• Journal of the Korean Society for Railway
• /
• v.19 no.5
• /
• pp.565-575
• /
• 2016

Wheel reprofiling is frequently conducted to remove faults such as flange wear, flat areas, and cracks that occur in railway vehicle operation. We analyzed the dynamic performances of a vehicle before and after wheel reprofiling to grasp the influence of reprofiling on the dynamic behavior of the vehicle. We measured the wheel profile of the test vehicle and conducted a running test to analyze the vibration and comfort characteristics of the test vehicle. The result of the test indicated that vibration of the test vehicle after wheel reprofiling was reduced compared to that before wheel reprofiling. And, comfort level of the test vehicle after wheel reprofiling was improved by about 3dB laterally and vertically. Consequently, the positive effect of wheel reprofiling on the dynamic performance of vehicle was verified.

• Journal of the Korean Society for Railway
• /
• v.20 no.1
• /
• pp.11-19
• /
• 2017

Since operation of railway trains is a major source of particle pollution in tunnel air, a particle removal device can be an effective measure to remove wear particles. To obtain design conditions of the particle removal device that will be installed underneath the railway trains, the wind speed and particle concentration underneath the trains were investigated using a three-dimensional ultrasonic anemometer and a DustTrak aerosol monitor, respectively. The measurements were made for the trains running on Seoul Metropolitan Subway Line 5 on February 10, 2015. The data were analyzed according to the track geometry (straight, curved) and train speed pattern (acceleration, cruising, and deceleration) between stations. Train speed was also analyzed. The average wind speed and $PM_{10}$ concentration underneath the trains were ~30% of the train speed and ${\sim}200{\mu}g/m^3$ for both straight and curved sections. Average $PM_{10}$ concentration for deceleration sections was higher than that for acceleration sections.

• Journal of Biosystems Engineering
• /
• v.35 no.5
• /
• pp.294-301
• /
• 2010

This study was performed to improve the utilization of the ROPS and seatbelt of tractors in Korea. We surveyed the ROPS and seatbelt use and the tractor related accidents through the personal interviews for 141 farmers. And comfort test for tractor seatbelts is done for 4 different subjects by measuring the body pressure distribution. The survey showed that 79.3% of the tractor accidents was overturning accidents. And, in case the tractor has ROPS and seatbelt, there was no serious injuries. With this results, we could confirm that ROPS and seatbelt is very effective devices for protecting drivers in overturning accidents. But, in case farmers didn't wear seatbelt, there was some fatal injuries. This shows the importance of the seatbelt use in working and driving tractors. Therefore, we tested the comfort of the tractor seatbelt for 4 different subjects operating the pedal in tractor seat simulator and in the tractor running on various roads. From the results of the static test in the Lab, it was shown that more the seatbelt anchorage point is far form SIP point, more the body pressure of the belly became higher, and more the subjects feel uncomfortable. Not only in the static test in the simulator, but also in the dynamic test in riding tractors, it was shown that non retractable seatbelt was more uncomfortable than retractable seatbelt. According to this study, we concluded that we need to promote the utilization of the ROPS and seatbelt use. And, the non retractable seatbelt need to be replaced by retractable seatbelt. Also, we recommend that the seatbelt anchorage position should to be in the seatbelt anchorage area of the ISO 3776 standard.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.12
• /
• pp.797-803
• /
• 2019

This study was carried out to reduce the lateral vibration of high-speed electric multiple units. In the study, the high-speed electric multiple unit prototype (HEMU-430X) has a high lateral vibration at low equivalent conicity regardless of the wheel profiles (XP55, GV40, S1002). As wheel wear progresses and the equivalent conicity increases, the lateral vibration tends to decrease. The reason is that a combination of the suspension characteristics causes the body and bogie to resonate at a frequency of 1.4 Hz when the equivalent conicity is low, resulting in body hunting. An investigation of the lateral vibration of overseas high-speed trains showed that a decrease in the hydraulic stiffness of the yaw damper could improve the vibration. The series stiffness of the yaw damper is a combination of the hydraulic stiffness and elastic joint. In this study, an attempt was made to improve the lateral vibration by lowering the stiffness of the elastic joint. The series stiffness of the adjusted yaw damper was approximately 60% compared to the original one. The on track test results showed improvement in the lateral vibration for both running directions. The vibration reduction method of this study can be used for EMU-250 and EMU-320 in future commercial operations.

• Journal of Energy Engineering
• /
• v.26 no.3
• /
• pp.131-136
• /
• 2017

Automobile engine oil is the most important lubricant for operating as the engine is started. Recently, manufacturers of the automotive industry and lubricants are considerably improving the quality of oil with additive to extend change cycle period. Most customers are recommended genuine oil among different types from shop expert. Through this report we suggest another reference point for consumer to pick highly efficient lubricant. This report is investigated oil compounds to compare with 6 different automotive considering actual running condition for 7 months. we conducted experiment from physical and chemical perspectives. In the field, through various experiments oil compounds between mineral oil and synthetic oil are largely distinguished in oxidation, viscosity, fluid and TBN. These are influenced by engine part wear as piston, bearing etc. Comparing various investigation with different oil the performance of synthetic oil is shown better condition in flash point, oxidation stability and also found less in change pollutant iron, Al compounds. Additives of oil show clear difference Ca level in detergent-dispersant both mineral oil and synthetic oil. And Zn in extreme pressure additives and P in Lubricity improver make no difference to both.

• Journal of the Korean Society for Railway
• /
• v.20 no.2
• /
• pp.165-172
• /
• 2017

High frequency squeal noise can be generated when a railroad vehicle runs a sharp curved section; this noise causes environmental complaints and excessive wear on the wheel and the railroad track. In this paper, curved squeal noise experiments on a commercial railway were carried out to investigate this phenomenon. The relationship of the squeal noise pressure level, the frequency characteristics, the railway running speed, and the modal behavior of the wheel were investigated. At the same time, the lateral motion of the wheel relative to the rail was captured using a video camera; wheel movement was calculated when the noise was generated. queal noise occurred at the highest level at the inner front wheel; this phenomena is considered to be related to the lateral vibration response characteristics of the wheel. It can be seen that the magnitude of this squeal noise is not directly related to the increase in vehicle speed.

• Journal of the Korean Society for Railway
• /
• v.20 no.4
• /
• pp.433-439
• /
• 2017

Urban railway tunnels are polluted by resuspension of deposited bottom dust or newly generated wear dust. A hybrid type dust collector consisting of a baffle and an electrostatic precipitator was developed to remove these types of airborne dust when trains are running in the tunnel. Since dust collection efficiency of the hybrid dust collector is inversely proportional to the airflow rate, the relationship between airflow rate and dust collection efficiency was experimentally investigated for two baffle models. Collection efficiencies for dust larger than $0.5{\mu}m$ for the hybrid dust collector model A1, operated at 3.4 m/s, were greater than 30%; those for the hybrid dust collector model A2, operated at 4.7 m/s, were higher than 20%. When the applied voltage was 13 kV, the amounts of $PM_{10}$ collected with model A1 and model A2 dust collectors were estimated at $253{\mu}g$ and $242{\mu}g$ per hour, respectively.

• Journal of East-West Nursing Research
• /
• v.2 no.1
• /
• pp.83-95
• /
• 1997

Cooking food is very important in Chinese medicine when we regard the food to be the principal origin of the nutrition of human body and the condition required to maitain the activities of the life of human body. Chinese medicine has accumulated the diverse and rich experience of cooking food through long clinical experience as well as made an important contribution to the healthy and long life through the unique theory of cooking food. Chineses medicine has deep view on the relations between food cooking and healthy and long life as well as presented the principle of cooking food created unique ways of food cooking such as food treatment. As the above, from the ancient times, Chinese medicine established Chinese medical science of nutrition under the consciousness of the theory that food and medicine have the same origin and practiced the methods of promoting the health through rightly selecting the foods. Therefore it has been thought that human beings can enjoy healthy life by rich supply of the nutrition. Comfortable ways of sleeping requie the emotion and peace with temperation in pleasure and anger, and also we should be temporate in eating, acting, sleeping posture and be flee from the wind, and we should not put on a quilt when sleep, and we should sleep alone and be careful about sexual life. The concrete measures for sexual intercourse are that: 1) we should marry at the right age not to be married at early age. 2) we should obey nature and not live unmarried life. 3) we should be temperate in having sexual intercoure and in excessive sexual desire. Regarding the residence and clothes: the residence environment should be calm and beautiful and the room for the residence should be well designed to be clean and sanitary and we should wear suitable clothes. All living creatures are living according to the rhythm of the living body and the change of the great nature. The Reason why the living things show the periodical rhythm is not that it is the truth of the great nature, but that the living life itself shall be ceased to be existed in case of running counter to such rhythm. There are 2 specially important things: one is about food in biological view and the other is the residence in social side. By starting from the theory that food and medicine have the same origin and root, we should rightly select the foods to promote the health at the maximum, and it is very important for human to be well obeying the environment and temperate in the life of residence and mind (Choi, Sam Byun, Shon, Sook Young, 1997). As the above, the cook in Chinese medicine suggests us the suitable ways of achieving the goal of nursing. Therefore the continuous study of this field is necessary based on this my study though it is unsatisfactory at this time but it would be the basic materals in establishing the nursing science of Chinese medicine.