• Bulletin of the Korean Chemical Society
• /
• v.11 no.4
• /
• pp.286-290
• /
• 1990

The surface enhanced Raman scatterings of Zn(Ⅱ) tetrakis (4-N-methyl pyridyl) porphyrins were studied in silver sol. Zn(Ⅱ) tetrakis (4-N-methyl pyridyl) porphyrin was found to be adsorbed on silver surface via flat-on geometry with some inhomogeneous distribution in the orientation of pyridyl groups. Both the selective enhancement of Raman modes depending on the mode character and the theoretical arguments of SERS are utilized to support the above conclusion. The surface induced substitution reaction of Mn(Ⅲ) tetrakis (4-N-methyl pyridyl) porphyrin chloride to Ag(Ⅱ) tetrakis (4-N-methyl pyridyl) porphyrin was detected via surface enhanced Raman spectrum.

• Membrane Journal
• /
• v.31 no.5
• /
• pp.293-303
• /
• 2021

Separation membranes used in water filtration, protein purification or biomedical filtration device frequently undergo membrane fouling for several reasons. The formation of biofilm on the membrane surface by bacteria causes a severe problem for durability of the membrane. For the protein separation, the membrane pores get blocked due to surface hydrophobicity of the membrane. There are several approaches controlling the membrane fouling and one of them is the incorporation of silver nanoparticles. Antibacterial properties of silver nanoparticles are well known and thus widely used in several applications. In this review, we have focused on the membranes where silver nanoparticles or its derivatives are either incorporated in the active layer of thin film composite membranes or uniformly distributed throughout the whole membranes.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2004.05a
• /
• pp.83-83
• /
• 2004

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2005.05a
• /
• pp.305-305
• /
• 2005

• Journal of the Korean Electrochemical Society
• /
• v.5 no.1
• /
• pp.1-6
• /
• 2002

Silver doped vanadium pentoxides with a doping ratio Ag/V ranging from 0.03 to 0.11 were synthesized by sol-gel process, and $Li/Ag_xV_2O_5$ cell was investigated by the electrochemical methods. It appears to be amorphous layered material and entangled fibrous textures has been grown to form anisotropic corrugated fibrils. NMR measurements revealed that several different kinds of $Li^+$ ions exist in the lithium intercalated xerogel electrodes and the average cell potential was about 3.0V vs. $Li/Li^+$. The cell capacity of the silver doped $Ag_xV_2O_5$ xerogel cathodes was more than 359 mAh/g at discharge current 10mA/g and cycle efficiency $94\%$ was achieved.

• Journal of the Korean Ceramic Society
• /
• v.44 no.7
• /
• pp.343-348
• /
• 2007

Alumina/silver nanocomposites were fabricated using a soaking method through a sol-gel route to construct an intra-type nanostructure. The pulse electric-current sintering (PECS) technique was used to sinter the nanocomposites. Several specimens were annealed after sintering. The microstructure, mechanical properties, critical frontal process zone (FPZ) size, and thermo-mechanical properties of the nanocomposites were estimated. The relative densities of the specimens sintered at 1350 and $1450^{\circ}C$ were 95% and 99%, respectively. The maximum value of the three-point bending strength was found to be 780 MPa for the $2{\times}2{\times}10 mm$ specimen sintered at $1350^{\circ}C$. The fracture toughness of the specimen sintered at $1350^{\circ}C$ was measured to be $3.60 MPa{\cdot}m^{1/2}$ using the single-edge V-notched beam (SEVNB) technique. The fracture mode of the nanocomposites was transgranular, in contrast to the intergranular mode of monolithic alumina. The fracture morphology suggested that dislocations were generated around the silver nanoparticles dispersed within the alumina matrix. The specimens sintered at $1350^{\circ}C$ were annealed at $800^{\circ}C$ for 5 min, following which the maximum fracture strength became 810 MPa and the fracture toughness improved to $4.21 MPam^{1/2}$. The critical FPZ size was the largest for the specimen annealed at $800^{\circ}C$ for 5 min. Thermal conductivity of the alumina/silver nanocomposites sintered at $1350^{\circ}C$ was 38 W/mK at room temperature, which was higher than the value obtained with the law of mixture.

• Restorative Dentistry and Endodontics
• /
• v.45 no.2
• /
• pp.23.1-23.12
• /
• 2020

Objectives: This study aimed to summarize the outcome of in vitro studies comparing the antibacterial effectiveness of QMix with other irrigants against Enterococcus faecalis. Materials and Methods: The research question was developed by using population, intervention, comparison, outcome, and study design framework. The literature search was performed using 3 electronic databases: PubMed, Scopus, and EBSCOhost until October 2019. The additional hand search was performed from the reference list of the eligible studies. The risk of bias of the studies was independently appraised using the revised Cochrane Risk of Bias tool (RoB 2.0). Results: Fourteen studies were included in this systematic review. The overall risk of bias for the selected studies was moderate. QMix was found to have a higher antimicrobial activity compared to 2% sodium hypochlorite (NaOCl), 17% ethylenediaminetetraacetic acid (EDTA), 2% chlorhexidine (CHX), mixture of tetracycline isonomer, an acid and a detergent (MTAD), 0.2% Cetrimide, SilverSol/H2O2, HYBENX, and grape seed extract (GSE). QMix had higher antibacterial efficacy compared to NaOCl, only when used for a longer time (10 minutes) and with higher volume (above 3 mL). Conclusions: QMix has higher antibacterial activity than 17% EDTA, 2% CHX, MTAD, 0.2% Cetrimide, SilverSol/H2O2, HYBENX, GSE and NaOCl with lower concentration. To improve the effectiveness, QMix is to use for a longer time and at a higher volume.

• Journal of Korean Ophthalmic Optics Society
• /
• v.4 no.1
• /
• pp.51-56
• /
• 1999

$TiO_2$ thin films were spin coated on commercial Nickel-Silver with 2%Ti-naphthanate toluene solution by sol-gel process. The thin films were heat-treated at $500^{\circ}C$ for 2min and then decorative-protective coating was obtained. The conditions for gold colored coating, and the morphology, microstructure and color of the coating surface were have been characterized by Optical microscope, Photospectrometer and XRD. The heating temperature of colored-$TiO_2$ coating was $500^{\circ}C$ and was preferable. The average thickness of 1 time coating was $0.24{\mu}m$ and the total thickness increased linearly as a function of the coating time. The color of amorphous colored-$TiO_2$ coating was changed from gold to dark redish gold with coating time. 'L' as lightness and 'b' were decreased to red, but 'a' was decreased to blue after increase with coating time.

• Korean Journal of Materials Research
• /
• v.24 no.12
• /
• pp.671-676
• /
• 2014

It is known that bones get damaged by accidents and aging. Since the discovery of Bioglass, various kinds of ceramics have been also found to bond to living bone; some of these ceramics are already being clinically used as bone-repairing materials. In the present study, antibacterial calcium silicate gel ($Ag-30CaO{\cdot}70SiO_2$ gel) was prepared by sol-gel method in order to control the microstructure, which is related to the dissolution rate and induction period of apatite formation in body environment. In addition, biological $Ag-30CaO{\cdot}70SiO_2$ is tested. This was done to impart antimicrobial activity to the $30CaO{\cdot}70SiO_2$. Ag ion was added during sol-gel synthesis to replace the $H_2O$ added during the making of the $30CaO{\cdot}70SiO_2$ gel, which has silver solutions of various concentration. After the sol-gel process, 1N-$HNO_3$ solution was used to wash the gel when synthesizing the gel, in order to maintain the porous structure and remove PEG, water soluble polymers. Then, the apatite forming ability of the sol-gel derived CaO-$SiO_2$ gels was investigated using simulated body fluid (SBF), which had almost the same ion concentration as that of human blood plasma. The gels were analyzed by FT-IR spectroscopy, SEM observation, XRD, and fluorescent microscopy. The apatite was successfully created even after washing the gel; apatite is present in an amorphous state, and was found to affect the concentration of the Ag ion in cells in MC3T3 live & dead assay results. From these results, it is suggested that a good material that can be used to repair defects of nature bone is $Ag-30CaO{\cdot}70SiO_2$ gel.

• Bulletin of the Korean Chemical Society
• /
• v.32 no.11
• /
• pp.3861-3864
• /
• 2011

Rhodamine B dye (RB) has been introduced into the mesoporous silica (SBA15) and Ag anchored mesoporous silica by applying solution impregnation method. Surface treatment of SBA15 with 3-aminopropyltrimethoxysilane (APTMS) facilitates selective anchoring of the RB molecules on SBA15. The photoluminescence spectra of RB confined within SBA15 indicates higher emission intensity, than that of the RB solid, particularly in the presence of Ag nanoparticles. The significant enhancement in photoluminescence intensity is attributed to the local enhancement of the optical fields near the molecules by interactions with silver plasmons.