• Journal of Bio-Environment Control
• /
• v.28 no.4
• /
• pp.366-375
• /
• 2019

This experiment aims to determine the proper irrigation scheduling based on a whole-substrate capacitance using a newly developed device (SCMD) by comparing with the integrated solar radiation automated irrigation system (ISR) and sap flow sensor automated irrigation system (SF) for the cultivation of tomato (Solanum lycopersicum L. 'Hoyong' 'Super Doterang') during spring to winter season. For the SCMD system, irrigation was conducted every 10 minutes after the first irrigation was started until the first run-off was occurred, of which the substrate capacitance was considered to be 100%. When the capacitance threshold (CT) was reached to the target point, irrigation was re-conducted. After that, when the target drain volume (TDV) was occurred, the irrigation stopped. The irrigation volume per event for the SCMD was set to 50, 75, or 100 mL at CT 0.9 and TDV 100 mL during the spring to summer cultivation, and the CT was set to 0.65, 0.75, 0.80, or 0.90 in the winter cultivation. When the irrigation volume per event was set to 50, 75, or 100 mL, the irrigation frequency in a day was 39, 29, and 19, respectively, and the drain rate was 3.04, 9.25, and 20.18%, respectively. When the CT was set to 0.65, 0.75, or 0.90 in winter, the irrigation frequency was about 6, 7, 15 times, respectively and the drain rate was 9.9, 10.8, 35.3% respectively. The signal of stem sap flow at the beginning of irrigation starting time did not correspond to that of solar irradiance when the irrigation volume per event was set to 50 or 75 mL, compared to that of 100 mL. In winter cultivation, the stem sap flow rate and substrate volumetric water content at the CT 0.65 treatment were very low, while they were very high at CT 0.90 was high. All the integrated data suggest that the proper range of irrigation volume per event is from 75 to 100 mL under at CT 0.9 and TDV 100 mL during the spring to summer cultivation, and the proper CT seems to be higher than 0.75 and lower than 0.90 under at 75 mL of the irrigation volume per event and TDV 70 mL during the winter cultivation. It is going to be necessary to investigate the relationship between capacitance value and substrate volumetric water content by determining the correction coefficient.

• Journal of Korea Water Resources Association
• /
• v.50 no.12
• /
• pp.803-813
• /
• 2017

Recently, various studies have been conducted to optimize the pump operation scheduling and/or the pump/tank size minimizing the system cost of water distribution network. Prior to that, it is important to understand the sensitivity of pump/tank size on the system cost and overall water quality. Here, we have performed the sensitivity analysis to investigate the effect of pump/tank size on the economic cost (construction and operation) and water quality (water age). The analysis was applied on a real, large-scale water transmission network currently operating in South Korea. The results revealed that the pump/tank size has a strong influence on system construction/operation costs. Especially, the tank size has a significant effect on the system-wide water quality. In the case of applied networks, the operating cost decreases as the capacity of the facility increases, but the design cost increases. Using a sensitivity analysis, a suitable range of pump/tank size could be suggested to minimize costs and stabilize the water quality at the same time prior to a system design.

• Proceedings of KOSOMES biannual meeting
• /
• 2007.05a
• /
• pp.203-210
• /
• 2007

This paper treats optimal route safety assessment system at seaway based on weather forecasting data through INMARSAT. Since early times, captain have been sailing to select the optimum route considering the weather, ship loading status condition and operational scheduling empirically. However, it is rare to find digitalized onboard route support system whereas weather facsimile or wave and swell chart are utilized for the officer, based on captain's experience. In this paper, optimal route safety assessment system which is composed of voyage efficiency and safety component is introduced. Optimum route minimized ETA(estimated time of arrival) and fuel consumption that shipping company. and captain are requiring to evaluate for efficient voyage considering speed loss and power increase based on wave added resistance of ship. In the view point of safety, seakeeping prediction is performed based on 3 dimensional panel method Basically, the weather forecast is assumed to be prepared previously in order to operate this system.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.5D
• /
• pp.617-625
• /
• 2008

In low-density areas where travel pattern is widely dispersed and travel demand is relatively low, transit operators find it very difficult to provide a reasonable level of service at a reasonable cost. Timed-transfer system or network, if designed properly, can provide a reasonable level of service for passengers using transit systems serving low-density areas. The paper intends to apply a timed-transfer system for bus lines serving Yangsan City area and to assess the effects resulted from the application. The concept of a timed-transfer network/system is briefly described, and the present conditions of bus systems in Yangsan City area are discussed, focusing on the aspects of network type and the related problems. The bus timed-transfer network for the area is then developed by adjusting the existing routes and network with the consideration of travel time, route alignments, headways and transfer centers. One must note that developing a timed-transfer network presumes that network and schedule should be developed together. The effects of the developed time-transfer system on the passengers and operators are found substantially so as to justify its introduction to the City. The results of this study will be of considerable use for planners to design the transit systems in low density areas, where in general travel activities are widely dispersed and travel demands are low, so that provision of good quality of transit services are difficult.

• Journal of Korean Academy of Nursing Administration
• /
• v.5 no.2
• /
• pp.209-224
• /
• 1999

I have practiced this reserch for the purpose of proposition of basic data for amendment and addition of computer system after I surveyed the degree of abilities and satisfaction on the computerization in nursing\ practice. Subjects were collected from September 1 to September 30, 1998. Study subjects are 151 clinical nurses who are working at university hospital in Chonbuk area. Study instrument consists of 116 questionnaire which was developed by Kim H. K(1998). The data were analized number, mean ,t-test, ANOVA by using SPSS. The study results are as follows: 1. Most of the nurses who answered the questions were educated computerizing(96%). The abilities of computer program utilities were the most in inputting data(74%). The program nurses wanted computerizing education was wordprocess, dealing internet and statistics. 2. As for applying parts of computer system in nursing, the most nurses were Dr's order check (96%), treatment activity(91.4%), medication(89.4%), lab. test(87 .4%), transfering department(85.4%), transfering room(79.5%), diet(71.8%), discharge (70.2%), Barcord Sticker(70.2%) , reservation(62.2%) in order that were all conected order system mutually to other part. It showed that computer system was not applied for treating the original nursing work such as nursing record (13%), duty scheduling(6.0%) , nursing process(4.6%) , Q.I(1.3%), nursing research(1.3%), education(1.3%), 3. As for the benefit when computer system is applied for, the most respondence was promptness of work and convenience(90.6%) , exactness of work (82.8%), offering information exactily and efficiently(36.3%), offering good quality of nursing (6.0%) in order. 4. The degree of contentment on computerizing in nursing practice showed average 3.24%. The best marking item is that they are eager to participate in the computer education. Next, the automatic output of label and giving the number automatically is to prevent loss and mentioned items of patient registration from being changed(3.95) and to prevent mistakes possibly happening because of doctor's difficult order(3.85). 5. The problems which may happen to in nurses' utilization of computerization for the nursing practice showed average 3.18. The most problem is that the practice may stop because of the problem of computer itself(3.67), and the next, the indication of act can be imperfect(3.66) , manual training may overlap because of incomplete computerization (3.60), practical education for the computerizing is lack(3.41), and the computer literate nurses are lack(3.40) . 6. Study subject's contentment by age was significant difference(F=3.10,P=0.0119). Study subject's contentment by job posision was significant difference(F=6.001P=0.0034) I will propose the following according to the above results. The domain of original nursing practice is urgernt. Manual and indication of act should be made before long in computer obstacle. Nursing department should support the nurses so that they could receive the education needed for the nurses themselves.

• Asia-Pacific Journal of Business Venturing and Entrepreneurship
• /
• v.13 no.2
• /
• pp.115-123
• /
• 2018

This study is empirically intended to put forward the modeling and process improvement measures for the SCM capability in small venture firms. The findings are summarized as follows. There were strategic alliance, technological development and centralization in the modeling of strategic planning for supply chain, not the least of which is strategic alliance, followed by centralization and technological development. There were routing scheduling, network integration and third party logistics outsourcing in decision making, not the least of which was network integration. There were customer service management, productivity management and quality management in management control, not the least of which was quality management. And there were order management choice, pricing demand, shipment delivery and customer management in transaction support system, not the least of which was order management choice. As for the above-mentioned findings, to maximize the SCM capability and operate the optimized process in small venture firms, the existing strategic alliances can optimize the quality management and stabilize the transaction support system through the network sharing and integration from the perspective of relevant organizational members' capability and process improvement. And the strategic linkage between firms can maximize the integrated capability of information system beyond the simple exchange relation between electronic data, achieving a differentiated competitive advantage. Consequently, the systematization and centralization for the maximization of SCM capability, including the infrastructure construction based on the system compatibility and reliability for information integration, should be preceded before the modeling of the integrated capability for optimum supply chain and the best process management in the smart era.

• Journal of KIISE:Computer Systems and Theory
• /
• v.33 no.9
• /
• pp.592-607
• /
• 2006

This paper proposes a technique to select processors and hardware IPs and to map the tasks into the selected processing elements, aming to achieve high performance with minimal system cost when multitask applications with real-time constraints are run on a multicore SoC. Such technique is called to 'Hardware-Software Cosynthesis Technique'. A cosynthesis technique was already presented in our early work [1] where we divide the complex cosynthesis problem into three subproblems and conquer each subproblem separately: selection of appropriate processing components, mapping and scheduling of function blocks to the selected processing component, and schedulability analysis. Despite good features, our previous technique has a serious limitation that a task monopolizes the entire system resource to get the minimum schedule length. But in general we may obtain higher performance in multitask multicore system if independent multiple tasks are running concurrently on different processor cores. In this paper, we present two mapping techniques, task mapping avoidance technique(TMA) and task mapping pinning technique(TMP), which are applicable for general cases with diverse operating policies in a multicore environment. We could obtain significant performance improvement for a multimedia real-time application, multi-channel Digital Video Recorder system and for randomly generated multitask graphs obtained from the related works.

• Journal of Korea Water Resources Association
• /
• v.51 no.12
• /
• pp.1171-1180
• /
• 2018

Korea's water transmission system is operated by the nonpressure flow method that flows from highlands to lowlands due to the nature of Korea with many mountainous areas. In order to store water in the highlands, the water pumps are installed and operated. However, In this process, a lot of electrical energy is consumed. therefore, it is necessary to minimize the energy consumption by optimizing the size and operation schedule of the water pumps. The optimal capacity and operation method of the water pump are affected by the size of the tank (distributing reservoir). Therefore, in order to economically design and operate the water transmission system, it is reasonable to consider both the construction cost of the water pump and the tank and the long-term operation cost of the water pump at the step of determining the scale of the initial facilities. In this study, the optimum design model was developed that can optimize both the optimal size of the water pump and the tank and the operation scheduling of the water pump by using the genetic algorithm (GA). The developed model was verified by applying it to the water transmission systems operated in Korea. It is expected that this study will help to estimate the optimal size of the water pump and the tank in the initial design of the water transmission system.

• Journal of Advanced Navigation Technology
• /
• v.20 no.6
• /
• pp.595-603
• /
• 2016

In the Republic of Korea, the LTE-based public safety (PS-LTE) network is being built for the 700 MHz frequency band. However, the same bands are also assigned to the LTE-based high-speed railway (LTE-R) network. Therefore, it is essential to utilize the co-channel interference management schemes for the coexistence of two LTE networks in order to increase the system throughput and to reduce the user outage probability. In this paper, we focus on the downlink (DL) system for the coexistence of PS-LTE and LTE-R networks by considering non radio access network (RAN) sharing and LTE-R RAN sharing by PS-LTE users (UEs) to analyze the UE throughput. Moreover, we also utilize the cooperative communications schemes, such as coordinated multipoint (CoMP) for the coexistence of PS-LTE and LTE-R networks in order to reduce the UE outage probability. We categorize the coexistence of PS-LTE and LTE-R networks into four different scenarios, and evaluate the performance of each scenario by the important performance indexes, such as UE average throughput and UE outage probability.

• Journal of Broadcast Engineering
• /
• v.16 no.5
• /
• pp.834-845
• /
• 2011

Massive broadcasting contents such as UHD(Ultra High Definition) TV which requires multi-channel capacity for transmission has been introduced in recent years. A transmission scheme with channel bonding has been considered for transmission of massive broadcasting contents. In HFC(Hybrid Fiber Coaxial) networks, DOCSIS 3.0(Data Over Cable Service Interface Specification 3.0) has already applied channel bonding schemes for up/downstream of data service. A method unlike DOCSIS 3.0 is required to introduce a channel bonding scheme in the broadcasting service having unidirectional transmission with a downstream. Since a massive broadcasting content requires several channels for transmission, VBR(Variable Bit Rate) transmission has been emerging for the bandwidth efficiency. In addition, research on channel allocation and resource scheduling is required to guarantee QoS(Quality of Service) for the broadcasting service based on VBR. In this paper, we propose a transmission method for mass broadcasting service in HFC network and show the UHD transmission simulator developed to evaluate the performance. In order to evaluate the performance, we define various scenarios. Using the simulator, we assess the possibility of channel bonding and VBR transmission for UHD broadcasting system to provide mass broadcasting service efficiently. The developed simulator is expected to contribute to the efficient transmission system development of mass broadcasting service.