• 전자공학회논문지
• /
• 제50권11호
• /
• pp.64-69
• /
• 2013

본 논문에서는 10-bit 해상도의 Two-Step Single-Slope A/D 변환기를 이용한 고속 CMOS Image Sensor(CIS)를 제안하였다. 제안하는 A/D 변환기는 5-bit coarse ADC 와 6-bit fine ADC 로 구성되어 있으며, 기존의 Single-Slope A/D 변환기보다 10배 이상의 변환속도를 나타내었다. 또한 고속 동작에서 적은 노이즈 특성을 갖기 위해 Digital Correlated Double Sampling(D-CDS) 회로를 제안하였다. 설계된 A/D 변환기는 0.13um 1-poly 4-metal CIS 공정으로 제작되었으며 QVGA($320{\times}240$)급 해상도를 갖는다. 제작된 칩의 유효면적은 $5mm{\times}3mm$ 이며 3.3V 전원전압에서 약 35mW의 전력소모를 나타내었다. 변환속도는 10us 이었으며, 프레임율은 220 frames/s으로 측정되었다.

• 센서학회지
• /
• 제18권4호
• /
• pp.269-273
• /
• 2009

In this paper, a study on a portable hydrogen alarm system based on the palladium coated single mode fiber sensor has been reported. The fabricated hydrogen sensor exhibited 0.14 dB, 0.41 dB and 0.54 dB optical intensity variation when it was exposed by the nitrogen and hydrogen mixed gas containing 0.5 %, 1 % and 4 % of the hydrogen concentration, respectively. The fabricated sensor exhibited 20 second of response time and 120 second of recovery time for 4 % hydrogen containing gas. The fiber optics layout and software algorithm for detection of hydrogen leakage have been presented. The implanted portable hydrogen alarm system successfully generated an alarm signal when a 4 % hydrogen containing gas was leaked out.

• 대한토목학회논문집
• /
• 제26권3D호
• /
• pp.461-467
• /
• 2006

노면에 차량 검지센서를 설치하여 개별차량의 속도자료를 수집하는 경우, 일반적으로 일정거리가 이격되게 설치한 두 개 이상의 차량 검지센서간의 반응시간을 활용하여 차량의 속도를 산출하게 된다. 본 논문에서는 차로당 센서 1개만을 설치하여 개별차량의 속도 산출을 함에 있어, 기존 방법인 파형의 기울기를 이용하여 속도 추정하는 방법(Case 1)과 평균차량길이를 적용한 속도산출(Case2), 새로 고안한 방법인 단일 테이프스위치(Tape Switch) 센서를 수평형으로 설치하고 평균축거를 적용하여 속도 추정하는 방법(Case 3), 그리고 테이프스위치 센서를 사선형으로 설치하고 차량의 평균윤거(Mean of tread)를 적용하여 속도 추정하는 방법(Case 4)에 대한 속도 추정정확도를 평가하였다. 4가지 방식 각각에 대해 현장에서 센서를 설치하고 기준값과 속도추정 값을 비교 분석을 했으며, 평가지표로는 등가계수(Equality Coefficient), 절대오차백분율(MAPE)을 통하여 평가하였다. 평가결과는 Case1 > Case 4 > Case 2, 3 순으로 양호한 결과를 보이는 것으로 분석되었다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2016년도 전력전자학술대회 논문집
• /
• pp.363-364
• /
• 2016

In this paper, a novel bridgeless interleaved power factor correction circuit with single current sensor is proposed. The proposed control strategy requires only one current sensor for the interleaved bridgeless PFC. By sampling the output current, all the boost indictor currents can be calculated and used to control the input current according to the input voltage. The reduced number of current sensors and associated feedback circuits helps reduce the cost of system. The problem caused by the unequal current gain between current sensors inherently does not exist in the proposed topology. Thus, current sharing between converters can be achieved more accurately and the high frequency distortion is decreased. In addition, the proposed technique can be applied to the other kinds of interleaved PFC topologies. Performance of the proposed control strategy is verified by the experimental results with 6.6kW bridgeless interleaved PFC circuit.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 하계학술대회 논문집 B
• /
• pp.974-976
• /
• 2001

This paper presents a method to reduce commutation torque ripples occurred during commutation in brushless do motor drives using a single DC-link current sensor. In brushless dc motor drives with a single dc current sensor instead of 3-phase line current sensors, it is noted that dc-link current sensor cannot give any information corresponding to the motor currents during line current commutation intervals. A new technique to resolve such a problem is dealt with based on a deadbeat current control in which motor armature voltage command is computed from a dc-link current reference, an actual current and counter emf voltage. The simulation results show that the proposed method reduces the torque ripple significantly.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1995년도 추계학술대회 논문집 학회본부
• /
• pp.342-344
• /
• 1995

Using piezoresistive effects of single-crystal and poly-crystalline silicon, pressure sensors of the same pattern were fabricated for comparison of temperature characteristics. Optimum size and aspect ratio of rectangular sensor diaphragm were calculated by FEM. For polsilicon pressure sensor, polysilicon resistors of Wheatstone bridge were deposited by LPCVD to be used in a wide' temperature range. Polysilicon pressure sensors showed more stable temperature characteristics than single-crysta1 silicon in the range of $-20\sim125[^{\circ}C]$. To get low TCO (Temperature Coefficient of Offset), below $\pm$3 [${\mu}V/V/^{\circ}C$], it is needed for each TCR of piezoresistors to have a deviation within $\pm25[ppm/^{\circ}C]$ less than $\pm500[ppm/^{\circ}C]$ of resistors for polysilicon pressure sensor can result in low TCS(Temperature Coefficient of Sensitivity) of -0.1[%FS/$^{\circ}C$].

• 소음진동
• /
• 제10권6호
• /
• pp.941-948
• /
• 2000

Active noise control is an approach to reduce the noise by utilizing a secondary noise source that destructively interferes with the unwanted noise. In general, active noise control systems rely on multiple sensors to measure the unwanted noise field and the effect of the cancellation. This paper develops an approach that utilizes a single sensor. The noise field is modeled as a stochastic process, and an adaptive algorithm is used to adaptively estimate the parameters of the process. Based on these parameter estimates, a canceling signal is generated. Oppenheim assumed that transfer function characteristics from the canceling source to the error sensor is only a propagation delay. This paper proposes a modified Oppenheim algorithm by considering transfer characteristics of speaker-path-sensor This transfer characteristics is adaptively cancelled by the proposed adaptive modeling technique. Feasibility of the proposed method is proved by computer simulations with artificially generated random noises and sine wave noise. The details of the proposed architecture. and theoretical simulation of the noise cancellation system for three dimension enclosure are presented in the Paper.

• 한국멀티미디어학회논문지
• /
• 제6권7호
• /
• pp.1131-1138
• /
• 2003

능동소음제어는 원치 않는 소음에 대하여 2차 소음으로 상쇄 간섭을 발생시켜 소음을 제거하는 방법이다. 일반적으로 능동소음제어기의 성능은 2차 소음이 주 소음을 얼마나 잘 추정하는가에 따라 결정된다. 2차 소음은 스피커를 통해 발생되며 마이크를 통해 오차 신호를 수음한다. 일반적으로 스피커와 마이크의 전달특성은 이상적이지 못하기 때문에 신호를 왜곡시켜 능동소음제어기의 성능이 저하된다. 본 논문에서는 스피커와 마이크의 전달특성을 고려한 단일센서 능동소음제어기를 제안한다. 스피커와 마이크의 전달특성에 의한 2차 소음의 왜곡을 줄이기 위하여 적응 역모델링 기법으로 전달 특성을 추정하고 주 소음은 Kalman필터를 이용하여 추정한다. 실험을 통하여 제안하는 단일센서 능동소음제어기가 효과적으로 소음을 감쇠시킴을 보인다.

• Journal of Power Electronics
• /
• 제11권6호
• /
• pp.837-845
• /
• 2011

This paper proposes phase current reconstruction techniques for two-phase two-leg and two-phase four-leg inverters using a single current sensor. In the proposed methods, one phase current is sampled simultaneously with a particular branch current by using only one current sensor, and then current reconstruction algorithms are applied to extract the information on two phase currents from the sensor output. The sampled current information is periodically updated at the peak and the valley of the triangular carrier waveform in each switching cycle of pulse-width modulation (PWM). The voltage vector spaces where the phase currents can be reconstructed are evaluated. Compared to the existing method using two individual current sensors in two phases, the proposed schemes can save implementation cost since it is possible to remove one current sensor. In addition, the proposed methods are free from gain discrepancy issues between two current sensors. Simulations and experiments show excellent current reconstruction performance of the proposed methods.

• International Journal of Naval Architecture and Ocean Engineering
• /
• 제6권1호
• /
• pp.74-86
• /
• 2014

The optimization techniques are explored in the direction of arrival (DOA) estimation based on single acoustic pressure gradient vector sensor (APGVS). By analyzing the working principle and measurement errors of the APGVS, acoustic intensity approaches (AI) and the minimum variance distortionless response beamforming approach based on single APGVS (VMVDR) are deduced. The radius to wavelength ratio of the APGVS must be not bigger than 0.1 in the actual application, otherwise its DOA estimation performance will degrade significantly. To improve the robustness and estimation performance of the DOA estimation approaches based on single APGVS, two modified processing approaches based on single APGVS are presented. Simulation and lake trial results indicate that the performance of the modified approaches based on single APGVS are better than AI and VMVDR approaches based on single APGVS when the radius to wavelength ratio is not bigger than 0.1, and the two modified DOA estimation methods have excellent estimation performance when the radius to wavelength ratio is bigger than 0.1.