• 대한치주과학회:학술대회논문집
• /
• 2007.11a
• /
• pp.136-137
• /
• 2007

• Proceedings of the KIEE Conference
• /
• 2004.04a
• /
• pp.18-20
• /
• 2004

This paper formulates the principle of the permanent magnetic actuator (PMA) and its dynamic characteristic calculation applicable to High Voltage Vacuum Interrupter (38kV/31.5kA). The new type of PMA is need to apply to High Voltage Vacuum Interrupter for large stroke length and contact force at interrupter. Consequently this paper describes the ideal matching of the new type of PMA mechanism with the characteristics required to operate successfully, reliably and efficiently a High Voltage Vacuum Interrupter.

• Proceedings of the KIEE Conference
• /
• 1990.07a
• /
• pp.383-386
• /
• 1990

This paper concerns a DC-DC converter using the characteristic of series resonance. Operation principle of the system described by the proposed equation is illustrated. Characteristics of steady state of the system which is essential to system design is evaluated for frequency and pulse width characteristic using dimensionless parameter. The proposed circuit based in constant voltage control uses the Pulse Width Modulation - Time Ratio Control method.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2009.03a
• /
• pp.1060-1067
• /
• 2009

Previous research on the slope failure has mainly reported that most of the slope failures occur due to surface rainfall infiltration in the rainy season. A slope of which surface is protected by shotcrete or plants, can also fail due to increase in pore water pressure from the ground water flow beneath the surface, rather than from the surface. In this study such case of slope behavior is investigated using the model test and numerical method including strength reduction method. Hydraulic boundary conditions of the slopes is considered using coupled numerical scheme. The failure mechanism of the slope is investigated and the effect of pore water pressure on slope safety is identified. Increase in pore water pressure due to lateral infiltration has significantly reduced the stability of slope.

• Proceedings of the KIEE Conference
• /
• 1988.07a
• /
• pp.746-749
• /
• 1988

This paper describes an arrhythmia detection algorithm using PP and PR Interval. In order to detect P-wave accurately, an improved 5-point derivative method is used. In this paper, the RR, PP and PR interval. and the number of P-waves per RR Interval are detected for arrhythmia detection. These parameters can be utilized to diagnose in the varied types of AV block, atrial fibrillation, and PVC.

• Transactions on Electrical and Electronic Materials
• /
• v.11 no.2
• /
• pp.77-80
• /
• 2010

Indium tin oxide (ITO) films with a 5 nm thick Au interlayer were prepared on glass substrates. The effects of the Au interlayer on the gas sensitivity for detecting methanol vapors were investigated at room temperature. The conductivity of the film sensor increased upon exposure to methanol vapor and the sensitivity also increased proportionally with the methanol vapor concentration. In terms of the sensitivity measurements, the ITO film sensor with an Au interlayer shows a higher sensitivity than that of the conventional ITO film sensor. This approach is promising in gaining improvement in the performance of ITO gas sensors used for the detection of methanol vapor at room temperature.

• Proceedings of the KIEE Conference
• /
• 2005.04a
• /
• pp.61-63
• /
• 2005

In this paper, a new type of permanent magnetic actuator (PMA) with multi-stage coils is proposed. Although the conventional type of PMA has many advantages, it cannot be applied in the high voltage circuit breakers due to its short stoke length. The new type of PMA has long stroke length by using multi-stage coils, so it can be applied as an actuator for the high voltage circuit breakers. Dynamic characteristics are calculated by the finite element method (FEM), equation of electric circuit and dynamic equation. The position of plunger and the current of coils in case of the actuator applied in 38kV, 40kA vacuum circuit breaker are presented.

• Proceedings of the KIPE Conference
• /
• 2013.07a
• /
• pp.411-412
• /
• 2013

This paper proposes the reverse current control method of synchronous boost converter for fuel cell. In order to implement a high efficiency charger with the synchronous boost converter, using MOSFETs instead of diodes is essential. Using the conventional boosting method, the reverse current is generated during transient state due to the nature of fuel-cell which needs soft starting depending on the amount of hydrogen. By using PWM control method, fuel-cell can be protected from being damaged by reverse current, so synchronous boosting method can be applied to charger applications. The experimental results are shown to verify that the implementation of high-efficiency converter is possible.

• Proceedings of the KIEE Conference
• /
• 2000.07d
• /
• pp.2551-2553
• /
• 2000

고속 신호처리 및 실시간 제어 분야에 적합한 제어성능을 발휘하기 위해서는 신호처리전용 마이크로프로세서인 DSP(Digital Signal Processor)를 이용한 제어용 보드가 널리 활용되고 있다. 본 연구를 통하여 전기도금용 전원장치의 고성능화를 위하여 DSP제어용 보드를 개발하였으며, 전체구성은 고속 신호처리를 위한 메인 마이크로프로세서로서 경제성과 응용범위가 넓은 TMS320C32 DSP CHIP, Wait없는 프로그램 및 데이터 처리를 위한 고속 SRAM, 외부 디지털 입출력을 위한 인터페이스 회로, 아나로그 입출력 회로 및 PC 혹은 다른 마이크로컴퓨터와의 통신을 위한 직렬 통신 회로 등으로 구성하였다. 개발된 DSP 보드는 시제품 제작을 완료하여 그 성능 및 신뢰성을 검증하였으며, 전기도금장치의 고성능 제어처리를 위하여 채용하여 상품화 개발을 완료하였다.

• Annual Conference of KIPS
• /
• 2004.11a
• /
• pp.641-644
• /
• 2004

내장형 소프트웨어 성능 평가 및 분석 도구는 제한된 자원에 효율적인 내장형 소프트웨어의 개발 속도와 신뢰성 향상을 위한 유용한 도구이다. 본 논문은 내장형 시스템 개발자가 쉽고 편리하게 성능 평가 결과를 분석하고 효율적인 소프트웨어 개발 기회를 보장받을 수 있는 GUI 형태의 성능 분석 레포팅 뷰어(reporting viewer)를 설계하고 구현한다. 제안하는 성능 분석 레포팅 뷰어는 내장형 소프트웨어에 대해 생성된 저수준의 성능 평가 로그를 API 수준의 자료구조로 변경하는 정보 변환기 모듈과 API 형태의 자료구조를 이용해 사용자가 원하는 결과를 GUI 형태로 출력하는 레포팅 생성기로 구성된다. 제안하는 성능 분석 레포팅뷰어는 개발자나 사용자에게 그래픽 형태의 편리한 성능 분석 레포팅을 제공하며, 나아가API를 통해 개발자 자신의 취향에 맞는 레포팅 화면의 구성과 개발 가능성을 제공할 수 있을 것으로 기대된다.