• Solar Energy
• /
• v.11 no.3
• /
• pp.74-83
• /
• 1991

In this study, the (p)ZnTe/(n)Si solar cell and (n)CdS-(p)ZnTe/(n)Si poly-junction thin film are fabricated by vaccum deposition method at the substrate temperature of $200{\pm}1^{\circ}C$ and then their electrical properties are investigated and compared each other. The test results from the (p)ZnTe/(n)Si solar cell the (n)CdS-(p)ZnTe/(n)Si poly-junction thin fiim under the irradiation of solar energy $100[mW/cm^2]$ are as follows; Short circuit current$[mA/cm^2]$ (p)ZnTe/(n)Si:28 (n)CdS-(p)ZnTe/(n)Si:6.5 Open circuit voltage[mV] (p)ZnTe/(n)Si:450 (n)CdS-(p)ZnTe/(n)Si:250 Fill factor (p)ZnTe/(n)Si:0.65 (n)CdS-(p)ZnTe/(n)Si:0.27 Efficiency[%] (p)ZnTe/(n)Si:8.19 (n)CdS-(p)ZnTe/(n)Si:2.3 The thin film characteristics can be improved by annealing. But the (p)ZnTe/(n)Si solar cell are deteriorated at temperatures above $470^{\circ}C$ for annealing time longer than 15[min] and the (n)CdS-(p)ZnTe/(n)Si thin film are deteriorated at temperature about $580^{\circ}C$ for longer than 15[min]. It is found that the sheet resistance decreases with the increase of annealing temperature.

• Progress in Medical Physics
• /
• v.11 no.1
• /
• pp.73-83
• /
• 2000

In this study, we investigate the effects of poor shimming on quantitative measurement of ratios of metabolite levels by proton magnetic resonance spectroscopy ($^1$H MRS). Coefficient of variation (COV) of metabolite ratios for point resolved spectroscopy (PRESS) and stimulated-echo acquisition mode (STEAM) spectra was evaluated from a phantom containing in vivo levels of metabolites using a conventional whole body 1.5T MR system and conventional acquisition and analysis protocol. A statistical P-value was also calculated from a linear regression for relationship of metabolite ratios. N-acetylaspartate (NAA)/ creatine (Cr) and NAA/ choline (Cho) had low COV values for the long and short TE spectra (29.1 and 27.5%; 23.8 and 12.6 %), whereas Cho/Cr and Cr/Cho had high COV values (50.0 and 68.6 %; 27.5 and 29.3 %). A linear relationship between NAA/Cr and Cho/Cr, and between NAA/Cho and Cr/Cho revealed the statistical significance in the long and short TE spectra, respectively (P < 0.0001 and P < 0.0001; P = 0.015 and P = 0.005). There was no significant relationship between Cho/NAA and Cr/NAA in the measurement (P = 0.159; P = 0.910). The present study suggested that NAA/Cr and NAA/Cho could be useful for data with poor shimming in $^1$H MR spectroscopy. In conclusion, statistical significance of metabolite ratios indicated that the Cr and Cho levels could be interpreted as a significant alteration factor in the long and short TE spectra, and then should be used with care to provide precise metabolite quantification.

• Journal of the Microelectronics and Packaging Society
• /
• v.7 no.4
• /
• pp.1-5
• /
• 2000

Properties of AC applied hot pressed ($Pb_{1-x}Sn_{x}$) Te thermoelectrics were investigated. Mechanical alloying process used to produce alloyed powder to reduce the inhomogeneity and to avoid vaporization of constituents. It showed an increase in the mechanical alloying time with increasing of Sn contents in ($Pb_{1-x}Sn_{x}$)Te. ($Pb_{1-x}Sn_{x}$)Te were sintered at 873 to 923K for 1-4 minutes, under 150 kgf/$\textrm{cm}^2$ by AC applied hot pressng method. The short sintering time of AC applied hot pressing process could reduce the vaporization of Te. The density of ($Pb_{1-x}Sn_{x}$) Te was more dependent on the sintering temperature than the sintering time. The p-n transition was observed at x=0.1 but only p type conduction behavior was observed at more than 20 mol% of Sn compositions. The maximum value of Seebeck coefficient is 250 $\mu$V/K for x=0.2 at 500K. As the amount of Sn increases, the peak value of Seebeck coefficient drops and shifts to higher temperature and the peak value of electrical conductivity decreased with increasing temperature.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.4 no.4
• /
• pp.363-369
• /
• 1994

Bimuth telluride base thermoelectrics are prepared by AC current applied hot pressing method. It is possible to minimize the defects arising from the vaporization of Te, thanks to the very short processing time compared to the single crystal growing method. The optimum conditions for the AC applied hot pressing of 95 mol% $Bi_2Te_3-5 mol% Bi_2Se_3$ thermoelectrics are sintering at $400^{\circ}C$, for 2 minutes, under 1500 kgf/$\textrm{cm}^2$, with the particle size of $125 to 250 {\mu}m$, range of powder. The resultant Z value (figure of merit) was $2.2{\times}10^{-3}/K$.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.4 s.107
• /
• pp.351-357
• /
• 2006

In this paper, a direct $TM_{01}-TE_{11}$ mode converter of circular waveguide which is used the approximated design method of mode conversion between $TM_{01}$ and $TE_{11}$ modes is designed for radiation with the maximum directivity of high power energy into air (rom high power microwave antenna system. The proposed direct $TM_{01}-TE_{11}$ mode converter is calculated and designed with an approximated method for non-linear function about an extended non-constant serpentine type of circular waveguide. Then, the designed mode converter is optimized by length of 200 mm and efficiency above 95% by FIM simulation and achieved short length and high efficiency of the antenna by results of fabricated and measured characteristics.

• Journal of Sensor Science and Technology
• /
• v.7 no.1
• /
• pp.67-72
• /
• 1998

The crystallized CuPc and PbTe films are formed by thermal evaporation and pulsed ArF excimer laser ablation. Structural and electrical properties of thin film is observed by XRD and current-voltage(I-V) curves. From XRD analysis, both PbTe and CuPc thin films show a-axis oriented structure. For the measurement of photovoltaic effect, the transverse current-voltage curve of CuPc/Si, PbTe/Si and PbTe/CuPc/Si junctions have been analyzed in the dark and under illumination. The PbTe/CuPc/Si junction exthibits a strong photovoltaic characteristics with short circuit current($J_{sc}$) of $25.46\;mA/cm^{2}$ and open-circuit voltage($V_{oc}$) of 170 mV. Quantum efficiency and power conversion efficiency are calculated to be 15.4% and $3.46{\times}10^{-2}$, respectively. Based on the results of QE and ${\eta}$, the photocurrent process of PbTe/CuPc/Si junction can be explained as following three effective steps; photocarrier generation in the CuPc layer, carrier separation at PbTe/CuPc interface, and finally a transportation of electrons through the PbTe layer.

• The Journal of Korean Medicine Ophthalmology and Otolaryngology and Dermatology
• /
• v.11 no.1
• /
• pp.180-196
• /
• 1998

A Literatur Review of Physical and Breathing Exercises for Ear Health, the results were as follows. 1. The most common using way is rubbing your ears and auricle with warm palms. 2. To stimulate inner acoustic meatus, obstruct external acoustic meatus for a short time by the palm or fingers and then to stimulate it by the sudden opening. 3. This method is a common way to press aurical or orifice of external acoustic meatus for example, TE21(耳門), TE20(角孫), GB2(聽會), TE19(노息), TE18(계脈), GB11(竅陰), TE17(예風) etc. 4. The best time to pratice is early in the morning or before go to bed, but a litter difference by the writer's opinion, so there is not consistency. 5. Since tinnitus and hardness of hearing is related to the who1e body, it is known that you can relax your whole body by pressing the acupuncture points located in the head of occipital region or by stretching the upper half of the body. 6. There is method that obstruct your ears with palms and 3rd finger on your occipital region and splash by the 2th fingers.(sound the celestial drum)

• Journal of the Korean Society of Radiology
• /
• v.12 no.5
• /
• pp.623-630
• /
• 2018

Non-alcoholic fatty liver disease is the most common cause of chronic liver diseases. This study was to characterize early hepatic lipid changes in fatty liver rat model by in vivo short-echo time(TE) $^1H$-MRS(Proton - Magnetic Resonance Spectroscopy). Each the examinations were measured from liver parenchyma in rats at 0, 2, 4, 6, 8 weeks followed by high fat diet, respectively. Significant increase in lipid signals. 0.9, 1.3, 2.3, 2.8, and 5.3 ppm was found in animals with 2 weeks(p<0.01). Therefore, $^1H$-MRS is useful in detecting and characterizing various hepatic lipid alterations as early as 2 weeks for the start high fat diet.

• Current Photovoltaic Research
• /
• v.5 no.1
• /
• pp.1-8
• /
• 2017

Two different fluorine-doped tin oxide (FTO)-coated glass substrates were investigated to find better suitability for CdTe solar cells. Substrate A consisted of FTO (300 nm)/$SiO_2$ (24 nm)/intrinsic $SnO_2$ (30 nm)/borosilicate glass (2.2 mm), and substrate B consisted of FTO (700 nm)/intrinsic $SnO_2$ (30nm)/borosilicate glass (1.8 mm). The overall thickness of the FTO/glass substrates was about 2.5 mm. The total light transmittance of substrate B was much higher than that of substrate A throughout the whole spectral region, even though the thickness of the FTO in substrate B was twice larger than that of the FTO in the substrate A. The short-circuit current greatly increased in substrate B and the external quantum efficiency (EQE) increased over the whole wavelength range. This study shows that the diffuse optical transmittance played a key role in the large EQE value in the blue wavelength region, and the direct transmittance played a key role in the large EQE value in the red wavelength region. The higher transmittance is due to the rough surface generated by the thicker FTO on glass. The conversion efficiency of the CdTe solar cell increased from 12.4 to 15.1% in combination of rough FTO substrate and Cu solution back contact.

• Proceedings of the Korea Association of Crystal Growth Conference
• /
• 1996.06a
• /
• pp.516-518
• /
• 1996

Bimuth telluride type thermoelectrics are prepared by AC current applied got pressing method. It is possible to minimize the defects arising from the vaporization of Te, because of the very short processing time. The optimum conditions for the got pressing of 95mol% $Bi_2Te_3$-5mol%$Bi_2Se_3$ themoelectrics are sintered at $400^{\circ}C$, for 2min. with 1500 kgf/$cm^2$ from the particle size of 125 to 250 $\mu$m rang of powder. the resulted Z value (figure of merit) was 2.2$\times$10-3deg-1.