• MALSORI
• /
• no.67
• /
• pp.195-216
• /
• 2008

This paper addresses the problem of single-channel speech separation to extract the speech signal uttered by the speaker of interest from a mixture of speech signals. We propose to apply time-frequency smoothing to the existing statistical single-channel speech separation algorithms: The soft mask and the minimum-mean-square-error (MMSE) algorithms. In the proposed method, we use the two smoothing later. One is the uniform mask filter whose filter length is uniform at the time-Sequency domain, and the other is the met-scale filter whose filter length is met-scaled at the time domain. In our speech separation experiments, the uniform mask filter improves speaker-to-interference ratio (SIR) by 2.1dB and 1dB for the soft mask algorithm and the MMSE algorithm, respectively, whereas the mel-scale filter achieves 1.1dB and 0.8dB for the same algorithms.

• Progress in Superconductivity and Cryogenics
• /
• v.25 no.3
• /
• pp.1-6
• /
• 2023

We have been developing a new magnetic filter so that small sized paramagnetic substances can be separated even in a low magnetic field (lower than 2T). The developed filter is a packed ferromagnetic filament with a triangular cross section. The filament has a diameter of 120 ㎛ and a length of 3 mm, and is mechanically packed with a volume ratio of 17.6%. Using this filter, a magnetic separation experiment of hematite was carried out using a superconducting magnet at the field of 2T. Similarly, magnetic separation was performed using a conventional magnetic filter. It became clear that the separation efficiency of newly developed filter is high as that of conventional mesh filter. The smaller sized hematite (<3 ㎛) could be separated though conventional mesh filter could not separate.

• Geophysics and Geophysical Exploration
• /
• v.15 no.2
• /
• pp.51-56
• /
• 2012

One of the most critical and essential procedures in the interpretation of gravity and magnetic data is to separate the anomaly due to the specific geologic structure from the summation of effects from a broad variety of geologic sources, especially those of different depths. Separation of the residual anomaly from the regional field is the most simple case of the vertical separation. If the anomaly due to a layer of specific depth can be separated or the depth of the separated layer can be quantitatively determined, it may deserve the separation-sounding. We suggest a wavelength filter whose cutoff frequency is determined by log-power spectrum analysis, as a separation-sounding filter. We applied this filter both to synthetic and real gravity data acquired at Heunghae area, and compared the results with those of Jacobsen's upward continuation filter. These showed that the proposed separation-sounding filter could be a useful tool for interpretation of the vertical geologic structure by stripping the gravity effects of geologic sources down to the desired depth.

• Progress in Superconductivity and Cryogenics
• /
• v.24 no.3
• /
• pp.7-11
• /
• 2022

We are conducting research and development of magnetic filters for magnetic separation targeting paramagnetic materials. In order to develop a new magnetic filter with a large magnetic gradient, stainless fiber (SUS430, 120 mm × 3 mm) with a triangular cross section was sintered with a high void ratio (~ 70%) and the magnetic filter (20 mm × 2 mm) was created. When this magnetic filter was used to perform magnetic separation of hematite (particle size 50 ㎛) under a maximum magnetic flux density of 1.49 T, high separation rates were obtained.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2022.05a
• /
• pp.135-135
• /
• 2022

In this study, we evaluated uncertainties in baseflow separation filter methods focusing on changes in recession constant (𝛼) values, which include Lynie & Holick (LH) algorithm, Chapman algorithm, Eckhardt filter, and EWMA filter. Here, we analyzed daily streamflow data at 14 stations in the Urmia Lake basin, Iran, from 2015 to 2019. The 𝛼 values were computed using three different approaches from calculating the slope of a recession curve by averaging the flow over all seasons, a correlation method, and a mean value of the ratio of Q_t+1 to Q_t. In addition to the 𝛼 values, the BFImax (maximum value of the baseflow index (BFI)) was determined for the Eckhardt filter through the backward filter method. As results, it indicates that the estimated baseflow is dependent upon the selection of filter methods, their parameters, and catchment characteristics at different stations. In particular, the EWMA filter showed the least changes in estimating the baseflow value by changing the 𝛼 value, and the Eckhardt filter and LH algorithm showed the highest sensitivity to this parameter at different stations.

• Journal of the Korean Ceramic Society
• /
• v.46 no.6
• /
• pp.662-667
• /
• 2009

Porous SiC candle filter preforms were fabricated by extrusion and ramming process. To fabricate SiC candle filter preform, commercially available 85 ${\mu}m\;{\alpha}-$-SiC powder and 44 ${\mu}m$ mullite, CaC$O_3$ powder were used as the starting materials. The candle type preforms were fabricated by vacuum extrusion and ramming process, and sintered at $1400{^{\circ}C}$ 2 h in air atmosphere. The effect of forming method on porosity, density, strength (flexural and compressive strength) and microstructure was investigated. Also, corrosion test of the sintered candle filter specimens as forming method was performed at $600{^{\circ}C}$ in IGCC syngas atmosphere. The sintered SiC filter which was formed by ramming process has more higher density and exhibit higher strength than extruded filter. Its maximum density and 3-point bending strength were 2.00 g/$cm^3$ and 45 MPa, respectively.

• Journal of Korean Society of Environmental Engineers
• /
• v.30 no.2
• /
• pp.234-238
• /
• 2008

Coarse pore filter could be an alternative of membrane for solid-liquid separation in an activated sludge reactor because of inexpensive cost of the filter material and high flux at low filtration pressure. However such filter module has much less specific filtration area compared to the membrane. Therefore a certain effort is required to increase the specific filtration area in the module design of such coarse pore filter for solid-liquid separation in an activated sludge reactor. In this study, tubular type coarse pore filter was designed at various diameter and configuration. The filtration performance was investigated to separate solid in the activated sludge reactor for domestic wastewater treatment. Tubular type coarse pore filter module could be successfully applicable to solid separation in the activated sludge reactor. The design parameters were the tube diameter of 10mm and vertical installation. Smaller diameter of the tube caused faster increase of the filtration pressure because of the hydraulic head loss in the tube channel.

• Journal of Korean Society for Atmospheric Environment
• /
• v.20 no.3
• /
• pp.361-369
• /
• 2004

A metal fiber bed has seldom been applied to the practical filtration process despite its excellent mechanical and chemical stability. The filter-bed used in this work was highly porous with open structure, of which apparent porosity was 80 ∼ 90%. Although pressure loss across the filter-bed was very low, separation efficiency was found to be quite high. This paper focuses on the basic filtration mechanisms of a metal filter-bed and a thin ceramic filter from fly ash for reference. The experimental parameters were face velocity, dust loading and porosity of filter-bed. Pressure drop increased with increasing face velocity and dust feeding load for both filters. It also showed that dust particles deposited in the deep flow path, finally resulting in clogging the pore channels. It thereby indicates that the dominating mechanism of the metal filter-bed would be depth filtration. Meanwhile, the thin fly ash composite filters trapped the aerated dust mainly on the surface of the filter medium, so that the instantaneously formed dust layer might cause a steep increase of pressure drop across the filtration system.

• Journal of Korean Society of Water and Wastewater
• /
• v.23 no.6
• /
• pp.769-778
• /
• 2009

Performances and internal behaviors of the upflow hybrid anaerobic filters treating a dairy wastewater were analyzed to identify the functions and roles of the modular crossflow media and sludge bed layer and to discover their interrelationship in the filter. The media could perform independent biological and physical separation role without buildup of sludge bed, while the role of sludge bed was dependent on the function of the media. The filter packed with the crossflow media did not necessarily require the formation of sludge bed when treating a dairy wastewater. Biological contribution of the media was controlled by that of biologically active sludge bed complementing mutually each other. The gas-liquid-solid separation capability of the media was indispensible to ensure the active biological role of sludge bed, since sludge bed buildup without the media had no independently effective biological function. It was believed that the filter in itself could also function as a selector for physical gas-liquid-solid separation resulting in selectively concentrating particles with superior settleability in sludge bed. The sludge bed in the filter played a key role in the physical solids capture from influent as well as biological organics removal.

• Journal of the Korea Society of Computer and Information
• /
• v.22 no.12
• /
• pp.55-61
• /
• 2017

In this paper, we propose a novel tracking method using target separation and detection that are based on discriminative correlation filter (DCF), which is studied a lot recently. 'Retainability' is one of the most important factor of tracking. There are some factors making retainability of tracking worse. Especially, fast movement and occlusion of a target frequently occur in image data, and when it happens, it would make target lost. As a result, the tracking cannot be retained. For maintaining a robust tracking, in this paper, separation of a target is used so that normal tracking is maintained even though some part of a target is occluded. The detection algorithm is executed and find new location of the target when the target gets out of tracking range due to occlusion of whole part of a target or fast movement speed of a target. A variety of experiments with various image data sets are conducted. The algorithm proposed in this paper showed better performance than other conventional algorithms when fast movement and occlusion of a target occur.