• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 1996년도 춘계 학술대회논문집
• /
• pp.58-67
• /
• 1996

This paper describes some computational results of various energy and environmental systems using Patankar's SIMPLE method. The specific topics handled in this study are jet bubbling reactor for flue gas desulfurization, cyclone-type afterburner for incineration, 200m tall stack for 500 MW electric power generation, double skin and heat storage systems of building energy saving for the utilization of solar heating, finally turbulent combustion systems with liquid droplet or pulverized coal particle. A control-volume based finite-difference method with the power-law scheme is employed for discretization. The pressure-velocity coupling is resolved by the use of the revised version of SIMPLE, that is, SIMPLEC. Reynolds stresses are closed using the standard $k-{\varepsilon}$ and RNG $k-{\varepsilon}$ models. Two-phase turbulent combustion of liquid drop or pulverized coal particle is modeled using locally-homogeneous, gas-phase, eddy breakup model. However simple approximate models are incorporated for the modeling of the second phase slip and retardation of ignition without consideration of any detailed particle behavior. Some important results are presented and discussed in a brief note. Especially, in order to make uniform exit flow for the jet bubbling reactor, a well-designed structure of distributor is needed. Further, the aspect ratio in the double skin system appears to be one of important factors to give rise to the visible change of the induced air flow rate. The computational tool employed in this study, in general, appears as a viable method for the design of various engineering system of interest.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2003년도 제20회 춘계학술대회 논문집
• /
• pp.141-144
• /
• 2003

액체로켓엔진의 연소불안정을 해석하기 위해 Euler-Lagrange 방법을 사용하여 간단한 분무연소를 해석하였다. 2차 축대칭좌표계에서 가스 온도와 액적 궤도, 액적 반지름을 구하였고 Euler-Lagrange 방법이 액적의 궤도, 액적의 크기와 주위 가스의 온도분포의 경향성을 잘 나타내는 것을 검증하였다.

• 대한전기학회논문지:시스템및제어부문D
• /
• 제49권6호
• /
• pp.299-306
• /
• 2000

The primary cause of air pollution by vehicles is imperfect combustion of fuel. One of the most usual causes of this imperfect combustion is the misfire in IC(Intenal Combustion) engine. Recently it is obligated for an ECU to monitor the emission level and warn the driver in case of exceeding specified emission standards. Therefore, in order to comply with this OBD-II regulations, car makers are investing a considerable amount into technology which would enable the detection of misfire and the particular cylinder in which misfire is taking place. So far, it has been able to detect misfire using engine speed, which can be obtained crank angle. However, such a method posed a problem in analyzing at high speed and in recognizing the misfire from the load impact at bumpy road. In this paper, misfire detection is made possible by simple arithmetic using WDFT, especially at high engine speed. In addition, the moving window method of a Walsh function is applied to determine the cylinders under misfire in case of multiple misfires. An actual experiment was conducted to prove that WDFT is applicable to effective in computation speed and to same result in misfire detection and cylinder determination at idle, part load and bumpy road conditions.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2015년도 제51회 KOSCO SYMPOSIUM 초록집
• /
• pp.247-250
• /
• 2015

The characteristics of opposed nonpremixed tubular flames with radiation heat loss are investigated using linear stability analysis and 2-D numerical simulations. Two extinction limits, as the $Damk{\ddot{o}}hler$ number is small or large, are confirmed using finite difference method with a simple continuation method. It is verified that the results of linear stability analysis predict the number of flame cells and the critical Da starting cellular instability or amplification of temperature near both extinction limits with good resolution.

• 한국추진공학회지
• /
• 제23권3호
• /
• pp.88-95
• /
• 2019

수소 토치 점화 시스템은 순수한 알루미늄을 이용하여 점화가 가능하고 점화 방법이 간단해 알루미늄 연소 시스템으로 많이 사용되고 있다. 하지만 기존의 수소 토치 점화 시스템은 수소 공급을 위해 고압의 수소탱크가 필요해 무게가 무거워지는 단점이 있다. 이러한 문제를 해결하기 위해 본 연구에서는 고체 화학수소화물인 $NaBH_4$를 이용한 수소 점화 시스템을 설계하였다. $NaBH_4$는 약 $500^{\circ}C$에서 열분해가 시작되고 수소가 발생한다. $NaBH_4$ 열분해 특성에 영향을 미치는 변인들을 분석하고, $NaBH_4$ 기반 수소 점화 시스템을 이용해 알루미늄 연소 실험을 수행하여 실제 시스템 적용 가능성에 대해 검증 하였다.

• Journal of Mechanical Science and Technology
• /
• 제17권3호
• /
• pp.357-369
• /
• 2003

Electromagnetic valve (EMV) actuation system is a new technology for improving fuel efficiency and at the same time reducing omissions in internal combustion engines. It can provide more flexibility in valve event control compared with conventional variable valve actuation devices. The electromagnetic valve actuator must be designed by taking the operating conditions and engine geometry limits of the internal combustion engine into account. To help develop a simple design method, this paper presents a procedure for determine the basic design parameters and dimensions of the actuator from the relations of the valve dynamics, electromagnetic circuit and thermal loading condition based on the lumped method. To verify the accuracy of the lumped method analysis, experimental study is also carried out on a prototype actuator. It is found that there is a relatively good agreement between the experimental data and the results of the proposed design procedure. Through the whole speed range, the actuator maintains proper performances in valve timing and event control.

• 전기화학회지
• /
• 제13권4호
• /
• pp.264-269
• /
• 2010

$LiNi_{0.5}Mn_{0.3}Co_{0.2}O_2$의 리튬이온 이차전지 양극 물질로의 특성을 연구하기 위해서 단순 연소합성법을 이용하여 합성했다. 합성된 물질의 구조적 특징을 분석하기 위하여 X-선 회절분석(XRD)과 주사전자현미경 (FE-SEM)을 측정하였다. X-선 회절분석을 통하여 합성된 $LiNi_{0.5}Mn_{0.3}Co_{0.2}O_2$시료가 육방정계 층상구조가 형성된 것을 확인하였다. FE-SEM을 통해 측정한 결과 $LiNi_{0.5}Mn_{0.3}Co_{0.2}O_2$ 입자는 일정한 형태를 가지지 않았으며 크기는 대략 100~300 nm의 크기임을 확인할 수 있었다. 그리고 전기화학적 특성을 측정하기 위하여 충 방전 용량 측정과 CV(Cyclic Voltammetry)를 측정하였다. 2.8 V에서 4.3 V까지 충 방전 용량을 측정한 결과 ~162 mAh/g의 초기 방전 용량을 가졌다.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2001년도 제23회 KOSCO SYMPOSIUM 논문집
• /
• pp.35-41
• /
• 2001

A second-order conditional moment closure(CMC) model is applied to the prediction of local extinction in a turbulent hydrocarbon diffusion flame and compared with direct numerical simulation(DNS) results for the flame. Combustion of a hydrocarbon fuel is described by a simple two-step mechanism. A second-order correction for conditional mean reaction rate terms is made by the assumed pdf method. The results show that the second-order closure is necessary for accurate prediction of intermediate species, while first-order CMC gives good predictions for fuel, oxidant, product and temperature. Conditional variances and covariances are well predicted during an extinction process while they are overpredicted during a reignition process.

• 한국연소학회지
• /
• 제20권4호
• /
• pp.42-48
• /
• 2015

This study was investigated the estimation of VOCs (Volatile Organic Compounds) emission from a gas station tank. To improve the atmosphere environmental quality near the gas station, the installation of vapor recovery system has been expanded recently. Therefore, it was necessary to calculate VOCs emissions from the gas station tank with vapor recovery systems for evaluation of their performance. The VOCs emissions are difficult to measure directly because of various sources and irregularly emission by pressure rise. In this study, VOCs emissions were estimated by simple calculation based on the equation of state for measured pressure, temperature and volume of a gasoline tank at a gas station. The result confirmed that the present national emission factor did not have significant discrepancy with the calculated value.

• Applied Biological Chemistry
• /
• 제18권2호
• /
• pp.56-60
• /
• 1975

완두유묘의 자엽 및 뿌리조직중 탄소-14 방사능을 Liquid scintillation counter로 신속히 측정하는 새로운 방법에 관하여 실험하였다. 식물조직을 액체공기에 처리하여 분쇄한 다음 Gel phosphor에 헌탁시켜, Liquid scintillation counter로 측정하였다. 이시료에 다시 내부표준물질을 가한 다음 계측효율을 구하여 Apparent absolute activity를 얻었다. 이렇게 얻은 헌탁시료의 절대방사능은 자기 흡수현상 때문에, 따로 Flask combustion 방법으로 구한 절대방사능 보다는 낮았으나, 항상 비례하였다. 따라서 동일한 실험조건하에서 상술한 비율을 얻으면, 완두조직중 탄소-14의 점대방사능은, 비교적 간편한 헌탁측정(suspension counting) 만으로 가능하였다. 본방법은 완두 외에 다른 식물조직중 탄소-14 분석에도 쓰일 수 있다.