• 한국재료학회지
• /
• 제27권4호
• /
• pp.216-220
• /
• 2017

The effect of electron beam (EB) irradiation on the electrical properties of Zn-Sn-O (ZTO) thin films fabricated using a sol-gel process was investigated. As the EB dose increased, the saturation mobility of ZTO thin film transistors (TFTs) was found to slightly decrease, and the subthreshold swing and on/off ratio degenerated. X-ray photoelectron spectroscopy analysis of the O 1s core level showed that the relative area of oxygen vacancies ($V_O$) increased from 10.35 to 12.56 % as the EB dose increased from 0 to $7.5{\times}10^{16}electrons/cm^2$. Also, spectroscopic ellipsometry analysis showed that the optical band gap varied from 3.53 to 3.96 eV with increasing EB dose. From the results of the electrical property and XPS analyses of the ZTO TFTs, it was found that the electrical characteristic of the ZTO thin films changed from semiconductor to conductor with increasing EB dose. It is thought that the electrical property change is due to the formation of defect sites like oxygen vacancies.

• 한국재료학회지
• /
• 제3권1호
• /
• pp.58-64
• /
• 1993

고탄소 Dr-Ti 합금강의 회전접촉 피로마모실험에서 실험조건에 따라 다르게 변화하는 subsurface zone의 가공경와의 정도를 잔류응력의 분포로서 조사하였다. 시험전 표면잔류응력은 마모특성에 영향을 주지 못하였고, 접촉응력과 회전속도가 증가할수록 표면 잔류응력은 감소하여 갔으나 subsurface zone내의 최대압축잔류응력은 증가하였고, 그의 포화깊이는 깊었다. 이들 실험결과와 이론적 전단응력의 분포와의 관계에 관하여 검토하였다.

• 전자공학회논문지B
• /
• 제33B권4호
• /
• pp.209-216
• /
• 1996

In this paper, we propose a learning method of multi-layer perceptrons (MLPs) with 8-bit data precision. The suggested method uses the cross-entropy cost function to remove the slope term of error signal in output layer. To decrease the possibility of overflows, we use 16-bit weighted sum results into the 8-bit data with appropriate range. In the forwared propagation, the range for bit-conversion is determined using the saturation property of sigmoid function. In the backwared propagation, the range for bit-conversion is derived using the probability density function of back-propagated signal. In a simulation study to classify hadwritten digits in the CEDAR database, our method shows similar generalization performance to the error back-propagation learning with 16-bit precision.

• 한국세라믹학회지
• /
• 제32권3호
• /
• pp.289-294
• /
• 1995

As the results of the study on the effects of mixing time for raw materials to the electric and magnetic properties of Mg-ferrite, the fraction of spinel phase after calcination and the geometry density of sintered Mg-ferrite increased from 30% to 100% and from 2.5g/cc to 4.25g/cc respectively due to mixing-homobenity of raw materials. The AC resistivity of grains decreased and lattice parameter, saturation magnetization increased due to the increase in Fe+2 of sintered body. conclusively the characteristic of powder after calcination had strong influence on the microstructure, electric, and magnetic properties in Mg-ferrite sintered body.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2010년도 추계 학술발표회
• /
• pp.263-268
• /
• 2010

Thermal characterization of geomaterials has significant implication on the geothermal energy, disposal of nuclear wastes, geological sequestration of carbon dioxides and recovery of hydrocarbon resources. Heat transfer in multiphase materials is dominated by the thermal conductivity of consisting components, porosity, degree of saturation and overburden pressure, which have been investigated by the empirical correlation at macro-scale. The thermal measurement by Transient Plane Source (TPS) and associated algorithm for interpretation of thermal behavior in geomaterials corroborate the robustness of sensing techniques. The method simultaneously provides thermal conductivity, diffusivity and volumetric heat capacity. The newly introduced thermal network model enables estimating thermal conductivity of geomaterials subjected to the effective stress, which has not been evaluated using previous thermal models. The proposed methods shows the applicability of reliability of TPS technique and thermal network model.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2002년도 추계학술대회논문집
• /
• pp.222-227
• /
• 2002

MR(Magneto-rheological) fluid is smart fluid that can change its characteristics then magnetic fields are applied. Recently, many researches have been performed on this MR fluid for the application in a vareity of areas including automobile shock absorbers. This paper describes the design procedure of a MR damper and the analysis results of its dynamic characteristics. MR fluid in the magnetic field shows initial yield shear stress and increasing resistive viscosity with final saturation thereafter. Herschel-Bulkley model is used to simulate the flow characteristics of MR fluid and magnetic analysis is used to identify the magnetic property of the MR fluid in the orifice of the damper. The dynamic characteristics of the damper was predicted and compared with the experimental results for typical sinusoidal excitations.

• 비파괴검사학회지
• /
• 제30권6호
• /
• pp.539-547
• /
• 2010

In this study, characteristics of the fundamental longitudinal guided wave mode, L(0,1), which is a usual mode employed in the inspection of the above-ground pipe, of the buried pipe were numerically investigated considering property changes in the surrounding soil. Results showed that soil conditions are significantly affecting the attenuation of L(0,1) mode in the pipe embedded in soil. Especially, if the soil is partially saturated, the attenuation of L(0,1) mode is larger and is very similar regardless of the degree of water saturation in the surrounding soil. However, when the soil is fully saturated, the attenuation of L(0,1) mode is less and show different trend with its partially saturated counterparts.

• 한국지하수토양환경학회:학술대회논문집
• /
• 한국지하수토양환경학회 2000년도 창립총회 및 춘계학술발표회
• /
• pp.84-89
• /
• 2000

Parametric studies based on laboratory pilot tests were performed to investigate the relationships between electrical resistivity and contaminated soil properties. Three kinds of sandy soils sampled and leachates from a industrial waste landfill were mixed to model the contaminated soils. Electrical resistivity of soils were measured by using a simulated resistivity cone penetrometer probe. In the experiments, the electrical resistivity were observed with changing the water content, void ratio, unit weight, degree of saturation, and concentration of the leachate. The test results show that the electrical resistivity of soils depends largely on the water content and the electrical property of pore water rather than unit weight and types of soils.

• 전기학회논문지
• /
• 제66권5호
• /
• pp.765-771
• /
• 2017

This paper presents concurrent design methods of surface permanent magnet synchronous machines for saliency-tracking self-sensing position estimation. Magnetic saliency for the self-sensing is created by stator pole saturation due to the rotor zigzag leakage flux. The power conversion properties such as saliency ratio, torque ripple, and efficiency vary according to motor design. The property change due to design modification is analysed by using finite element analysis, and with the appropriate design modification, proper saliency is created while preserving their power conversion capabilities.

• 한국분말재료학회지
• /
• 제11권1호
• /
• pp.16-21
• /
• 2004

The nano-sized Co particles were successfully synthesized by chemical vapor condensation (CVC) process using the precursor of cobalt carbonyl ($Co_2(CO)_8$). The influence of carrier gases on the microstructure and magnetic properties of nanoparticles was investigated by means of XRD, TEM, XPS and VSM. The Co nano-particles with different phases and shapes were synthesized with a change of carrier gas : long string morphologies with coexistence of fcc and hcp structure in Ar carrier gas condition; finer Co core in a mass of cobalt oxide with only fcc structure in He; rod type cobalt oxide phase in Ar＋6vol％$O_2$. The saturation magnetization and coercivity was lower in Co nanoparticles synthesized in He carrier gas, due to their finer size.