• 한국수산과학회지
• /
• 제10권1호
• /
• pp.65-69
• /
• 1977

The characteristics of two stage compressor which is constituted of two separated reciprocating compressors was tested measuring the volumetric efficiency of each compressor at suction of both bighandlowpressdresideusillgorificetypeflolrmeters. The volumetric efficiency of low pressure side compressor was lower than that of the high side when they were operating under the same compression ratio. And it tended to reduce obviously by lowering evaporating temperature resulting in a markable reduction of refrigerating capacity at the same time. It is assumed that the falling of volumetric efficiency at low side compressor was directed by the decrease in evaporating temperature which derives the falls of gas pressure at suction, increase in compression ratio, and gas flow resistance at suction and discharge valves.

• 전기학회논문지
• /
• 제60권7호
• /
• pp.1372-1377
• /
• 2011

This paper proposes the control method of MPPT(maximum power point tracking) for the wind energy generation system using the duty ratio control of boost type DC-DC converter. For a lower cost and a higher reliability, the wind and the generator velocity sensors are removed. MPPT control is implemented by changing the duty ratio of the boost converter. Chain rule is applied by using each function. The grid side inverter is controlled to regulate unity power factor. The proposed control method was analyzed mathematically and verified by the computer simulation using PSIM.

• 설비공학논문집
• /
• 제24권1호
• /
• pp.45-50
• /
• 2012

The plate fin and tube type of heat exchanger is widely used in air conditioner, and the heat exchanger is assembled by the mechanical expansion of copper tubes and fastening the aluminum fin. The objective of the present study is to investigate how the mechanical expansion of copper tube affects on the heat transfer performance of a plate fin and tube type heat exchanger. This study has been performed by experimental and numerical methods. The numerical and experimental results show that the tube expansion ratio has a influence on the heat transfer performance. Within the tested expansion ratio, the contact pressure shows the peak value and it decreases as the expansion ratio increases. Air-side heat transfer coefficient increases until the expansion ratio reaches 1.23, and then decreases with the similar pattern to the contact pressure. Also, contact heat transfer coefficient shows the maximum when the contact pressure is highest as well as the air-side heat transfer coefficient.

• 전력전자학회논문지
• /
• 제18권3호
• /
• pp.247-255
• /
• 2013

In this paper, a soft switching DC-DC converter for AC module type photovoltaic (PV) module integrated converter is proposed. A push-pull converter is suitable for a low voltage PV AC module system because the step-up ratio of a high frequency transformer is high and the number of primary side switches is relatively small. However, the conventional push-pull converters do not have high efficiency because of high switching losses by hard switching and transformer losses (copper and iron losses) by high turns-ratio of the transformer. In the proposed converter, primary side switches are turned on at zero voltage switching (ZCS) condition and turned off at zero current switching (ZVS) condition through parallel resonance between secondary leakage inductance of the transformer and a resonant capacitor. Therefore the proposed push-pull converter decreases the switching loss using soft switching of the primary switches. Also, the turns-ratio of the transformer can be reduced by half using a voltage-doubler of secondary side. The theoretical analysis of the proposed converter is verified by simulation and experimental results.

• 한국유체기계학회 논문집
• /
• 제15권6호
• /
• pp.5-10
• /
• 2012

The effect of pressure-side opening length on three-dimensional flow fields and aerodynamic losses downstream of a cavity squealer tip has been investigated in a turbine rotor cascade for the squealer rim height-to-chord ratio and tip gap height-tochord ratio of $h_{st}/c$ = 5.05% and h/c = 2.0% respectively. The opening length-to-camber ratio is changed to be $OL/c_c$ = 0.0, 0.1, 0.2, 0.3, 0.4, 0.5, and 0.7 The results show that longer OL leads not only to weaker secondary flow but also to lower aerodynamic loss in the tip leakage vortex region, while it significantly widens the area with high aerodynamic loss in the passage vortex region. The aerodynamic loss coefficient mass-averaged all over the measurement plane is kept almost constant for $0.0{\leq}OL/c_c{\leq}0.3$, whereas it increases rapidly for $OL/c_c$ > 0.3 in proportion to $OL/c_c$. There is little deterioration in flow turning with increasing $OL/c_c$.

• 한국운동역학회지
• /
• 제17권4호
• /
• pp.45-55
• /
• 2007

We investigated the biomechanics and characteristics of shoulder rotator muscles for professional woman volleyball players. The purpose of this study was to analyze the isokinetic peak torque and range of motion for shoulder joint rotation. We measured the strength and ROM of the internal rotation(IR) and external rotation(ER) of shoulders joint for nine professional woman Volleyball players and nine University students with Biodex and Simi-motion. 1. We measured peak torques for the shoulder joint rotator at angular velocities of 60/s and 180/s. It was found that the peak torques were significantly different between the two groups and also between the hands used. 2. At angular velocity of 60/s, IR/ER ratio of the shoulder joint was significantly different depending on the groups and the hands in use. There was a significant difference for 'Dominant side' at angular velocity of 180/s, but no significant difference for 'Non-dominant side' and the controls group. 3. Regarding the ROM of rotation of the shoulder joint group, IR was significantly different between the groups and the hands in use. 4. IR/ER ratio of the shoulder joint for Dominant side was quite different between the groups.

• 약학회지
• /
• 제17권3호
• /
• pp.129-136
• /
• 1973

In order to establish the chemical standards for the quality control of ginsentgextract, an approach for the assay of sapogenin contents in the part of main roots and fibrous side roots was performed by combination of preparative thin layer chromotographic procedure and vanillin-$H_{2}SO_{4}$ color reaction. The contents of dammarane aglycones as funcction of dammarane glycosides in 80%-EtOH extracts were analyzed by the method from the main roots and fibrous side roots of Korean ginseng grown for 4-6 years. The differences by their grown ages in the contents of dammarane glycosides, in the ratio of panaxadiol to panaxatriol contents, and in the mounts of 80% EtOH extract were not significant in the parts of main roots and fibrous side roots of Korean gingeng. Differences due to the part for medicinal uses were highly significant in all parameters mentioned, showing following results ; in the main roots ; 80% EtOH extract, 12.7-15.7 % : the ratio of aglycone composition, 0.955-1.012 : dammarane glycoside (as diglucoside bases), 1.537-1.863 ; in fibrous isde roots ; 80% EtOH extract, 26.0-26.02% : dammarane glycoside, 4.767-5.641 : the ratio, 1.456-1.50.

• 한국수자원학회논문집
• /
• 제40권3호
• /
• pp.277-286
• /
• 2007

사다리꼴단면을 가진 광정횡월류위어에서의 흐름특성을 3차원 수치모의를 통해 분석하였다. 본 연구결과， 본류 수로의 푸르드수가 증가함에 따라 월류유량비와 횡월류 유량계수는 감소하는 경향을 보였다. 그리고 횡월류 유량이 증가하면서 월류부 하류 수로의 주흐름구간은 축소되며，횡윌류위어의 대안 측에 형성되는 재순환영역의 크기는 증가하는 양상을 보였다. 횡월류위어 측에서의 주흐름방향 수위분포는 위어 시점부에서 급격히 하강하여 점차 증가하다 위어 종점부에서 급격히 상승했다 하강하는 양상을 보이는데, 위어 종점부에서 수위가 급히 상승하는 원인은 위어의 종점부가 흐름의 장애물로 작용하기 때문이다.

• 한국통신학회논문지
• /
• 제42권4호
• /
• pp.739-746
• /
• 2017

직교 주파수 분할 다중 반송파(OFDM) 방식은 다양한 장점이 있지만 최대 전력 대 평균 전력비율(PAPR)이 커서 증폭기의 비선형 왜곡에 취약하다는 단점이 존재한다. 이러한 단점을 해결하고 데이터의 손실도 방지하기 위하여 선택사상 기법이 제안되었다. 그러나 선택사상 기법은 송신단에서 위상 변형에 사용된 위상 시퀀스를 수신단에서도 알아야 되기 때문에 부가 정보를 추가하여 전송해야 한다. 이에 따라 데이터 전송효율 손실이 발생한다. 본 논문에서는 부가 정보가 필요 없는 상호 상관을 이용한 새로운 선택사상 기법의 수신기를 제안한다. 수신단이 알고 있는 송신단에서 전송할 파일럿 신호와 위상시퀀스 곱을 수신된 파일럿 신호와 상호 상관을 취하여 상호 상관 값이 가장 큰 위상시퀀스로 부가정보를 검출한다. 모의실험을 통하여 본 수신기는 기존의 방식보다 개선된 비트오류율(BER) 및 부가정보 오류확률(SIER) 성능을 보인다는 것을 확인하였다.

• Journal of Electrical Engineering and Technology
• /
• 제9권5호
• /
• pp.1762-1773
• /
• 2014

In this paper, a distributed image coding scheme for multi-view video through an efficient generation of side information is proposed. A distributed video coding technique corrects the errors in the side information, which is generated with the original image, by using the channel coding technique at the decoder. Therefore, the more correct the generated side information is, the better the performance of distributed video coding. The proposed technique is to apply the distributed video coding schemes to the image coding for multi-view video. It generates side information by selectively and efficiently using both 3-dimensional warping based on the depth map with spatially adjacent frames and motion-compensated temporal interpolation with temporally adjacent frames. In this scheme the difference between the adjacent frames, the sizes of the motion vectors for the adjacent blocks, and the edge information are used as the selection criteria. From the experiments, it was observed that the quality of the side information generated by the proposed technique was improved by the average peak signal-to-noise ratio of 0.97dB than the one by motion-compensated temporal interpolation or 3-dimensional warping. The result from analyzing the rate-distortion curves revealed that the proposed scheme could reduce the bit-rate by 8.01% on average at the same peak signal-to-noise ratio value, compared to previous work.