• Journal of the Korean Institute of Telematics and Electronics T
• /
• v.36T no.2
• /
• pp.63-69
• /
• 1999

The frequency-dependent characteristics of the finline have previously been analyzed using several frequency domain approaches. But the time domain TLM method presented in this paper is another independent approaches for obtaining frequency domain results for finline. The structure analysed with this algorithm is unilateral finline in WR-62 waveguide enclosures and the symmetrical condensed node based on the properties of Huygen's scattering model is used. From the TLM results, the frequency-dependent scattering parameters of a unilateral finline have been calculated by Fourier transform of the time domain data. The numerical results are in good agreements with other paper, thus demonstrating the validity and usefulness of the proposed method.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.2A
• /
• pp.63-69
• /
• 2003

In this paper, the scattered field from a perfectly conducting fractal surface by Finite-Difference Time-Domain(FDTD) method was computed. A one-dimensional fractal surface was generated by using the fractional Brownian motion model. Back scattering coefficients are calculated with different values of the spectral parameter(S0), fractal dimension(D) which determine characteristics of the fractal surface. The number of surface realization for the computed field, the point number, and the width of surface realization are set to be 80, 1024, 16λ, respectively. In order to verify the computed results these results are compared with those of small perturbation methods, which show good agreement between them.

• Korean Journal of Remote Sensing
• /
• v.26 no.6
• /
• pp.653-664
• /
• 2010

The land surface reflectance is a key parameter influencing the climate near the surface. Therefore, it must be determined with sufficient accuracy for climate change research. In particular, the characteristics of the bidirectional reflectance distribution function (BRDF) when using earth observation system (EOS) are important for normalizing the reflected solar radiation from the earth's surface. Also, wide swath satellites like SPOT/VGT (VEGETATION) permit sufficient angular sampling, but high resolution satellites are impossible to obtain sufficient angular sampling over a pixel during short period because of their narrow swath scanning. This gives a difficulty to BRDF model based reflectance normalization of high resolution satellites. The principal objective of the study is to add BRDF modeling of high resolution satellites and to supply insufficient angular sampling through identifying BRDF components from SPOT/VGT. This study is performed as the preliminary data for apply to high-resolution satellite. The study provides surface parameters by eliminating BRD effect when calculated biophysical index of plant by BRDF model. We use semi-empirical BRDF model to identify the BRD components. This study uses SPOT/VGT satellite data acquired in the S1 (daily) data. Modeled reflectance values show a good agreement with measured reflectance values from SPOT satellite. This study analyzes BRD effect components by using the NDVI(Normalized Difference Vegetation Index) and the angle components such as solar zenith angle, satellite zenith angle and relative azimuth angle. Geometric scattering kernel mainly depends on the azimuth angle variation and volumetric scattering kernel is less dependent on the azimuth angle variation. Also, forest from land cover shows the wider distribution of value than cropland, overall tendency is similar. Forest shows relatively larger value of geometric term ($K_1{\cdot}f_1$) than cropland, When performed comparison between cropland and forest. Angle and NDVI value are closely related.

• Current Optics and Photonics
• /
• v.3 no.4
• /
• pp.342-349
• /
• 2019

We present a theoretical research concerning terahertz (THz) wave generation with $KTiOPO_4$ (KTP) by collinear phase matching (CPM) stimulated polariton scattering (SPS). Both CPM and corresponding nonzero nonlinear coefficients can be simultaneously realized with $s{\rightarrow}f+f$ in yz plane, $s{\rightarrow}f+s$ with ${\theta}$ < ${\Omega}$ in xz plane and $s{\rightarrow}f+f$ with ${\theta}$ < ${\Omega}$ in xz plane. The effective nonlinear coefficients including electronic nonlinearities and ionic nonlinearities are calculated. Based on the parameter values of refractive indices, absorption coefficients and effective nonlinear coefficients, we simulate THz wave intensities generated with CPM SPS by solving coupled wave equations and give the relationship among the maximum THz wave intensity, optimal crystal length and the angle ${\theta}$. The calculation results demonstrate that CPM SPS with KTP can generate THz waves with high intensities and quantum conversion efficiencies.

• Elastomers and Composites
• /
• v.37 no.2
• /
• pp.79-85
• /
• 2002

Ethyl-branched polyethylene [PE(2)] containing 2mole% ethyl branch and three ethylene-propylene rubbers (EPR's) having the same ethylene(E)-propylene(P) molar ratio(E/P=50/50) with different stereoregularity, that is, random EPR (r-EPR), alternating-EPR (alt-EPR) and isotactic-alternating-EPR (iso-alt-EPR) were mixed for the investigation or their properties depending on the stereoregularity. Crystallinity of the prepared blends decreased with increasing content of amorphous EPR because of a decrease in both the degree of annealing and kinetics of diffusion of the crystallizable polymer content. With blend composition, crystallinity was reduced with the stereoregularity in EPR. The thermodynamic interaction parameter(x) for the three blend systems approximately equals to zero near the melting point. These systems were determined to be miscible on a molecular scale near or above the crystalline melting point or the crystalline PE(2). From the measurement of $T_m$ vs. $T_c$, the behavior of PE(2) is mainly due to a diluent effect of EPR component. The spherulite size measured by small angle light scattering (SALS) technique depended upon blend composition, and stereoregularity of EPR. The size of spherulite was enlarged with the content of rubbery EPR and the decrease of stereoregularity in EPR.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1993.11a
• /
• pp.134-136
• /
• 1993

Microelectronic fabrication technology .is based on the use of lithsgraphy to create small linewidths and patterns that make up ULSI. In previous papers, we discussed the theoretically calculated values such as ion range, ion concentration,ion transmission coefficient and the defocused ion beam-induced characteristics in a-Se$_{75}$Ge$_{25}$. In this paper, the typical Monte Carlo (MC) simulation results and p개cedures for the focused ion beam lithography were presented. The interaction and scattering of ions with the resist depend on the beam energy, impact parameter arid resist parameters. For ion exposure simulations, the quantity of interest is the spatial distribution of energy deposited by ions in the resist due to interaction phenomena with resist ions.s.s.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.3
• /
• pp.464-473
• /
• 2000

The method is presented which predicts voltage waveforms at each nodes inter-connected arbitrarily on the coupled transmission lines by extracting the node connection condition to be included in the modal telegrapher's equation, hence analyzing the mechanism of waveform propagation on transmission lines. It is shown that it is also possible to analyze efficiently the coupled nonuniform lines. And then the nonuniformity of coupled lines is demonstrated for suppressing the crosstalk spikes using the one-dimensional inverse-scattering control theory. The predicted waveforms by presented method are analyzed and verified by comparison with those by the generalized S-parameter technique.

• Journal of the Korean Vacuum Society
• /
• v.12 no.S1
• /
• pp.36-39
• /
• 2003

Field-domain dynamics and current self-oscillations are theoretically studied in quantum-well (QW) negative-effective-mass (NEM) $p^{+}pp^{+}$ diodes when the electric field is applied along the direction of the well. The origin of current self-oscillations is the formation and traveling of electric-field domains in the p-base. We have accurately considered the scattering contributions from carrier-impurity, carrier-acoustic phonon, and carrier-optic phonon. It's indicated that, both the applied bias and the doping concentration largely influence the current patterns and self-oscillating frequencies, which lie in the THz range for the NEM $p^{+}pp^{+}$ diode with a submicrometer p-base. The complicated field-domain dynamics is presented with the applied bias as the controlling parameter.

• Atmosphere
• /
• v.18 no.1
• /
• pp.1-14
• /
• 2008

The cloud amount, one of the basic parameter in atmospheric observation, have been observed by naked eyes of observers, which is affected by the subjective view. In order to ensure reliable and objective observation, a new algorithm to retrieve cloud amount was constructed using true color images composed of red, green and blue (RGB). The true color image is obtained by the Skyview, an all-sky imager taking pictures of sky, at the Science Building of Yonsei University, Seoul for a year in 2006. The principle of distinguishing clear sky from cloudy sky lies in the fact that the spectral characteristics of light scattering is different for air molecules and cloud. The result of Skyview's algorithm showed about 77% agreement between the observed cloud amount and the calculated, for the error range, the difference between calculated and observed cloudiness, within ${\pm}2$. Seasonally, the best accuracy of about 83% was obtained within ${\pm}2$ range in summer when the cloud amounts are higher, thus better signal-to-noise ratio. Furthermore, as the sky turbidity increased, the error also increased because of increased scattering which can explain the large error in spring. The algorithm still need to be improved in classifying sky condition more systematically with other complimentary instruments to discriminate thin cloud from haze to reduce errors in detecting clouds.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.34D no.9
• /
• pp.15-20
• /
• 1997

Waveguide bandpass filters using E-plane or H-plane discontinuities have been used in many satellite communication systems. Since the transmitter and receiver of such systems tend to be getting smaller, components such as bandpass filters must also be reduced in size. In this paper, in order to reduce the waveguide, itself, of which bandpass filters consist, double plane step waveguide discontinuities are considered. They are analyzed using the mode matching method and the genralized scattering parameter of the cascaded structure is calculated. The characteristics of the bandpass filter which is designed using the reduced size waveguide is optimized by OSA90$^{TM}$. The bandpass filter has a good characteristics and smaller size than those made of the E-plane or H-plane step discontinuities.s.