• 기술사
• /
• 제38권5호
• /
• pp.5-9
• /
• 2005

The seismic design provisions of the 2005 KBC has been based on the 2000 IBC and has considered the building code situations in Korea. There are site ground motion, soil class, seismic design category in the significant changes of the 2005 KBC. In the case of soft soil condition, the response spectrum acceleration of the 2005 KBC is larger than that of previous code. To reduce the seismic force of the 2005 KBC, it need to introduce the eqrthauke force resisting system with high ductility.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 1998년도 봄 학술발표회 논문집
• /
• pp.213-220
• /
• 1998

• 한국가스학회지
• /
• 제21권1호
• /
• pp.1-5
• /
• 2017

독성가스 사고 시 토양 침적은 사고피해범위에 영향을 미치는 주요 변수이다. 본 연구에서는 토양의 깊이 및 유기물 함량 비율이 독성가스 염소의 토양 침적 특성에 미치는 영향을 연구하였다. 실험에 이용된 장치로는 미국의 Air Force Research Laboratory에서 구축한 장치를 벤치마킹하였다. 다양한 합성토양을 이용해 유기물의 함량을 변화시키면서 토양 침적실험을 진행하였다. 다양한 합성토양에 일정 농도의 염소를 노출시킨 후, 염소 침적의 정도를 정량화하기 위해 음이온 크로마토그래피를 이용하여 침적량을 측정하였다. 그 결과, 토양 표면에서의 침적량 변화에 비해 깊이에 따른 침적량의 변화 경향은 볼 수 없었으나, 염소 노출 시간에 따른 표면 침적량의 차이는 증가함을 확인 할 수 있었다. 또한, 유기물 함량에 따른 침적량은 유기물 함량이 증가함에 따라 비례관계를 보였다. 토양 표면에서의 염소 침적량의 증가는 주로 토양 내 유기물 함량에 의존함을 확인하였다.

• Geomechanics and Engineering
• /
• 제28권2호
• /
• pp.197-207
• /
• 2022

The seismic holding behaviors of plate anchor embedded into submerged coarse-grained soils were investigated considering different anchor inclinations. The limit equilibrium method and the Pseudo-Dynamic Approach (PDA) were employed to calculate the inertia force of the soils within the failure rupture. In addition, assuming the permeability of coarse-grained soils was sufficiently large, the coefficient of hydrodynamic force applied on the inclined plate anchor is obtained through adopting the exact potential flow theory. Therefore, the seismic holding resistance was calculated as the combination of the inertia force and the hydrodynamic force within the failure rupture. The failure rupture can be developed due to the uplift loads, which was assumed to be an arc of a circle perpendicular to the anchor and inclines at (π/4 - φ/2). Then, the derived analytical solutions were evaluated by comparing the static breakout factor N_γ to the published experimental and analytical results. The influences of soil and wave properties on the plate anchor holding behavior are reported. Finally, the dynamic anchor holding coefficients N_γd, were reported to illustrate the anchor holding behaviors. Results show that the soil accelerations in x and z directions were both nonlinear. The amplifications of soil accelerations were more severe at lower normalized frequencies (ωH/V) compared to higher normalized frequencies. The coefficient of hydrodynamic force, C, of the plate anchor was found to be almost constant with anchor inclinations. Finally, the seismic anchor holding coefficient oscillated with the oscillation of the inertia force on the plate anchor.

• Structural Engineering and Mechanics
• /
• 제31권4호
• /
• pp.453-475
• /
• 2009

The literature regarding the free vibration analysis of Bernoulli-Euler and Timoshenko beams on elastic soil is plenty, but the free vibration analysis of Reddy-Bickford beams on elastic soil with/without axial force effect using the Differential Transform Method (DTM) has not been investigated by any of the studies in open literature so far. In this study, the free vibration analysis of axially loaded Reddy-Bickford beam on elastic soil is carried out by using DTM. The model has six degrees of freedom at the two ends, one transverse displacement and two rotations, and the end forces are a shear force and two end moments in this study. The governing differential equations of motion of the rectangular beam in free vibration are derived using Hamilton's principle and considering rotatory inertia. Parameters for the relative stiffness, stiffness ratio and nondimensionalized multiplication factor for the axial compressive force are incorporated into the equations of motion in order to investigate their effects on the natural frequencies. At first, the terms are found directly from the analytical solutions of the differential equations that describe the deformations of the cross-section according to the high-order theory. After the analytical solution, an efficient and easy mathematical technique called DTM is used to solve the governing differential equations of the motion. The calculated natural frequencies of one end fixed and the other end simply supported Reddy-Bickford beam on elastic soil using DTM are tabulated in several tables and figures and are compared with the results of the analytical solution where a very good agreement is observed and the mode shapes are presented in graphs.

• Geomechanics and Engineering
• /
• 제32권2호
• /
• pp.145-157
• /
• 2023

This paper aims at investigating the face stability of large-diameter underwater shield tunnels considering seepage in soft-hard uneven strata. Using the kinematic approach of limit upper-bound analysis, the analytical solution of limit supporting pressure on the tunnel face considering seepage was obtained based on a logarithmic spiral collapsed body in uneven strata. The stability analysis method of the excavation face with different soft- and hard-stratum ratios was explored and validated. Moreover, the effects of water level and burial depth on tunnel face stability were discussed. The results show the effect of seepage on the excavation face stability can be accounted as the seepage force on the excavation face and the seepage force of pore water in instability body. When the thickness ratio of hard soil layer within the excavation face exceeds 1/6D, the interface of the soft and hard soil layer can be placed at tunnel axis during stability analysis. The reliability of the analytical solution of the limit supporting pressure is validated by numerical method and literature methods. The increase of water level causes the instability of upper soft soil layer firstly due to the higher seepage force. With the rise of burial depth, the horizontal displacement of the upper soft soil decreases and the limit supporting pressure changes little because of soil arching effect.

• 한국지반공학회논문집
• /
• 제15권6호
• /
• pp.71-86
• /
• 1999

본 연구는 국내 11 네일링 현장을 대상으로 경사계와 변형률계의 계측자료를 이용하여 쏘일네일링 벽체의 변위와 네일의 인장력을 고찰하였다. 연구결과 최대수평변위량은 시공과정이 양호한 현장의 경우와 불량한 경우 각각 굴착깊이(H)의 0.2%, 0.3%이하로 나타났으며, 벽체의 최대수평변위 발생위치는 지표면으로부터 굴착심도의 약 5~l5%이내의 벽체상단에서 발생하였다. 최종굴착깊이$(H_f)$와 네일의 길이(L)와의 길이비 R이 0.5이하, 0.5~0.6, 0.6~0.7인 경우 최대수평변위가 각각 굴착깊이(H)의 0.4%, 0.3%, 0.2%로 나타났다. 그러나 길이비 R이 0.7이상인 경우에는 최대수평변위가 굴착깊이의 약0.3%로 증가하는 것으로 나타났으며 이러한 결과는 굴착깊이가 얕고, 토사층 부분이 많았기 때문으로 판단된다. 최대인장력을 무차원화한 K값은 지표면으로부터 최종굴착깊이$(H_f)$의 $0.6H_f$까지는 0.8이하로 나타났으며, $0.6H_f$에서부터 최종굴착면까지 선형적으로 감소하는 것으로 나타났다. 그리고 최종굴착완료시 네일의 최대 인장력$(T_{max)$이 네일의 항복인장력$(T_{\sigmay)$에 최대 60%까지 도달하는 것으로 나타났다.

• 드라이브 ㆍ 컨트롤
• /
• 제20권4호
• /
• pp.115-122
• /
• 2023

This study utilized a discrete element method (DEM) simulation, as one of the virtual field trials, to predict the impact of tillage depth on the rotary blade shaft during rotavator tilling. The virtual field for the simulation was generated according to soil properties observed in an actual field. Following the generation of particles for the virtual field, a sequence of calibration steps followed to align the mechanical properties more closely with those of real soil. Calibration was conducted with a focus on bulk density and shear torque, resulting in calibration errors of just 0.02% for bulk density and 0.52% for shear torque. The prediction of the load on a rotary tiller's blade shaft involved a three-pronged approach, considering shaft torque, draft force, and vertical force. In terms of shaft torque, the values exhibited significant increases of 42.34% and 36.91% for every 5-centimeter increment in tillage depth. Similarly, the vertical force saw substantial growth by 40.41% and 36.08% for every 5-centimeter increment. In contrast, the variation in draft force based on tillage depth was comparatively lower at 18.49% and 0.96%, indicating that the effect of tillage depth on draft force was less pronounced than its impact on shaft torque and vertical force. From a perspective of agricultural machinery research, this study provides valuable insights into the DEM soil modeling process, accounting for changes in soil properties with varying tillage depths. These findings are expected to be instrumental in future agricultural machinery design studies.

• 한국수자원학회논문집
• /
• 제51권3호
• /
• pp.235-246
• /
• 2018

본 연구의 주목적은 조양하 유역의 유출응집구조와 에너지소비 양상을 멱함수 법칙분포의 틀 내에서 해석하고 이를 기반으로 토사유실에 민감한 우심지역을 추출하기 위한 방법론을 제시해 보고자 하는 것이다. 이를 위하여 GIS를 기반으로 대상유역 내 지점별 배수면적과 함께 소류력 및 수류력을 정의하는 지형학적 인자를 추출하여 해당 인자들에 대한 여누가 분포의 도해적 해석과 함께 멱함수 법칙분포의 적합을 수행하였으며 소류력과 수류력의 규모별 특성권역을 기반으로 토양우실 우심지역을 추출하여 보았다. 소류력를 기반으로 한 토사유실 우심지역의 경우 수류력을 기반으로 한 결과에 비하여 우심지역의 범위가 매우 좁게 평가되고 있음을 시각적으로 확인할 수 있었다. 이러한 결과는 소류력이 멱함수 법칙분포를 따르지 않는 규모종속성 지형학적 인자이기 때문인 것으로 판단된다. 이에 따라 해당 지형학적 인자는 멱함수 법칙분포의 틀 내에서 자연유역의 에너지 규모를 적절하게 반영하지 못하는 것으로 사료되며 본 연구에서 수류력을 기반으로 제시한 지형학적 인자가 토사유실의 평가를 위해 보다 합리적인 것으로 판단된다. 토사유실 우심지역을 도시해 본 결과 국부경사에 종속적인 사면활동 활성구간에서 발생한 토사가 국부경사와 배수면적에 종속적인 지표유동 활성구간을 통하여 계곡으로 이동하는 경로를 시각적으로 확인할 수 있어 본 연구에서 제시한 방법론의 타당성을 판단할 수 있었다.

• 한국전산구조공학회:학술대회논문집
• /
• 한국전산구조공학회 2005년도 춘계 학술발표회 논문집
• /
• pp.529-537
• /
• 2005

This paper proposes the shaking table testing method, without any soil specimen only using building model as an experimental part, considering dynamic soil-structure interaction based on the substructure method. The two-layered soil is assumed as a soil model of the entire soil-structure interaction syhstem(SSI) in this paper. Differently from the constant soil stiffness, the frequency-dependent dynamic soil stiffness is approximated for the case of both acceleration and velocity feedback, respectively. The interaction force is observed from measuring the accelerations at superstructure. Using the soil filters corresponding to the approximated dynamic soil stiffness, the shaking table drives the acceleration or velocity, which the needed motion to give the building specimen the SSI effects. Experimental results show the applicability the proposed methodologies to the shaking table test considering dynamic soil-structure interaction.