• Journal of the Korean Electrochemical Society
• /
• v.13 no.4
• /
• pp.277-282
• /
• 2010

Durability of automotive polymer electrolyte membrane fuel cell (PEMFC) strongly depends the startup/shutdown procedure. Formation of hydrogen/air boundary in the anode gas channel, so-called reverse current condition, particularly induces fast degradation of the cathode. Under the reverse current condition, high voltage is present at the cathode facing air in the anode gas channel and is a function of residual oxygen concentration in the gas channels, that increases with storage time and reaches 21% (air) eventually. In this study, effects of residual oxygen concentration in a PEMFC on degradation of the PEMFC.

• Journal of the Korea Safety Management & Science
• /
• v.10 no.1
• /
• pp.129-137
• /
• 2008

The studies on the logistics has been mainly centered on the logistics information system and logistics performance on the supply chain for the enterprise's profit making. For sustainable development, it's being required the construction of recycling-oriented system, and it's also necessary to construct the efficient system not only in forward but in reverse channel. In addition, it's required to construct information system for supporting reverse logistics smoothly. In this study of manufacturing enterprises, recognition on the environmental problems is set as the adaptation degree to the national environmental regulations and enterprise's concern to the environmental logistics, and it presents the direction through analyzing the effects of such environmental logistics recognition on reverse logistics information system and performance. In order to achieve these aims, it was performed through combining philological and positive studies.

• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.34S no.7
• /
• pp.19-27
• /
• 1997

This paper presents the performance analysis of MC-CDMA system in reverse links acquired through the computer simulation. For channel estimation which is essential component of mobile communications, a modified alpha algorithm is proposed to estimate the channel sate for MC-CDMA system. In order to update the channel estimator of each subchannel, the modified algorithm uses the final hard-decision value in the receiver.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.8B
• /
• pp.674-682
• /
• 2003

This paper presents the studies on wireless channel modeling and reverse link synchronization of CATV. This paper analyzes multi-path fading channel to the cause of signal distortion in the wireless communication environment. We represent the microwave link characteristics according to the channel model. Multi-path channel can affect fading.

• Journal of the Korea Safety Management & Science
• /
• v.8 no.3
• /
• pp.125-141
• /
• 2006

If do not become whole optimization because enterprise's individual enterprise internal determinate improvement effort is associated with activity in enterprise SCM, competitive power can not but be extremely limited the result. Therefore, to spur in hidden cost's discovery and logistics' optimization is actuality. In this paper, as long as it is by logistics cost except empty driving if reverse logistics happens in distribution channel progressing, logistics reverse logistics' hidden cost through model that do minimization profit of logistics to look for plan that can do maximization try. Finally, is based on dual of distribution cost and profit of logistics and reverse logistics and achieves Pull, optimal system modeling that use Push system and gropes method of effective logistics cost.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.9 no.2
• /
• pp.131-140
• /
• 1998

MAI(Multi-Access Interference) and fast channel variation due to the fading environment are the major problems in the mobile CDMA communication systems. Recently, interest has been increasing in applying the Adaptive Linear MMSE Detector to MAI cancellation in the CDMA reverse link. In this paper, we propose a modified Adaptive Linear MMSE Detector structure which can be used in Long-duration code CDMA system in the presence of independent Rayleigh fading. We use independent multiple tap-weight vector structure to cope with the variation of spreading sequence pattern between neighbor symbols because of the Long-duration code. In this case, more exact channel parameter estimation is required. To solve this problem, we use coherent CDMA structure which can track the channel parameters like amplitude and phase by employing the low power pilot channel in the CDMA reverse link.

• International Journal of Computer Science & Network Security
• /
• v.23 no.6
• /
• pp.27-34
• /
• 2023

This paper proposed an Inter-Carrier-Interference (ICI) Canceling Orthogonal Frequency Division Multiplexing (OFDM) receiver for 5G mobile system to support 500 km/h linear motor high speed terrestrial transportation service. A receiver in such high-speed train sees the transmission channel which is composed of multiple Doppler-shifted propagation paths. Then, a loss of sub-carrier orthogonality due to Doppler-spread channels causes ICI. The ICI Canceler is realized by the following three steps. First, using the Demodulation Reference Symbol (DMRS) pilot signals, it analyzes three parameters such as attenuation, relative delay, and Doppler-shift of each multi-path component. Secondly, based on the sets of three parameters, Channel Transfer Function (CTF) of sender sub-carrier number 𝒏 to receiver sub-carrier number 𝒍 is generated. In case of 𝒏≠𝒍, the CTF corresponds to ICI factor. Thirdly, since ICI factor is obtained, by applying ICI reverse operation by Multi-Tap Equalizer, ICI canceling can be realized. ICI canceling performance has been simulated assuming severe channel condition such as 500 km/h, 2 path reverse Doppler Shift for QPSK, 16QAM, 64QAM and 256QAM modulations. In particular, for modulation schemes below 16QAM, we confirmed that the difference between BER in a 2 path reverse Doppler shift environment and stationary environment at a moving speed of 500 km/h was very small when the number of taps in the multi-tap equalizer was set to 31 taps or more. We also confirmed that the BER performance in high-speed mobile communications for multi-level modulation schemes above 64QAM is dramatically improved by the use of a multi-tap equalizer.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.344-345
• /
• 2012

The Gate-Induced-Drain-Leakage (GIDL) current with channel doping and width dependence are characterized. The GIDL currents are found to increase in MOSFETs with higher channel doping levels and the observed GIDL current is generated by the band-to-band-tunneling (BTBT) of electron through the reverse-biased channel-to-drain p-n junction. A BTBT model is used to fit the measured GIDL currents under different channel-doping levels. Good agreement is obtained between the modeled results and experimental data. The increase of the GIDL current at narrower widths in mainly caused by the stronger gate field at the edge of the shallow trench isolation (STI). As channel width decreases, a larger portion of the GIDL current is generated at the channel-isolation edge. Therefore, the stronger gate field at the channel-isolation edge causes the total unit-width GIDL current to increases for narrow-width devices.

• Journal of the Korean Society for Precision Engineering
• /
• v.19 no.6
• /
• pp.160-165
• /
• 2002

A study on digital processes of injection mold in reverse engineering are presented. Reverse engineering is useful fur several cases, where user has no geometry information of object. Laser scanner is used to obtaining 3D coordinates of object. Sequences to process cloud data are described; sampling to reduce number of points, sorting to adjust the point order, and fitting to curve and surface, and so on. Split slide structure of mold is used fur undercut part and high viscosity material. Flow of injection molding are analysed to correct cooling channel and simulate molding conditions. NC tool paths are generated to carve core and cavity. The processes are performed in digital data for reduction of lead time and consecutive geometry data.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.5
• /
• pp.10-23
• /
• 1996

In this paper, the reverse link performance evaluation with synchronous CDMA is analyzed in the PCS system, which is the schem based on proposed method of KMT-PCS to increase the capacitance of cellular CDMA system. We make the baseband system model of CDMA reverse link, and then analyze system performance and subsystem techniques considering effect of channel and power control that are improtant factor influencing system performance in the PCS system. Based on this result, the paper presents primary technique analyses required at synchronous reverse link proposed by the KMT, which compose of initial synchronization range in initial synchronization step and control signal period in the synchronization maintenance step.