• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.9A
• /
• pp.991-997
• /
• 2004

In this paper, we propose the architecture of modem receiver to fabricate HomePNA 2.0 chip. HomePNA suffers from inferior channel because of bridge tap, the effect of amateur HAM band and so on. To transfer data over such channel, HomePNA 2.0 uses training sequence to equalize channel and uses FD-QAM optionally as modulation method. So modem receiver demodulate QAM based signal and needs optimum architecture that fully uses these transmission feature. As a result of research, we define 2 mode function of modem receiver depending on TX/RX state. In this paper, particularly, we show the algorithm of equalizer, carrier phase recovery and frame synchromzationblock and propose architecture that improve the performance of channel equalization and is stable in operation. In the end, we estimate the performance of proposed HomePNA2.0 modem receiver over HomePNA TEST LOOP using SPW program.

• Journal of radiological science and technology
• /
• v.38 no.4
• /
• pp.429-435
• /
• 2015

The purpose of this study was to prospectively estimate the effectiveness of multi-transmit parallel technique in reduced FOV(Field of View) less than 26 cm. Homogeneity, SNR(signal to noise ratio) and acquisition time were measured and compared by setting FOV less than 26cm on the T1 and T2 weighted images using ACR phantom. The multi-transmit parallel technique resulted in significantly faster image acquisition by 46.8 % in T1 weighted images and 18.9% in T2 weighted images. The homogeneity and SNR values had no significant difference between pre and post application of the multi-transmit parallel technique. In conclusion, this study demonstrates the feasibility of multi-transmit parallel technique in FOV less than 26cm with a rapid acquisition and maintained image quality.

• Journal of Communications and Networks
• /
• v.9 no.4
• /
• pp.446-456
• /
• 2007

Increased access to broadband networks has led to a fast-growing demand for voice and video over IP(VVoIP) applications such as Internet telephony(VoIP), videoconferencing, and IP television(IPTV). For pro-active troubleshooting of VVoIP performance bottlenecks that manifest to end-users as performance impairments such as video frame freezing and voice dropouts, network operators cannot rely on actual end-users to report their subjective quality of experience(QoE). Hence, automated and objective techniques that provide real-time or online VVoIP QoE estimates are vital. Objective techniques developed to-date estimate VVoIP QoE by performing frame-to-frame peak-signal-to-noise ratio(PSNR) comparisons of the original video sequence and the reconstructed video sequence obtained from the sender-side and receiver-side, respectively. Since processing such video sequences is time consuming and computationally intensive, existing objective techniques cannot provide online VVoIP QoE. In this paper, we present a novel framework that can provide online estimates of VVoIP QoE on network paths without end-user involvement and without requiring any video sequences. The framework features the "GAP-model", which is an offline model of QoE expressed as a function of measurable network factors such as bandwidth, delay, jitter, and loss. Using the GAP-model, our online framework can produce VVoIP QoE estimates in terms of "Good", "Acceptable", or "Poor"(GAP) grades of perceptual quality solely from the online measured network conditions.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.33 no.9
• /
• pp.89-96
• /
• 2005

This paper discusses the daytime atmospheric conditions and the possibility of daytime star detection with the purpose of practical use of the star sensor for daylight navigation. In order to estimate the daytime atmospheric data, we use the standard atmospheric model (LOWTRAN 7), from which atmospheric transmittance and radiance from background sky are calculated. Assuming the star sensor with an optical filter to reduce background radiation, different separation angles between the star sensor and the sun are set up to express the effect of the solar radiation. As considerations of field of view (FOV) of the star sensor, the variation of the sky background radiation and the star density of the detectable star are analyzed. In addition, the integration time to achieve a required signal-to-noise ratio and the number of the radiation-caused electrons of the charge coupled detector(CCD) working as the limit to daylight application of the star sensor are calculated.

• The Journal of the Acoustical Society of Korea
• /
• v.21 no.7
• /
• pp.665-670
• /
• 2002

The most common form of pre-emphasis is y(n)=s(n)-As(n-1), where A typically lies between 0.9 and 1.0 in voiced signal. Also, this value reflects the degree of pre-emphasis and equals R(1)/R(0) in conventional method. This paper proposes a new flattening method to compensate the weaked high frequency components that occur by vocal cord characteristic. We used interval information of LSP to estimate formant frequency, After obtaining the value of slope and inverse slope using linear interpolation among formant frequency, flattening process is followed. Experimental results show that the proposed method flattened the weaked high frequency components effectively. That is, we could improve the flattening characteristics by using interval information of LSP as flattening factor at the process that compensates weaked high frequency components.

• The Journal of the Acoustical Society of Korea
• /
• v.32 no.2
• /
• pp.116-123
• /
• 2013

This paper represents generation of time-varying underwater acoustic channels by performing scattering simulation with time-varying ocean surface and Kirchhoff approximation. In order to estimate the time-varying ocean surface, 1D Pierson-Moskowitz ocean power spectrum and Gaussian correlation function were used. The computed scattering coefficients are applied to the amplitudes of each impulse of BELLHOP simulation result. The scattering coefficients are then compared with measured doppler spectral density of signal components which were scattered from ocean surface and the correlation time used in the Gaussian correlation function was estimated by the comparison. Finally, bit-error-rate and channel correlation simulations were performed with the generated time-varying channel based on passive time-reversal communication scenario.

• Journal of Communications and Networks
• /
• v.15 no.3
• /
• pp.312-320
• /
• 2013

Home evolved Node-B (HeNB), also called a femtocell or a femto base station, is introduced to provide high data rate to indoor users. However, two main problems arise in femtocell networks: (1) Small coverage area of HeNB, which results in limited cell-splitting gain and ping-pong handover (HO) problems and (2) high inter-femtocell interference because HeNBs may be densely deployed in a small region. In this study, an efficient cooperation mechanism called an HeNB-aided virtual-HO (HaVHO) scheme is proposed to expand the coverage area of femtocells and to reduce inter-femtocell interference. The cooperation among neighbor HeNBs is exploited in HaVHO by enabling an HeNB to relay the data of its neighbor HeNB without an HO. The HaVHO procedure is compatible with the existing long term evolution specification, and the information exchange overhead in HaVHO is relatively low. To estimate the signal to interference plus noise ratio improvement, the area average channel state metric is proposed, and the amount of user throughput enhancement by HaVHO is derived. System-level simulation shows that HaVHO has a better performance than the other four schemes, such as lesser radio link failure, lesser ping-pong handover, lesser short-stay handover, and higher user throughput.

• Journal of the Korea Society for Simulation
• /
• v.29 no.2
• /
• pp.21-33
• /
• 2020

This study develops a simulator for determining the sonar sensor configuration of unmanned underwater vehicles (UUVs) based on a scenario, in order for UUVs to conduct an effective anti-submarine warfare (ASW). First, we analyze the missions and operational concepts of UUVs in the field of ASW, and then select a Hold-at-Risk scenario as the one with the highest priority. Next, for modeling the components of a simulator, the motion, acoustic characteristic, and environment condition of the platforms (UUV and target submarine) are specified. Especially, based on the beam pattern of each sonar configuration considered in this paper, the passive sonar equation is used to verify target detection, and we further estimate the azimuth and elevation of the target using amplitude and phase of the received signal, respectively. The simulation results show the performance tendency depending on the sonar sensor configurations of a UUV, and the simulator provides a high applicability under various scenarios.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.45 no.5
• /
• pp.95-102
• /
• 2008

This paper presents an appropriate approach for modeling noise in Computed Radiography(CR) images of high strength materials. The approach is specifically designed for types of noise with the statistical and nonlinear properties. CR images Ere degraded even before they are encoded by computer process. Various types of noise often contribute to contaminate radiography image, although they are detected on digitalization. Quantum noise, which is Poisson distributed, is a shot noise, but the photon distribution on Image Plate(IP) of CR system is not always Poisson process. The statistical properties are relative and case-dependant due to its material characteristics. The usual assumption of a distribution of Poisson, binomial and Gaussian statistics are considered. Nonlinear effect is also represented in the process of statistical noise model. It leads to estimate the noise variance in regions from high to low intensity, specifying analytical model. The analysis approach is tested on a database of steel tube step-wedge CR images. The results are available for the comparative parameter studies which measure noise coherence, distribution, signal/noise ratios(SNR) and nonlinear interpolation.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2013.10a
• /
• pp.851-853
• /
• 2013

Recently, location-based service as the developed continuously, interest in positioning technology is increasing. As the most famous indoor positioning technology, WPS is a positioning technology using WiFi, which can complement the limits of the indoor positioning to have a GPS. In this paper, to provide a system for monitoring the position of the inside of the user based on the position information that using the RSSI signal of the wireless AP based WPS technology, they grip the location information of the mobile nodes in the indoor. If using the method proposed, it is expected to be applied to various services it is possible to apply the WPS, this is because it is possible to estimate in real time the location distribution of mobile nodes in the indoor.