• Journal of Animal Environmental Science
• /
• v.1 no.1
• /
• pp.9-19
• /
• 1995

This study was carried out to investigate the effect of sawdust bedding barn on manure handing, management labour and physiological aspect of dairy cows, and then to establish the criteria on the optimum utilization method of sawdust bedding barn. 46 tie stall barns and 49 sawdust bedding barns were surveyed to cmopare the milk productivity between two different barns, and also 5 tie stall barns, 15 sawdust bedding barns and 1 rice hull bedding barn were selected to study the utilization situation of sawdust barn in Kyung-Ki province area. The major results obtained were as follows; 1. The roof material of sawdust barn were consisted of 66% vinyl house, 23% PVC light and 11% slate and galvanum coated tin. Most of the floor structure was earth ground with the rate of the approximately 82%. 2. The average occupied area of sawdust bed per cow was 15.2 $m^2$, depth that 30 cm and the utilization period was 12 months. 3. Milk Yield was significantly higher at sawdust barn than at tie stall barn(P<0.01). Bacterial and somatic cell count in raw milk were less at the sawdust barn than in tie stall barn. However, there was not significance difference between two barns. 4. The labour hour needed to cow management in the sawdust barn was approximately 48% of that of tie stall barn. 5. The temperature and moisture content measured in sawdust bed were closely affected by seasonal ambient temperature. The skin and hair of cow were much cleaner at the PVC light roofed sawdust barn than any other roof materials. 6. The additives used for improving of fermentation did not show any effect on temperature and moisture content in sawdust bed. When the ambient temperature was $30.4^{\circ}C$, the surface temperature of measured 1 cm above the sawdust bed was $12.2^{\circ}C$ lower and the temperature of 100 cm above the sawdust bed was $2.4^{\circ}C lower under shading net facility than that of vinyl roofed one.7. The hoof length of miking cow was 7.95 cm in tie stall and 9.19 cm in sawdust barn with high significance (P<0.01). And disease occurence such as mastitis and foot-rot tended to decrease in the sawdust barn. 8. The number of total bacteria and coliform bacteria were less in the sawdust bed compared with earth ground resting area. And a parasite strongyloides papillosus was detected but without any infected cow. 9. The nitrate($NO_3N$) content in non-roofed earth ground resting area and earth ground under the sawdust bed was likely to pollute the ground water. 10. In economic point of view, rice hull bedding barn was the cheapest among different systems. And in the sawdust bedding barn PVC light + slate roofed barn was most desirable, and vinyl roofed one the least.

• Journal of Mushroom
• /
• v.14 no.1
• /
• pp.1-5
• /
• 2016

To minimize cultivation costs, prevent insect-pest infestation, and improve the production efficiency of thermophilic mushrooms, plant substrates obtained from local areas in Cambodia were used for production of both spawn and mushrooms. In this experiment, different sawdusts different organic wastes and grain ingredients and analyzed for improvement of spawn-production efficiency. Four thermophilic mushroom species, Pleurotus sajor-caju (oyster mushroom, Sambok), Ganoderma lucidum (deer horn shaped), Auricularia auricula (ear mushroom), and Lentinula edodes (shiitake), were used to identify efficient new substrates for spawn and mushroom production. Although the mycelia in the rubber tree sawdust medium showed a slightly slower growth rate (10.9 cm/15 days) than mycelia grown in grains (11.2 cm/15 days in rice seeds), rubber tree sawdust appeared to be an adequate replacement for grain spawn substrates. Th findings indicate that rubber tree sawdust, sugarcane bagasse, and acacia tree sawdust supplemented with rice bran and calcium carbonate could be new alternative the substrates for. Although sugarcane bagasse and rubber tree sawdust showed similarly high biological efficiencies (BE) of 60% and 60.8%, respectively, acacia tree sawdust exhibited relatively a low biological efficiency of 22.4%. However, it is expected that acacia sawdust has potential for the mushroom cultivation when supplemented with currently used sawdust substrates in Cambodia, because of its relatively low price. The price of the sawdust (20 kg sawdust= 6500 Riel or 1.6 USD) currently used was 6.5 times higher than the price of acacia sawdust (201000 Riel or 0.25 USD). Therefore, utilization for acacia sawdust for mushroom cultivation could become feasible as it would reduce by producing costs of mushrooms in rural areas of Cambodia.

• International Journal of Industrial Entomology and Biomaterials
• /
• v.39 no.2
• /
• pp.60-66
• /
• 2019

This study was carried out to investigate the development and oviposition characteristics of Protaetia brevitarsis fed mulberry fermented sawdust added with mulberry cake. The results of rearing of P. brevitarsis larvae on oak fermented sawdust and mulberry fermented sawdust added with different ratio of mulberry cake, the development periods of larvae feed sawdust with mulberry cake were about 41.6~48.5 days and shortened by 117 or more than that without treatment. The development periods were shorter as the ratio of mulberry cake added increased and there was no difference according to the kind of sawdust. But the weight of the larvae raised in mulberry fermented sawdust added with mulberry cake was heavier than that of the larvae raised in oak fermented sawdust added with mulberry cake. When mass rearing P. brevitarsis larvae in oak fermented sawdust, the addition of 5% mulberry cake was appropriate. Also, the average number of laying eggs of female who fed diet with mulberry cake was 12.3% higher than that of untreated.

• Journal of Animal Environmental Science
• /
• v.5 no.1
• /
• pp.17-22
• /
• 1999

This experiment was conducted to determine the influence of litter type on growing performance of broiler and litter characteristics. Sawdust, wood chips and solid part of cattle manure was used as a litter from 7 to 42 days of broiler age. The body weight was significantly (p<.05) higher in manure solid than those of sawdust and wood chips. The litter production was 2,134, 2,246 and 1,785g per bird on the sawdust, the wood chip and the manure solid during 35 days, respectively. Although the initial moisture contents of the litter materials were different 23.5% for sawdust, 16.26% for wood chips and 61.57% for cattle manure solids, the moisture were different 23.5% for sawdust, 16.26% for wood chips and 61.57% for cattle manure solid, the moisture contents became similar after 28 days of the experimental period. The nitrogen content of manure solid was higher than those of sawdust and wood chips. It was concluded that solid part of cattle manure and wood chips were potentially useful source of litter materials for broiler.

• Mycobiology
• /
• v.42 no.3
• /
• pp.249-255
• /
• 2014

We evaluated a more practical and cost-effective immobilization carriers for ethanol production using the yeast Saccharomyces cerevisiae. Three candidate materials-rice hull, rice straw, and sawdust-were tested for their cell-adsorption capacity and operational durability. Derivatizations of rice hull, rice straw, and sawdust with the optimal concentration of 0.5 M of 2-(diethylamino)ethyl chloride hydrochloride (DEAE HCl) resulted in > 95% adsorption of the initial yeast cells at 2 hr for DEAE-rice hull and DEAE-sawdust and in only approximately 80% adsorption for DEAE-rice straw. In addition, DEAE-sawdust was found to be a more practical carrier for immobilizing yeast cells in terms of operational durability in shaking flask cultures with two different speeds of 60 and 150 rpm. Furthermore, the biosorption isotherms of DEAE-rice hull, -rice straw, and -sawdust for yeast cells revealed that the $Q_{max}$ of DEAE-sawdust (82.6 mg/g) was greater than that of DEAE-rice hull and DEAE-rice straw. During the 404-hr of continuous column reactor operation using yeast cells immobilized on DEAE-sawdust, no serious detachment of the yeast cells from the DEAE-sawdust was recorded. Ethanol yield of approximately 3.04 g/L was produced steadily, and glucose was completely converted to ethanol at a yield of 0.375 g-ethanol/g-glucose (73.4% of the theoretical value). Thus, sawdust is a promising practical immobilization carrier for ethanol production, with significance in the production of bioethanol as a biofuel.

• Journal of the Korean Wood Science and Technology
• /
• v.45 no.6
• /
• pp.857-871
• /
• 2017

The major substrates used in soilless growing media are peat moss and perlite, where peat moss is a limited and expensive natural resource. Determination of appropriate substrates based on technical and economic feasibility is the vital aspect of research and the key to success in any soilless production system. This research work was performed to evaluate different low-cost and sustainable alternative substrate as soilless growing media for horticulture plant. The objective of this study was to compare the effect of sawdust species and steam treatment, for physico-chemical properties and growth of horticultural plant. This study involves the physical and chemical characterization and growth test of four substrate (pine sawdust, oak sawdust, steamed pine sawdust and steamed oak sawdust) in order to evaluate their use as components of growing media. Steamed oak sawdust ($121^{\circ}C$, 30 min) showed adequate physical and chemical properties compared to peat moss for their use as growing media. The growing media were prepared using different mixture proportion to grow Brassica campestris L., Festuca arundinacea and Lespedeza cyrtobotrya Miq. The highest germination, stem length and leaf area of Brassica campestris L., Festuca arundinacea and Lespedeza cyrtobotrya were observed in 30 minute steamed oak sawdust mixture growing media. The steam treatment condition of sawdust used in the growing media significantly positive affected the germination, the stem length and the leaf area.

• Journal of Animal Environmental Science
• /
• v.5 no.1
• /
• pp.53-62
• /
• 1999

This study was carried out to investigate how to reuse the livestock waste and develop fly ash as a subsitution of sawdust which is used commonly to make compost. Fly ash and sawdust were mixed the ratio of 8 to 2, 7 to 3, 6, to 4, 5 to 5, 4 to 6. 3 to 7 and 2 to 8 after fermentation for 60 days the change of temperature, moisture, pH, organic matter, nitrogen content and C/N ratio were analyzed. The results are as follows; Temperature was reached to maximum (63.5$^{\circ}C$) more quickly in scraper type than in slurry type with adding large sawdust. When fly ash and sawdust were mixed same amount at scraper type and slurry type, moisture was 46.6~53.7% and maintained a good condition for fermentation. pH was showed the range of 7~10 as a mixture of fly ash. Organic matter contents were increased with increasing the added sawdust but did not show any tendency. Nitrogen content was also increased with increasing the amount of added sawdust but did not show any tendency. C/N ratio was increased to 20~60 with increasing the added sawdust, but when sawdust and fly ash were mixed 50:50, there was no significant during fermentation periods. In conclusion, supplementation of fly ash at the level of 50% of sawdust maintained a good condition for fermentation as a livestock waste composting.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2002.10a
• /
• pp.608-611
• /
• 2002

We developed low resistance drum that is used in sawdust machine in this research. The existent drum have two dimensional cutting form(orthogonal cutting) when see cutting pattern of saw cutter and wood, cutting resistance is big and cutting power is cost much, and also, vibration happens extremely. To improve this shortcoming, we developed helical type low cutting resistance drum for three dimensional cutting possible, decreased vibration and cutting resistance of sawdust machine, and improve productivity and sawdust ventilation. Also, a developed drum is mounting in sawdust machine, it is sold by product.

• 한국신재생에너지학회:학술대회논문집
• /
• 2008.10a
• /
• pp.153-156
• /
• 2008

MILD combustion has been successfully applied to gaseous fuels and few commercial systems are now in operation. Extending MILD combustion applicability to solid fuel of sawdust is the focus of the present work. The MILD combustion furnace at the University of Adelaide in Australia was used in this study. A measurement of $O_2$ and CO emissions have been carried out in parallel with consideration of NOx emission and compared in each modes of conventional natural gas combustion, natural gas MILD combustion, NOx emission in natural gas MILD combustion mode can be reduced to 20% in comparison with conventional combustion. Emission in cases of air carrying sawdust combustion and $CO_2$ carrying sawdust combustion were also compared. Air and $CO_2$ were sued as a carry gas for the sawdust. It was found that MILD conditions are possible for sawdust particles of less than $355{\mu}m$ without additional air pre-heating. It was also found that when using $CO_2$ as the carry gas the flame inside the furnace was not visible anymore and that NOx emission dropped to less than two folds.

• The Korean Journal of Mycology
• /
• v.38 no.2
• /
• pp.142-145
• /
• 2010

In this study, we attempted to find substitute materials, swelling rice hull, cocopeat, corncob and coconut sawdust, for sawdust in bottle cultivation of Pleurotus ostreatus. Chemical characters of mixture substrates with four substitute materials for pine sawdust were not different significantly. By comparison in mycelial growth and yield of fruitbody, mixture substrate of cocopeat were showed the same level in P. ostreatus. Therefore, it is suggested that cocopeat was substituted for sawdust for cultivation of P. ostreatus.