• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.1
• /
• pp.232-238
• /
• 2013

This paper study the position estimation of MBK system according to the non-linear filter for non-Gaussian noise in underwater sensor networks. In the filter to estimate location, recently, the extended Kalman filter (EKF) and particle filter are getting attention. EKF is widely used due to the best algorithm in the Gaussian noise environment, but has many restrictions on the usage in non-Gaussian noise environment such as in underwater. In this paper, we propose the improved One-Dimension Particle Filter (ODPF) using the distribution re-interpretation techniques based on the maximum likelihood. Through the simulation, we compared and analyzed the proposed particle filter with the EKF in non-Gaussian underwater sensor networks. In the case of both the sufficient statistical sample and the sufficient calculation capacity, we confirm that the ODPF's result shows more accurate localization than EKF's result.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.18 no.1
• /
• pp.129-134
• /
• 2018

Research on the technique for estimating the indoor position has been actively carried out. In particular, the WiFi fingerprint method, which does not require any additional infrastructure, is being partially used because of its high economic efficiency. The KNN method which estimates similar points to the corresponding points by comparing intensity information of the WLAN reception signal measured at various points in advance with intensity information measured at a specific point in the future is simple but has a good performance. However, in the conventional KNN scheme, since the number K of average candidate positions is constant, there is a problem that the position estimation error is not optimized according to a specific point. In this paper, we proposed an algorithm that adaptively changes the K value for each point and applied it to experimental data and evaluated its performance.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.11
• /
• pp.2541-2546
• /
• 2013

In this paper, we proposed on the azimuth correction method for a line-of-sight data-link tracking antenna system. Tracking antenna system is essential to maintain line-of-sight between moving object and data-link equipment. In order to calculate the azimuth and elevation between the moving object and antenna system, we used GPS data. also to match the each coordinate systems, we used geomagnetic sensor or beacon. However, the geomagnetic disturbance-prone terrain in places difficult to correct calibration. The first step, finds the location of the strongest RF signal, we should remember the difference between the reference point and the detected position of the antenna. The second step, we could communicate each other. And the azimuth angle is calculated by GPS values. Despite the geomagnetic interference, we can correct the azimuth angle quickly and easily.

• The KIPS Transactions:PartB
• /
• v.11B no.3
• /
• pp.247-256
• /
• 2004

In this paper, we propose the prediction search algorithm for block matching using the temporal/spatial correlation of the video sequence and the renter-biased property of motion vectors The proposed algorithm determines the location of a better starting point for the search of an exact motion vector using the point of the smallest SAD(Sum of Absolute Difference) value by the predicted motion vector from the same block of the previous frame and the predictor candidate pint in each search region and the predicted motion vector from the neighbour blocks of the current frame. And the searching process after moving the starting point is processed a adaptive search pattern according to the magnitude of motion vector Simulation results show that PSNR(Peak-to-Signal Noise Ratio) values are improved up to the 0.75dB as depend on the video sequences and improved about 0.05∼0.34dB on an average except the FS (Full Search) algorithm.

• Journal of Communications and Networks
• /
• v.12 no.2
• /
• pp.103-113
• /
• 2010

In this paper, a tradeoff between the total energy consumption-per-bit and the end-to-end rate under spatial reuse in wireless multi-hop network is developed and analyzed. The end-to-end rate of the network is the number of information bits transmitted (end-to-end) per channel use by any node in the network that is forwarding the data. In order to increase the bandwidth efficiency, spatial reuse is considered whereby simultaneous relay transmissions are allowed provided there is a minimum separation between such transmitters. The total energy consumption-per-bit includes the energy transmitted and the energy consumed by the receiver to process (demodulate and decoder) the received signal. The total energy consumption-per-bit is normalized by the distance between a source-destination pair in order to be consistent with a direct (single-hop) communication network. Lower bounds on this energy-bandwidth tradeoff are analyzed using convex optimization methods. For a given location of relays, it is shown that the total energy consumption-per-bit is minimized by optimally selecting the end-to-end rate. It is also demonstrated that spatial reuse can improve the bandwidth efficiency for a given total energy consumption-per-bit. However, at the rate that minimizes the total energy consumption-per-bit, spatial reuse does not provide lower energy consumption-per-bit compared to the case without spatial reuse. This is because spatial reuse requires more receiver energy consumption at a given end-to-end rate. Such degraded energy efficiency can be compensated by varying the minimum separation of hops between simultaneous transmitters. In the case of equi-spaced relays, analytical results for the energy-bandwidth tradeoff are provided and it is shown that the minimum energy consumption-per-bit decreases linearly with the end-to-end distance.

• KSBB Journal
• /
• v.11 no.4
• /
• pp.420-430
• /
• 1996

One-step immuno-chromatography assay system for heat-killed Salmonella typhimurium antigens was developed. Three major components used were a glass fiber membrane (placed at the bottom of the system) with an antibody (specific to the analyse, detection antibody)-gold conjugate deposited in a dry state on the surface, a nitrocellulose membrane (middle) with an antibody (also, specific to the analyse but recognized different epitome: capture antibody) and anti-detection antibody immobilized in spatially separated areas, and a cellulose membrane (top) as absorption pad. These membranes were partially superimposed such that a wicking of aqueous solution containing sample can continuously take place through membranes. Variables that affected the system performance were the concentration of capture antibody, the location on the membrane, inert protein used for blocking of the membrane and for carrying the sample, and the concentration of the gold conjugate. Under optimal conditions, within 15 minutes after absorption of a sample solution from the bottom of the system antigen-antibody complexes of sandwich type were formed on the membrane surface area with immobilized capture antibody and a color signal was generated in proportion to the analyse concentration. The minimum do tection limit of the analyse was $1{\times}106$ Salmonella cells/mL.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.9
• /
• pp.821-827
• /
• 2015

Electromagnetic waves which are emitted from the Sun due to solar flare explosion can cause failures in HF radio communications in the day-side area of the Earth, that is so-call as Radio Blackouts. The international scale representing the severity of the Radio Blackouts is determined by the solar X-ray flux which is measured by United States Geostationary Operational Environmental Satellite. However, the scale is not always applicable to HF communication users in the different area on the Earth, because the HF communication effects depend not only on the X-ray strength but also on the subsolar point location. To solve this problem, we developed a HF radio spectrum monitoring system utilizing a spectrum analyzer. This system conducts a real-time measure of the HF spectrum, and automatically calculates signal to noise ratios and the occurrences of the HF blackouts as comparing with the interference level which is described from the ITU recommendation.

• The Journal of the Korean bone and joint tumor society
• /
• v.9 no.2
• /
• pp.212-216
• /
• 2003

A Common peroneal nerve palsy caused by ganglionic cyst is very rare condition but well recognised entities. There have been three previous reports describing the magnetic resonance image (MRI) findings of peroneal nerve entrapment due to a ganglionic cyst. Ultrasonography, MRI, and electromyography (EMG), nerve conduction velocity (NCV), and microscopic examination were taken for diagnosis. A tubular structure near the fibular neck extending longitudinally over several slices with an inferior extension towards the superior tibiofibular joint with high T2 signal intensity was characteristic. The peroneal nerve was exposed and the ganglionic cyst was excised. The nerve was paralysed immediately after operation, but at 4 month after operation, started recovery of the function gradually and has recovered completely at 7 month. MRI is helpful to detect the extent, location, and origin of the cyst. Meticulous surgical excision can provide favorable result.

• The Journal of the Acoustical Society of Korea
• /
• v.16 no.6
• /
• pp.76-84
• /
• 1997

Loose parts monitoring system(LPMS), which is used to detect metallic loose parts in the nuclear power plant, plays an important role in safe and reliable operation of the plant. To prevent from the damage due to the loose parts, most domestic nuclear power plants are using, or planning to use LPMS. However, these LPMS's, which are all invented from overseas and thereby depend on the oversea technologies, are very expensive, and are known to be inefficient to diagnose loose parts due to the lack of fundamental know-how of LPMS. Therefore, the main purpose of this paper is to propose and to realize a new loose parts localization algorithm which is simple and efficient enough even for the inexperienced operators to diagnose loose parts accurately and promptly. Considering practical nuclear power plant circumstances, some simulations for estimating the loose parts location have been done. The results show that the proposed method, called a modified circle intersection method, performs high resolved loose parts localization with 3.4% of error.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.14 no.1
• /
• pp.119-124
• /
• 2014

In this paper, A GSm/WCDMA band antenna which can be confirmed positioning information of a container by using the GPS/GLONASS bands on one board and can be sent the positioning information to the mobile communication network in real time is designed. A microstrip patch antennas which supports dual-band (GPS and GLONASS) was optimized. The antenna size is $25{\times}25{\times}5[mm]$. A chip monopole antennas which supports dual-band (GSM and WCDMA) was optimized. The antenna size is $27{\times}8{\times}3.2[mm]$. To amplify the Satellite reception signal level, two-stage low noise amplifier(LNA) was designed. The LNA gain is 27[dB]. The size of Jig for antennas measuring is $100{\times}30{\times}1[mm]$.