• 한국해양공학회지
• /
• 제27권5호
• /
• pp.88-92
• /
• 2013

The icebreaking research vessel (IBRV) ARAON had her second ice trial in the Arctic Ocean in the summer season of 2010. During the voyage, the local ice loads acting on the bow of the port side were measured using 14 strain gauges. These measurements were carried out in three icebreaking performance tests. To convert the measured strains into the local ice pressures, a finite element model of the instrumented area was developed. The influence coefficient method (ICM), which uses the influence coefficient from the finite element model, and the direct method, which uses the measured strain, were selected as the conversion methods. As a result, the maximum measured pressure was 1.236MPa, and the average difference between ICM and the direct method was about 5% for an area of $0.2m^2$. The pressure-area relationship of the measurement falls below the range of the existing pressure-area curve, which is due to the low ice strength of melted ice in the summer.

• 한국산학기술학회논문지
• /
• 제21권4호
• /
• pp.546-551
• /
• 2020

함정에는 격벽으로 구분되어 나누어지는 공간인 격실이 종류와 목적에 따라 수개 혹은 수십 개가 존재한다. 이러한 격실들은 화재 및 화재로 인한 연기의 전이방지, 침수 시 침수의 확산 방지 등 특정 격실에서 발생하는 특이 상황들이 타 격실로의 전이를 방지하여 생존성 향상에 목적을 두고 설계된다. 생존성 향상 목적 달성을 위하여 각 격실들은 기밀 또는 수밀을 유지하도록 건조하며, 각 격실의 기밀 또는 수밀 정도를 확인하기 위하여 함정 건조 단계에서 평가를 수행한다. 건조하고 있는 군함에 관한 평가는 해군 지침에 의거하여 함 건조업체 주관으로 해군 및 국방기술품질원이 입회하여 평가를 실시한다. 생존성과 직결되는 만큼 격실 기밀 평가의 중요성은 매우 높아 명확한 기준에 따라 수행되고 있으나, 1개 이상의 복수개 격실 기밀 평가 시 1개 압력센서로 압력을 측정하여 격실 압력을 실시간으로 확인하는 것과 각 격실별 미세한 압력 변동 사항 확인이 제한되는 것을 식별하였다. 따라서 본 연구에서는 현재 수상함정 중 군함에서 실시하고 있는 그룹 격실 기밀평가 방안에 대한 개선 방안 및 신뢰성 검증 방안에 대해 서술하였다.

• 대한조선학회논문집
• /
• 제45권2호
• /
• pp.175-185
• /
• 2008

One of the concerns that arise during navigation in ice-covered waters is the magnitude of ice loads encountered by ships. However, the accurate estimation of ice loads still remains as a rather difficult task in the design of icebreaking vessels. This paper focuses on the development of simple ice load prediction formulas for the icebreaking cargo vessels. The maximum ice loads are expected from unbroken ice sheet and these loads are most likely to be concentrated at the bow area. Published ice load data for icebreaking vessels, from the model tests and also from full-scale sea trials, are collected and then several ice load prediction formulas are compared with these data. Finally, based on collected data, a semi-empirical ice load prediction formula is recommended for the icebreaking cargo vessels.

• International Journal of Naval Architecture and Ocean Engineering
• /
• 제11권1호
• /
• pp.364-379
• /
• 2019

Wave-induced ship motion and load responses are usually investigated on the assumption that the incident waves are long-crested. The realistic sea waves are however short-crested irregular waves. Real practice reveals that the ship motion and load responses induced by short-crested waves are different from those induced by long-crested waves. This paper aims to conduct a comprehensive study on ship motions and loads in different wave fields. For this purpose, comparative studies by small-scale model towing tank test and large-scale model sea trial are conducted to experimentally identify the difference between ship motions and loads in long-crested and short-crested irregular waves. Moreover, the influences of directional spreading function of short-crested waves on ship motions and loads are analyzed by numerical seakeeping calculation. The results and conclusions obtained from this study are of great significance for the further extrapolation and estimation of ship motions and loads in short-crested waves based on long-crested wave response results.

• 수산해양기술연구
• /
• 제42권3호
• /
• pp.148-157
• /
• 2006

A model experiment, simulation test using personal computer and real sea trial fishing were carried out to investigate the basic efficiency of bottom trawl net which can be used in the sea mount of North West Pacific, and experimental values were analyzed as the values of full-scale bottom trawl net. Hydrodynamic resistance for the full-scale trawl net according to the Koyama equation was 2.1 times higher than that of simulation and 2.4 times higher than that of model experiment at the average towing velocity. At the 3.5kt's of towing speed, net width of the full-scale trawl net was 2.5% smaller than that of simulation and 8.2% larger than that of model experiment. On the fishing experiment of the full-scale trawl net for the 3.5kt's of average towing speed, average net height of A group(same direction with external force) was 423.5% higher than that of model experiment and 457.1% higher than that of simulation and that of B group(opposite direction with external force) were 283.8% and 306.3% higher than in case of model experiment and Simulation respectively. Net mouth of the full-scale trawl net was 338.1-504.6% higher than those of model experiment and simulation in A group, and 525.2-745.3% higher in B group.

• 수산해양기술연구
• /
• 제36권4호
• /
• pp.274-280
• /
• 2000

본 연구는 실습선에서 사용 중인 6폭짜리 저층트롤 어구의 저항을 끌줄의 길이와 예망 속도별로 분석하기 위하여 그물의 저항과 전개판의 저항을 계측하고, 어구의 저항계수를 산정하였으며, 그 결과를 요약하면 다음과 같다. 1. 시험 어구의 저항은 끌줄의 길이가 길수록 증가하나, 저항 R$\sub$t-w/=3800v$^2$으로 대표할 수 있다. 2. 그물 어구의 저항은 끌줄의 길이에 따라 다소 증가하나, 그물 어구의 저항 R$\sub$n/=10R$\sub$n/=10d/lλ$\sub$a/λ$\sub$b/v$\^$1.3/의 식으로 대표할 수 있다. 3. 시험 어구의 전개판의 저항 R$\sub$b/=1810v$\^$0.8/으로 대표할 수 있다. 4. 끌줄의 길이별로 측정된 저항값과 Koyama의 저항식과 비교하면, 예망속도가 작을 때는 시험 어구의 저항이, 예망속도가 클 때는 Koyama의 저항식에 의한 저항값이 크게 나타났다.

• 대한조선학회논문집
• /
• 제54권3호
• /
• pp.204-214
• /
• 2017

Recently, ship owners have been requiring the assessment of the maneuverability of a twin-screw ship under machinery failures. In this paper, we are only focused on the propulsion failure among propulsion failure, power supply failure, steering system failure etc. First of all, the mathematical model for the twin-screw 174K LNGC is verified by comparing the simulated results for $35^{\circ}$ turning test, $10^{\circ}/10^{\circ}$ zigzag test and $20^{\circ}/20^{\circ}$ zigzag test under normal operating condition and those obtained from free running model tests. And, sea trial results of 216K LNGC under single propeller failure are compared with those of 174K LNGC under identical condition to verify the proposed method to predict maneuverability under single propeller failure. After the straight line maneuver is simulated under the single propeller failure, the speed and equilibrated heading and rudder deflection angles at steady state are predicted. After the IMO maneuvering tests are simulated under the single propeller failure, the results are reviewed to investigate the maneuvering characteristics due to the failure.

• 한국해양공학회지
• /
• 제32권6호
• /
• pp.518-526
• /
• 2018

As a new technical approach, this paper introduces a method for improving an electrically propelled outboard motor in consideration of the driving system applied to an electric-propulsion boat with solar cell energy. The most efficient model for a drive shaft, propeller shaft, and bevel gear was suggested and examined with respect to the results of test operation in prototype mode. Furthermore, this research included a performance evaluation of the manufactured prototype to acquire the purposed quantity value and the development items. After manufacturing the desired prototype of an electrically propelled outboard motor, the maximum sail time, thrust force, noise, and weight were evaluated in a performance test. An additional test in relation to the maximum sail speed (knots) of the completed prototype was conducted using a sea trial evaluation to acquire the optimum quantity.

• 수산해양기술연구
• /
• 제53권2호
• /
• pp.177-186
• /
• 2017

This study is intended to provide navigator with specific information necessary to assist in the avoidance of collision and in operation of ships to evaluate the maneuverability of research vessel Jera. Authors carried out full-scale sea trials for turning test, zig-zag test, and spiral test at actual sea-going condition, which were performed on starboard and port sides with 10-20 rudder angle at service speed of 10 knots. The turning circle was much different at both of the turning of port and starboard which was longer at the starboard than at the port. In the zig-zag test results, the port and starboard was $10^{\circ}$ the first and second overshoot angles were $6.0^{\circ}$, $5.8^{\circ}$ and $6.3^{\circ}$, $7.1^{\circ}$ respectively and the first overshoot angles were $16.4^{\circ}$, $17.6^{\circ}$ when using $20^{\circ}$. Her maneuverability index T and N can be easily determined by using an analogue computer with the data obtained from the zig-zag tests where K is a constant representing the turning ability and T is a constant representing her quick response. In the zig-zag tests under $10^{\circ}$ or $20^{\circ}$ at rudder angle, the value K is 0.149. 0.123 sec- and T is 11.853 and 6.193 sec and angular velocity is $0.937^{\circ}/sec$ and $1.636^{\circ}/sec$. In the spiral test, the loop width was unstable at $+0.51^{\circ}$ and $-1.19^{\circ}$ around the midship of rudder, but the tangent line at $0^{\circ}$ was close to vertical. From the sea trial results, we found that she did comply with the present criterion in the standards of maneuverability of IMO.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2000년도 가을 학술발표회논문집(I)
• /
• pp.395-398
• /
• 2000

Recently, increasement of usage contents of sea sand in constructing concrete structures due to insufficiency of high quality river sand, led to many studies for steel corrosion and control methods on it in concrete. But, domestic studies for threshold chloride contents of steel corrosion are not so many as those of foreign states. In this study, the electrochemical test as half cell potential measurement and linear polarization method to estimate the corrosion of steel in contents mixed with several levels chloride contents was performed, thereby, pre-mixed chloride were compared with results measured quantitatively for steel corrosion. And, based on these data, a trial to determine threshold chloride contents of steel corrosion was made.