• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.2
• /
• pp.301-312
• /
• 1996

A new approach is presented for recovering the 3-D shape from shading image. Photometric Stereo Method (PSM) is generally based on the direct illumination. In this paper, the reflectance function is derived by introduceing the indirect diffuse illumination in PSM and then applied to hybrid reflectance model which consists fo two components; the Lambertian reflectance and the speclar reflectance. Under the hybrid reflectance model and the indirect diffuse illumination circumstances, the 3-D shape of object can be recovered from the suface normal vector extracted from the surface roughness, the surface reflectance ratio, and the intensity value of a pixel. This method is rapid because of using the reference table and simplifies the restriction condition about the reflectance function existing in prior studies. The recovery efficiency in our method is better than that in prior studies. Also, this method is applied to various types of surfaces by defining general reflectance function.

• Journal of the Korean Solar Energy Society
• /
• v.29 no.3
• /
• pp.19-27
• /
• 2009

In this study, Urban Climate Simulation was performed by 3-Dimensional Urban Canopy Model. The characteristics of urban climate were analyzed combining artificial land coverage, building size, heat production from the air conditioning and topographic conditions as physical variables which affects urban climate characteristics. The results are as follows. (1) The aspects of the urban climatal change is derived to be related to the combination of the building coverage ratio, building height and shading area. According to the building height, the highest temperature was increased by $2.1^{\circ}C$ from 2-story to 5-story building and the absolute humidity by 2.1g/kg maximum and the wind velocity by 1.0m/s was decreased from 2-story to 20-story building. (2) Whole heat generation was influenced by the convective sensible heat at the lower building height and by the artificial heat generation at the higher one over 20-story building influence to some extent of the building coverage ratio. The effect of the altitude is not more considerable than the other variables as below $1^{\circ}C$ of the air temperature. In the last, deriving the combination of building coverage and building height is needed to obtain effectiveness of the urban built environment planning at the point of the urban climate. These simulation results need to be constructed as DB which shows urban quantitative thermal characters by the urban physical structure. These can be quantitative base for suggesting combinations of the building and urban planning features at the point of the desirable urban thermal environment as well as analyzing urban climate phenomenon.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.24 no.4
• /
• pp.135-140
• /
• 2024

It is said that PV power generation systems have a long lifespan compared to other renewable energy sources and require little maintenance. However, there are cases where the performance expected during initial design is not achieved due to shading, temperature rise, mismatch, contamination/deterioration of PV modules, failure of inverter, leakage current, and arc generation. Therefore, in order to solve the problems of these systems, the power generation amount and operation status are investigated qualitatively, or the performance is comparatively analyzed based on the performance ratio (PR), which is the performance index of the solar power generation system. However, because it includes large losses, it is difficult to accurately determine whether there are any abnormalities such as performance degradation, failure, or defects in the PV power generation system using only the performance coefficient. In this paper, we studied a status diagnosis algorithm for shading, inverter failure, leakage, and arcing of PV modules to optimize the power generation of PV power generation systems according to changes in the surrounding environment. In addition, using the studied algorithm, we examined the results of an empirical test on condition diagnosis for each area and the resulting optimized operation of power generation.

• Korean Journal of Plant Resources
• /
• v.29 no.4
• /
• pp.363-375
• /
• 2016

Potentilla kleiniana is a perennial herb beloning to Rosaceae family. Herein we investigated the effect of light intensity, light quality and chemical elicitor on plant growth and the accumulation of bioactive compounds in P. kleiniana. After 60 days of cultivation under different shading level [0% (200 μmol·m⁻²·s⁻¹), 35% (95 μmol·m⁻²·s⁻¹), 55% (65 μmol·m⁻²·s⁻¹), 75% (40 μmol·m⁻²·s⁻¹)] in the greenhouse, chlorophyll and carotenoid content were the highest under 35% treatment, however, plant height, leaf number and biomass were the highest under non-shading. As a result of cultivation among strong light condition as a control, florescence and three mixture light sources [red:white:blue (RWB) = 8:1:1, red:blue (RB) = 8:2, red:green:blue (RGB) = 8:1:1] as treatments in plant growth chamber (25 ± 2℃, 185 ± 3 μmol·m⁻²·s⁻¹), growth, biomass, chlorophyll content low difference between total phenolic compouds and flavonoid content were higher under RWB treatment. DPPH radical elimination ability was the highest under all treatments especially florescence and RGB treatment except control. As a result of treating chemical elicitor [salicylic acid (SA), methyl jasmonate (MeJA)] concentration (0, 50, 100, 200 μM) respectively, plant height, petiole diameter and biomass were higher under non-treatment, MeJA 50 μM. It was investigated that fresh weight and dry weight under MeJA 50 μM treatment were especially a little high. Total phenolic compounds and flavonoid content of SA 50 μM treatment was the highest but DPPH radical elimination ability was significantly the highest under MeJA 200 μM (88.65%) and MeJA 50 μM (87.84%) treatment. Thus, this study suggested that we determined optimal shading and light quality in the greenhouse and plant growth chamber also confirmed bioactive compound content, antioxidant ratio increase according to different chemical elicitation concentration.

• Asian Journal of Turfgrass Science
• /
• v.15 no.2
• /
• pp.65-76
• /
• 2001

This study was designed to estimate on the interaction of the first productivity, light condition and to examine the ecophysiological characteristics of Zoysia japonica. rtificial community of Zoysia japonica was analyzed effect of matter production and growth construction under various shading condition. The results summarized this experiment were as follows; 1. The relative growth rate (RGR) in all experimental plots was high during the growth stage of 20 days after transplanting, and then decreased. The maxium RGR value appeared in the control plot (2.13g/g. 10days) during the growth stage from 10 to 20 days after transplating. RGR value in server shading of short day condition was remarkably decreased from the early growth stage. The main factor to lower RGR value considered as a short day condition than that of shading. 2. The net assimilation rate (NAR) in all experimental plots except 3hour photoperiod plot was high during the early growth stage after transplanting, and then decreased early growth stage after transplanting, and then decreased as the growth proceeded. The maxium value appeared in the control plot (35g/g. 10days). NAR value in the severe shading of short day condition plots was low. Especially, NAR value in the three hours photoperiod plot was remarkably low from the early growth, there was no great difference by growth stage. NAR had negative correlation with LAI and positive correlation with RGR. 3. The increasing rate of leaf area ratio(LAR) was high during the early growth stage after transplanting in the control plot and in the photoperiod plot, the shorter the exposure time to sunlight, the higher the LAR value from the early growth stage. Especially, its value in the 3 hour photoperiod plot was remarkably high but its increasing rate was lower as the growth proceeded. LAR hade negative correlation on RGR and NAR. 4. The crop growth rate(CGR) in each experimental plot was increased until 50 days after transplanting, and then decreased. After that time, the maxium CGR value appeared in the control plot (1.56g/$\textrm{cm}^2$. 10-days), 60 days after transplanting, CGR had positive correlation with LAI. The optimum LAI in the control, 9 hour, 7 hour, 5 hour, and 3 hour photoperiod plots appeared as 1.87, 1.12, 0.83, and 0.18.

• Journal of Korean Society of Forest Science
• /
• v.73 no.1
• /
• pp.43-54
• /
• 1986

This study was carried out to investigate the influence of light intensity on the growth of Korean white pine (Pinus koraiensis) seedlings. The seedlings were grown under four different relative light intensities: 100%, 63%, 37%, and 19% of full sunlight by covering with saran screen on seed bed. The results obtained were summarized as follows; 1. The highest shoot elongation was found at 37% in relative light intensity (RLI) plot, and the best growth in root, seedling length and diameter increment appeared at 100% on RLI plot. Contribution rates of shading to growth in shoot elongation, root growth, seedling length, and diameter increment were 9.3%, 26.2%, 21.0%, and 48.7%, respectively. 2. The greatest number of one-year-old needle fascicle was found at 100% in RLI plot, whereas that of two-year-old needle fascicle appeared at 37% in RLI plot. The contribution rate of the light intensity to number of needle fascicle was 3.9% and factor of leaf age contributed to number of needle fascicle in 27.8%. The length of needles grown under different light intensities varied with needle ages. The longest length of new needles appeared at 37% in RLI plot, but old needles were not clear in influence of light intensity. The contribution rate to needle length by the light intensity was 2.5%. 3. The heaviest value of the fresh and dry weight of seedlings appeared at 100% of RLI plot then decreased with light intensity. The contribution rates to fresh and dry weight by the shading were 38% and 7.6% respectively. 4. The largest value of the dry weight of needles appeared at 100% of RLI plot and then decreased with light intensity. The contribution rates to dry weight of needles by the light intensity was 13.18%. 5. The values of T/R ratio increased with decreased light intensity and the contribution rate was 7.0%. 6. Positive correlation and linear regressions were recognized between dry weight of leaf and other factors (dry weight of shoot, root, seedling and diameter increment).

• New & Renewable Energy
• /
• v.1 no.1 s.1
• /
• pp.37-43
• /
• 2005

High-efficiency silicon solar cells have potential applications on mobile electronics and electrical vehicles. The fabrication processes of the high efficiency cells necessitate com placated fabrication precesses and expensive materials. Ti/Pd/Ag metal contact has been used only for limited area In spite of good stability and low contact resistance because of Its expensive material cost and precesses. Screen printed contact formed by Ag paste causes a low fill factor and a high shading loss of commercial solar cells because of high contact resistance and a low aspect ratio. Low cost Ni/Cu metal contact has been formed by using a low cost electroless and electroplating. Nickel silicide formation at the interface enhances stability and reduces the contact resistance resulting In an energy conversion efficiency of $20.2\%\;on\;0.50{\Omega}cm$ FZ wafer. Tapered contact structure has been applied to large area solar cells with $6.7\times6.7cm^2$ in order to reduce power losses by the front contact The tapered front metal contact Is easily formed by the electroplating technique producing $45cm^2$ solar cells with an efficiency of $21.4\%$ on $21.4\%\;on\;2{\Omega}cm$ FZ wafer.

• Journal of Ginseng Research
• /
• v.8 no.1
• /
• pp.65-74
• /
• 1984

This experiment was carried out to study the effects of light intensity and soil water regimes on the growth of ginseng seedling. The results were as follows: 1. The maximum light intensity and optimum temperature in 1,le photosynthesis of ginseng seedling were 10,000 lux and 23 $^{\circ}C$. Respiration rate was increased at high temperature. 2. Air and soil temperature under the shading were increased as the increase of light intensity but soil water contents were decreased as the increase of light intensity, whereas air and soil temperature were decreased as the increase of precipitation under the shade b5: soil water contents were increased as the increase of precipitation under the shade. 3. The higher the transmittance of the shade, the greater the specific leaf weight (S.L.W.) and stomatal density. In contrast, however, the contents of total chlorophyll, chlorophyll a and b, and stomatal length was decreased. There was no any significant difference light intensity of the a/b ratio of chlorophyll. 4. The highest photosynthesis was occurred in ginseng leaves grown under the shade 5% L.T.R. and net photosynthesis rates increased with increasing soil water contents. 5. Optimum condition for usable seedling yield were 5% L.T.R. and 3.3% precipitation under the shade. Useless seedling increased with increasing precipitation under the shade.

• Korean Journal of Construction Engineering and Management
• /
• v.12 no.6
• /
• pp.151-159
• /
• 2011

Due to the Korean government's renewable energy support policy such as the renewable energy utilization building certificate and enlarging the compulsory ratio of investment on the public building, the rooftop photovoltaic projects are expanding rapidly. It is very important for the rooftop photovoltaic projects to analyze the shading effect of the adjacent structures or own facilities. But, the photovoltaic arrangements are planned by the experience of the designers or simple graphic tools. The purpose of this study is to build the process model for optimizing of rooftop photovoltaic arrangement based on three-dimensional geo-spatial information.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.26 no.10
• /
• pp.481-485
• /
• 2014

Low solar gain glazing should be applied on windows in order to reduce the solar radiation load. In a country where a cooling and a heating load coexist throughout the year, such as in Korea, a high solar gain glazing is need to reduce the heating load, but a low solar gain glazing should be applied to reduce the cooling load. Recently, dynamic windows have been developed for which the solar shading performance switches according to the amount of solar radiation flowing into the indoor space through the glazing, and these have been used in building to solve such problems. The purpose of this research is to analyze the energy performance of the electrochromic glazing for dynamic windows that has been extensively commercialized for office buildings in Incheon and Ulsan through an energy simulation implemented in the eQUEST program.