• Journal of Energy Engineering
• /
• v.7 no.1
• /
• pp.35-43
• /
• 1998

Electrodes using for the anode electrode of direct methanol fuel cell with Pt/C and Pt/Ru/C catalyst were prepared and characterized by SEM, TEM, thermal analysis and electrochemical analysis. The half cell tests were carried out with 1 M $H_2SO_4$ electrolyte and 1 M $CH_3OH$ in order to evaluate the electrode performance. The employed electrochemical methods were cyclic vol-tammetry and potentiodynamic polarization experiments. It was found that 20 w% polytetrafluoroethylene (PTFE) content in catalyst showed the best performance due to the best platinum utilization on PTFE-containing catalyst layer. It was found that Pt/Ru/C binary catalyst inhibited the poisoning of anode electrode showing improved performance compared to the Pt/C catalyst by the adsorption of oxygen containing species on the electrode surface at same time. The apparent activation energy for methanol oxidation on the Pt/Ru/C and Pt/C catalyst layer was 11.60 kJ/mol and 26.85 kJ/mol, respectively.

• Korean Chemical Engineering Research
• /
• v.46 no.2
• /
• pp.286-290
• /
• 2008

Small amounts of CO in reformate fuel gas effectively block platinum catalysts by strong adsorption on the platinum surface at the operation temperature of $60{\sim}80^{\circ}C$ in PEMFC. To oxidate CO, Ru/C layer (CO filter) was placed between Pt/C layer and GDL (gas diffusion layer) in this study. Ru/C filter provided good CO-tolerant PEMFC anode, but decreased the performance of unit cell about 10% at 0.6 V due to mass transfer resistance from Ru/C filter thickness and increase of charge transfer resistance. Membrane degradation is one of the most important factors limiting the life-time of PEMFCs. Membrane durability would be dependent on the electrode catalyst type. It seemed that Ru catalyst layer would shorten the life time of PEMFC as enhanced the fluoride emission rate of membrane in acceleration test.

• Transactions of the Korean hydrogen and new energy society
• /
• v.21 no.5
• /
• pp.390-397
• /
• 2010

0.5wt% Ru/$\alpha-Al_2O_3$ catalysts are prepared by deposition-precipitation method for the preferential CO oxidation In order to investigate the effect of pH on the Ru dispersion and particle size, the pH of precursor solution is adjusted to between 5.5 and 9.5. 0.5wt% Ru/$\alpha-Al_2O_3$ catalyst prepared at the pH of 6.5 has high Ru dispersion of 17.9% and small particle size of 7.7nm. In addition, 0.5wt% Ru/$\alpha-Al_2O_3$ catalyst prepared at the pH 6.5 is easily reduced at low temperatures below $150^{\circ}C$ due to high dispersion of $RuO_2$ particle and shows high CO conversion over 90% in the wide temperature range between $100^{\circ}C$ and $160^{\circ}C$. Moreover, the deposition-precipitation is a feasible method to improve the Ru dispersion as compared to the impregnation method. The 0.5wt% Ru/$\alpha-Al_2O_3$ catalyst prepared by deposition-precipitation exhibits higher CO conversion than 0.5wt% Ru/$\alpha-Al_2O_3$ catalysts prepared by impregnation due to higher metal dispersion and better reducibility at low temperature.

• Bulletin of the Korean Chemical Society
• /
• v.31 no.1
• /
• pp.151-156
• /
• 2010

In this paper, we characterized bimetallic Pt-Ru/C alloy catalysts having four different compositions and compared the catalytic activities of the prepared alloys for CO oxidation. ICP-AES, EDS, XRD, TEM, and XAS were used to investigate the composition, degree of alloying, particle size, and electronic structure of the prepared Pt-Ru/C catalysts. Those results indicated the synthesis of the alloy catalysts with intended composition and uniform size. The electrochemical study of the characterized alloys showed higher catalytic activity for CO oxidation than that of the commercial Pt/C (E-TEK, Inc., 20 wt %) catalyst. Especially, it was shown that the alloy catalyst with Ru composition of 50 atomic % gave the highest catalytic activity for CO oxidation.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2010.05a
• /
• pp.373-376
• /
• 2010

The characteristics of thermal-resistance catalyst for $N_2O$ propellant decomposition were studied in the present study. Si was added to the $Al_2O_3$ support to stabilize its surface area at high temperature (> $1000^{\circ}C$). Ru was used as a catalyst for $N_2O$ decomposition. The prepared catalysts were characterized using SEM, EDS and XRD analysis, and $N_2O$ conversion was measured as reaction temperatures. The Ru/$Al_2O_3$-Si catalyst showed better performance than Ru/$Al_2O_3$ catalyst.

• 한국신재생에너지학회:학술대회논문집
• /
• 2007.06a
• /
• pp.188-190
• /
• 2007

The MEA with the catalyst layer containing PtRu black and 60 wt. %Pt/C as their anode and cathode catalysts. For find to effect of carbon support, the MEA with platinum black for cathode catalyst was fabricated. The performance of the MEA with the catalyst layer containing (PtRu black:60 wt.% Pt/C) as their anode and cathode catalyst has shown competitively higher value than the performance of the MEA with the catalyst layer containing (PtRu black:Pt black) as their anode and cathode catalyst.

• Journal of the Korean Chemical Society
• /
• v.46 no.1
• /
• pp.57-63
• /
• 2002

The hydropurification reaction of CTA (crude terephthalic acid) was carried out with hydrogen over PdRu/CCM (carbon-carbonaceous composite material) catalyst in a batch reactor at high temperature. The first order kinetics of hydropurification is confirmed with the linear dependence of ln(4-CBA; 4-carboxybenzaldehyde) with reaction time. The reaction condition studied is thought to represent the hydropurification well because of the linear dependence of catalytic activity on the catalyst weight. The p-toluic acid (p-tol) in solid and liquid increases with the conversion of reaction or the decrease of 4-CBA. However, the benzoic acid (BA) concentration does not depend much on the conversion. The AT (alkali transmittance) does not depend on the 4-CBA when the concentration is higher than about 0.2% which shows the 4-CBA, in itself, does not cause the coloring effect. The AT of PTA depends inversely with the concentration of 4-CBA when the 4-CBA is less than about 0.15%. This may show the coloring materials are removed in parallel with the hydrogenation of 4-CBA. The (0.3%Pd-0.2%Ru)/CCM shows larger residual catalytic activity than a commercial catalyst, 0.5%Pd/C, after using in a commercial reactor even though the former has smaller fresh activity than the latter. The palladium and ruthenium in PdRu/CCM show the synergetic effect in activity when the ruthenium concentration is about $0.2{\sim}0.35$ wt%. It may be supposed that the PdRu/CCM catalyst can be a promising candidate to replace the commercial Pd/C catalyst.

• 한국신재생에너지학회:학술대회논문집
• /
• 2011.11a
• /
• pp.86.2-86.2
• /
• 2011

저온형 연료전지인 직접 메탄올 연료전지(Direct Methanol Fuel Cells, DMFC)는 친환경적인 발전 시스템, 높은 에너지 효율의 장점 때문에 주목을 받고 있으나 연료극의 촉매로 사용되는 금속은 고가의 귀금속인 Pt와 Ru가 요구되어 제조비용이 비싸기 때문에 촉매의 양을 줄이고, 반응 도중 생성되는 CO에 의한 촉매의 피독 문제 등 해결하여야 할 점이 산적해 있어 연료전지 중 촉매의 활성을 높이는 연구들이 활발히 이루어지고 있다. 종래의 MEA의 촉매층 제조공정은 우선 환원석출법에 의해 Pt-Ru/C를 합성하고 Nafion 용액에 혼합하여 Pt-Ru/C 슬러리를 제조한다. 이 방법에서는 carbon sheet에 spray 방법으로 Pt-Ru/C 촉매층이 만들어지기 때문에, Pt-Ru 촉매가 Nafion에 의해 부분적으로 매몰되어 촉매의 전기화학적 활성이 떨어지는 문제점이 있다. 이를 해결하는 방안으로 펄스전류를 이용하여 Pt-Ru 합금입자를 carbon sheet에 전기화학적으로 담지 시켜 Nafion에 매몰되는 것을 방지하는 펄스전해법 연구가 진행되고 있다. 그러나 촉매의 입자크기가 일반적으로 50~70 nm 이상으 크기 때문에 촉매의 낮은 활성이 문제점으로 야기되고 있다. 본 연구에서는 Pt-Ru/C 촉매층 제조 문제점을 해결하고, 촉매의 전기화학적 활성을 증가시키기 위해서 2~4 nm Pt-Ru 콜로이드를 전해액으로 사용하고, 전기영동법을 이용하여 Pt-Ru 나노 입자를 carbon sheet($1{\times}1cm^2$) 에 담지 시켰다. 전기영동법에서 균일한 Pt-Ru 촉매층의 제조를 위해 전류인가 방법으로는 펄스전류를 사용하였고, 실험변수로는 전해액 pH, duty cycle, 담지시간을 선정하였다. 합성된 Pt-Ru 콜로이드를 TEM분석으로 나노입자의 크기와 분산성 분석하였고, 콜로이드 나노입자의 표면전하 상태를 분석하기 위해 zeta-potential을 분석하였다. Pt-Ru/C의 촉매의 전기화학적 활성을 분석하기 위하여 0.5 M H_2SO_4$ 와 1 M $CH_3OH$ 혼합용액에 CV(Cyclic Voltammetry)실시하였고, carbon sheet 전극 상 Pt-Ru의 분산성 확인을 위하여 FE-SEM분석을 수행하였다.

• Bulletin of the Korean Chemical Society
• /
• v.28 no.4
• /
• pp.529-532
• /
• 2007

Combined temperature programmed reaction (TPR) and infrared (IR) spectroscopic studies for Fischer- Tropsch reaction have been performed over Ru/SiO2 and Ru-Ag/SiO2 supported catalysts. Reaction of linearly absorbed CO with hydrogen starts at 375 K over Ru/SiO2 catalyst and reaches maximum at 420 K accompanied with an intensity decrease of linear CO absorption. The reaction with bridged absorbed CO peaks around 510-535 K. Addition of Ag yields mixed Ru-Ag bimetallic sites while it suppresses the formation of bridged bonded CO. Formation of methane on this modified surface occurs at 390 K and reaches maximum at 444 K. Suppression of hydrogen on the Ag-doped surface also occurs resulting in the formation of unsaturated hydrocarbons and of CHx intermediates not observed with Ru/SiO2 catalyst. Such intermediates are believed to be the building blocks of higher hydrocarbons during the Fischer-Tropsch synthesis. Linearly absorbed CO is found to be more reactive as compared to bridged CO. The Ag-modified surface also produces CO2 and carbon. On this surface, hydrogenation of CO begins at 390 K and reaches maximum at 494 K. The high temperature for hydrogenation of absorbed CO and C over Ru-Ag/SiO2 catalyst as compared to Ru/SiO2 catalyst is due to the formation of Ru-Ag bimetallic surfaces impeding hydrogen adsorption.

• Journal of Industrial and Engineering Chemistry
• /
• v.68
• /
• pp.325-334
• /
• 2018

Lactose is a reducing disaccharide consisting of two different monosaccharides such as galactose and glucose. The hydrogenation of lactose to lactitol is a formidable challenge because it is a complex process and several side products are formed. In this work, we synthesized Ru-Ni bimetallic nanohybrids as efficient catalysts for selective lactose hydrogenation to give selective lactitol. Ru-Ni bimetallic nanohybrids with $Ru-NiO_x$ (x = 1, 5, and 10 wt%) are prepared by impregnating Ru and Ni salts precursors with $TiO_2$ used as support material. Ru-Ni bimetallic nanohybrids (represented as $5Ru-5NiO/TiO_2$) catalyst is found to exhibit the remarkably high selectivity of lactitol (99.4%) and turnover frequency i.e. ($374h^{-1}$). In contrast, monometallic $Ru/TiO_2$ catalyst shows poor performance with ($TOF=251h^{-1}$). The detailed characterizations confirmed a strong interaction between Ru and NiO species, demonstrating a synergistic effect on the improvement on lactitol selectivity. The impregnation-reduction method for the preparation of bimetallic $Ru-NiO/TiO_2$ catalyst promoted Ru nanoparticles dispersed on NiO and intensified the interaction between Ru and NiO species. $Ru-NiO/TiO_2$ efficiently catalyzed the hydrogenation of lactose to lactitol with high yield/selectivity at almost complete conversion of lactose at $120^{\circ}C$ and 55 bar of hydrogen ($H_2$) pressure. Moreover, $Ru-NiO/TiO_2$ catalyst could also be easily recovered and reused up to four runs without notable change in original activity.