• Journal of Environmental Health Sciences
• /
• v.24 no.1
• /
• pp.132-140
• /
• 1998

Laboratory-scale experiments were conducted using a three-stage rotating biological contactor unit followed by lime precipitation and sedimentation with effluent recycle to the first stage. The purpose of this study was to evaluate the effects of hydraulic loadings of 0.031-0.076 $m^3/m^2/d and recycle ratio of 1 to 3 on the simultaneous removal of organics and nutrients from domestic wastewater. Lime was added to maintain pH of 10.4-11.0 in the coagulation-flocculation reactor. Results showed that the highest nitrogen removal rate of 70.5% occurred at the lower hydraulic loading of 0.031 $m^3/m^2/d at a recirculation rate of 300%, and similarly, highest nitrification occurred at the same hydraulic loading and recycle ratio. Concentration of ammonia nitrogen in the effluent was less than 1 mg/l at the same operating conditions for higher nitrogen removal. Whereas, high BOD and COD removal was observed at hydraulic loading rate of 0.054 $m^3/m^2/d, and high removal of organic matter was evident from the consistent low COD and BOD value. Results obtained from the operating condition of higher loading rate, 300% of recycle rate showed the highest removals. Increasing in recycle rate and hydraulic loading rate increased the volatile solids fraction of the sludges generated to the extent of 47% at 0.076 $m^3/m^2/d hydraulic loading and 300% recirculation rate. Since pH in the flocculator was maintained at the pH of 10.4-11.0, above 90% removal of phosphorus was obtained. Average concentration of suspended solids was always maintained over 40 mg/l in the effluent. Therefore an RBC unit operating at a hydraulic loading near 0.031 $m^3/m^2/d with a recycle rate of 300% is a viable and feasible alternate conditions to produce an effluent with relative low organic matter and phosphorus, provided that there is a neutralization unit to control the pH and SS of the effluent.

• Journal of Microbiology
• /
• v.45 no.2
• /
• pp.113-121
• /
• 2007

The bacterial diversity inherent to the biofilm community structure of a modified rotating biological contactor wastewater treatment process, referred to as the Rotating Activated Bacillus Contactor (RABC) process, was characterized in this study, via both culture-dependent and culture-independent methods. On the basis of culture-dependent methods, Bacillus sp. were found to exist in large numbers on the biofilm (6.5% of the heterotrophic bacteria) and the microbial composition of the biofilms was quite simple. Only three phyla were identified-namely, the Proteobacteria, the Actinobacteria (High G+C Gram-positive bacteria), and the Firmicutes (Low G+C Gram-positive bacteria). The culture-independent partial 16S rDNA sequence analysis revealed a considerably more diverse microbial composition within the biofilms. A total of eight phyla were recovered in this case, three of which were major groups: the Firmicutes (43.9%), the Proteobacteria (28.6%), and the Bacteroidetes (17.6%). The remaining five phyla were minor groups: the Planctomycetes (4.4%), the Chlorobi (2.2%), the Actinobacteria (1.1%), the Nitrospirae (1.1%), and the Verrucomicrobia (1.1%). The two most abundant genera detected were the endospore-forming bacteria (31.8%), Clostridium and Bacillus, both of which are members of the Firmicutes phylum. This finding indicates that these endospore-forming bacteria successfully colonized and dominated the RABC process biofilms. Many of the colonies or clones recovered from the biofilms evidenced significantly high homology in the 16S rDNA sequences of bacteria stored in databases associated with advanced wastewater treatment capabilities, including nitrification and denitrification, phosphorus accumulation, the removal of volatile odors, and the removal of chlorohydrocarbons or heavy metals. The microbial community structures observed in the biofilms were found to correlate nicely with the enhanced performance of advanced wastewater treatment protocols.

• Journal of environmental and Sanitary engineering
• /
• v.11 no.2
• /
• pp.43-52
• /
• 1996

Using rotating biological contactor(RBC) with artificial endogenous stage and aerobic fixed biofilm reactor(AFBR), organic material removal and biological nitrification of piggery wastewater has been studied at a pilot plant. RBC was operated in the endogenous phase at a interval of every 25 days. The concentration of COD, BOD and TKN in influent wastewater were from 2,940 to 3,800 mg/L, from 1,190 to 1,850 mg/L and from 486 to 754 mg/L respectively. The maximum active biomass content represented as VSS per unit aera was $2.0mg/cm$^{2}$ and biofilm dry density of $17mg/cm^{3}$ was observed at biofilm thickness of $900{\;}{\mu}m$. It was observed that the pilot scale RBC/AFBR process exhibited 72 percentage to 93 percentage of BOD removal, In order to obtain more than 90 percentage of BOD removal, the organic loading rate to the RBC/AFBR process should be maintained less than $0.09{\;}m^{3}/m^{2}{\cdot}day(125.9g{;\}BOD/m^{3}{\cdot}d$. The TKN removal efficiencies was from 45.5 to 90.9 percentage according to vary influent loading rate, It was estimated that the RBC/AFBR process consumed approximately 6.2 mg/L(as $CaCO_{3}$) of alkalinity per 1 mg/L of $NH_{3}$-N oxidized as the nitrification took piace.

• Journal of environmental and Sanitary engineering
• /
• v.10 no.1
• /
• pp.1-11
• /
• 1995

We had passed through a serious water pollution with a rapid urbanization and industrialization in the 1960's. Seoul Chunggyechun Sewage Disposal System set uP in 1966 and finished in 1976, as the first sewage disposal system in Korea, had covered only 4 percentage of the sewage disposal system per capita for 10 years. Through holding the Asian Games in 1986 and the Olympic Games in 1988, we expanded the sewage disposal system so that it became increased 18 percentage of the population in 1986. Finally, we have installed about 60 sewage disposal system by 1994 for a large environmental investment which was critically caused by "Phenol Accident in Nakdong River" . Now, the sewage disposal system per capita covers 42 percentage and the activity for water quality improvement is going on rapidly. The method of sewage disposal is mainly "activated sludge process" . However, the technical ability for the sewage disposal has largely developed since 1991 so the "extended aeration process" is used in Po$\v{u}$n, Tangyang, Mun$\v{u}$i, "rotating biological contact process" in Onch$\v{u}$ng, Pukok, and "oxidation ditch process" in K$\v{o}$ch'ana.

• Journal of Environmental Science International
• /
• v.10 no.3
• /
• pp.239-245
• /
• 2001

This research was performed to investigate the dynamics of microbial community by RBC (Rotating Biological Contactor) using Rhodococcus sp. EL-GT and activated sludge. Cell counts revealed by DAPI were compared with culturable bacterial counts from nutrient agar. Colony counts on nutrient agar gave values 20~25% and 1~15% of cell counts (DAPI). The cell counts for the dynamics of bacterial community were determined by combination of in situ hybridization with fluorescently-labelled oligonyucleotide probes and epifluorescence microscopy. Around 90~80% of total cells visualized DAPI were also detected by the bacteria probe EUB 338. For both reactors proteobacteria belonging to the gamma subclass were dominant in the first stage (1 and 2 stage) and proteobacteria belonging to the gamma subclass were dominant in the last stage (3 and 4 stage).

• 한국생물공학회:학술대회논문집
• /
• 2002.04a
• /
• pp.243-246
• /
• 2002

In this study, biological production of fumaric acid by Rhizopus oryzae KCTC 6946 using rotary biofilm contactor was investigated. In study of neutralizing agent on fumaric acid production, $Na_2CO_3$ was more effective than NaOH. After 24 hr of incubation with a rotating speed of 10 rpm at $35^{\circ}C$, biofilm was grown on and around the surface of the disks. The yield and volumetric productivity of rotary biofilm contactor were 33.8% and 0.595 g/L${\cdot}$h, respectively, with the optimum effective disk surface area of 1,583 $cm^2/L$.

• Journal of Biomedical Engineering Research
• /
• v.17 no.2
• /
• pp.173-178
• /
• 1996

The objective of this paper is to investigate the effect of AC field on the protoplast of plant cells. The results of investigation will be the basis for the development of etectric cell fusion device. For the experiment, we made the electrode and AC and DC pulse generator and observed the behavior of the protoplasts through the inverted microscope which is connected to the monitor and video recorder by the CCD camera. As a result, the numbers of rotating, moving and destructed protoplasts and viability of the protoplasts have close relation to the amplitude of AC field, while the rotation rate is closely related to the frequency of AC pulse.

• Proceedings of the KOSOMBE Conference
• /
• v.1989 no.05
• /
• pp.77-80
• /
• 1989

This paper describes a study on the locomotion control system for a indoor-use mobile wheelchair. Three lode of operations - BASIC, AUTOMATIC and PROGRAMMED - are employed as basic algorithm building block. One-chip microcomputer 8031 is dominating the control of actuation part and it can control the range of rotating speed of the wheel both right and left by servo motor. Keyboard is employed as a command input device. This system is intended to improve the daily life of the disabled by the intelligent interactive operation scheme.

• Journal of Biomedical Engineering Research
• /
• v.13 no.3
• /
• pp.235-244
• /
• 1992

In this paper, fluttering behavior of mechanical monoleaflet tilting disc heart valve prostheses during the opening phase was analyzed taking into consideration the impact between the occluder and the guiding strut at the fully open position. The motion of the valve occluder was modeled as a rotating system, and equations were derived by employing the moment equilibrium principle. Forces due to lift, drag, gravity and buoyancy were considered as external forces acting on the occluder. The 4th order Runge-Kutta method was used to solve the governing equations. The results iimonstrated that the occludes reaches steady equilibrium position only after damped vibration. Fluttering frequency varies as a function of time after opening and is in the range of 8-84 Hz. Valve opening appears to be affected by the orientation of the valve relative to gravitational force. The opening velocities are in the range of 0.65-1.42m/sec and the dynamic loads by impact of the occludes and the strut are in the range of 90-190 N.

• Journal of Biomedical Engineering Research
• /
• v.12 no.3
• /
• pp.149-156
• /
• 1991

In this paper, fluttering behavior of mechanical bileaflet heart valve prosthesis was analyzed taking into consideration of the impact between valve plate and stopper Vibration system of the valve was modeled as a rotating system, and equations are induced by moment equilibrium equations. Lift force, drag force, gravity and buoyancy were considered as external forces acting on the valve plate/ The 4th order Runge-Kutta method was used to solve the equations. Valve plate does not come to the static equilibrium position at a stretch, but come to that position after under damping vibration. Damping ratio increases as the cardiac optput increases, and the mean damping ratio is in the range of 0.16~40.25. Fluttering frequency does not have any specific value, but varies as a function of time. It is in the range of 10~40Hz. Valve opening appears to be affected by the orientation of the of the valve relative to gravitational forces.