• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.30 no.4
• /
• pp.413-422
• /
• 2012

After development of GPS in the 1960's, the United States released SA(Selective Availability) in 2000 and then the GPS has become commercialized to the present. The result of repeatedly developed GPS observation, the GPS real-time observation methods is RTK which basically always needs two base stations and has a fault of the accuracy decreasing as the distance between a mobile station and a receiver is increasing. Because of these weakness, VRS method has come out. VRS(Virtual Reference Station) generates the imaginary point near mobile station from several observatory datum of GPS, sets the accurate location of mobile station, thus shows high reliability and mobility. Now, the cadastral datum point is used with azimuth, repetition, and graphical traversing method for traverse network. The result of measurement indicates many problems because of different accomplishment interval given point, restrictions on the length of the conductor, many errors on the observations. So, this study did comparative analysis of the cadastral datum points through VRS method by Continuously Operating Reference Station. Through the above comparative analysis, The comparative result between surveyed result with repetition method through total station observed Cadastral Control Points and surveyed result with VRS-RTK has shown that average error of x-axis is -0.08m, average error of y-axis, +0.07m and average distance error is +0.11m.

• The Journal of the Acoustical Society of Korea
• /
• v.35 no.2
• /
• pp.125-133
• /
• 2016

In order to obtain high-resolution seafloor images, research on SA (Synthetic Aperture) processing and the development of related underwater systems have been performed in many countries. Recently the SA processing is also recognized as an important technique in Korea and researchers started related basic study. However, most previous studies ignored the Doppler effect by a moving receiver array. In this paper reconstructed SAS (Synthetic Aperture Sonar) images and position errors are analyzed according to the speed of a moving array for understanding its moving effect on the SAS images. In the analysis the spatial frequency domain interpolation algorithm is used. The results show that as the moving speed of the array increases the estimated position error also increases and image distortion gets worse when we do not consider the array motion. However, if the compensated receiver signals considering the array motion are used the position error and image distortion can be eliminated. In conclusion a signal processing scheme which compensates the Doppler effect is necessary especially in the condition where the array speed is over 1 m/s.

• Journal of Cadastre & Land InformatiX
• /
• v.45 no.2
• /
• pp.117-130
• /
• 2015

A least squares method for adjusting the horizontal network satisfies the conditions which is minimizing the sum of the squares of errors based on probability theory. This research compared accuracy of 3rd cadastral control points adjusted by traditional and least square method with respect to the result of Network-RTK. Test results showed the least square method more evenly distribute closure error than traditional method. Mean errors of least square and traditional adjusting method are 2.7cm, 2.2cm respectively. In addition, blunder in angle observations can be detected by comparing position errors which calculated by forward and backward initial coordinates. However, distance blunder cannot offer specific observation line occurred mistake because distance error propagates several observation lines which have similar directions.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.26 no.1
• /
• pp.11-36
• /
• 2021

The solar annual (Sa) and semiannual (Ssa) tides account for much of the non-uniform annual and seasonal variability observed in sea levels. These non-equilibrium tides depend on atmospheric variations, forced by changes in the Sun's distance and declination, as well as on hydrographic conditions. Here we employ tidal harmonic analyses to calculate Sa and Ssa harmonic constants for 21 Korean coastal tidal stations (TS), operated by the Korea Hydrographic and Oceanographic Agency. We used 19 year-long (1999 to 2017) 1 hr-interval sea level records from each site, and used two conventional harmonic analysis (HA) programs (Task2K and UTide). The stability of Sa harmonic constants was estimated with respect to starting date and record length of the data, and we examined the spatial distribution of the calculated Sa and Ssa harmonic constants. HA was performed on Incheon TS (ITS) records using 369-day subsets; the first start date was January 1, 1999, the subsequent data subset starting 24 hours later, and so on up until the final start date was December 27, 2017. Variations in the Sa constants produced by the two HA packages had similar magnitudes and start date sensitivity. Results from the two HA packages had a large difference in phase lag (about 78°) but relatively small amplitude (<1 cm) difference. The phase lag difference occurred in large part since Task2K excludes the perihelion astronomical variable. Sensitivity of the ITS Sa constants to data record length (i.e., 1, 2, 3, 5, 9, and 19 years) was also tested to determine the data length needed to yield stable Sa results. HA results revealed that 5 to 9 year sea level records could estimate Sa harmonic constants with relatively small error, while the best results are produced using 19 year-long records. As noted earlier, Sa amplitudes vary with regional hydrographic and atmospheric conditions. Sa amplitudes at the twenty one TS ranged from 15.0 to 18.6 cm, 10.7 to 17.5 cm, and 10.5 to 13.0 cm, along the west coast, south coast including Jejudo, and east coast including Ulleungdo, respectively. Except at Ulleungdo, it was found that the Ssa constituent contributes to produce asymmetric seasonal sea level variation and it delays (hastens) the highest (lowest) sea levels. Comparisons between monthly mean, air-pressure adjusted, and steric sea level variations revealed that year-to-year and asymmetric seasonal variations in sea levels were largely produced by steric sea level variation and inverted barometer effect.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.29 no.3
• /
• pp.293-301
• /
• 2011

The ionospheric delay is the largest error source in GPS positioning after the SA effect has been turned off in May, 2000. In this study, we used 44 permanent GPS stations being operated by National Geographic Information Institute (NGII) to estimate Total Electron Content (TEC) based on pseudorange measurements phase-leveled by a linear combination with carrier phases. The Differential Code Bias (DCB) of GPS satellites and receivers was estimated and applied for an accurate estimation of the TEC. To validate our estimates of DCB, changes of TEC values after DCB application were investigated. As a result, the RMS error went down by about an order of magnitude; from 35~45 to 3~4 TECU. After the DCB correction, ionospheric TEC maps were produced at a spatial resolution of $1^{\circ}{\times}1^{\circ}$. To analyze the effect of the number of sites used for map generation on the accuracy of TEC values, we tried 10, 20, 30, and 44 stations and the RMS error was computed with the Global Ionosphere Map as the truth. While the RMS error was 5.3 TECU when 10 sites are used, the error reduced to 3.9 TECU for the case of 44 stations.

• Proceedings of the Korean Statistical Society Conference
• /
• 2005.05a
• /
• pp.1-6
• /
• 2005

SAS의 PROC MIXED는 ANOVA 추정량보다 더 다양한 잔차최대우도추정법 또는 최대우도추정법으로 모수들을 추론할 수 있다. 혼합모형에 속하는 불균형중첩오차구조를 갖는 선형회귀모형에서 랜덤효과에 해당되는 그룹간의 분산과 고정효과에 해당되는 회귀계수들에 대한 신뢰구간을 구하기 위하여 대표본인 경우와 소표본인 경우에 대하여 PROC MIXED를 사용한다. 시뮬레이션을 실행한 결과, 대표본인 경우에는 모수들의 신뢰구간을 구하기 위하여 PROC MIXED를 활용할 수 있지만, 소표본인 경우에는 PROC MIXED를 사용할 경우, 그룹간 분산과 회귀계수 가운데 하나인 절편항에 대한 신뢰구간은 시뮬레이터된 신뢰계수가 명시한 신뢰계수를 지키지 못하는 것을 보인다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38B no.2
• /
• pp.154-161
• /
• 2013

This paper presents the signal-to-interference plus noise ratio (SINR) estimation of IEEE 802.16m WirelessMAN-Advanced mobile station with simulation and implementation results. The downlink signal of IEEE 802.16m has two kinds of A-Preambles: the PA-preamble and the SA-preamble. This paper proposes the efficient method of estimating SINR with A-Preambles, by measuring noise power from PA-preamble and measuring interference power and signal power from SA-preamble. The proposed SINR measurement block contains important features such as subcarrier phase rotation elimination and simplified dB transform. The result of this paper is integrated to ETRI's IEEE 802.16m test mobile station, used for decision of adaptive-modulation-and-coding (AMC) and hand-over. It showed good measurement performance in simulation and unified system link test also.

• Journal of Advanced Navigation Technology
• /
• v.4 no.2
• /
• pp.152-161
• /
• 2000

Recently, it is considered to combine the GPS receiver with the GLONASS for the improvement of performance and accuracy. This combined system reduces errors by SA for GPS, and has merits to select receivable satellite. In this paper, aperture-coupled patch antenna and small sized ceramic dielectric patch antenna are designed and implemented for GPS/GLONASS combined receiver, which show a wideband characteristics with circular polarization. The manufactured antennas have the bandwidth more than 240 MHz, VSWR less than 1.5:1, and the axial ratio less than 3dB, and satisfy required characteristics of the GPS/GLONASS antenna.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2022.11a
• /
• pp.169-170
• /
• 2022

Due to the higher use of nonrenewable fossil fuel energy, environment friendly sustainable energy from waste materials is attracting attention of the researchers. Considering that, jute stick (JS) biochar has been considered for this study for ecofriendly and sustainable thermal energy storage application. Waste jute sticks (JS), which are being mainly used as a fuel for cooking purpose, have been pyrolyzed to produce porous biochar and have been used for shape stabilization of stearic acid (SA) as phase change material (PCM). SA at 1:1 ratio has been incorporated into the activated JS biochar to concoct shape-stabilized phase change composite (SAJS). The SAJS has been evaluated by different techniques such as Fourier transform-infrared spectroscope (FT-IR), scanning electron microscopy (SEM), differential scanning calorimetry (DSC), and thermogravimetric analysis (TGA). The obtained composite PCM has shown excellent shape stability with a high latent heat storage, suggesting its suitability for thermal energy storage applications.

• Journal of Navigation and Port Research
• /
• v.29 no.8 s.104
• /
• pp.685-692
• /
• 2005

In this study, it is surveyed and analyzed under the condition of developing GPS receiver that the present status of use and the precision of GPS receiver installed in naval vessels. Throughout interview and questionnaire with the workers in naval vessels, reliability and utilization of GPS receiver are verified. In conclusion, it is suggested that the development of GPS receiver system as well as navigation methods in naval vessels. The result of this study is as follows. Though the workers in naval vessels regard the accuracy of GPS receiver position as the fix by geographical navigation method. However, it is confirmed that its practical usage is when it is difficult to obtain the fix by geographical navigation method or R/D position or for verification. The suggested plans to develop the navigation methods from naval vessels standpoint are designing a parallel systems and introducing the GPS receiver system that functions well and is linked to the electronic navigation chart.