.721-729
• /
• 2015

Surface heat balance of the Gangjeong-Goryung Reservoir is analyzed for 12-17 August 2013. Each flux elements at the water surface is derived from the special field observations with application of an aerodynamical bulk method for the turbulent heat fluxes and empirical formulae for the radiation heat fluxes. The rate of heat storage in the reservoir is estimated by using estimated by surface heating rate and the vertical water temperature data. The flux divergence of heat transport is estimated as a residual. The features of the surface heat balance are almost decided by the latent heat flux and the solar radiation flux. On average for 12-17 August 2014 in the Gangjeong- Goryung Reservoir, if one defines the insolation at the water surface as 100 %, 94 % is absorbed in the reservoir; thereafter the reservoir loses about 30~50% by sensible heat, latent heat and net long-wave radiation. The residue of 50~80 % raises the water temperature in the reservoir or transported away by the river flow during the daytime.

• 태양에너지
• /
• 제18권3호
• /
• pp.89-94
• /
• 1998

태양열 응용을 위한 한 방편으로 캡슐화된 PCM을 이용한 유동층 축열조에서 축열 및 방열과정에서 열전달 특성을 살펴보았다. 유동층 축열조는 원통형으로 높이는 40cm, 직경은 5.0cm 이었다. 축열물질은 무기염의 일종인 sodium acetate 였으며, 이것은 파라핀 왁스와 PMMA 로 코팅되었다. 캡슐화된 PCM의 크기는 약 $2{\sim}3mm$였으며, 용융점은 $58^{\circ}C$였다. 축열 및 방열과정시 유동층 축열조의 시간에 따른 온도분포, 순간 열저장 및 방출 속도를 측정하였으며 이로부터 유동층 축열조의 체적 열전달 계수를 도출하였다. 또한 유동층 축열조의 조업변수인 열전달 유체의 유속, 유입온도에 대한 열전달 계수의 영향도 관찰하였다.

• 교육시설 논문지
• /
• 제18권3호
• /
• pp.35-41
• /
• 2011

Performance of a small-capacity solar absorption cooling system was investigated experimentally. Ten sets of evacuative-tube solar-heat collectors and a 5 kW single-stage absorption cooler were combined to produce a hybrid cooling system. The performance of the cooling system was measured using a tim-coil unit installed in a small plastic storage. It was found from the test on a sunny day of May that when the temperature of the hot water supplied from the solar collectors to the generator of the absorption cooler reached $60^{\circ}C$, the absorption cooler started cooling and the cold water temperature measured from the fan-coil unit reached $18^{\circ}C$. The COP, which is defined as the ratio of the cooling power to the total electrical power input was higher than 1.0.

• 태양에너지
• /
• 제2권1호
• /
• pp.49-58
• /
• 1982

Aim of this study was to obtain the heating performance and the economic evaluation on solar heating system for greenhouse which area of floor was $90m^2$. For heating performance effective solar energy for the greenhouse was compared with overall heating loads including coefficient of heat transfer and conduction. And the economic evaluation solar heating system was evaluated by comparison its initial investiment costing with oil saving cost. Initial investiment costing included collector cost, storage cost, piping cost, control system cost and miscellaneous costs which included pumps, motors etc. The contents of this study included the survey of climate conditions for solar heating, long-term collector performance and optimum collector area of solar heating system in existing greenhouse. The results are follows: 1. Average horizontal radiation during winter was $2,434Kcal/m^2$ day which was the highest value in this country, so the climate conditions of Suwon was suitable for solar heating. 2. Resulting calculation of the optimum collector area was $30m^2$ and the solar energy accounted for 30% of the overall heating load. 3. The capacity of storage tank required 60 liter per unit area ($m^2$) of solar collector.