• Geomechanics and Engineering
• /
• 제20권5호
• /
• pp.411-420
• /
• 2020

Numbers fitting-curve equations have been proposed to predict soil-water retention curve (SWRC) whose parameters have no definitude physical meaning. And these methods with precondition of measuring SWRC data is time-consuming. A simplified directly method to estimate SWRC without parameters obtained by fitting-curve is proposed. Firstly, the total SWRC can be discretized into linear segments respectively. Every segment can be represented by linear formulation and every turning point can be determined by the pore-size distribution (PSD) of Mercury Intrusion Porosimetry (MIP) tests. The pore diameters governing the air-entry condition (AEC) and residual condition (RC) can be determined by the PSDs of MIP test. The PSD changes significantly during drying in SWR test, so the determination of AEC and RC should use the PSD under corresponding suction conditions. Every parameter in proposed equations can be determined directly by PSD without curve-fitting procedure and has definitude physical meaning. The proposed equations give a good estimation of both unimodal and bimodal SWRCs.

• 토지주택연구
• /
• 제1권1호
• /
• pp.59-65
• /
• 2010

The paper presents a comparison between a semi-implicit time integration linear finite element implementation and fully-implicit nonlinear Newton-Raphson finite element implementation of a triphasic small strain mixture formulation of an elastic partially saturated porous medium. The pore air phase pressure pa is assumed atmospheric, i.e., $p_a$ = 0, although the formulation and implementation are general to handle increase in pore air pressure as a result of loading, if needed. The solid skeleton phase is assumed linear isotropic elastic and partially saturated 'consolidation' in the presence of surface infiltration and traction is simulated. The verification of the implementation against an analytical solution for partially saturated pore water flow (no deformation) and comparison between the two implementations is presented and the important of the porosity-dependent nature of the partially saturated permeability is assessed on comparison with a commercial code for the partially saturated flow with deformation. As a result, the response of partially saturated permeability subjected to the porosity influences on the saturation of a soil, and the different behaviors of the partially saturated soil between staggered and monolithic coupled programs is worth of attention because the negative pore water pressure in the partially saturated soil depends on the difference.

• 한국토양환경학회지
• /
• 제3권2호
• /
• pp.101-114
• /
• 1998

토양오염 정화방법의 하나인 토양증기추출법 (soil vapor extraction, SVE) 은 오염된 토양에 진공 또는 가압의 공기를 공급하여 연속적인 공기 흐름을 유도함으로써 토양의 기공에 잔류하는 유해화합물의 증발을 촉진하여 오염물질을 제거하는 공정이다. 본 연구에서는 토양증기추출법의 효율에 영향을 주는 인자들 가운데에서 토양의 수분함량과 오염물질의 종류가 오염물질의 제거효율에 미치는 영향에 대하여 실험연구를 수행하였다. 인공토양으로 미세기공이 없는 glass bead, sand, 그리고 미세기공이 많고 흡착능이 강한 molecular sieve가 사용되었으며, 오염물질로는 톨루엔, 메틸에틸케톤, 트리클로로에틸렌이 사용되었다. 본 연구에서는 오염물질의 탈착실험을 180분 이내로 수행하였으며, 이 범위 내에서는 인공토양으로부터의 유기화합물 탈착 현상에서 제거효율과 기공부피수, 각각에 로그를 취하였을 때 선형적 특성이 나타났다. 여기에서 기공부피수란 반응기를 통과한 공기의 부피를 기공부피로 나눈 것이다. 세 가지 유기화합물 모두 수분함량이 0%일 때 가장 낮은 제거속도를 보였으며 일정량의 수분이 포함됨으로써 유기화합물 제거에 필요한 기공부피수가 현저히 줄어듦을 관찰할 수 있었다. 또한, 트리클로로에틸렌과 같이 밀도가 큰 유기화합물의 제거를 위해서는 많은 양의 기공부피수가 소요되며 따라서 작업시간이 매우 길어지게 되므로, 토양증기추출법 외에 다른 정화방법을 함께 사용하여야 한다. 또한 인공토양의 특성에 따른 유기화합물의 탈착현상에 대하여 조사하였으며, 미세기공의 유무가 오염물질의 탈착속도에 미치는 영향이 톨루엔과 메틸에틸케톤에서 상이하게 나타났음을 알 수 있었다. 이러한 연구결과는 정화대상지역의 토양특성, 오염물질 등에 대한 조사를 시행한 후 SVE를 이용한 적절한 정화방법을 설계하는데 기초자료로 이용할 수 있을 것이다.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2008년도 춘계 학술발표회 초청강연 및 논문집
• /
• pp.998-1003
• /
• 2008

It has been recognized unsaturated soil behaviour playing an important role in geomechanics. Up to now, only a few experimental data are available for the technical difficulties related to both volume changes and suction measurements. In this study, the volume changes of unsaturated compacted silty soil were monitored with proximeter (i.e. non-contactable transducer) during various triaxial compression tests, which gave a realistic estimation in the volume changes of unsaturated soil sample. Various triaxial compression tests for unsaturated soil under different drainage conditions are carried out. The behaviour of the pore pressure, namely, the pore-air pressure and the pore-water pressure, and matric suction during the shearing tests are investigated. The experimental results have revealed that the mechanical behaviour of unsaturated soil can be significantly affected by the matric suction.

• 한국농공학회논문집
• /
• 제47권5호
• /
• pp.43-49
• /
• 2005

In this study. it was suggested that the elastic model to analyze the behavior of pore water pressure in saturated sand specimen on the condition of non-drainage. The model based on the experiments which were performed for the relationships between the pore water pressure and the grain size of specimen, and effective stress, respectively. The suggested model embodied the pore water and soil grain as separate elastic springs of different stiffness. The springs were joined parallel and the axial strains were restricted to the same deformation. The suggested model was well consistent with the experiments.

• Advances in environmental research
• /
• 제4권3호
• /
• pp.183-196
• /
• 2015

Migration of leachate generated through embankment of construction waste soil (CWS) in low-lying areas was studied through physical and chemical analysis. A leachate solution containing soluble cations from CWS was found to have a pH above 9.0. To determine the distribution coefficients in the alkali solution, column and migration tests were conducted in the laboratory. The physical and chemical properties of CWS satisfied environmental soil criteria; however, the pH was high. The effective diffusion coefficients for CWS ions fell within the range of $0.725-3.3{\times}10^{-6}cm^2/s$. Properties of pore water and the amount of undissolved gas in pore water influenced advection-diffusion behavior. Contaminants migrating from CWS exhibited time-dependent concentration profiles and an advective component of transport. Thus, the transport equations for CWS contaminant concentrations satisfied the differential equations in accordance with Fick's 2nd law. Therefore, the migration of the contaminant plume when the landfilling CWS reaches water table can be predicted based on pH using the effective diffusion coefficient determined in a laboratory test.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2010년도 추계 학술발표회 3차
• /
• pp.135-139
• /
• 2010

A construction technique to install the soil-bentonite (SB) cut-off wall for in-situ geoenvironmental containment by employing the trench cutting and re-mixing deep wall method is first presented in this paper. The laboratory test results on the hydraulic barrier performance of SB in relation to the chemical compatibility are then discussed. Hydraulic conductivity tests using flexible-wall permeameters as well as swell tests were conducted for SB specimens exposed to various types and concentrations of chemicals (calcium chloride, heavy fuel oil, ethanol, and/or seawater) in the permeant and/or in the pore water of original soil. For the SB specimens in which the pore water of original soil did not contain such chemicals and thus the sufficient bentonite hydration occurred, k values were not significantly increased even when permeated with the relatively aggressive chemical solutions such as 1.0 mol/L $CaCl_2$ or 50%-concentration ethanol solution. In contrast, the SB specimens containing $CaCl_2$ in the pore water had the higher k values. The excellent linear correlation between log k and swelling pressure implies that the swelling pressure can be a good indicator for the hydraulic barrier performance of the SB.

• 한국지하수토양환경학회지:지하수토양환경
• /
• 제19권3호
• /
• pp.15-24
• /
• 2014

Soil pollution has been recognized as a serious problem because it causes groundwater pollution through medium contacts. Although concentration of individual chemical could be more easily measured by physico-chemical analysis, it is not easy to consider the bioavailability of edaphic receptors living in soil or groundwater. To measure the toxicity of soil, the soil extracts (soil elutriates or soil suspensions in the other words) are often used due to the difficulties of extracting soil pore water. In this study, we reviewed 15 toxicity test methods found in literature to analyze the detail of each extraction method and to recommend the most frequently used extraction methods. The identified most commonly used extraction methods are as following: The 1 : 4 soil:water ratio, 24 hours shaking time, room temperature, dark, and separation of supernatant using a $0.45{\mu}m$ pore size filter.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2006년도 춘계 학술발표회 논문집
• /
• pp.189-198
• /
• 2006

This paper concerns the finite element (FE) modeling approach for NATM tunneling in water bearing ground within the framework of stress-pore pressure coupled analysis. Fundamental interaction mechanism of ground and groundwater lowering was first examined and a number of influencing factors on the results of coupled FE analysis were identified. A parametric study was then conducted on the influencing factors such as soil-water characteristics, location of hydraulic boundary conditions, the way of modeling drainage flow, among others. The results indicate that the soil-water characteristics plays the most important role in the tunneling-induced settlement characteristics. Based on the results, modeling guidelines were suggested for stress-pore prssure coupled finite element modeling of NATM tunneling.

• 한국지진공학회:학술대회논문집
• /
• 한국지진공학회 2003년도 춘계 학술발표회논문집
• /
• pp.140-147
• /
• 2003

There are many problems in the prediction of soil dynamic behaviors because undrained excess pore water pressure builds up and then the strain softening behavior is occurred simultaneously. A few analytical methods based on the dynamic constitutive model have been proposed but the model hardly predict the excess pore water pressure directly. In this study, the verification on the disturbed state concept (DSC) model, proposed by Dr, Desai was performed. Some laboratory tests such as conventional triaxial tests and cyclic triaxial tests were carried out to determine DSC Parameters and then disturbance values are determined by the proposed equation. Through this verification, it is proved that the disturbed state concept can express reliably the soil dynamic characteristics such as excess pore water pressure and strain softening behavior. It is also found that the critical disturbance which is determined at the minimum curvature of disturbance function can be a the specific index.