• International Journal of Highway Engineering
• /
• v.17 no.5
• /
• pp.105-113
• /
• 2015

PURPOSES: The aim of this study is to analyze and compare the operational effectiveness and safety of three different types of roundabout found in the literatures using a VISSIM and SSAM program. METHODS : The three types roundabout tested are the 2-lane roundabout (2R), the Turbo roundabout (TR), and the Flower roundabout (FR). For each scenario, three roundabout types and traffic conditions such as traffic volume and movement ratio were applied to VISSIM in order to compute the average delays. In addition the total conflict was calculated through SSAM by using trajectory data from VISSIM. RESULTS: From the analysis results, the average delay in TR and FR type was higher than the 2R. Regardless of the roundabout types, the average delay was reduced as the right-turn vehicles increased. The total conflict in TR was fewer than 2R for all traffic conditions. CONCLUSIONS : The results of this study can be used in the planning and design process of roundabout deployment. The data also provides some numerical justifications in transition from at-grade intersection to roundabout.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.31 no.2D
• /
• pp.209-215
• /
• 2011

Roundabout has circular traffic island in the intersection center and is kind of intersection where the automobile bypass circular traffic island. In Korea, the provisional Roundabouts Design Guidelines were published in 2004 by MLTM (Ministry of Land, Transport and Maritime Affairs). This guideline did not discussed domestic traffic circumstance. It just only introduced foreign instances and their guidelines. In addition, the recent National Competitiveness roundabouts as part of the green growth has been concentrated on the interest. In this paper, 90 degree of the 4-legged roundabout was compared with 72 degree, 45 degree, and 30 degree 5-legged roundabouts by micro simulation VISSIM. As a result of analysis, average travel time is decreased when the inscribed circle diameter become bigger the roundabout. 5-legged roundabout until 2,000 volume per hour evaluated to be similar effect at 90 degree of 4-legged roundabout.

• Journal of Korean Society of Transportation
• /
• v.21 no.3
• /
• pp.59-69
• /
• 2003

Signalized intersections are widely used in urban street network. However, it was reported that a roundabout is better than a signalized intersection in terms of delay when the approaching traffic volume for each bound is low. The objective of this study is to develop entry capacity models of roundabout and establish the warrant for signalized intersection based on the delay. The entry capacity of a roundabout is determined by the circulating traffic volume and the geometric design of the roundabout such as the diameter of central island, entry lane widths, and the circulating roadway width. The traffic and geometric characteristics of four roundabouts were collected and analyzed. The study reveals that; i)among the geometric features, the diameter of central island and the circulating roadway width influence the entry capacity, and ii)even though it is difficult to compare the models of each country due to different geometric features considered in the models, the models developed in this study show higher capacity than the models from Israel or Germany. These seem to be attributed to the facts that; i)the outside diameters of the roundabouts selected in this study are larger than in the other studies, and ii)the acceptable gap in Korea is smaller than that in the other countries. In order to compare the performances of round- about and signalized intersection, the performance of roundabouts was evaluated with the SIDRA. The simulation was conducted only for the roundabouts composed of single lane. According to the result of the analysis, it may be concluded that when the approaching traffic volume for each bound is lower than 600pcph, a roundabout is better than a signalized intersection in terms of its operational performance.

• Journal of the Korean Society of Safety
• /
• v.32 no.5
• /
• pp.135-140
• /
• 2017

This study deals with the safety of roundabout. The purpose of this study is to analyze the factors affecting the pedestrian accidents of roundabout near schools. In pursuing the above, this study gives particular attentions to comparatively analyzing the pedestrian accident by number of entry and circulatory lane. The traffic accident data from 2013 to 2015 are collected from TAAS data set of Road Traffic Authority. To develop the pedestrian accident model, the Poisson and negative binomial models has been utilized in this study. Such the dependent variable as the number of pedestrian accidents and the 24 independent variables as geometry, traffic volume and others are used. The main results are as follows. First, 3 Poisson and 2 negative binomial models(${\rho}^2$ of 0.153~0.426) which are all statistically significant are developed. Second, the common variable of models based on the number of circulatory roadway lane is analyzed to be the entry lane width and that of the number of entry lane is evaluated to be the design speed. Also specific variables are evaluated to splitter island, roundabout sign, number of approach road, bus stop and elementary school. Finally, the design speed might be expected to decrease the number of pedestrian accidents near schools.

• International Journal of Highway Engineering
• /
• v.17 no.1
• /
• pp.91-98
• /
• 2015

PURPOSES : Although signalized intersections have been considered the best way to control traffic volume in urban areas for several decades, roundabouts are currently being discussed as an alternative way to control traffic volume, especially when traffic is light. Because a roundabout's efficiency depends on the load geometry as well as the traffic volume, design guidelines for roundabouts are recommended only if the incoming traffic volume is very low. It is rare to substitute a roundabout for an existing signalized intersection in urban areas. This study aims to estimate the benefits from the transformation of an existing signalized intersection into a roundabout in an urban area. When there is a more moderate volume of traffic, roundabouts can be effectively used by optimizing signals located at an approaching roadway. METHODS : The methodologies of this paper are as follows: First, a signalized intersection was analyzed to determine the traffic characteristics. Second, the signalized intersection was transformed into a roundabout using VISSIM microscopic traffic simulation. Then, we estimated and analyzed the effects and the performance of the roundabout. In addition, we adjusted a method to improve the benefits of the transformation via the optimization of signals located at an approaching road to control the incoming traffic volume. RESULTS : The results of this research are as follows: The signal-optimized roundabout improved delays compared with the signalized intersection during the morning peak hour, non-peak hour, and evening peak hour by 1.78%, 12.45%, and 12.72%, respectively. CONCLUSIONS : According to the simulation results of each scenarios, the signal-optimized roundabout had less delay time than the signalized intersection. If optimized signal control algorithms are installed in roundabouts in the future, this will lead to more efficient traffic management.

• International Journal of Highway Engineering
• /
• v.17 no.3
• /
• pp.133-141
• /
• 2015

PURPOSES : This study dealt with traffic accidents occurring within roundabouts. The objective of this study was to analyze safety effect by introduction of roundabouts. METHODS : In pursuing the above, traffic accident data on roundabouts are collected and compared. For the analysis, collected data were separated as all intersection points, turning lane accident, approach lane accident by geometric design. RESULTS : Through the study results, it was found that the total accidents decreased by 55 accidents/2 year with safety effect of roundabouts. Also the result shows that accidents by point of two-lane roundabout at turning lane(0.26) and approach lane(0.27) is risky than total accidents by point(0.09). Moreover, accidents by point shows high value as diameter of a roundabout is bigger. CONCLUSIONS : When a roundabout is introduced at the intersections there are safety effects by reduction of traffic accidents.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.34 no.4
• /
• pp.1299-1306
• /
• 2014

Recently, there are many roundabouts installation works which are ordered to provide convenient transportation to road users as well as to eliminate traffic accidents and traffic delays. This study propose an approximate construction cost estimation model for early stages of roundabout construction. The model is designed considering the conditions of the early stage roundabout construction sites in Jeju. The regression equation of approximate construction cost was derived through regression analysis of 25 design data of roundabout construction in Jeju, and it was analyzed to have a high prediction accuracy. Finally, results verifies high prediction accuracy of the derived regression equation. Difference between the estimation cost and the design cost was only 2.3%, 3.7%, and 5.8% that verifies the high accuracy of the proposed approximate construction cost estimation model.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.12 no.2
• /
• pp.63-75
• /
• 2013

Roundabouts have been operated in Europe, America and Australia since the 1970s, and many relevant researches continually was carried out. Though many studies regarding roundabout have been recently conducted in korea, most of them have focused on its operational safety and efficiency. Moreover, roundabout design guideline did not define a clear criteria related to pedestrian in roundabout, but seldom investigate the influences of pedestrian on crosswalk. In this study, we seek ways to operate the pedestrian crosswalk signal on roundabout maximizing their operational effects in exceptional case such as rush hour or intersection near the special facilities. We proved that roundabout signal operation is effective under certain circumstances in according to the number of pedestrian, and suggested the optimal signal timing plan for signalized roundabouts. For pursuing the above, we conducted the simulation test using the VISSIM model. The results show that the operational effectiveness of signalized roundabout was evaluated to be better than non-signalized roundabout in specific pedestrian volume condition. In addition, those results are confirmed using simulation analysis conducted on the real roundabout.

• Journal of Korean Society of Transportation
• /
• v.35 no.5
• /
• pp.385-395
• /
• 2017

This study deals with the small-scale roundabout. The purpose of this study is to analyze the average delay of vehicle in roundabout, and suggest the efficient planning and design standard. In pursuing the above, this study gives particular attentions to analyzing the average delay time according to the inscribed circle diameter, speed of circulatory roadway lane and traffic volume. The operational efficiencies of 96 scenarios (3 sizes of inscribed circle diameter ${\times}$ 4 types of circulatory roadway speed ${\times}$ traffic volume) are analyzed using VISSIM (Verkehr In $St{\ddot{a}}dten$-SIMulationsmodell). The main results are as follows. First, the optimal design speed of small-scale roundabout are derived from the above scenario analysis. Second, the traffic volume of LOS D is estimated to be 2,180-2,740pcph. Third, the traffic volume of LOS F that is required to improve is above 2.780pcph. The results might be expected to give some implications to providing the countermeasures for the operational efficiency of roundabout.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.22 no.6
• /
• pp.83-89
• /
• 2021

To improve the performance of self-driving cars, the introduction of V2X, a communication technology that connects vehicles, infrastructure, and vehicles, is essential. Even if traffic information of the other vehicle is known, the structure of the intersection and a distance calculation algorithm are required for accurate calculations at roundabouts. This paper proposes a design algorithm for a rotating intersection and implemented in Matlab that complies with the national design rules and enables accurate calculations. Assuming the roundabout and the entrance/exit path to be a circle, a method for measuring the distance between vehicles at an arbitrary point was proposed using the horizontal shift of the entrance circle to the main circle. The algorithm could be used in fully autonomous vehicles by designing a roundabout suitable for the terrain by arbitrarily varying the angle between branches and the radius of curvature of the entrance and exit roads, and transmitting a warning signal when a collision between two driving vehicles is expected.