• Magazine of the Korean Society of Agricultural Engineers
• /
• v.36 no.3
• /
• pp.84-89
• /
• 1994

Section forces of greenhouse structures were studied to suggest basic information for the structural design of greenhouses with respect to roof types and support conditions. Structural analyses were performed for pitched and arched roof, and fixed and hinged support under snow loads and wind loads. Followings are the results obtained and are expected to be useful in determining the span length and roof type in greenhouse design. 1. Special considerations might he required for roof design at the heavy snow region, and for the support design at the strong wind region, respectively. 2. Single-span structure was found to be stronger than multi-span structure under the snow load, but the former was found to be weaker than the latter under the wind load. 3. Arched roof structure was expected to be safer than pitched roof structure if the dimensions and loads were equal. 4. Greenhouse orientation and roof slope should be considered in optimum structural design of grrenhouses, because these two factors are closely related with the influence of wind load and snow load.

• Journal of Environmental Science International
• /
• v.23 no.8
• /
• pp.1437-1446
• /
• 2014

This study, the urban energy used office building green roof type composition of the target by analyze building energy reductions. Green roof is total 6 types(type A~F) were selected, EnergyPlus the energy simulation programs were used. Top floor of green roof types evaluation, the reduction of the cooling peak load type E(1.26%), type D(1.30%), type C(1.37%), type B(1.45%), type F(1.49%), and heating peak load is type D(1.32%), type E(1.40%), type C(1.47%), type F(1.69%), type B(2.13%) order. Annual cooling load of heating load is reduced more than about 1% effect. The heating load reduction ratio for a maximum of 9% respectively. Cooling peak load of the building energy performance evaluation of type F > type B > type C > type D > type E in the order and in the case of peak loads heating type B > type F > type D > type E>type C order. Annual total energy use reduction of 1.07 to 1.22% and earn, type B in the best good. In primary energy use reductions in the presence of a green roof were in the 4249~4876 kWh/yr. Annual $CO_2$ emissions reductions of unapplied type A were analyzed on average 469.78 kg.

• Proceedings of the Korean Society for Emotion and Sensibility Conference
• /
• 2009.11a
• /
• pp.269-272
• /
• 2009

The temperature of PV modules that integrated into building facades or roof increases that could reduce the electrical efficiency of the PV system. In order to incresae PV system's efficiency it is very important to remove the heat from the PV modules. For this purpose, hot air can be extracted from the space between PV modules and building envelope, and used for heating in buildings. The solar collector utilizing this thermal effect is called photovoltaic-thermal(PVT) solar collector. This paper compares the experimental performance of building-integrated PVT collectors that applied on building roof and facade. There are two different case: a roof-integrated PVT type and a facade-integrated PVT type. The experimental results show that the collected thermal energy of the roof-integrated type was 24% higher, compared to that of the facade-integrated.

• Journal of the Korean Institute of Rural Architecture
• /
• v.14 no.2
• /
• pp.1-10
• /
• 2012

The purpose of this study is to provide the method of saving the construction cost per unit area of the New Hanok using the inner space of a roof as a floor space with a structural modification of it's roof. The proportion of a roof of the Traditional Hanok accounts for about a half of it's elevation, so it is an essential element of it. But, compare to the whole construction cost of the Traditional Hanok, it costs over a half of expenses to build it. Recently, at the traditional building type, it is found that the inner space of a roof of it is used as a floor space with a structural modification of it's roof. It can be divided into two types, the storage type and the living type. The New Hanok at downtown can accommodate various new lifestyle, so the length of it's Yangtong is longer than that of the Traditional Hanok. When we adjust the proportion of the traditional Hanok to the New Hanok, the height of the column and the roof of the New Hanok becomes also higher than those of the traditional Hanok. So, using the upper part of the column and the roof of the New Hanok, we can make the inner space of a roof of the New Hanok as a floor space -like a bed room, tea room, personal work space and a storage- vertically connect with the 1st floor as the main living area. As a result, it is expected to save the unit construction cost of the New Hanok and has an extensity of space when we build the New Hanok at downtown.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.26 no.3
• /
• pp.342-349
• /
• 2016

Objectives: The objective of this paper is to find flow and heat transfer characteristics numerically in boiler buildings for three different ventilation window configurations. Methods: Turbulent natural convection flow in boiler buildings with a constant heating wall temperature was analyzed numerically. Governing equations were solved with standard finite-volume method using the SIMPLE algorithm. Conclusions: Flow and heat transfer characteristics are found for three different ventilation types. In the lower area under furnace, velocity and temperature distributions show similar patterns among the three different ventilation types. In the upper area over furnace, however, air flow is well mixed with lower peak temperatures for types B and C, which have roof ventilation windows, compared to type A which has side wall louvers only. Also, type B, with a single large roof window, shows better ventilation effect than does type C with its distribution roof windows.

• KIEAE Journal
• /
• v.17 no.1
• /
• pp.49-54
• /
• 2017

Purpose: Temperature in urban areas increase much more than suburban areas and it is called urban heat island (UHI) phenomenon. There are several solutions to control UHI phenomenon such as green roof system, water space construction, and cool roof system. However, application of green roof system and cool roof system to some of the buildings which compose the city has a critical limit. Therefore, in order to diminish the temperature rising and UHI phenomenon due to climate change of the city, it needs to approach from the viewpoint of site or city, rather than the viewpoint of individual buildings. This study is aims at analyzing UHI phenomenon by characteristics of surface materials and suggesting the solutions to reduce UHI phenomenon by types of complex. Method: Literature reviews were conducted to analyze the cause, mitigating plan, and recent trends of UHI phenomenon. For the simulation analysis, the type of complex was classified 3 representative complex. Based on measured reflectivity, simulation about UHI phenomenon was conducted by setting 4 strategies; albedo of roof, road pavement, green roof system, and vegetating around buildings. Result: As the results of simulating the UHI reduction factor by types of complex, it showed that the effect of temperature reduction on the building roof layer is more effective than adjusting the reflectivity of buildings such as green roof system, planting near the buildings in both the detached house complex, apartment complex, and commercial complex.

• Korean Journal of Heritage: History & Science
• /
• v.35
• /
• pp.100-118
• /
• 2002

Originally, Gyeongcheonsa pagoda was located in Busosan, Jungyeon-ri, Gwangdeok-myeon, Gaepung-gun, Gyeonggi-do,but it has suffered from being taken out to Japan illegally in 1907 and being returned to Korea in 1918. After returned to Korea, Gyeoncheonsa Pagoda had been neglected and restored in 1960. It had been exhibited outside the Gyeingbokgung Palace after restoration, but many problems were raised. It was taken to pieces in 1995 and it is conservation and restoring today. However, the top of pagoda is necessary to be researched about its archetype because the shapes of stupa in 1902 and in 1960(the shape of pagoda after restoration) are all different from its archetype. According to picture datum in 1902, the top of pagoda was a Korean building type on a 10 layered roof stone. On the other hand, when it was restored in 1960, cement suspected as a anda was taken place between Korean building type and a 10 layered roof stone. Therefore, I am going to examine Restoration of Gyeongcheonsa pagoda in this thesis. When we examine historical records of Geongcheonsa and datum of parts, we can know that the pagoda was established in 1348(Goryeo Dynasty) but it is difficult to know the truth of its establishment and demolition of Gyeongcheonsa-temple. Three ways to restore the top of the pagoda of Gyeoncheonsa Pagoda can be c o n s i d e r e d . First, Korean building type made by metals is located on a 10 layered roof stone, which is same to picture datum in 1902. Second, the shape of and a type, which is similar to the shape when it was restored in 1960's. Also it is similar to Lamapagoda type. Third, to restore the top of pagoda of gabled roof type, which is similar to the top of pagoda of Wongaksagi P agoda. However it is necessaray to exmamine functions about circle grooves hollowed out in a 10 layered roof stone in restoration. Also we need to find out the archetype of dragon sculpture through the dragon claws left on an edge of a 10 layered roof stone.

• Journal of the Korean Institute of Rural Architecture
• /
• v.14 no.3
• /
• pp.109-119
• /
• 2012

This study aims to analyze architectural characteristics of railway station facilities which were built with development of railroads from Japanese Colonial Period to 1950's. To achieve this goals, 7 railway stations in Gyeongju area that are worth preserving were set up as research targets. For this study, I analyzed literature of the railway station and drawings which the KORAL Daegu Branch is keeping. Railway stations without a construction drawing investigated a direct visit. After analyzing the railway station facilities, the architectural properties such as plan, elevation and section have been identified. The results are as follows. First, Each modern railway station is usually consisted of waiting room and office, and ancillary spaces have been added. Over the years, however, the space was expanded horizontally. In that case, the structure and finish materials have been changed, like now. Second, Most of the roof shape is 'Matbae'(gable roof), especially Gyeongju station and Bulguksa Station are 'Woojingak roof. The roof structure is truss structure, especially as Pratt and Scissors type, but Gyeongju Station's structure is a reinforced concrete. Third, main doorway of waiting room is located in the center of the front gable. However, small stations like 'Ahwa' and 'Ipsil' station to ensure the passengers' waiting area are placed next to the office area.

• Proceedings of the KSRS Conference
• /
• 2005.10a
• /
• pp.83-86
• /
• 2005

This paper presents a method for point-based 3D building reconstruction using LiDAR data and digital map. The proposed method consists of three processes: extraction of building roof points, identification of roof types, and 3D building reconstruction. After extracting points inside the polygon of building, the ground surface, wall and tree points among the extracted points are removed through the filtering process. The filtered points are then fitted into the flat plane using ODR(Orthogonal Distance Regression). If the fitting error is within the predefined threshold, the surface is classified as a flat roof. Otherwise, the surface is fitted and classified into a gable or arch roof through RMSE analysis. Based on the roof types identified in automated fashion, the 3D building reconstruction is performed. Experimental results showed that the proposed method classified successfully three different types of roof and that the fusion of LiDAR data and digital map could be a feasible method of modelling 3D building reconstruction.

• Journal of architectural history
• /
• v.27 no.6
• /
• pp.7-18
• /
• 2018

The purpose of this paper is to analyze the double stylobate of the three-story stone pagoda in Yeongnam region and to divide the types of arrangements of the body-stone and roof-stone and find their correlation. Research objects are 47 three-story stone pagodas in Yeongnam region which have accurate documents and plans. After dividing a double stylobate of three-story stone pagodas into a lower and upper stylobate, we classified each stylobate into a type of body-stone and roof-stone from an architectural point of view. Types of arrangement of body-stones are divided into methods of using the 'ㅡ' shaped stone and methods of using 'ㄱ' shaped stone in the corner. And types of arrangement of roof-stones are divided into methods of arranging stones in a row or in a grid pattern. As the size of the pagoda increases, 'ㄱ' shaped stones used for the body-stone and stones for the roof-stone are arranged in a grid pattern. As the size of the pagoda becomes smaller, the body-stone is consist of 'ㅡ' shaped stone, and the roof-stone is arranged in a row. As the construction year of the pagoda becomes later, the size of the pagoda becomes smaller and types of body-stone and roof-stone had been stereotyped. As a result, the size of the stone pagoda became smaller as constructed later, and the type of body-stone and roof-stone of the double stylobate appear differently according to the size of the pagoda.