• Transactions of the Society of Information Storage Systems
• /
• v.3 no.2
• /
• pp.54-58
• /
• 2007

Using metal/Si materials as a recording layer, we have achieved good results for a SR disc (super resolution disc). Mainly by controlling metal composition and the ratio of metal to Si of recording layer, signal qualities were greatly enhanced. At the mark length of 75nm, the best CNR (Carrier to Noise Ratio) was about 45dB. Write power was reduced down to about 6.5mW. LFN (Low Frequency Noise) could also be reduced down to 14dB. Single tone pattern jitters for every mark whose length is from 2T through 8T were achieved to be below 10%. The readout signal was stable sustaining CNR>40dB during about 15,000 times reading. The so-called "3T-problem" could be avoided.

• The Journal of Advanced Prosthodontics
• /
• v.11 no.1
• /
• pp.23-31
• /
• 2019

PURPOSE. To investigate and compare the surface roughness (SR), weight and height of monolithic zirconia (MZ), ceramometal (CM), lithium disilicate glass ceramic (LD), composite resin (CR), and their antagonistic human teeth enamel. MATERIALS AND METHODS. 32 disc shaped specimens for the four test materials (n=8) and 32 premolars were prepared and randomly divided. SR, weight and height of the materials and the antagonist enamel were recorded before and after subjecting the specimens to 240,000 wear-cycles ($49N/0.8Hz/5^{\circ}C/50^{\circ}C$). SR, height, weight, and digital microscopic qualitative evaluation were measured. RESULTS. CM ($0.23+0.08{\mu}m$) and LD ($0.68+0.16{\mu}m$) exhibited the least and highest mean difference in the SR, respectively. ANOVA revealed significance (P=.001) between the materials for the SR. Paired T-Test showed significance (P<.05) for the pre- and post- SR for all the materials. For the antagonistic enamel, no significance (P=.987) was found between the groups. However, the pre- and post- SR values of all the enamel groups were significant (P<.05). Wear cycles had significant effect on enamel weight loss against all the materials (P<.05). CR and MZ showed the lowest and highest height loss of 0.14 mm and 0.46 mm, respectively. CONCLUSION. MZ and CM are more resistant to SR against the enamel than LD and CR. Enamel worn against test materials showed similar SR. Significant variations in SR values for the tested materials (MZ, LD, CM, and CR) against the enamel were found. Wear simulation significantly affected the enamel weight loss against all the materials, and enamel antagonist against MZ and CM showed more height loss.

• KSBB Journal
• /
• v.14 no.3
• /
• pp.342-350
• /
• 1999

Photobacterium phosphoreum was used in order to study response to heavy metal including $HgCl_2$, $CdCl_2$, $MnSO_4$ and $ZnSO_4$ in view of developing monitoring system for toxic substances. The concentrations of heavy metal causing 50% reduction($EC_{50}$) in bioluminescence intensity were determined with both free and immobilized P. phosphoreum. The bioluminescence responses were examined at various concentrations of heavy metal after 10, 20 and 30 min of exposure. The linear correlation between Gamma values and concentrations of heavy metal was obtained and $EC_{50}$ was calculated from the linear correlation. The significant inhibitory concentrations for bioluminescence emission were found to be 0.05mg/L for $HgCl_2$, 25mg/L for $CdCl_2$, 50mg/L for $MnSO_4$ and 12.5mg/L for $ZnSO_4$, respectively. The free cell and disc type were shown to be more sensitive to heavy metal than cells mixed with Na-alginate or immobilized on Sr-alginate. However, the linear regression curves were derived from the Sr-alginate immobilized cells indicating the immobilization method is a useful tool for monitoring of heavy metal under more stable condition of bioluminescence.

• Membrane and Water Treatment
• /
• v.8 no.5
• /
• pp.437-448
• /
• 2017

A high quality Na-X zeolite membrane was synthesized on a seeded ${\alpha}-alumina$ disc by the secondary growth method. Structural characterization was done by X-ray spectroscopy, FT-IR spectroscopy, SEM and AFM imaging. The performance evaluation of the membrane was firstly tested in separation of glucose/water solutions by pervaporation process. There was obtained a separation factor $182.7{\pm}8.8$, while the flux through the membrane was $3.6{\pm}0.3kg\;m^{-2}\;h^{-1}$. The zeolite membrane was then used for desalination of aqueous solutions consisting of $Na^+$, $Ca^{2+}$, $Cs^+$ and $Sr^{2+}$ because of the importance of these ions in water and wastewater treatments. The effects of some parameters such as temperature and solution concentration on the desalination process were studied for investigating of diffusion/adsorption mechanism in membrane separation. Finally, high water fluxes ranged from 2 up to $9kg\;m^{-2}\;h^{-1}$ were obtained and the rejection factors were resulted more than 95% for $Na^+$ and $Ca^{2+}$ and near to 99% for $Cs^+$ and $Sr^{2+}$. Based on the results, fluxes were significantly improved due to convenient passage of water molecules from large pores of NaX, while the fouling was declining dramatically. Based on the results, NaX zeolite can efficiently use for the removal of different cations from wastewaters.

• Microbiology and Biotechnology Letters
• /
• v.25 no.2
• /
• pp.166-172
• /
• 1997

Aspergillus niger was selected as a strain producing the potent raw starch hydorlyzing enzyme. These experiments were conducted to investigate the conditions of the glucoa- mylase production, the purification of the enzyme, some characteristics of the purified enzyme and hydrolysis rate on various raw starches such as com, rice, potato, glutinous rice, sweet potato, wheat and barley. The optimum cultural temperature and time for the enzyme production on wheat bran medium were $30^{\circ}C$ and 96hrs, respectively. The respective addition of yeast extract and nutrient broth on wheat bran medium increased slightly the enzyme production. The enzyme was purified by ammonium sulfate fractionation and DEAE-cellulose column chromatography. The specific activity of the purified enzyme was 30.7u/mg-protein and the yield of enzyme activity was 25.8%. The purified enzyme showed a single band on polyacrylamide disc gel electrophoresis and its molecular weight was estimated to be 56,000 by SDS-polyacrylamide disc gel electrophoresis. The isoelectric point for the purified enzyme was pH3.7. The optimum temperature and pH were $65^{\circ}C$ and pH 4.0, respectively. The purified enzyme was stable in the pH range of pH 3.0-9.5 and below $45^{\circ}C$, and its thermal stability was slightly increased by the addition of $Ca^{2+}$. The purified enzyme was activated by $Co^{2+},\;Sr^{2+},\;Mn^{2+},\;Fe^{2+},\;Cu^{2+}$. Raw rice starch, raw corn starch, raw glutinous rice starch, raw sweet potato starch, raw wheat starch and raw barley starch showed more than 90% hydrolysis rate in 48hrs incubation. Even raw potato starch, most difficult to be hydrolyzed, showed 80% hydrolysis rate. The purified enzyme was identified as glucoamylase.

• Journal of Biomedical Engineering Research
• /
• v.21 no.3 s.61
• /
• pp.285-293
• /
• 2000

Age-related changes in the geometry of human lumbar spine would lead to changes of its mechanical behaviors. To investigate the effects of the geometric changes, no age-related changes in the material/mechanical properties were considered. Using the finite element method. two age-related models of lumbar spine segments (L3-L4) were constructed. The annulus of the models was modeled as laminate composite elements with 16 layers and 6 materials. The spinal stiffness and facet reaction of the lumbar spine increased with the age-related geometric changes in various combined loadings. Fiber and transverse tensile strains of the inner annulus. cancellous bone stress and end-plate stress decreased with the age-related geometric changes whereas fiber/layer compressive strains of the annulus. facet reaction. ligament reaction and end-plate rigidity increased. Consequently, it appears that in the normal age-related deterioration of discs, the age-related geometric change contributes to the increase of spinal stiffness (the decrease in range of the motion segment), preventing an excessive deformation of the disc.

• Korean Journal of Plant Tissue Culture
• /
• v.24 no.5
• /
• pp.305-311
• /
• 1997

Bacillus thuringiensis, a gram-positive soil bacterium, is characterized by its ability to produce crystalline inclusions during sporulation. The crystal proteins exhibit a highly specific insecticidal activity. An insecticidal crystal protein (ICP), Cry II A, is specifically toxic to both lepidopteran and dipteran insects. In this study, tobacco plants transformed by the cry II A gene have been generated. The Cry II A crystal protein was purified from E. coli JM103 harboring cry II A gene by differential solubility. The activated Cry II A was prepared by tryptic digestion. The purified protoxin (70 kDa) and the activated toxin (50 kDa) were analyzed by SDS-PAGE. To generate the transgenic tobacco having cry II A gene, the cry II A gene was subcloned to a plant expression vector, pSRL2, having two CaMV 35S promoters. The recombinant plasmid was transformed into tobacco (N. tabacum var. Petit Havana SR1) by Agrobacterium-mediated leaf disc transformation. Through the regeneration, six putative transgenic tobacco plants were obtained and three transformants were confirmed by Southern blot analysis. It has been found that one plant had single copy of cry II A gene, another had two copies of the gene, and the third had a truncated gene. After the immunochemical confirmation of cry II A expression in plants, the transgenic tobacco plants will be used to study the genetics of future generation with the insecticidal crystal protein gene cry II A.

• Journal of Life Science
• /
• v.13 no.1
• /
• pp.83-89
• /
• 2003

To investigate the function of chloroplast small heat shock protein (HSP), transgenic tobacco plants (Nicotiana tabacum L, cv. SR-1) that constitutively overexpress the rice chloroplast small HSP (Oshsp26) were generated. Effects of constitutive expression of the Oshsp26 on thermotolerance were investigated with the chlorophyll fluorescence. After 5-min incubation of leaf discs at high temperatures, an increase in the Fo level, indication of separation of LHCII from PSII, was mitigated by constitutive expression of the chloroplast small HSP When tobacco plantlets grown in Petri dishes were incubated at $20^{\circ}C$/TEX> for 45 min and subsequently incubated at $20^{\circ}C$/TEX> leaf color of wild-type plant became gradually white and all plantlets were finally died. Under the conditions in which all the wild-type plants died, more than 80% of the transformants remained green and survived. It was also found that the levels of Oshsp26 protein accumulated in transgenic plants were correlated with the degree of thermotolerance. These results suggest that the chloroplast small HSP plays an important role in protecting photosynthetic machinery, as a results, increases thermotolerance of whole plant during heat stress.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.34 no.6
• /
• pp.765-770
• /
• 2005

In this study, we investigated antimicrobial and cytotoxicity effects of Undaria pinnatifida Sporophyll, which using methanol, dichloromethane and ethanol were extracted and fractionated into four different types: methanol (UPMM), hexane (UPMH), butanol (UPMB) and aqueous (UPMA). The antimicrobial activity was increased in proportion to its concentration by the paper disc method. Among the solvent fractions, UPMM and UPMB showed relatively strong antimicrobial activities in the order. Among various partition layers, the methanol partition layer (UPMM) was showed the strongest cytotoxic effects on all cancer cell lines. We also observed quinone reductase (QR) induced effects in all fraction layers of UP on HepG2 cells. The QR induced effects of UPMH on HepG2 cells at $320\mu g/mL$ concentration indicated 2.36 with a control value of 1.0.