• Journal of Korean Society of Water and Wastewater
• /
• v.21 no.2
• /
• pp.225-233
• /
• 2007

Road runoff water is one of the non-point sources (NPSs) of pollution negatively influencing drinking water source. Numerous road runoff NPS waters have been studied for over the last decade. However, the sources of pollution can be conditional, seasonal, or accidental. Therefore, measurement of pollutant loadings in different site is necessary to estimate the effect of road runoff water. The objective of this study was to examine the quality of road runoff water from a city bridge in Seoul, Korea. This study was conducted for two years to assess annual discharge pollution loads. In this study, key water quality parameters including chemical oxygen demand ($COD_{Cr}$), biochemcial oxygen demand ($BOD_5$), total nitrogen (T-N), total phosphorus (T-P), and suspended solid (SS) were measured at 18 different events. The results showed that typically the pollutant concentrations are higher at the beginning of each event and decrease afterwards. The first 20% of the volume of the runoff from each event is transporting 46% ($COD_{Cr}$), 48% ($BOD_5$), 50% (T-N), 34% (T-P), 30% (SS), respectively. The event mean concentrations (EMCs) were $COD_{Cr}$ (199 mg/L), $BOD_5$ (41.2 mg/L), T-N (7.97 mg/L), T-P (0.42 mg/L) and SS (113 mg/L). Although the results were consistent with the previous study (Barbosa and Hvitved-Jacobsen, 1999), $COD_{Cr}$, $BOD_5$, T-N exhibit a stronger first flush effect compared to the other contaminants.

• Water for future
• /
• v.26 no.3
• /
• pp.125-135
• /
• 1993

This study was conducted for two purposes. The first was the selection of the proper model for the urban runoff, and NPS(non-point source) loads and the second was the adjustment of the selected model through the calibration and the verification of the observed data on an urban drainage basin. The selected model for this study was the Storm Water Management Model(SWMM) developed and maintained by the US Environmental Protection Agency(EPA). In particular, the Runoff Block for the surface discharge and the Transport Block for the flow routing was used. The study basin is Youngdu basin, which is a typical developed urban drainage basin. The four rainfall events for the runoff and the two for the four NPS pollutants(SS, BOD, COD and TN) were used for the calibration and the estimation of the model parameters. This study performed the calibration with regard to the peak discharge, the time to peak discharge, the volume and the relative error for three items. It was shown that SWMM can successfully be used for the prediction of the runoff and the NPS pollutants discharge. The result of this study can be used as the basis for the analysis of the correlation between the runoff and the NPS pollutants discharges, and the analysis of the mass balance with the monthly and annual NPS loads in an urban drainage basin.

• International Journal of Highway Engineering
• /
• v.11 no.3
• /
• pp.141-149
• /
• 2009

Objective of this study was to characterize the particle size distribution(PSD) and quantify the pollutant concentration in highway runoff. Runoff samples during two rainfall events at four road sites in Gyunggi-Do were collected and PSD and associated pollutant distribution was quantified. Also, rainfall amount, flow rate, and other pollutants in samples were analyzed. PSDs in each sample were analyzed and compared with temporal trends of other pollutants. High partial event mean concentrations(PEMC) of particulates were observed at the beginning of runoff and rapid decrease thereafter. Other pollution parameters such as turbidity, TSS, BOD, TN, and TP also have similar temporal runoff trend with the PEMC. Especially PEMC was well correlated with total suspended solids(TSS) and turbidity. Cu, Pb, Zn had high concentration both runoff and sediment. Heavy metals in sediment were strongly bound to fine particles that have the large surface area-to-volume ratios.

• Journal of Korean Society on Water Environment
• /
• v.20 no.5
• /
• pp.525-533
• /
• 2004

The object ofthis study was to test for STORMSYS process that composed Catch Basin and Stormsys(three units: vortex solids separator, filter media bed and vegetated filter strips). It could be applied to treat the first-flush non-point pollution materials on the road(especially, motorway). This study investigated that the runoff characteristics of non-point pollutions containing the heavy metal(Fe, Zn and Cu) by rainfall showed relatively high pollution concentration in the early-stage storm runoff on the road, which seems to be caused by the vehicular traffic, and showed the rapid reduction of pollution concentration on the basis of about 5mm rainfall volume. As the number of the non-rainy days were increased, the pollution concentration by storm runoff was increased, also. As a test result of this process, the average removal efficiency of BOD, $COD_{mn}$, SS, T-N and T-P over the testing period were 92.7%,88.6%,97.4%,93.0% and 93.3%, respectively. Also, the average removal efficiency of n-Hexane, Fe, Zn and Cu were 86.7%, 96.1%, 84.4% and 78.4%, respectively. As shown in the characteristics of storm runoff, the non-point pollution materials have high pollution concentration in the early-stage storm runoff on the road, the installation of STORMSYS process is expected to reduce considerable amount of non-point pollutions.

• Journal of Korean Society of Water and Wastewater
• /
• v.27 no.3
• /
• pp.299-312
• /
• 2013

This study investigated the contaminant loading and characteristics of particle size distributions(PSDs) in the rainfall runoff from two different sources, the pavement road and the ancillary parking lot, and then evaluated four different types of filter media(i.e., EPP, EPS, Zeolite, and Perlite) to treat runoff water. The results showed that runoff from the pavement road contains 5.6 and 20 times higher SS and Pb concentrations, respectively, than that from the parking lot. The particles smaller than $100{\mu}m$ occupied 89.8 % of runoff from the pavement road and 81.4 % of that from the parking lot by volume. The effect of the hydraulic loading, at 950 m/day filtering linar velocity and 40 cm head loss, was largest for Zeolite, followed by Perlite, EPS, and EPP. The return period of tested media calculated by the regression equation for head loss indicated that EPP has the longest life time. The average SS removal rate was similar for all media at between 84.9 % and 89 %, while the effect of various filter column heights was different, showing minimal for EPP and maximum for EPS. All filter media tested demonstrated over 95 % of SS treatment efficiency for the particles bigger than $100{\mu}m$, while for the ones smaller than $100{\mu}m$ the efficiency was in order of EPP(82.4%) > Perlite(76.1 %) > EPS(66.2 %) > Zeolite(65.2 %). The results in conclusion implies that EPP is most effective filter media for the highly contaminated fine particles from road runoff.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2005.05b
• /
• pp.578-582
• /
• 2005

In this study, the conceptual foundation and development process of the Antecedent soil Moisture Condition(AMC) in SCS runoff curve number method are reviewed. Although the runoff volume is very sensitive with AMC condition, the AMC class limits developed in SCS(1972) are used in rainfall-runoff analysis without careful consideration. Tn this study, following the SCS curve number development process, rainfall-runoff characteristics of the Jang-Pyung subbasin subject to the Pyung-Chang River basin are analyzed to evaluate the reasonability of the AMC class limits at present. The New AMC class limits are proposed by the sensitive analysis of the antecedent rainfall - curve number value. As a result, the classification value of AMC-I with II is 22mm of antecedent 5-day rainfall amount, and the classification of AMC-II with III is 117mm in growing season. When the New AMC class limits are applied to Jang-Pyung subbasin, AMC probability distribution shows that the AMC-II has increased remarkably even though the AMC-I has a little higher value. But the AMC-III has the smallest one. According to the conceptual basis of the curve number method, the AMC probability distribution, the New AMC class limits adopted, gives reasonable results.

• KCID journal
• /
• v.18 no.1
• /
• pp.4-17
• /
• 2011

The standard design methodology was suggested to construct wetland system for reducing non-point source pollution from Saemangeum reclaimed paddy land. To set for the design flow and concentrations, runoff and water quality survey were conducted during the irrigation period in 2008 at Gyehwa reclaimed paddy land located at near Saemangeum lake. It is rational that 1ha is the optimum constructed wetland size. To meet this size, the moderate drainage area of reclaimed paddy field was 50ha under the conditions that rainfall is 30mm, average runoff coefficient is 0.83, and runoff capture ratio is 0.6. At these condition, the runoff volume from 50ha was 10,520 $m^3/d$ including base flow during irrigation period. To select the optimum wetland system, several case studies were conducted by focusing on the tidal reclaimed land areas having wetland systems in Seokmun. Pond-Wetland system was selected as the standard model because of showing the highest reduction efficiency. Single variable regression equation were delivered to estimate effluent water concentrations from the designed wetland by using long-term monitoring data from the Seokmun experiment site. The effluent concentration from the designed wetland using these equation were showed moderately range.

• Membrane and Water Treatment
• /
• v.10 no.1
• /
• pp.67-74
• /
• 2019

Apparent changes in the natural hydrologic cycle causing more frequent floods in urban areas and surface water quality impairment have led stormwater management solutions towards the use of green and sustainable practices that aims to replicate pre-urbanization hydrology. Among the widely documented applications are infiltration techniques that temporarily store rainfall runoff while promoting evapotranspiration, groundwater recharge through infiltration, and diffuse pollutant reduction. In this study, a laboratory-scale infiltration device was built to be able to observe and determine the factors affecting flow variations and corresponding solids removal through a series of experiments employing semi-synthetic stormwater runoff. Results reveal that runoff and solids reduction is greatly influenced by the infiltration capability of the underlying soil which is also affected by rainfall intensity and the available depth for water storage. For gravel-filled structures, a depth of at least 1 m and subsoil infiltration rates of not more than 200 mm/h are suggested for optimum volume reduction and pollutant removal. Moreover, it was found that the length of the structure is more critical than the depth for applications in low infiltration soils. These findings provide a contribution to existing guidelines and current understanding in design and applicability of infiltration systems.

• Journal of Korean Society on Water Environment
• /
• v.34 no.6
• /
• pp.650-660
• /
• 2018

The objective of this study was to compare the rainfall-runoff characteristics in streams of classified urban and rural watershed using land use and population density. EMC (event mean concentration) of BOD, COD, TP and SS increased significantly in urban and rural watershed, but that of TN remained unchanged. Although there were no significant differences in EMC of BOD, COD, TN, TP depending on the watershed characteristics, EMC of BOD and COD significantly increased in the urban watershed, while EMC of TP increased in the rural watershed. In the urban watershed, the first flush time was faster and the first flush effect was stronger in BOD, COD, and TP. However, the difference between cumulative mass and cumulative volume was found to be less than 0.2 in the rural watershed, indicating a weak first flush effect. The discharged masses of BOD (70 %), COD (64 %), and TP (66 %) in the first flush of runoff were higher in urban watershed, while TN (67 %) was higher in rural watershed. The reproducibility of first flush time and the strength of first flush using CV (coefficient of variation) was found to be more reproducible for first flush time in both watersheds. In rural watershed, the CV value of first flush time for TP out of water quality parameters was lower. Whereas the CV values of first flush time for BOD, COD and TP in urban watersheds were similar.

• Journal of Korea Water Resources Association
• /
• v.30 no.1
• /
• pp.83-93
• /
• 1997

The purpose of the study is to analyze the sensitivity of the parameters that affect the runoff and water quality in the studied drainage basins. SWMM model is applied to the four drainage basins located at Namgazwa and Sanbon in Seoul and Gray Haven and Kings Creek in the USA. first of all, the optimum values of the parameters which have least simulation error to the observed data, are detected by iteration procedure. These are used as the standard values which are compared against the procedure. These are used as the standard values which are compared against the varied parameter values. In order to catch the effectiveness of the parameters to the computing result, the parameters are changed step by setp, and the results are compared to the standard results in flowerate and quality of the sewer. The study indicates that the discharge is greatly affected by the types of runoff surface, i.e., impervious area remarkably affects the peak flow and runoff volume while the surface storage affects the runoff volume at mild sloped basins. In addition, the major parameters affecting the pollution concentrations and loadings are the contaminant accumulation coefficient per unit area per time and the continuous dry weather days. Furthermore, the factors that affect the water quality during the initial rainfall period are the rainfall intensity, transport capacity coefficient and its power coefficient. Consequently, in order to simulate the runoff-water quality, it is needed to evaluate previous data in the research performed for the studied basins. To accurately estimated from the tributary areas and the rational computation methods of the pollutants calculation should be introduced.