• 센서학회지
• /
• 제17권4호
• /
• pp.295-302
• /
• 2008

$TiO_2,\;ZrO_2$, and $SiO_2$ were added in the concentration of 1 - 3 wt.% to improve long-term stability for the $SnO2$ thick film gas sensor. Short-term sensor resistances up to 90 h were measured to investigate the stabilization time of initial resistance in air. Long-term resistance drifts in air and in gas to 5000 ppm methane for the sensors annealed at $750^{\circ}C$ for 1 h and continuously heated at an operating temperature of $400^{\circ}C$ were also measured up to 90 days at an interval of 1 day. The long-term drifts in methane sensitivity for the three metal oxide-doped $SnO2$ sensors are closely related to methane sensitivity level, catalytic activity, and long-term drift in sensor resistance in air. Those stabilities are mainly discussed in terms of oxidation state and catalytic activity.

• 한국재료학회지
• /
• 제24권1호
• /
• pp.43-47
• /
• 2014

NiO-doped hibonite pigments were synthesized by the solid state method to get stabilized blue color pigment in both oxidation and reduction atmospheres. Optimum substitution condition with NiO for hibonite blue pigment was investigated. Experimental results were comparable to those of previous cobalt-minimization studies performed with other phosphate- or oxide-based cobalt-containing ceramic pigments (having olivine ($Co_2SiO_4$), spinel ($CoAl_2O_4$), or with co-doped willemite ($(Co,Zn)_2SiO_4$) structures). Composition was designed varying the NiO molar ratio increasing with $SnO_2$. The optimum substitution content is 0.93 mole NiO with 0.75mole $SnO_2$. The characteristics of the synthesized pigment were analyzed by XRD, Raman spectroscopy, SEM, and UV-vis. Synthesized pigment was applied to a lime-barium glaze with 10 wt% each and fired at an oxidation atmosphere of $1250^{\circ}C/1h$ and a reducing atmosphere $1240^{\circ}C/1h$. Blue color was obtained with $L^*a^*b^*$ values at 43.39, -6.78, -18.20 under a reducing atmosphere and 41.66, -6.36, -14.7 under and oxidation atmosphere, respectively.

• 대한화학회지
• /
• 제28권5호
• /
• pp.328-334
• /
• 1984

새로운 4가지의 phenyl N-benzenesulfonylchloroformimidate 유도체를 합성하고 $25^{\circ}C$와 1 ; 4 dioxane-물의 이성분 혼합용매중에서 가수분해 반응속도를 자외선 분광 광도법으로 측정하여 넓은 pH범위에 적용되는 가수분해 반응속도식을 유도하였다. 치환기 효과(${\rho}$ = -0.45, ${\rho}$ = 0.40), 용매효과 (m = 1.3-1.5, n = 5.0-5.5), 반응속도식 및 생성물 분석 등의 결과로부터 가수분해 반응 메카니즘을 제안하였다. 즉, pH 0.0-8.0의 산성과 중성용액에서는 $SN_1$, 그리고 pH 10.0이상의 알카리성 용액에서는 $SN_2$반응으로 가수분해가 시작되어 $E_1CB$반응으로 benzensulfonamide를 생성하는 일련의 반응으로 가수분해가 진행됨을 알았다.

• 한국재료학회지
• /
• 제14권7호
• /
• pp.462-469
• /
• 2004

The effect of Cu addition on the corrosion characteristics of Zr alloys that developed for nuclear fuel cladding in KAERI (Korea Atomic Energy Research Institute) was evaluated. The alloys having different element of Nb, Sn, Fe, Cr and Cu were manufactured and the corrosion tests of the alloys were performed in static autoclave at $360^{\circ}C$, distilled water condition. The alloys were also examined for their microstructures using the optical microscope and the TEM equipped with EDS and the oxide property was characterized by using X-ray diffraction. From the result of corrosion test more than 450 days, the corrosion rate of the Zr-based alloys was changed with alloying element such as Nb, Sn, Fe, Cr and especially affected by Cu addition. The corrosion resistance was increased with increasing the Cu content and the tetragonal $ZrO_2$ layer was more stabilized on the Cu-containing alloys.

• 한국재료학회지
• /
• 제16권2호
• /
• pp.129-136
• /
• 2006

In order to get basic information on the reference electrode material for the long life Al concentration sensor in zinc galvanizing melt, the workability and stability of fluorine potential cell with $CaF_2$ single crystal electrolyte were examined carefully at constant temperature for six kinds of reference materials (Zn, Sn, Cd, Bi, Pb, Al-Sn alloy + fluorides). Good workability and stability of the sensor were found in sensor with $Bi+BiF_3$ reference electrode. The Al sensor with $Bi+BiF_3$ reference electrode was assembled and was tested in Zn-Al melt with different Al concentration. The EMF was changed rapidly with the change of Al concentration and was stabilized in a short time. Thus the response of EMF was satisfactory for $CaF_2$ sensor. The correlationship between EMF from the sensor and logarithm of Al concentration has been derived from the least square regression method. E/mV=57.515log[wt% Al]+1883.3 R=0.9717 ($0.013{\leq}[wt% Al]{\leq}0.984$) The EMF from Al sensor was increased linearly against logarithm of [wt% Al]. The fluorine potential of Zn-Al melt was also calculated to be in the range of $10^{-60}{\sim}10^{-61}$ Pa for the present experiemental condition.

• Bulletin of the Korean Chemical Society
• /
• 제22권1호
• /
• pp.25-29
• /
• 2001

Nucleophilic substitution reactions of O-imidomethyl derivatives of phenols with OH- were studied theoretically using the semiempirical AM1 and Solvation Model 2.1 (SM2.1) methods in the gas phase and aqueous solution, respectively. In the gas phase, the two reaction paths, in which the imide (1a) or phenol (1b) is functioning as a leaving group, can occur competitively. In contrast, in aqueous solution, path (1b) becomes more favorable than (1a) because the transition states (TS) of path (1b) are more stabilized by solvent. Differences in solvation energies are caused by the structural differences of TS, i.e., the TS via path (1b) is more dissociative than that via path (1a). Therefore we conclude that the solvent effects play an important role in the hydrolysis of O-imidomethyl derivatives of phenols. However, reactivity is dependent on the acidities of both the imide and the phenol fragments since the ρz values vary progressively from 4.2 (Z' = I) to 2.5 (Z' = IV) as the acidities of imide increase. These are in good agreement with the experimental results.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2005년도 추계학술대회논문집
• /
• pp.192-195
• /
• 2005

Nanometer operating linear motor is difficult to control the nano-positioning because of the vibration between structures changing of mechanical friction force happened by properties of the vibration and heat caused by operating of a mover. Therefore, it is required to analysis the vibration and heat about a mover. In this paper, we will analyze the property of vibration through analyzing by using FEM a mover of linear motor developed in the non-load situation and suggest the direction of optimal design about a mover by using method of DOE, also try to find the solution to operate the linear motor stabilized through the reducing weight of mover considering the vibration.

• Bulletin of the Korean Chemical Society
• /
• 제21권8호
• /
• pp.823-827
• /
• 2000

Gas-Phase reactions of methyl and ethyl nitrites with anionic nucleophiles of SH-, F- and OH- are investigated theoretically at the MP2/6-311+G* level. The SN2 processes are all highly exothermic and proceed with a typ-icaI double-weIl reaction coordinate profile. The elimination reactions of methyl nitrite with SH- and F- are double-well energy surface processes,with stabilizedproduct complexes of NO-...H2S and NO-...HF, pro-ceeding by an E1 cb-like E2 mechanism. The $\beta-elimination$ of ethyl nitrite is an E2 type process. The $\alpha-elimi-nation$ reactions of methyl and ethyl nitrites with OH- have triple-well energy profiles of Elcb pathway with an $\alpha-carbanion$ intermediate which is stabilized bythe vicinal $nc\alpha-{\sigma}*o-N$ charge transfer interactions. CompIex-ation ofmethyl carbanion with HF seems to provide a stable intermediate within a triple-well energy profile of El cb channel in the reaction of F- with methyl nitrite.

• Journal of Applied Biological Chemistry
• /
• 제42권1호
• /
• pp.7-11
• /
• 1999

An extracellular chitinase of the selected strong antifungal microorganism, Serratia sp. 3095, was purified by salting out, affinity adsorption, Sepadex G-100 gel fitration, Sepadex G-75 gel fitration and DEAE Sepadex A-50 chromatography. The molecular weight of the purified chitinase was estimated to be 62,000 dalton by SDS-PAGE. Optimal pH and temperature of the chitinase were pH 7.5 and 45, respectively. The enzyme retained more than 80% of the activity between pH 5.5 and pH 10.5, and below $50^{\circ}C$ but was unstable above $60^{\circ}C$, below pH 5.0. The activity of the chitinase was inhibited about 60% by $Sn^{2+}$, 40% by $Hg^{2+}$ and $Ag^+$, 70% by AHA, 40% by iodoacetate, 35% by thiourea and p-CMB, but stabilized by SDS. $K_m$ value of the purified chitinase was 3.68 mg/ml for colloidal chitin. The chitinase from Serratia sp. 3095 showed antifungal activity to Fusariurm solani.

• 한국재료학회지
• /
• 제10권1호
• /
• pp.34-40
• /
• 2000

디지털형 압전/전왜 액츄에이터 응용을 위하여 상경계(반강유전상/강유전상) 조성인 $Pb_{0.94}Y_{0.04}[(Zr_0.6Sn_0.4)_{0.915}Ti_0.085]O_3$ (PYZST) 계를 택하여 과잉 PbO의 첨가량 및 소결 조건 변화에 따른 상전이 특성, 유전 특성 및 전기장 유기변형 특성을 연구하였다. 사방정 구조를 갖는 PYZST 세라믹스에서 과잉 PbO 첨가에 따른 결정구조의 변화는 거의 확인되지 않았으나, 소결 후 입자가 약간 작아지며 둥근 형태로 변화하였고 첨가량 증가에 따라 적정 소결온도는 감소하였다. 과잉 PbO의 첨가량이 증가함에 따라, 분극측정시 반강유전상이 보다 안정되는 경향을 보였고, 전계유도변형 측정시 인가전기장 제거상태에서의 변형의 형상기억성이 감소하고 디지털형 변형곡선 특성이 강화되었다. 또한 최대 유전상수와 전계 유기변형량은 감소하였으나 반면 상전이(반강유전상$\leftrightarrow$강유전상) 전기장 및 비저항은 증가하는 경향을 나타냈다. 이러한 결과는 과잉으로 첨가된 PbO에 의한 격자 결함반응 및 분역벽 이동 거동 가능성과 연관시켜 설명하였다.