• Journal of the Mineralogical Society of Korea
• /
• v.19 no.1 s.47
• /
• pp.31-38
• /
• 2006

Site environments bring about various different deterioration forms of stone cultural properties. The aim of this study is to document the influence of coarse grained sandy soil on the deterioration of stone cultural properties. Bulguksadabotap is a good example that demonstrates the problem with coarse grained sandy soil. The ground around the Bulguksadabotap is covered with coarse grained sandy soil and the pagoda is surrounded by the corridors. Coarse grained sandy soil float easily in the air and deposit in the complicated stone structure caused by strong wind in Gyeongju and numerous visitors. To explain the influence of coarse grained sandy soil on the deterioration, the coarse grained sandy soil and weathered stone pieces of Bulguksadabotap were analyzed by XRD, optical microscopy, SEM for mineralogical component and IC and ICP-AES for the soluble salts. The soil and weathered stone pieces include clay minerals, such as smectite and kaolinite, can expand with water and exert pressure on the stone. Small size of the clay minerals in the coarse grained sandy soil can easily penetrate into the weathered surfaces of the Bulguksadabotap. The weathered stone pieces also contain NaCl, which is known to contribute to increase the expandibility of clay minerals by providing with $Na^{+}$ or by dropping the equilibrium of relative humidity. These results indicates that coarse grained sandy soil is not proper to site environment for weathered stone cultural properties.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.51 no.6
• /
• pp.69-76
• /
• 2009

Soils exhibit creep behavior in which deformation and movement proceed under a state of constant stress or load. In Korea, weathered soil is abundant and occupies around one-third of the country. Weathered soil is visually described as a sandy or gravelley soil, but the behavior is quite different from the behavior of usual sand and gravel. In particular, the permeability of weathered soil is similar to sand, but the durability of settlement is similar to clay. Therefore analysis of time-dependent behavior of weathered soil is very important. In this study, Creep tests with weathered soils were carried out under constant principal stress differences of various stress levels which were experimentally obtained by triaxial compression test. The results of these tests showed the creep behavior for which the deformation increased with time, and the results are consistent with phenomenological model by creep equation of Singh-Mitchell.

• Journal of the Korean Geotechnical Society
• /
• v.38 no.2
• /
• pp.5-13
• /
• 2022

The unsaturated behavior of sandy silt (SM soil) was investigated experimentally. Special attention was given to the stress-strain behavior of unsaturated weathered soil (SM) prior to failure and behavior at failure under monotonic loading. A sandy silt (SM) weathered soil containing a certain amount of fine contents distributed in Korea, was chosen to form samples with different densities of Dr=25%, 60%, and 75%. and matric suctions. The isotopically Consolidated Drain test (CD-test) was performed to maintain a constant matric suction during the shearing process. Based on the experimental results, it was qualitatively identified that the higher the relative density, the greater the virtual friction angle (ϕ^b) value and AEV (Air Entry Value) were induced. Also it is found that the internal friction angle (ϕ') is more or less constant. even if the matric suction is increased.

• Journal of the Korean Geotechnical Society
• /
• v.35 no.11
• /
• pp.75-95
• /
• 2019

The numerical analysis on PHC piles socketed into weathered rocks through sandy soil layers was conducted to propose the table solution or the chart solution to obtain the mobilization capacity. The mobilization capacity was determined at the settlement of 5% pile diameter and applied a safety factor of 3.0. In order to utilize the excellent compressive strength of the PHC pile effectively, it is recommended that the allowable bearing capacity of ground would be designed to be more than the long-term allowable compressive pile load. A procedure for determining an allowable pile capacity for PHC piles socketed into weathered rocks through sandy soil layers is given by the sum of the allowable skin friction of the sandy soil layer and the weathered rock layer and the allowable end bearing capacity of the weathered rock layer. The design efficiency of the PHC pile is about 85% at the reasonable design stage in the verification of the newly proposed method. Thus, long-term allowable compressive load (P_all) level of PHC piles can be utilized in the optimal design stage.

• Journal of the Korean GEO-environmental Society
• /
• v.12 no.7
• /
• pp.31-37
• /
• 2011

Only a few studies have been conducted using reduced slag as recycled material. The reduced slag in electric furnace is produced as a by-product in making a steel and a few applications of the reduced slag as expensive additives and bonding materials or as the stabilized soils was reported. The purpose of this study is to present the feasibility of the reduced slag as recycled material, especially, in a field of civil engineering. In order to achieve the purpose experiments such as SEM and XRF analysis was conducted for the reduced slag in electric furnace. Based on the results various geotechnical experiments were conducted to know engineering properties of slag-soil mixtures. Weathered soils and clay are mixed with reduced slag for various ratios. As the ratio of reduced slag to weathered soil increases, the maximum dry unit weight of the mixture decreased with increasing optimum moisture content. The results indicates that there is no effect on a reduced slag by compaction efforts. The shear strengths of the weathered soil-slag mixtures are slightly higher or similar to those of weathered soils. The permeability of the weathered soil-slag mixtures is similar to that of silty or sandy soils. Therefore, it is possible to use the mixtures as embankment or backfill materials in the fields. The unconfined strength of the mixtures of reduced slag and clay is higher than that of clay and it tends to increase with the curing time. Therefore it can be used to improve the soft ground.

• Journal of the Korean Geotechnical Society
• /
• v.33 no.3
• /
• pp.49-62
• /
• 2017

In order to understand response of geo-structures to the freezing-thawing process in the ground, it is necessary to consider phase change of the pore water of the ground and also to understand soil interaction with structures. In this study, numerical analysis was carried out for freezing and thawing effect on the modular road system. Neumann's theoretical equation for freezing-thawing processes in porous media can be used to estimate frozen depth and heaving from basic soil properties and ground and surface temperature, but its application is limited to the case for the sediment with fully saturated condition and zero unfrozen water content. Numerical analysis of the modular road system was performed on various soil types and different ground water table as the varying freezing index. The amount of heaving in the silty soil was much larger than those in granite weathered soil or sandy soil, and lowering groundwater level reduced ground heaving induced by freezing. Numerical analysis for temperature history of the ground surface predicted residual heaving near the surface by the freeze-thaw process in silty soil. It ought to reduce stiffness and bearing capacity of the ground so that it will impair stability and serviceability of new road system. However, the amount of residual heaving was insignificant for the road system installed in weathered soil granite and sandy soil. Since modular road system is a pavement structure mounted on the supporting substructure unlike the prevalent road pavement system, strict criteria should be applied for uniform and differential settlement of the pavement system.

• Journal of the Korean Geotechnical Society
• /
• v.15 no.4
• /
• pp.43-56
• /
• 1999

The use of berms can be an effective method to restrain excessive movements of wall and ground caused by deep excavations in urban area. But generally in construction sites, no berm remains for the sake of construction convenience or the geometry and magnitude of remaining berm is determined by individual experiences due to scarce research results. In this research, laboratory model tests and numerical analyses are used mainly for sandy soils. And efficient berms for restraining excessive movements by deep excavations are analyzed. Model tests were performed for the cases of cantilever and braced wall excavations, and the behaviors of retaining wall were analyzed according to the geometry and magnitude of berms. And also, numerical methods were used for analyzing efficient berms which are available in the soil and construction conditions in urban areas of Korea.

• Journal of the Korean Geotechnical Society
• /
• v.35 no.8
• /
• pp.31-42
• /
• 2019

A total of 73 pile design data for prebored PHC piles was analyzed to study the current design method. Based on the design data, a ratio of skin friction to total capacity from the pile design data was about 20~53%. Such low ratio of skin friction to total capacity tends to underestimate skin friction. Considering this tendency, the current design method should be improved. Also, an average design efficiency of PHC pile capacity was 70% and an average design efficiency for bearing capacity of soil or weathered rock was 80%, which shows slightly higher value than the former. This is probably due to the fact that the allowable bearing capacity is estimated to be equal to or slightly higher than the design load. Hence, the allowable bearing capacity should be estimated to be higher than the long-term allowable compressive force of the PHC pile. In the current design method, skin friction is calculated to be about 2.2 times lower than end bearing. The current design method for prebored PHC piles applied foreign design methods without any verification of applicability to the domestic soil or rock condition. Therefore, the current design method for prebored PHC piles should be improved.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.2 no.3
• /
• pp.47-53
• /
• 1999

This study was carried out to suggest the slope revegetation technology of biological engineering using the Ligustrum obtusifolium, which is one of the pioneer plant species. Ahead of the experimental construction, we evaluated the L. obtusifolium's value of biological engineering for the slope stabilization by testing the growth rate after the cuttings were buried for 8 weeks('98. 7. ~ '98. 9.). In this test, it was found that the L. obtusifolium, one of the species deep rooted with developed underground parts, is very effective for the slope stabilization and that the rooting powder(Hormex Powder) gave the better effects on root germination. In April of 1999, the experimental construction of biological engineering technology using recycled L. obtusifolium live cuttings(applied growth-stimulating compound) and green bags was conducted at sandy cut-slope in GLEN ROSS G.C.(Yongin). The slope was tolerant of soil erosion despite of heavy rainfall in the rainy season and many plant species invading for five months('99. 4. ~ '99. 9.). The vegetation research was performed through examining the frequency of each block using the transect method. 21 kinds of plant speices appeared in total area($25.5m^2$) and the dominant species are Digitaria sanguinalis, Setaria viridis, Cyperus amuricus, Persicaria blumei, Artemisia princeps var. orientalis. With regard to life forms, therophytes were shown with a dominant distribution of 66.7% of total species and neophytes relatively with a low distribution of 19.0%. Furthermore, it can be estimated that there is no ecological stabilization of this slope with the result of the ruderal species' occupation of 71.4%. It is too early to argue about ecological mechanical advantages and disadvantages of this technology, but, from the result of this study, it is expected that the slope revegetation technology of biological engineering using L. obtusifolium can be effectively applied to sandy slope(not rock or weathered rock slope) and that the early rapid stabilization and favorable succession could be done with the improvement of soil condition.

• Economic and Environmental Geology
• /
• v.43 no.2
• /
• pp.185-196
• /
• 2010

Clay veins that occurred in a slope by hydrothermal alteration, can significantly affect its slope stability. The effect of clay veins on the slope stability was investigated by numerical modeling study. Various parameters such as cohesion, internal friction angle, orientation, groundwater level, rainfall intensity and duration, have been modelled. As shear strength increased, factor of safety increased. As groundwater level developed, factor of safety decreased. For the case of slip surface developed on interface, factor of safety was lower than that for case of slip surface developed on either weathered soil or clay vein. The effect of various soil types of the slope stability was also investigated by simulating seepage through the slopes with various soils. The groundwater level significantly increased on the slopes with silty and generic soils. For the slope with sandy soil, almost no change in groundwater level was observed due to rapid drainage.