• Geomechanics and Engineering
• /
• v.18 no.4
• /
• pp.363-371
• /
• 2019

In this study, the load carrying behavior of piled rafts installed in inclined bearing rock layer was investigated for rock-mounted and -socketed conditions. It was found that settlements induced for an inclined bearing rock layer are larger than for a horizontal layer condition. The load capacity of piled rafts for the rock-mounted condition decreased as rock-layer inclination angle (${\theta}$) increased, while vice versa for the rock-socketed condition. The load capacities of raft and piles both decreased with increasing ${\theta}$ for the rock-mounted condition. When bearing rock layer was inclined, loads carried by uphill-side piles were greater than those by downhill-side piles. The values of differential settlements of rock-mounted and -socketed conditions were not significantly different whereas slightly higher for the rock-socketed condition. The values of load sharing ratio (${\alpha}_p$) and its variation with settlement were not markedly changed by the inclination of bedrock. It was shown that ${\alpha}_p$ for piled rafts installed in rock layer was not affected by ${\theta}$ whereas actual loads carried by raft and piles may vary depending on the pile installation and rock-layer inclination conditions.

• Journal of the Korean Society for Precision Engineering
• /
• v.26 no.2
• /
• pp.86-93
• /
• 2009

Elastomeric O-rings have been the most common seals due to their excellent sealing capacity, and availability in costs and sizes. One of the critical applications of O-ring seals is solid rocket motor joint seal where the operating hot gas must be sealed during the combustion. This has long been a design issue to avoid the system failure. For laterally constrained, squeezed and pressurized condition, deformed shape of O-ring was measured by computed tomography method and CCD laser sensor, compared with numerical calculations. As clearance gap changes, sealing performance had been evaluated on peak contact stresses at top, bottom and side contact surfaces. As clearance gap increases, peak contact stresses and contact widths in top and side contact surfaces increase, and the asymmetry of stress distributions is promoted due to pressure increase. It is suggested that peak stress of bottom contact surface can be approximated by simple superposition of peak ones due to squeeze and pressure. Under pressurized condition, sealing performance is dependent on not peak stresses of bottom and side contact surfaces but that of top.

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.8 no.3
• /
• pp.46-53
• /
• 2009

To find the working condition is one of the important factors in precision machining. In this study, we analyzed maximum working temperature by infra-red camera and surface roughness in side wall end milling using design of experiment (DOE): RSM(response surface methodology), ANOM(analysis of means) and ANOVA(analysis of variance) by table of orthogonal array. ANOM and ANOVA are well adapted to select sensitivity of design variables for maximum working temperature and surface roughness. The effective design variables and their levels should be determined using ANOM, ANOVA. RSM is presented 2nd order approximation polynomial of maximum working temperature and surface roughness is composed with design variables. Therefore, it is expected that the proposed procedure using design of experiment : table of orthogonal array, ANOM, ANOVA and RSM can be easily utilized to solve the problem of working condition.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2007.11a
• /
• pp.275-276
• /
• 2007

• Journal of Korean Neurosurgical Society
• /
• v.60 no.2
• /
• pp.220-224
• /
• 2017

Objective : This study aimed to unravel the putative mechanism underlying the neurologic deficits contralateral to the side with lumbar disc herniation (LDH) and to elucidate the treatment for this condition. Methods : From January 2009 to June 2015, 8 patients with LDH with predominantly contralateral neurologic deficits underwent surgical treatment on the side with LDH with or without decompressing the symptomatic side. A retrospective review of charts and radiological records of these 8 patients was performed. The putative mechanisms underlying the associated contralateral neurological deficits, magnetic resonance imaging (MRI), electromyography (EMG), and the adequate surgical approach are discussed here. Results : MRI revealed a similar laterally skewed paramedian disc herniation, with the apex deviated from the symptomatic side rather than directly compressing the nerve root; this condition may generate a contralateral traction force. EMG revealed radiculopathies in both sides of 6 patients and in the herniated side of 2 patients. Based on EMG findings and the existence of suspicious lateral recess stenosis of the symptomatic side, 6 patients underwent bilateral decompression of nerve roots and 2 were subjected to a microscopic discectomy to treat the asymptomatic disc herniation. No specific conditions such as venous congestion, nerve root anomaly or epidural lipomatosis were observed, which may be considered the putative pathomechanism causing the contralateral neurological deficits. The symptoms resolved significantly after surgery. Conclusion : The traction force generated on the contralateral side and lateral recess stenosis, rather than direct compression, may cause the contralateral neurologic deficits observed in LDH.

• Journal of Haehwa Medicine
• /
• v.15 no.1
• /
• pp.47-52
• /
• 2006

The purpose of this study was to show the effect of Umnungchon and Hyolhae about acupuncture side effects. 6 cases of patients treated in Hankyoreh Oriental madical clinic of Daejeon from Dec 1 2005 to Apr 15 2006 were survey. The side effect of acupunctur therapy is called neddling-shock(Chim-hun) and it happ. ened at to nervers, hungry, fatigue patient's condition. The side effect of acupuncture is paraesthesia, hypersensitivity, hematoma etc. But it was not mentioned in Oriental medical literature written in Chinese. I used Umlungchon and heulhe for The side effect of acupuncture and This point were effective treatment of paraesthesia, hypersensitivity, hematoma by acupuncture.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.27 no.5
• /
• pp.596-603
• /
• 2003

Present study has been conducted to see the relative effects of adding N: to fuel-side and air-side on flame structure, soot formation and NOx emissions. Experiments were carried out to ascertain to what degree chemical kinetics and/or molecular transport effects can explain the differences in soot formation and NOx emission by studying laminar diffusion flames. Direct photograph was taken to see the flame structure. CARS techniques was used to get the flame temperature profiles. And spatial distribution of soot could be obtained by PLII method. CHEMKIN code was also used to estimate the global residence time to predict NOx emissions at each condition. Results from these studies indicate that fuel-side dilution is more effective than air-side dilution in view of NOx emissions. However, air-side dilution shows greater effectiveness over fuel-side dilution in soot formation. And turbulent mixing and heat transfer problems were thought to be considered in practical applications.

• Journal of the Korean Society of Food Culture
• /
• v.11 no.5
• /
• pp.593-600
• /
• 1996

This study was undertaken to investigate the knowledge and the use of Korean traditional basic side dishes, dried side dishes and Jabans, by housewives. Among the 59 kinds dried side dishes and Jabans, the most well-known food (above 90% of subjects) turned out to be squid Po (dried strip), kong Jaban (seasoned bean), pollack Po, dried yellow croacker, build -dried anchovy Jaban and laver Boogag in the order. In cooking experience of dried side dish and Jaban, over 40% of subjects for build-dried anchovy Jaban, squid Po, dried yellow croacker and kong Jaban have cooked frequently. The proportion of subjects who has bought the marketed dried side dishes and Jaban products was 61.5%. Major problem of that products was pointed out for a sanitary condition and high price. If marketed dried basic side dishes and Jabans were improved over the aspects, the proportion of subjects who would buy the products was 70.0%. Preparation ability of these basic side dishes was influenced by age and educational level. The working housewives had higher frequency in use than the non-job housewives. The interesting degree for basic side dishes was not significantly different from age, resident area and educational level.

• The KSFM Journal of Fluid Machinery
• /
• v.15 no.4
• /
• pp.67-71
• /
• 2012

This study analyzed performance changes by an inner flow path of impeller groove for side channel type ring blower using CFD. Two models have the same side channel and clearance while one has an inner flow path and the other doesn't. To analyze the performance change of a ring blower, overall performance and local flow field were analyzed. For the overall performance, pressure increase and impeller torque were checked under the design flow condition. Under the design flow condition, pressure increase was greater for the model with the inner flow path. The model with the inner flow path showed improved efficiency because the area subject to torque decreased due to the creation of inner flow path. To analyze local flow field, a section was created from the representative location of each impeller groove toward the direction of radius. Inner channel pressure distribution depending on the rotation direction shows that the model with the inner flow path has pressure equilibrium of working fluid through the inner flow path. Velocity distribution of inside impeller groove shows that flow field was coupled and appeared to form an inner wall where the flow field was stabilized.

• The Journal of Korean Medicine
• /
• v.21 no.4
• /
• pp.138-147
• /
• 2000

Objectives and Method : In this study, I have investigated what kind of primary factors detennine the apoplexy prognosis, and the method of the function assessment about the apoplexy by inquiry into the literature on this subject Results and Conclusions : 1. The primary factors to have an effect upon the appoplexy are : the location of Pungsa; whether five organs ki is existent or not; pulse feeling; tongue condition; whether or not the patient produces stool or urine; for males, the left side; for females, the right side ; whether or not the patient sweats; consciousness; vital signs; and the region and size of disease and brain hernia. 2. MBI is often used because it is considered to be objective, simple, and highly reliable. But its absence of a legal recognition assessment is a major incongruence. 3. Inclusive and standard assessment are key points in the reinforecement by AM of legal recognition assessment, but it takes a lot of time and is not endowed with adding an extra weight and is vague to the division between the communication and social recognition grade. 4. AI is useful and easy to evaluate the mental ability, the capacity for locomotion and the daily activities inclusively.