• 한국화재소방학회논문지
• /
• 제24권4호
• /
• pp.92-97
• /
• 2010

부산 실내사격장 화재의 원인을 추정하고 화재안전대책을 강구하기 위해 화재 시뮬레이션과 사격장 화재의 사례조사를 수행하였다. 현장조사와 잔류화약 분말에 대한 사격시험도 실시하였다. 총구불꽃과 탄자 받이에서의 스파크의 흔적이 CCTV 녹화영상에 나타나지 않았고, 유탄의 충격에 잔류화약이 점화하지 않았다. 따라서 잠재적 점화원 중 담뱃불이 가장 유력한 점화원으로 추정되었다. 또, 사격실에서의 폭발원인은 폴리우레탄 흡음재와 흡음재에 축적된 잔류화약 분말의 격렬한 연소 때문으로 판단되었다. 한편, 실내 사격장의 안전대책으로 프로파일 폴리우레탄 흡음재의 사용금지, 잔류화약 제거와 철저한 관리, 탄자받이의 강구조물 제거 등이 필요하다.

• International Journal of Safety
• /
• 제9권1호
• /
• pp.1-5
• /
• 2010

On-site examinations and fire simulation were carried out to speculate on causes of the fire at an indoor shooting range in Busan. An experiment on the ignitability of unburned gunpowder was also conducted. Cigarette was the most likely source of ignition for the fire, while impact of a stray bullet failed to ignite the unburned gunpowder. The explosion in the shooting area was presumed to be caused by violent combustion of the polyurethane foam and unburned gunpowder accumulated on it. Fire safety measures include prohibit of use of profile polyurethane foam, complete clean-up of unburned gunpowder, and removal of steel components from the bullet trap.

• 인터넷정보학회논문지
• /
• 제11권1호
• /
• pp.117-128
• /
• 2010

소모적이고 안전사고에 노출된 실탄 사격을 대체할 수 있는 사격 시뮬레이션 시스템과 관련된 연구가 활발히 진행되고 있다. 본 논문에서는 기존의 센서 기반 기술을 이용한 인식 방법을 사용하지 않고 영상처리기반 기술을 이용하여 탄착점을 추출하는 과정을 제시하였다. 이를 위해 모의총기의 총구에 부착된 카메라로부터 획득한 영상 분석을 통해 탄착점 위치를 찾아내고, 그 탄착점의 좌표 값과 과녁과의 매핑을 통한 최종 사격결과를 계산하여 제공할 수 있도록 한다. 이 시스템은 전송된 영상에서 영사영역을 구분하는 단계, 영사영역 내에서 탄착점 위치를 추출하는 단계, 탄착점 위치에 따른 사격결과를 계산하여 사용자에게 제공하는 단계로 나누어진다. 전송된 영상을 이진 영상으로 변환 후 영사영역의 꼭짓점의 위치를 찾고 그 안에 존재하는 탄착점을 추출한다. 구현된 탄착점 추출과정을 단계별로 제시하였으며 모의 사격 시스템을 위한 인터페이스에서 결과를 확인 할 수 있도록 하였다. 실험을 통해 영사영역의 꼭짓점 위치의 정확성을 확인하였으며 탄착점 추출 및 그에 따른 점수 환산결과를 확인할 수 있도록 하였다.

• 수산해양기술연구
• /
• 제22권2호
• /
• pp.7-15
• /
• 1986

In order to investigate the performance for the mackerel purse seine of one boat purse seiner using in the sea area of Cheju Island, a model net is made of the scale of 1/400 of its full scale, and model test on the shape of net and the tension of purse line is carried out in the stagnant water channel of the circulating water tank. Designing and testing for the model net are based on the Tauti's law. The obtained results are as follows; 1. The sinking rate of net is maximized the value of 6.40 m/min from 5 to 10 minutes after shooting net, and the mean value is 6.13 m/min. 2. The enclosed area formed with the float line after pursing operation is 76-84% of the area which is formed immediately after the shooting operation. At that time, purse seine is pulled inward the circle of surrounding net about 26.5% of the diameter. 3. In operating, when longitudinal section area of the central part of the net is maximized, the split area of both the wing-ends is 31-32% of the former. 4. When the time for the completing of pursing is 20 minutes, the maximum tension of the purse line is about 10.2 tons.

• 한국전기전자재료학회논문지
• /
• 제23권9호
• /
• pp.708-713
• /
• 2010

In this research a ring light was developed so that a partial shadowless shooting for the patient's affected area at the medical treatment room and surgical operation room using high luminance light emitting diode (LED) for which attention is being paid as new lighting parts for medical purpose. LED which was applied to the development used high luminance three color LED for full color for which various color materialization and the adjustment of radiation intensity are possible and we can get white light in order to emphasize the delicate expression for generic tone of shooting object, strong highlight, simple shadow and three dimensional effect at the time of close-up shadowless shooting of the affected area. And at the time of design of ring light, the characteristics of LED and the loss of light at the time of penetrating light diffusion PC were considered so that intensity of illumination for over 150 lx can be obtained. The result of measurement of the intensity of illumination of the ring light that was developed revealed that maximum intensity of illumination of 225.7 lx was obtained, while smoke index was measured to be maximum 78 Ra in the case of Red(50%) Green(100%) and Blue LED(60%). We could confirm that response speed was also very fast as 1.72 ms.

• 한국물환경학회지
• /
• 제28권3호
• /
• pp.460-466
• /
• 2012

Perchlorate is used in a number of applications as an oxidizer in solid propellants, munitions and fireworks and is one of the endocrine disrupting chemicals, which interferes with iodide uptake into the thyroid gland. The purpose of this study was to investigate perchlorate occurrence and distribution with a results of analysis of 94 samples collected from military facilities in Korea from October 11 to October 23, 2011. Overall, among all of the 94 samples analyzed, perchlorate was detected in 6.4% of the total number of samples above $4{\mu}g/L$ (minimum reported limit) and the average concentration was $26.1{\mu}g/L$ and the maximum concentration was $107.7{\mu}g/L$ which was observed in surface water near manufacturing site of ammunition. By site classification, perchlorate was detected at one site in 4 manufacturing sites of ammunition and the maximum concentration was $107.7{\mu}g/L$ which was six times higher than that in guideline for perchlorate in Nakdong River and resulted from point source discharge. Perchlorate was detected at 3 sites in 78 measurements for shooting area and the maximum concentration was $12.4{\mu}g/L$ which was collected in dringking water and perchlorate in another sample was detected above MRL in shooting area was collected right away after shooting. These results showed that long term monitoring was needed considering weather conditions and shooting schedules.

• 한국안전학회지
• /
• 제33권3호
• /
• pp.65-70
• /
• 2018

Terrain data for disaster analysis in hazardous or disaster areas is not only important but also needs to be built quickly. In particular, the introduction of drones is in the early stages of research using drones in a variety of fields such as shooting, analyzing and managing hazardous areas. It is expected that drone will be faster, safer and more effective than existing data collection method in case of small scale disaster hazard area and disaster area where equipment or manpower input is difficult. Therefore, in this study, drone shooting was performed for hazardous areas in mountainous roads located in Samcheok city, Gangwon province, and ground reference points were measured by RTK-GPS. The measured data were converted into DSM (Digital Surface Model) data by coordinate correction using Pix4D postprocessing program and then applied to the analysis of the hazard area of mountainous area. As a result, it was shown that it is effective to identify the risk by using the basic terrain data obtained from the drones.

• 한국지하수토양환경학회지:지하수토양환경
• /
• 제20권6호
• /
• pp.111-116
• /
• 2015

The soil sample obtained from shooting area contaminated with Pb, Cu, and Zn was investigated to determine the chemical forms of heavy metals with Tessier’s sequential extraction method, which is constituted of five fractions such as ‘exchangeable’, ‘bound to carbonate’, ‘bound to oxide’, ‘bound to organic matter’, and residual fractions. The amount of organic matter was measured by loss on ignition (LOI) and then the results of ‘bound to organic matter’ and LOI were compared. The sequential extraction results show that 4.7%-45% of Pb, 6.2%-25.9% of Cu and 3.9%-15.3% of Zn belong to the ‘bound to organic matter’ fraction, but LOI result shows that only 1.0%-2.8% of organic matter exists in the soil sample. In heavy medium separation tests, because Pb and Cu extracted in ‘bound to organic matter’ and residual fractions were removed, the heavy metals in the fractions would exist as heavier forms. These results suggest that the part of heavy metal extracted in ‘bound to organic matter’ fraction would result from the oxidation of metallic forms by hydrogen peroxide and nitric acid used in the fraction, and, consequently, that the ‘bound to organic matter’ fraction should be investigated in detail to determine the removal method and treatment capacity when the Tessier’s sequential extraction method is used to examine heavy metal contaminants resulted from elemental metal like bullets.

• 환경영향평가
• /
• 제22권5호
• /
• pp.481-489
• /
• 2013

There are U.S. troops with a force about 290,000 strong stationed all around the world, approximately 150 countries. Among the troops, USFK has performed principal part with its stationing for 50 years against the military threat of North Korea. However, as a result of an investigation made into environmental contamination of several bases which were restituted from US to ROK by the Land Partnership Plan in the process of relocation of USFK, it was found that the area was contaminated by not only TPH and BTEX caused by diesel fuel and JP-8 but also various heavy metal over the standard level according to the operations of corps. Among these bases, 4 corps, each of which has different duties and function, were chosen to be analyzed for the characteristics and degrees of soil contamination. Fisrt of all, in armored camp the soil was contaminated by TPH and heavy metal (Zn, Ni, Pb) due to the repairing activities of tracked vehicles and shooting exercises. In army aviation camp, the soil was contaminated by TPH, BTEX and heavy metal (Zn, Cd) due to repairing activities of aircrafts. Also, in engineer camp there was contaminated area polluted by TPH and heavy metal (Zn, Pb) caused by open-air storage of various construction materials and TPH, BTEX and heavy metal (Zn, Pb, Cu) contamination of aircraft shooting area in shooting range camp were detected. Managing environment will be more effective when we identify the contaminative characteristics and take necessary measures in advance.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2010년도 추계학술대회
• /
• pp.757-758
• /
• 2010

진료 및 수술 집도 시 조명용 광원으로 할로겐램프와 플라즈마램프가 주로 사용되고 있다. 두 광원은 램프의 수명 및 과도한 발열로 인한 다양한 문제점을 야기할 뿐 아니라 냉각기로 인하여 부피 또한 매우 크다는 단점이 있다. 따라서 본 연구에서는 의료용 신조명 부품으로 주목받고 있는 고휘도 LED를 사용하여 진료실 및 수술실에서 환자의 환부에 대한 국소 무영 촬영이 가능하도록 링라이트를 설계 개발하였다. 개발에 적용한 LED는 환부 근접 무영 촬영시 피사체 고유의 Tone에 대한 섬세한 표현력과 강한 하이라이트, 간결한 쉐도우, 그리고 입체감을 부각시키기 위하여 다양한 색상 구현과 광량 조절이 가능하고 백색광을 얻을 수 있는 FULL COLOR용 고휘도 3색 LED를 사용하였다.