• Journal of the Korean Graphic Arts Communication Society
• /
• v.30 no.2
• /
• pp.35-45
• /
• 2012

Need color separation process to appear number of minimum printing plate waterway maximum printing color at printing process. This time, printing plate is separated three primary colors of C(cyan), M(magenta), Y(yellow). Appear all colors of printing such three primary colors. But, three primary color ink appears 100% dark gray that is not clean as chroma is neared color to 0 because is not pure. As well as, the ink area rate that is whole by over print amount increase of three primary is expanded. As a result, influence in secondary printablity set-off growth by inaccurate color reproduction and ink dry badness, trapping efficiency decline etc.. Apply ink saving method that is replaced as K ink in consisted dark color constituent because three primary colors are over print each other adding one more K(black) plate by method to improve these problem. Therefore, can reduce extension of the total ink area rate, and help in correct color appearance control. As well as, eco-friendly printing process attains improving printablity at the same time curtailment of printing expense by reducing requirement of total ink. Usually, there are UCR(under color removal) and GCR(gray component replacement) to ink saving application method. But, the practical use limit is insufficient state to tribe of technological investigation or field application about these method in domestic printing field. Therefore, in this research, ink saving been bringing by one method of eco-friendly printing confirmed that is applicable in usual domestic printing environment. Also, searched result getting in printablity by ink saving application.

• Journal of Broadcast Engineering
• /
• v.24 no.6
• /
• pp.1143-1151
• /
• 2019

In this paper, we propose a wireless transmission scheme that maximizes transmission efficiency per frequency bandwidth in a single carrier modulation scheme. The proposed scheme employs a decision directed channel tracking technique to remove both pilot signal and the guard interval signal between symbols in frames. It performs a raised cosine pulse shaping function with an roll-off factor of 0.05. In addition, 2×2 multiple input and multiple output using two polarized antennas is applied and both equalization and signal separation are performed in the frequency domain. The wireless modem with this technology confirms that the transmission speed of up to 63.3Mbps is achieved under the 5MHz frequency bandwidth

• Resources Recycling
• /
• v.14 no.6 s.68
• /
• pp.16-20
• /
• 2005

The selective sulphide precipitation of copper from sulphate solution containing nickel and cobalt was studied with adding $Na_{2}S$ solution. Precipitation efficiency of copper increased with raising pH of solution and increasing the amount of $Na_{2}S$ added and lowing its concentration. The increase in reaction time and temperature also improved the precipitation of copper. However, attempts to selectively precipitate copper met with limited success because of co-precipitation of nickel and cobalt. With adding $20\%$ $Na_{2}S$, 3 times equivalent of Cu, at pH 1.0 of solution, $25^{\circ}C$ and 30 minutes of reaction time, precipitation efficiencies of copper, nickel and cobalt were $94.1\%$, $4.3\%$ and $4.5\%$ respectively.

• Proceedings of the Korean Institute of Resources Recycling Conference
• /
• 2006.05a
• /
• pp.78-85
• /
• 2006

In textile industries, waste effluent containing zinc is generated during the manufacture of rayon yarn from the wood pulp or cotton linters. Due to the strict environmental regulations and the presence of toxic metallic and other constituents, the discharge of industrial effluents in the sewage or disposal of solid sludge as landfill is restricted. Before recycling of zinc as zinc sulphate solution to the spinning-bath of the rayon manufacturing plant the zinc sulphate solution must be free from calcium, which is deleterious to the process as gypsum precipitates with the increase in concentration and forms scale in the bath. In the present work an attempt has been made to develop a process following solvent extraction technique using thiophosphinic extractants, Cyanex 272 and 302 modified with isodecanol and diluted in kerosene to recover zinc from rayon effluent. Various process parameters viz. extraction of zinc from different concentration of solution, distribution ratio, selective extraction, O/A ratio on extraction and stripping from the loaded organic, complex formation in the organic phase etc. have been studied to see the feasibility of the process. The extractant Cyanex 302 has been found selective for the recovery of 99.99% of zinc from the effluent above equilibrium pH 3.4 maintaining the O/A ratio of 1/30 leaving all the calcium in the raffinate. It selectively extracted zinc in the form of complex $[R_{2}Zn.3RH]_{org}$ and retained all the calcium in the aqueous raffinate. The zinc from the loaded Cyanex 302 can be stripped with 10% sulphuric acid at even O/A ratio of 10 without affecting the stripping efficiency. The stripped solution thus obtained could be recycled in the spinning bath of the rayon plant. The raffinate obtained after the recovery of zinc could be disposed safely without affacting environment.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.10 no.7
• /
• pp.1648-1653
• /
• 2009

Fossil fuel causes the greenhouse effect by emitting $CO_2$, and an estimated amount of oil deposits are also limited. Therefore, people have been interested in alternative energies. Vegetable oil which is one of the alternative energies is eco-friendly renewable energy source and has similar properties like diesel oil with high efficiency. Also, vegetable oil has been well recognized as one of solutions to reduce the greenhouse effect caused by $CO_2$release. In this study, we chose Waste vegetable oil(WVO) to solve the problems of high price of grain and lack of food. Impurities and sediments from WVO were removed by separation process using sieves of $15{\mu}m$pore size. Blending was performed in Homo-mixer by 5000 rpm for 10 min. We investigated viscosities and Iodine values in different compositions of WVO and diesel oil blends. Finally, we could find out blended oils have some possibility to be used in the diesel engine.

• Nuclear Engineering and Technology
• /
• v.31 no.5
• /
• pp.506-511
• /
• 1999

The pilot system for radioactive liquid laundry waste was developed with treatment capacity, 1ton/hr and set up in the Yong Kwang unit #4. The system is composed of tank module, RO systems and a UV/$H_2O$$_2$photo-oxidation unit. The RO system consists of the BW unit (low-pressure RO for brackish water desalination) and the SW unit (high-pressure RO for seawater desalination). The BW unit possesses 4 RO membranes and it can reduce the feed water volume down to 1/10. This concentrated feed water can be reduced again up to 1/10 in its volume in the SW unit composed of 4 RO membranes. The UV/$H_2O$$_2$ photo-oxidation process unit was used for the detergent degradation. The operation of the pilot system was carried out and verified in its capability through the continuous operation and concentration operation using the actual liquid waste from the power plant. The design criteria and data for industrialization were yielded. The efficiency of the UV/$H_2O$$_2$ photo-oxidation process and the optimum operational procedure were evaluated. The decontamination factors for radioactive cobalt and cesium were measured. This on-site test showed the experimental result in the DF$\geq$300 and volume reduction factor$\geq$100.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.02a
• /
• pp.124-124
• /
• 2010

Much interest has been focused on InGaN-based materials and their quantum structures due to their optoelectronics applications such as light emitting diode (LED) and photovoltaic devices, because of its high thermal conductivity, high optical efficiency, and direct wide band gap, in spite of their high density of threading dislocations. Build-in internal field-induced quantum-confined Stark effect in InGaN/GaN quantum well LED structures results in a spatial separation of electrons and holes, which leads to a reduction of radiative recombination rate. Therefore, many growth techniques have been developed by utilizing lateral over-growth mode or by inserting additional layers such as patterned layer and superlattices for reducing threading dislocations and internal fields. In this work, we investigated various characteristics of InGaN multiple quantum wells (MQWs) LED structures grown on selectively wet-etched porous (SWEP) GaN template layer and compared with those grown on non-porous GaN template layer over c-plane sapphire substrates. From the surface morphology measured by atomic force microscope, high resolution X-ray diffraction analysis, low temperature photoluminescence (PL) and PL excitation measurements, good structural and optical properties were observed on both LED structures. However, InGaN MQWs LED structures grown on SWEP GaN template layer show relatively low In composition, thin well width, and blue shift of PL spectra on MQW emission. These results were explained by rough surface of template layer, reduction of residual compressive stress, and less piezoelectric field on MQWs by utilizing SWEP GaN template layer. Better electrical properties were also observed for InGaN MQWs on SWEP GaN template layer, specially at reverse operating condition for I-V measurements.

• Resources Recycling
• /
• v.22 no.4
• /
• pp.70-80
• /
• 2013

Waste refrigerator is the most large amount of item being recycled and the recycling process is the most complicated in WEEE (Waste Electrical and Electronic Equipment) because refrigerator is biggest product and consists of various parts and materials such as ferrous, non-ferrous, and plastics. Recently, recycling process of waste refrigerator has been being more complex since large capacity 2 door refrigerators and standing Kimchi refrigerators with various material are distributed on custom market. In addition, recycling of valuable resource from waste refrigerator is mandatory by WEEEs recycling legislation; therefore, high efficiency recycling enough for economic and environment-friendly recovery of valuable resource through present technical situation analysis and comparison of recycling technologies of waste refrigerator with advanced country.

• Resources Recycling
• /
• v.26 no.5
• /
• pp.67-76
• /
• 2017

In order to efficiently recycle waste industrial nickel-cadmium batteries, anodic and cathodic materials were crushed by a cut mill and classified by sieves. We used wet magnetic separation method for eliminating iron components from the crushed powders. In addition, the acid leaching test for the obtained anode and cathode powders was carried out under various conditions by means of the wet process. At the optimum leaching conditions with 2.0 M $H_2SO_4$ at $90^{\circ}C$, 15 wt $H_2O_2$ and L/S=20 for 3 hours, the leaching efficiency of nickel and cadmium was 99%, respectively.

• Membrane and Water Treatment
• /
• v.8 no.4
• /
• pp.381-393
• /
• 2017

The inorganic components in tobacco sheet extract have significant influence on the sensory taste of the cigars and the harmful component delivery in cigarette smoke. To identify the contributions of the divalent inorganic components on harmful components delivery in cigarette smoke, a self-made selective electrodialysis was assembled with monovalent ion-selective ion exchange membranes. The influences of current density and extract content on the desalination performance were investigated. Result indicates that the majorities chloride, nitrate, and sulfate ions were removed, comparing with 50-60% of potassium and only less than 10% of magnesium and calcium ions removed in the investigated current density. The permselectivity of the tested cations across the Selemion CSO cation exchange membranes follows the order: $K^+>Ca^{2+}>Mg^{2+}$. A current density of $15mA/cm^2$ is an optional choice by considering both the energy consumption and separation efficiency. When the extract contents are in the range of 7%-20%, the removal ratios the potassium ions are kept around 60%, while the removal ratios of the calcium and magnesium ions fluctuate in the range of 16-27% and 8-14%, respectively. The tobacco smoke experiments indicated that the divalent metal ions have dual roles for the harmful component delivery in cigarette smoke. The divalent potassium and calcium ions were unfavorable for the total particulate matter emission but beneficial to decrease the HCN delivery in the mainstream cigarette smoke. The selective electrodialysis is a robust technology to decrease the harmful component delivery in cigarette smoke.