• Applied Biological Chemistry
• /
• v.44 no.4
• /
• pp.257-261
• /
• 2001

Leather (skin & hide) is a body organ, comprising 3 to 5% of the animals weight. The cross-section of a leather is composed of two major divisions: the epidermis or grain layer and the corium or split layer. The leather is naturally covered with bacteria and fungi, because it is a particularly rich source of a wide variety of microorganisms. Stains or coatings of different colours occur in patches or over large areas, depending on the type of mould spore infestation. We examined the antibiotic effect of leather after washing. Upon applying equal fungicide, antibiotic effects increased as follows: grain layer>middle layer>flesh layer. Antibiotic effect decreased with increasing frequency of washing. Decrease in antibiotic effect was lower in OITZ fungicide than in TCMTB and CMK fungicides. Sulfated fatliquor showed higher antibiotic effect than phosphated fatliquor.

• Korean Journal of Applied Biomechanics
• /
• v.17 no.1
• /
• pp.111-119
• /
• 2007

The purpose of this study was to investigate muscle activity and gait pattern in lower limb depending on the outsole of heel rockers. Fifteen healthy men volunteered for this experiment. Each subject performed totally three trails with two pairs of different heel rocker shoes and a pair of normal running shoes at speed of 1.33m/s for 1 minute during walking on a treadmill. Kinematic data gathered in 100Hz was recorded and analyzed by using the 3D motion capture system to measure the trunk tilt and joint angle of the right lower limb. And the lower extremity muscle activities were simultaneously recorded in 1000Hz and assessed by using EMG. The statistical analysis was the one-way ANOVA with the repeated measures to compare among the three kinds of shoes. The level of statistical significance for all tests was 0.05. Joint angle of lower limb was showed statistically significant different in MST(hip joint), LHS(ankle joint), and RTO(knee and ankle joint). Muscle activity of rectus femoris and biceps femoris was statistically increased in both heel rocker shoes during gait cycle on treadmill. The maximum peak time of tibialis anterior in the negative heel rocker showed the delay of approximately 23.8%time than normal shoes. Gait pattern variability of the negative heel rocker was increased in the first half of the stance phase and the variability of the positive heel rocker was increased in the terminal stance phase. In Conclusion, stability was decreased in between joints of lower limb on positive heel rocker than negative heel rocker. This study found that there were different joint angle, muscle activity, gait pattern and coordinate system of the lower limb in each kind of shoes. These unstability affected the lower extremity and the whole body. A further study has to be continued with study of rehabilitation and exercise for a long-term.

• Journal of the Korean GEO-environmental Society
• /
• v.9 no.2
• /
• pp.47-59
• /
• 2008

Application of mechanically stabilized earth wall (MSEW) abutment has been rapidly increasing in United States of America, Pennsylvania since 2002. MSEW is effective for reducing construction cost and period compared to general concrete reinforced wall. In the paper, theoretical background and conventional criterion of MSEW abutment that is widely used abroad are analyzed. Based on the results, application of suitable MSEW abutment to domestic bridge type is examined. For the application of MSEW abutment in Korea, load interacting with upper shoe in domestic bridge types and structural analyses of beam seat and pile are investigated. As a result, all applications are possible except for PSC BOX Bridge that has heavy self-weight of girder. Through two and three dimensional numerical analyses, horizontal behaviour mechanisms between pile and MSEW were analyzed and field tests are also carried out for seven piles behind earth walls. From results of field tests, it is confirmed that an angle of internal friction of backfill material needs to be greater than 34 degree to use H-Pile as foundation of MSEW.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.1
• /
• pp.199-205
• /
• 2013

The purpose of this study was to analyze the changes in gait according to four style of bag's carryied method and three different bag's weights. Twenty healthy adults participated in four conditions. The first condition, they wearing a bag on one side shoulder and walked. The second condition, they carried a bag sling across on shoulder and walked. The third condition, they carried a bag on a back using both shoulders and walked. The fourth condition, they hold a bag in their right hand and walked. During all four conditions participants wore a SmartStep insole in their right shoe and had a pressure control device strapped to their right ankle. Each participant walked 10 meters carrying a 2.5 kg, 5 kg and 7.5 kg bag under all four conditions. There were significantly differents in stance phase rate; swing phase rate and walking speed according to bag weight of 2.5 kg, 5 kg, 7.5 kg.

• Journal of Adhesion and Interface
• /
• v.13 no.4
• /
• pp.163-170
• /
• 2012

Although ${\beta}$-cyclodextrin (${\beta}$-CD) has been used as medicine, agrichemical, food, cosmetic, antioxidant, anti-volatile agent, anti-hygroscopic agent, fading-protecting agent, and emulsifier due to its ability to form inclusion complex by enclosing another molecule (guest molecule), it has been restricted in practical application because of its low solubility in water and organic solvent. In this study, ${\beta}$-CD derivative as a new polyol with inclusion characteristics against Bisphenol A and cyclopropane, foaming agent for polyurethane (PU), and with improved solubility was synthesized, characterized and used to formulate rigid PU foam with better thermal conductivity and compressive strength compared to that from commercial polyols.

• PNF and Movement
• /
• v.20 no.3
• /
• pp.431-441
• /
• 2022

Purpose: The purpose of this study was to compare the changes in the contact area, maximum pressure, maximum mean pressure, and maximum force of functional insoles and general insoles when walking. Methods: Foot pressure was measured by the ignition of functional insoles and general insoles on Company N shoes. The foot pressure was measured using a precision pressure distribution meter (Pedar - X mobile system, Novel, Germany). Each insole sensor contained 99 independent cells and was inserted between the foot and the shoe. A wireless Bluetooth-type program was used to measure the pressure detected by the measuring insoles. In order to eliminate adaptation and fatigue caused by wearing the guide during the experiment, sufficient rest was taken between each experiment, and the wearing order was randomly selected. Results: Functional insole significantly increased the forefoot and midfoot (medial, lateral) (p<0.05), while total foot, forefoot, and rearfoot peak pressure significantly decreased (p < 0.05) compared to the general insole. Conclusion: In the functional insole, a high contact area was measured inside, even in the middle of the foot, leading to a proper change in foot pressure. It was confirmed that the contact area was reduced and dispersion occurred well. In addition, it was found that the maximum pressure in the front and back of the entire foot was reduced, so the weight pressure dispersion in the functional insole was evenly distributed, and the maximum average pressure change was similar.

• Journal of Fashion Business
• /
• v.26 no.2
• /
• pp.129-142
• /
• 2022

The purpose of this study is to develop socks to check the range of ankle movement during squats for men in their late 20s. Sensors of 6, 8, and 12 mm were selected, and each sample was impregnated 1 to 3 times. It was prepared using a CNT dispersion, and the GF value was measured using UTM. Among them, the sample with 2 impregnation showed the best GF value. As a result of applying each sample to the socks, the 12 mm sensor was wider than the area of the Achilles tendon, resulting in noise, and the 8 mm sensor was higher than the tensile strength of the socks, resulting in a decrease in the graph. Therefore, testing was performed using a 6 mm sensor. In order to determine the effectiveness of the sensor, the normal operating range was checked through squats, and significant changes were confirmed when the operating range was checked again through squats by performing operations that can increase the operating range through Gastrocnemius, Soleus stretching, and low lunge. Using the results of this study, it is expected that the average value of the ankle movement range of the user is checked prevent injury, to be provided as basic data for the production of shoe products and the promotion of physical health.

• Fashion & Textile Research Journal
• /
• v.26 no.1
• /
• pp.123-136
• /
• 2024

This study aimed to assess the mobility and thermal comfort of personal protective equipment (PPE) among female healthcare workers, taking into account wearers' physique and PPE protection levels. A total of 16 participants (age: 26.3 ± 8.3 y, height: 161.5 ± 7.3 cm, body weight: 57.1 ± 11.0 kg, BMI: 21.9 ± 3.6), representing diverse body types, underwent four PPE conditions: L (Low_Plastic gown ensemble), M (Medium_Tyvek 400), H (High_Tyvek 800J with Powered Air Purifying Respirator [PAPR]), and E (Extremely high_Tychem 2000 with PAPR, Bib apron, and Chemical-resistant gloves). The mobility protocol consisted of 10 different tasks in addition to donning and doffing. The 10 tasks were repeated twice at an air temperature of 24.3 ± 0.1℃, 59±4%RH. Findings revealed a disproportionate relationship between PPE protection and wearer discomfort. Significant differences in clothing microclimate and total sweat rate were observed between the lowest (L) and highest (E) protection levels (p < 0.01), while distinctions among medium levels were inconclusive. Subjective evaluations favored conditions H and L over M and E (p < 0.05), indicating reduced heat, and humidity, increased comfort, and lower exertion. Instances of mobility discomfort, specially in the small body type group, underscored the need for a suitable PPE size system for Korean adult female medical workers. Furthermore, enhancements in gloves, shoe cover, and PAPR hood designs are essential for improving ease of movement and preventing hindrance.

• Journal of the Korean Society of Safety
• /
• v.39 no.2
• /
• pp.1-8
• /
• 2024

Unwanted effects of electrostatic phenomena occur in various industries. Electrostatic problems originating from the human body in flammable atmospheres in the industry are especially concerning. A substantial volume of experimental data on the electrostatic charging voltages created on the human body owing to the rubbing of apparel were generated and reviewed during this study. The data were reviewed to determine whether the resultant charging levels of the human body are hazardous in flammable atmospheres. This study was conducted under several conditions, such as different fiber types used in apparel, shoe types, and relative humidities (RHs). The following conclusions were drawn in this study. ① The electrostatic charging levels of the human body owing to the rubbing of apparel increase with the increase in the surface resistances of apparel; however, the electrostatic charging levels may be different depending on the condition of the cloth surface. ② The discharging energy of 1.98-18.5 [mJ] from the human body exceeds the minimum ignition energy of most flammable materials, when removing an overcoat made of polyester, cotton and wool under severe conditions such as wearing height-raising shoes for men. ③ When removing antistatic apparel, the maximum discharging energy of 0.128 mJ from the human body is dangerous if the minimum ignition energy of the flammable material is between 10^-5-10^-4 [J] Grade; however, a minimum ignition energy of 10^-3 J Grade of the flammable material is considered safe. ④ While wearing antistatic shoes, the electrostatic charging voltage generated in the human body when removing an overcoat is 30 V; therefore, wearing such shoes is a suitable countermeasure when handling flammable materials. However, the antistatic abilities of shoes reduce when thick socks are worn. ⑤ As RH increases, the electrostatic charging levels of the human body decrease. ⑥ The electrostatic charging levels of the human body from removing a cotton overcoat can ignite the majority of flammable materials when RH is less than 30% under severe conditions such as wearing height-raising shoes for men.

• Journal of agricultural medicine and community health
• /
• v.36 no.4
• /
• pp.251-263
• /
• 2011

Objectives: The purpose of this study was to examine the factors associated with fear of falling among the elderly dwelling in rural communities. Methods: From February 1, 2010 to March 31, 2010, a questionnaire-based survey was sent to 2,628 persons 65 years or older dwelling in 1 Myeon and 1 Eup of Gyeongsangnam-do. Among these participants, 735 (27.9%) had fallen more than once in 2009. For data analysis, descriptive statistics and hierarchical multiple regression were performed using SPSS version 12.0. Results: Factors influencing the fear of falling in the elderly according to falls experienced were number of outpatient visits, number of falls, gender, admission, purchasing of health function foods, and activities of daily living. Overall, the study showed significant differences in the score of fear of falling according to gender, age, education, marital status, living arrangement, main means of mobilization, drinking, income, number of falls, admission, number of outpatient visits, experience with outpatient oriental medicine, purchasing of health function foods, medical assistance devices, season, fall location, fall cause, shoe type, injury type, limitation of activity, and activities of daily living. Conclusions: The results of this study suggest that programs should be developed specifically for elderly people who have experienced more than one fall because of increased fear due to multiple falls.