• Proceedings of the Korean Geotechical Society Conference
• /
• 1999.11c
• /
• pp.129-141
• /
• 1999

This paper presents the results of plate load test and dynamic load test performed to evaluate the performance of geocell where it is used to reinforce soft subgrade for high-speed railroad. Efficacy of geocell was observed in increase in bearing capacity of subgrade and reduction of thickness of reinforced sub-ballast. Plate load tests were carried out at four different places with varying foundation soil strength as a function of number of geocell layer, type of filler material, thickness of cover soil, and the presence of non-woven geotextile. Dynamic load tests were performed in a laboratory. The test soil chamber consists of, from the bottom, 50 cm thick clayey soil, one layer of geocell filled with crushed stone, 10 cm thick crushed stone cover, reinforced sub-ballast of varying thickness, 35 cm thick ballast. This configuration was determined based on the results of numerical analysis and plate load tests. For each set of the dynamic load tests, loads were applied more than 80,000 times. One layer of geocell underlying a 10 cm thick cover soil led to an increase in bearing capacity three to four times compared to a crushed stone layer of the same thickness substituted for the geocell and cover soil layer. Given the test conditions, the thickness of reinforced sub-ballast can be reduced by approximately 35 cm with the presence of geocell.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2003.06a
• /
• pp.145-154
• /
• 2003

When a nail pulled out in dense, granular soil, the soil in the vicinity of the nail tends to dilate, but its dilatancy results in a normal stress concentration at the soil/nail interface, thereby increasing the pull-out resistance of the inclusion. It is thought to be occurring within the resistance zone where the soil mass is at stationary state and the reinforcement are held in position by the soil, due to the friction or bond. In this paper, A series of direct shear and interface tests were conducted by using so called‘Constant Normal Stiffness Test Apparatus’which was modified and improved from the conventional direct shear box test rig. Unlikely the normal shear box test, this enables to simulate the different constraint effects of surrounding soil during shear under the conditions of constant stress and volume, constant normal stiffness. The aim of the research programme is to get better understanding of pull-out bond mechanism, thus to explore the possibility of evaluating the pull-out bond capacity of soil/reinforcement at the preliminary design stage from the laboratory test.

• Journal of Ocean Engineering and Technology
• /
• v.23 no.3
• /
• pp.20-29
• /
• 2009

This study investigated the shear strength characteristics of waste tire powder-added lightweight soil (WTLS), which were developed to recycle dredged soil, bottom ash, and waste tires. The WTLS used in this experiment consisted of dredged soil, bottom ash, waste tire powder, and cement. Test specimens were prepared with various contents of waste tire powder ranging from 0% to 100% at 25% intervals and bottom ash contents of 0% or 100% by the weight of the dry dredged soil. In this study several series of direct shear tests were carried out, which indicated that the shear properties of WTLS were strongly influenced by the mixing conditions, such as the waste tire powder content and bottom ash content. The unit weight, as well as the shear strength of the WTLS, decreased with an increase in waste tire powder content. The shear strength of WTLS with bottom ash was 1.34 times greater than that of WTLS without bottom ash. An average increase in cohesion of 30 kPa was obtained in WTLS with the inclusion of bottom ash due to the bond strength induced from the pozzolanic reaction of the bottom ash. In this test, the maximum value of the internal friction angle was obtained with a 25% content of waste tire powder.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2007.09a
• /
• pp.305-316
• /
• 2007

Free field ground motion during earthquake is significantly affected by the local soil conditions and it is essential for the seismic design to perform the site specific ground response analysis. So, Round Robin Test (RRT) on ground response analysis was performed for three sites in Korea. A total of 12 teams presented the results of ground response analysis with used input soil properties based on own judgement. In this paper, the results of one dimensional equivalent linear analysis presented by 11 teams were compared to evaluate the effect of input soil properties on ground response analysis. Additionally, 4 influence factors on ground response analysis, that is shear wave velocity of soil layer, nonlinear dynamic deformational characteristics, bedrock depth and bedrock velocity were studied for assumed simple soil conditions.

• KIEAE Journal
• /
• v.9 no.2
• /
• pp.65-71
• /
• 2009

Results from tests for what mixing rate of soil and sand is proper for the rammed earth and for how much additives are optimum are as under. 1) In the test to evaluate what mixing rate of soil and sand is desirable, peptizing property and surface sticking rate are found similar in its degree, but compression strength is found most stable when the ratio of soil and sand mixing shows 30:70 which indicates the best mixing rate of soil and sand. 2) In a test to add hydrated lime, compression strength, peptizing property, and surface sticking rate are found best when the mixing rate of soil and sand shows 23:7. 3) In a test to add sea weeds, the peptizing property goes down at 75% of sea weeds input a little bit more than at 100%, but compression strength shows best at 75% which is thought to be the best rate. 4) In a drop test, more soil powder mixed, the sticking strength gets better and more sands are contained, the sticking strength gets far worse to be scattered in powder type. 5) As concluding all results mentioned in the above item, the most desirable mixing rate of soil, sand, and hydrated lime is found to be 23:7:70 for the rammed earth where compression strength, peptizing property, and surface sticking rate are best.

• Geomechanics and Engineering
• /
• v.34 no.5
• /
• pp.473-480
• /
• 2023

Acid rain of soils has a significant impact on mechanical properties. An X-ray diffraction test, scanning electron microscope (SEM) test, laser particle size analysis test, and triaxial unconsolidated undrained (UU) test were carried out in red clay soils with different compaction degrees under the effect of different concentrations of acid. The experiments demonstrated that: the dissolution effect of acid rain on colluvium weakened with the increase in the compacting degree under the condition of certain pH values, i.e., the damage to the structure of red clay soil was relatively light, where the number of newly increased pores in the soil decreased and the agglomeration of soil particles increased; for the same compacting degree, the structural gap decreased, and the agglomeration increased with the increase in the pH value (acidity decreases) of the acid rain; the dissolution rate of Si, Al, Fe, and other elemental minerals and cement in red clay soil was found to be higher under the effect of acid rain, in turn destroying the original structure of the soil body and producing a large number of pores. This is macroscopically expressed as the decrease of the soil cohesion and internal friction angle, thereby reducing the shear strength of the soil body.

• Journal of Korean Society of Environmental Engineers
• /
• v.35 no.8
• /
• pp.607-612
• /
• 2013

Soil ecological risk assessment requires terrestrial toxicity data based on trophic levels including plants, earthworms, nematodes, and springtails. To expand the trophic levels, it is needed to consider primary producer algae, nearly distributed in terrestrial environment, as representative terrestrial test species. In this study, we collected research cases focused on soil-related test species and exposure media from SCI papers, and analyzed exposure media, test species, test chemicals, and other test methods, for reviewing research trends of soil-related algal toxicity. Up to now, in the soil-related algal toxicity, test species were 8 cases (Pseudokirchneriella subcapitata, Chlorella vulgaris, Scenedesmus bijugatus, Chlorococcum infusionum, Scenedesmus subspicatus, Nostoc linckia, Synechococcus elongatus, and Chlorococcum sp.) and endpoints were cell count or photosynthetic pigment content. Also, 5 of exposure media were liquid medium, soil extracts, porewater, agar medium, and soil. Most of papers used algae isolated from natural soils or soil extracts. There were only one case for assessing algal toxicity in soil medium. More researches regarding algal toxicity in soil environments need to be conducted consistently.

• Journal of the Korean GEO-environmental Society
• /
• v.18 no.2
• /
• pp.59-65
• /
• 2017

The costal reclamation construction is for making reclaimed land by dredging marine clay with seawater, and then bringing the dredged soil into the reclaimed land. During the process, the dredged soil in the reclaimed land undergoes the sedimentation-consolidation process. Among the processes, the consolidation is a very critical factor when planning reclaimed land because of its requiring time and settlement. In order to predict the requiring time and settlement, the Column test, which was suggested by Yano, has been usually used in the nation. However, the test method needs a very long time to identify the characteristic of sedimentation-consolidation of dredged soil. Therefore, in this study, in order to supplement the weakness of the Column test which needs such a long time, and in order to identify the characteristic of the sedimentation-consolidation for dredged soil in a short time, the Geo-centrifuge test was examined as an alternative method. The result considered that Geo-centrifuge test would be useful to identify the characteristic of sedimentation-consolidation for dredged soil efficiently.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.9 no.6
• /
• pp.143-151
• /
• 2006

Currently, there are researches about environment-friendly road construction plans led by the Ministry of Construction and Transportation in progress. Therefore, in order to create the revegetation techniques of thin layer-soil combination media hydroseeding measures by actively using native herbs and native woody plants instead of using imported foreign grasses as a concept of sustainable environment-friendly land development, this thesis is going to identify problems that can appear when applying the thin- layer-soil-media hydroseeding measures by the suggested in the "Slope revegetation design and guidelines" proposed by the Ministry of Construction and Transportation, and to propose improvement plans for the problems.To this aim, a seeding mixture selection test was conducted by the goal of slope restoration, and a test group for artificial slope was created. As for a test for June sowing, it was intended to identify appropriate combination quantity by conducting a test that differentiates the combination quantity, and as for a test for September sowing, an artificial slope test was conducted by creating an artificial bank for earth and soil and applying 1~2cm and 3~4cm thickness after differentiating the seed combination volume and slope aspects.

• Geomechanics and Engineering
• /
• v.29 no.3
• /
• pp.281-290
• /
• 2022

The direct shear test is commonly used to evaluate the shear behavior of frozen soil-structure interfaces under normal stress. However, failure criteria, such as the Mohr-Coulomb failure criterion, are needed to obtain the unconfined shear strength. Hence, the punch shear test, which is usually used to estimate the shear strength of rocks without confinement, was examined in this study to directly determine the adfreezing strength. It is measured as the shear strength of the frozen soil-structure interface under unconfined conditions. Different soils of silica sand, field sand, and field clay were prepared inside the steel and concrete ring structures. Soil and ring structures were frozen at the target temperature for more than 24 h. A punch shear test was then conducted. The test results show that the adfreezing strength increased with a decrease in the target temperature and increase in the initial water content, owing to the increase in ice content. The adfreezing strength of field clay was the smallest when compared with the other soil specimens because of the large amount of unfrozen water content. The field sand with the larger normalized roughness showed greater adfreezing strength than the silica sand with a lower normalized roughness. From the experiment and analysis, the applicability of the punch shear test was examined to measure the adfreezing strength of the frozen soil-structure interface. To find a proper sample dimension, supplementary experiments or numerical analysis will be needed in further research.