• Proceedings of the Korea Concrete Institute Conference
• /
• 2005.05b
• /
• pp.493-496
• /
• 2005

The Re-mi-con sludge water has been investigated because of environmental pollution and disposal cost. So, sludge water is partially reused as mixing water. However, if sludge water is reused too much that would influence the quality of concrete. KS specification limits the amount of sludge content up to 3$\%$ of cement weight. In this study, the effect of re-mi-con sludge on the characteristics of concrete is compared to raise the reuse ratio of re-mi-con sludge. From the test results, as blending ratio of re-mi-con sludge increases, workability is decreases. However, the re-mi-con sludge water have a minor effect on the strength development, the drying shrinkage and the resistance of freeze and thawing. Also, the existing model codes of drying shrinkage do not coincide with the test results of this study.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.3 no.1
• /
• pp.52-61
• /
• 2000

Permeability is important factor in the geotechnical problems, such as seepage discharge and dissipation of excess pore water pressure. The Kozeny-Carman equation works well for graded soils but serious discrepancies are found in clays. Major factor for these discrepancies is the tortuous flow path and unequal pore size. To estimate the permeability of fine grained soils, a permeability equation in which swelling potential is coupled with Kozeny-Carman equation is proposed in this study. To verify proposed equation, a series of variable head permeability test was carried out for steel making slag and sludge mixed with bentonite. The coefficients of permeability which is measured in the laboratory is compared with the values by the proposed equation. From the comparison, it is shown that the proposed equation can predict the coefficient of permeability of clays with satisfaction. As steel making slag and sludge is industry waste, it is reused as material of road foundation and cement but the rate of use is low. It mixed sodium-bentonite with high swelling property and permeability decrease effect. Then, Admixture investigates reuse possibility as liner of waste fill.

• Journal of Korea Water Resources Association
• /
• v.35 no.2
• /
• pp.213-220
• /
• 2002

This reserch was focused upon experimental study for wastewater reuse and conducted to evaluate optimum operating conditions of rapid filtration process such as filter flow rate, filtration time and backwashing condition for reuse of secondary-treated effluent using the pilot plant installed in real wastewater treatment plant. Also, the experiment on treatment char-acteristics of coagulant-added activated sludge process was performed to compare with activated sludge succeeded to rapid filtration. As the filtration velocity was 100m/day, the filtration time of the rapid filter connected with activated sludge system was revealed to 40 hours. Backwashing of filter was conducted by water wash and air scour. The optimum backwashing time and backwash flow rate were 10min and 10LPM, respectively. The quantity of backwashing water of the rapid filter was about 2% of total treated water.

• 수도
• /
• s.68
• /
• pp.33-49
• /
• 1994

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.44 no.3
• /
• pp.122-135
• /
• 2002

Although fly ash possesses viable engineering properties, an overwhelming majority of fly ash from coal combustion is still placed in storage or disposal sites. Similarly, sludges generated from various water treatment operations are predominantly subjected to the fate of land disposal. To prepare sludges fur land disposal typically requires time consuming dewatering schemes, which can become extremely difficult to execute depending upon the composition of the sludge and its affinity for water. This study was undertaken to reuse fly ash and sludge as construction materials. This paper includes geotechnical properties of fly ash and fly ash-lime-sludge mixture and results of compaction test, UU-test, falling head test, leaching test and CBR test. The effect on mixing fly ash with sludge and lime and the effect of curing period and the results are obtained from this test.

• Proceedings of the Korean Society of Agricultural Engineers Conference
• /
• 2000.10a
• /
• pp.458-465
• /
• 2000

Although Fly ash possess viable engineering properties, an overwhelming majority of the fly ash from coal combustion is still placed in storage or disposal sites. Similarly, sludges generated from various water treatment operations are predominantly subject to the fate of land disposal. To prepare sludges for land disposal typically requires time consuming dewatering schemes, which can become extremely difficult to execute dependent upon the composition of the sludge and its affinity for water. This test was undertaken to reuse of fly ash and sludge with mix. In this paper includes of geotechnical properties of fly ash and fly ash-sludge mixture and results of compaction test, unconfined test, falling head test and CBR test and it was analyzed the effect on mixing fly ash with sludge.

• Journal of Environmental Science International
• /
• v.11 no.1
• /
• pp.69-74
• /
• 2002

This study was performed to evaluate an applicability of the SMMCMAS system for reuse of the sewage from spa area and was operated to HLR(Hydraulic loading rate) of 211.3 to 126.8 $\ell$/㎥/d. The operating HRT(Hydraulic retention time) ranges were 2.5 to 1.5 hours. Conclusions are as follows; At the optimum HLR of 158.5 $\ell/\m^2$/d (HRT of 2.0 hours), the maximum BOD removal efficiency was 94% and the effluent BOD concentration was 1.1mg/$\ell$ in result. As the HLR was increased to 211.3 $\ell/\m^2$/d, BOD removal efficiency was decreased to 75% and BOD removal efficiency was also reduced to 74% at lower HLR of 126.8 $\ell/\m^2$/d. It shows that the maximum BOD removal efficiency occurs at an optimum HLR value and that the removal efficiency decreases when the HLR is either higher or lower than the optimum value. Sludge production rates were ranged 0.01 to 0.24gVSS/gBODrem/d and accomplished to 0.01gVSS/gBODrem/d at the optimum HLR of 158.5 $\ell/\m^2$/d.

• Journal of Korean Society of Water and Wastewater
• /
• v.20 no.2
• /
• pp.289-294
• /
• 2006

A pilot scale non-woven fabric filter separation activated sludge system was investigated for practical application on domestic wastewater reclamation and reuse. The system was operated in A/O (Anaerobic/Oxic) process with submerged filter module in the aerobic compartment. In the test of two types of filter materials ($70g/m^2$ and $35g/m^2$), the initial flux (0.42m/d) could be maintained for about three months by regular air backwashing of $70g/m^2$ filter at 0.3m water head. The removal efficiency of organic matter by the system was BOD 93.3%, CODcr 96.3%, SS 96.7%. The effluent quality was 7.8mg/L, 12mg/L and 5mg/L for BOD, CODcr and SS, respectively. The water quality was enough to meet a standard for domestic reuse without human contact. T-N removal efficiency was 49.9% at internal recycle rate 2Q and C/N ratio 3.3. The removal efficiency of T-P was 50% with average effluent concentration, 2.6mg/L.

• Journal of the Korean Applied Science and Technology
• /
• v.26 no.1
• /
• pp.80-86
• /
• 2009

This research was performed to evaluate heavy metal leaching characteristics of the sludge from paper mill process with sintering temperature. Heavy metal leaching of the sludge was characterized with Korean Leaching Test and Toxicity Characteristic Leaching Procedure. The test sludge was composed of 70.72% of moisture, 9.5% of volatile solids and 9.76% of fixed solids. As a result of XRF analysis, Fe was the highest inorganic element in approximately 83%, which implies the recycling possibility of the sludge in reuse of Fenton chemicals and artificial lightweight aggregate. Leaching of heavy metals from sintered sludge was lower than the dry ones. However, there was no significant difference in leaching characteristics between the sludges sintered at $350^{\circ}C$ and $650^{\circ}C$. Zn and Fe were leached more greatly in TCLP and KLT methods respectively.

• Environmental Engineering Research
• /
• v.13 no.3
• /
• pp.112-118
• /
• 2008

Residual solid in excess sludge treated by hydrothermal reaction was investigated as raw material for its recycling. Treated excess sludge and residual solid were also focused on their content change during hydrothermal reaction. Two kinds of excess sludge, obtained from a local food factory and a municipal wastewater treatment process, were tested under various conditions. Following hydrothermal reaction, depending on the reaction conditions, biodegradable substrates in treated excess sludge appeared to increase. The separated residual solid was a composite composed of organic and inorganic materials. The proportion of carbon varied from 34.0 to 41.6% depending on reaction conditions. Although 1.89% of hazardous materials were detected, SiO2 (Quartz) was a predominant constituent of the residual solid. X-ray diffraction (XRD) experiments revealed that the residual solid was of a partially amorphous state, suggesting that the residual solids could be easily converted to stable and non harmful substances through a stabilization process. Thus, this technology could be successfully used to control excess sludge and its reuse.