• Journal of the Korean Magnetic Resonance Society
• /
• v.20 no.1
• /
• pp.1-6
• /
• 2016

The proton NMR line widths and spin-lattice relaxation rates, $T_1^{-1}$, of ferroelectric $LiH_3(SeO_3)_2$, $Li_2SO_4{\cdot}H_2O$, and $LiN_2H_5SO_4$ single crystals were measured as a function of temperature. The line width measurements reveal rigid lattice behavior of all the crystals at low temperatures and line narrowing due to molecular motion at higher temperatures. The temperature dependences of the proton $T_1^{-1}$ for these crystals exhibit maxima, which are attributed to the effects of molecular motion by the Bloembergen - Purcell - Pound theory. The activation energies for the molecular motions of $^1H$ in these crystals were obtained. From these analysis, $^1H$ in $LiH_3(SeO_3)_2$ undergoes molecular motion more easily than $^1H$ in $LiN_2H_5SO_4$ and $Li_2SO_4{\cdot}H_2O$ crystals.

• Clean Technology
• /
• v.21 no.3
• /
• pp.153-163
• /
• 2015

The effects of H₂O and residue SO₂ in flue gases on the activity of the Fe/zeolite catalysts for low-temperature NH₃-SCR of NO were investigated. And the addition effect of Mn, Zr and Ce to Fe/zeolite for low-temperature NH₃-SCR of NO in the presence of H₂O and SO₂ was investigated. Fe/zeolite catalysts were prepared by liquid ion exchange and promoted Fe/zeolite catatysts were prepared by liquid ion exchange and doping of Mn, Zr and Ce by incipient wetness impregnation. Zeolite NH₄-BEA and NH₄-ZSM-5 were used to adapt the SCR technology for mobile diesel engines. The catalysts were characterized by BET, X-ray diffraction (XRD), SEM/EDS, TEM/EDS. The NO conversion at 200 ℃ over Fe/BEA decreased from 77% to 47% owing to the presence of 5% H₂O and 100 ppm SO₂ in the flue gas. The Mn promoted MnFe/BEA catalyst exhibited NO conversion higher than 53% at 200 ℃ and superior to that of Fe/BEA in the presence of H₂O and SO₂. The addition of Mn increased the Fe dispersion and prevented Fe aggregation. The promoting effect of Mn was higher than Zr and Ce. Fe/BEA catalyst exhibited good activity in comparison with Fe/ZSM-5 catalyst at low temperature below 250 ℃.

• Applied Chemistry for Engineering
• /
• v.31 no.4
• /
• pp.438-442
• /
• 2020

Studies on the recovery conditions and optimization process for valuable metal recovery through chemical treatment from detoxified asbestos-containing waste composed of calcium silicate, larnite, merwinite, and akermanite were conducted. The main components, Si, Ca, and Mg, of detoxified asbestos-containing waste (DACW) were separated and recovered in the form of SiO₂, CaSO₄, and Mg(OH)₂ compounds, respectively. Each separated component was confirmed through X-ray diffraction (XRD) and inductively coupled plasma spectrometer (ICP) analysis. The recovery conditions for each component were first treating them with an acid to separate SiO₂ and subsequently with H₂SO₄ to recover Ca in the form of sulfate, CaSO₄. The remaining Mg was recovered by precipitation with Mg(OH)₂ under strong basic conditions. This study suggested that it is possible to convert existing treatment process of asbestos waste by landfill through recovering the components into a resource-recycling green technology.

• Journal of Electrical Engineering and Technology
• /
• v.10 no.4
• /
• pp.1786-1795
• /
• 2015

It is common practice to identify the insulation faults of GIS through monitor the contents of SF₆ decomposed components. Partial discharges (PD) could lead to the decomposition of SF₆ dielectric, so new reactions usually occur in the mixture of the newly decomposed components including traces of H₂O and O₂. The new reactions also cause the decomposed components to differ due to the different amounts of H₂O and O₂ even under the same strength of PD. Thus, the accuracy of assessing the insulation faults is definitely influenced when using the concentration and corresponding change of decomposed components. In the present research, a needle-plate electrode was employed to simulate the PD event of a metal protrusion insulation fault for two main characteristic components SO₂F₂ and SOF₂, and to carry out influence analysis of trace H₂O and O₂ on the characteristic components. The research shows that trace H₂O has the capability of catching an F atom, which inhibits low-sulfide SF_x from recombining into high-sulfide SF₆. Thus, the amount of SOF₂ strongly correlates to the amount of trace H₂O, whereas the amount of SO₂F₂ is weakly related to trace H₂O. Furthermore, the dilution effect of trace O₂ on SOF₂ obviously exceeds that of SO₂F₂.

• Journal of Environmental Science International
• /
• v.29 no.11
• /
• pp.1025-1032
• /
• 2020

This work was performed to develop a dip injection wet scrubber (DIWS) system with chlorine dioxide as the oxidant. The exhaust pollutants from a lime kiln of paper-mill were introduced to the system. When NaClO₃ was used to oxidize NO into NO₂, the oxidation was unsatisfactory and the combination of HNO₃ or H₂SO₄ was required for 100% oxidation. ClO₂ is recommended to oxidize NO and SO₂ effectively. With the combination of 1^st stage of DIWS and ClO₂, 57.1% of NOx and 98% of SO₂ were effectively removed. In the case of 2^nd stage of DIWS and ClO₂, 93.5% of NOx and 99% of SO₂ were removed. The ClO₂+DIWS process was superior to the ClO₂+Scrubber process in terms of investment, running cost and NOx removal efficiency.

• Applied Chemistry for Engineering
• /
• v.33 no.6
• /
• pp.594-599
• /
• 2022

In the study, NH₃-SCO (selective catalytic oxidation) reaction activity accodrding to vanadium loading amount were compared when preparing Pt/V/TiO₂. Considering both NH₃ conversion rate and N₂ selectivity, V 2 wt% loading of the catalyst showed the best activity. When the correlation between physical/chemical characteristics and reaction activity was confirmed, it was confirmed that the increase in lattice oxygen and (V³⁺ + V⁴⁺) ratios were active factor. In addition, when the SO₂ durability experiment was conducted using the best catalyst, it was confirmed that the influence was insignificant even if the high concentration of SO₂ was injected.

• Bulletin of the Korean Chemical Society
• /
• v.26 no.7
• /
• pp.1029-1030
• /
• 2005

• Journal of Environmental Health Sciences
• /
• v.47 no.3
• /
• pp.279-291
• /
• 2021

Objectives: This study investigated the association between air pollutant levels and medical usage rates for environmental disease in a general residential area during the period 2015-2017. Methods: Air pollutant (PM₁₀, PM_2.5, SO₂, NO₂, CO, O₃) data were collected from Air-Korea. Medical usage data on environmental disease (asthma, allergic rhinitis, atopic dermatitis) for the period 2015-2017 in a general residential area in Gyeongsangnam-do Province were provided by the National Health Insurance Corporation. Pearson correlation analysis and multiple regression analysis were conducted to investigate the association between air pollutant levels and medical usage rates (SAS 9.4). In the multiple regression analysis, environmental disease was set as the dependent variable and air pollutants were set as independent variables and analyzed using the General Linear Model. Results: Except for PM_2.5, the average concentration of air pollutants in the surveyed area was below than the air environment standards of Korea. NO₂ was higher than Korea's national average, but CO was similar. The others were lower than the Korea's national average. The daily medical usage rates for environmental disease were 1.38‰ for asthma, 9.90‰ for allergic rhinitis, and 0.32‰ for atopic dermatitis. As a result of correlation analysis, PM₁₀ and SO₂, NO₂ and CO were significantly correlated with asthma, PM₁₀ and NO₂ and CO were correlated with allergic rhinitis, and PM₁₀ and PM_2.5, SO₂, NO₂ and CO were correlated with atopic dermatitis. As a result of multiple regression analysis, PM₁₀ and SO₂ were found to have a higher effect on asthma, PM₁₀ and NO₂ on allergic rhinitis, and SO₂ and NO₂ on atopic dermatitis, compared to other air pollutants. Conclusion: According to these results, air pollutants such as PM₁₀ and SO₂ and NO₂ were associated with the medical usage rates of environmental disease even in relatively low concentrations. Therefore, continuous monitoring will be required for general residential areas.

• Environmental Engineering Research
• /
• v.25 no.1
• /
• pp.88-95
• /
• 2020

An investigation of rare metals recovery from LiNi_xCo_yMn_zO₂ cathode material of the end-of-life lithium-ion batteries is presented. To determine the influence of reductant on the leach process, the cathode material (containing Li 7.6%, Co 20.4%, Mn 19.4%, and Ni 19.3%) was leached in H₂SO₄ solutions either with or without H₂O₂. The optimal process parameters with respect to acid concentration, addition dosage of H₂O₂, temperature, and the leaching time were found to be 2.0 M H₂SO₄, 4 vol.% H₂O₂, 70℃, and 150 min, respectively. The yield of metal values in the leach liquor was > 99%. The leach liquor was subsequently treated by precipitation techniques to recover nickel as Ni(C₄H₇N₂O₂)₂ and lithium as Li₂CO₃ with stoichiometric ratios of 2:1 and 1.2:1 of dimethylglyoxime:Ni and Na₂CO₃:Li, respectively. Cobalt was recovered by solvent extraction following a 3-stage process using Na-Cyanex 272 at pH_eq ~5.0 with an organic-to-aqueous phase ratio (O/A) of 2/3. The loaded organic phase was stripped with 2.0 M H₂SO₄ at an O/A ratio of 8/1 to yield a solution of 114 g/L CoSO₄; finally recovered CoSO₄.xH₂O by crystallization. The process economics were analyzed and found to be viable with a margin of $476 per ton of the cathode material.

• Particle and aerosol research
• /
• v.17 no.3
• /
• pp.55-69
• /
• 2021

Chungnam region accounts for the largest SO_X (22.8%) emission with the second-largest NO_X (10.8%) emission in Korea due to the integration of many large industrial sources including a steel mill, coal-fired power plants, and petrochemical complex. Air pollutants emitted by large industrial sources can cause harmful problems to humans and the environment. Thus, it is necessary to understand dispersion patterns of air pollutants from large industrial sources in Chungnam to characterize atmospheric contamination in Chungnam and the surrounding area. In this study, seasonal atmospheric dispersion characteristics for SO_X, NO_X, and PM2.5 from ten major point sources in Chungnam were evaluated using HYSPLIT 4 model, and their contributions to SO₂, NO₂ concentrations in the regions near the source areas were estimated. The predictions of the HYSPLIT 4 model show a seasonal different dispersion pattern, in which air pollutants were dispersed toward the southeast in winter while, northeast in summer. In summer, due to weaker wind speed, air pollutants concentrations were higher than in winter, and they were dispersed to the metropolitan area. The local emissions of air pollutants in Taean area had a greater influence on the ambient SO₂ and NO₂ concentrations at Taean, whereas SO_X and NO_X emissions from large sources located at Seosan showed relatevely little effect on the ambient ambient SO₂ and NO₂ concentrations at Seosan.