• Transactions of the Korean hydrogen and new energy society
• /
• v.33 no.4
• /
• pp.353-362
• /
• 2022

In this study, water diffusion in proton exchange membrane fuel cell at open circuit voltage (OCV) was analyzed through experiment. First, the reliability of the micro-sensor (SHT31) was verified. It was concluded the micro-sensor has an excellent reliability at 60℃ and 70℃. After the sensor reliability test, the temperature and relative humidity measurement in bipolar-plate was conducted at OCV. To analyze water distribution and water flux, the temperature and relative humidity was converted into dew point. To the end, it was found water concentration affects water diffusion.

• Journal of Animal Environmental Science
• /
• v.3 no.2
• /
• pp.77-85
• /
• 1997

Recently, local swine producers are rapidly adopting the indoor production system which developed in foreign countries. However, this imported system is reported as not functioning properly because of different climate conditions. The objective of this project was to investigate the environment characteristics of a windowless delivery swine building. The parameters studied were the heating and cooling loads, the daily changes of indoor temperature and relative humidity, the horizontal and the vertical distributions of indoor temperature, and the effect of mist cooling on indoor temperature. From this study, the following are founded : 1. The maximum cooling and heating loads were - 317.0kcal/㎡$.$h and 336.5kal/㎡$.$h in summer and in winter. The large loads seems to be on account of inappropriate operations of ventilating fans. 2. The daily variations of relative humidity in indoor were smaller than those in outside. Those values both in summer and in winter as relative humidities in door was lower than optimum for growing pigs, the additional humidifier might be helpful to increase the relative humidity in indoor. 3. The horizontal distribution of the indoor temperature was found to be uniform in the variation range of 1$^{\circ}C$. 4. The vertical distribution of the indoor temperature was not found to be uniform; the temperature of upper part was higher than that of slot part. 5. Average values of indoor temperature became lower by 3$^{\circ}C$ by mist cooling. But the variation of temperature was found to be larger; The middle part of the room was cooled down, but the corner part of the room was not affected by misting due to uneven nozzle configuration.

• Composites Research
• /
• v.32 no.6
• /
• pp.382-387
• /
• 2019

A single frequency strain mode test, a stress relaxation mode test, and a creep test using RH-DMA were performed to investigate the effects of relative humidity and temperature on the viscous properties of PET film. The relative humidity was 10%, 30%, 50%, 70%, and 90%. The temperature was considered to be 30~95℃ for single frequency strain mode tests, 30℃ and 70℃ for stress relaxation mode test, and 5~95℃ for creep test. According to the results, higher relative humidity results in lower storage modulus and loss modulus, but the maximum value of the loss modulus is not significantly affected by changes in relative humidity and is almost constant. Relaxation modulus decreases rapidly at the beginning and becomes constant, and as the temperature increases, it is susceptible to changes in relative humidity. Strain recovery also increases rapidly at the beginning and is susceptible to changes in relative humidity as the temperature increases. In addition, as the temperature increases, the degree of increase in creep compliance increases, and as the temperature rises above the glass transfer temperature, the degree of increase becomes very large. The master curve determined by the time-temperature superposition provides the information to predict the long-term performance under operating conditions such as relative humidity and temperature.

• Journal of Bio-Environment Control
• /
• v.18 no.3
• /
• pp.200-207
• /
• 2009

This study was conducted to analyze the variations of air temperature, relative humidity and pressure in a low pressure chamber for plant growth. The low pressure chamber was composed of an acrylic cylinder, a stainless plate, a mass flow controller, an elastomer pressure controller, a read-out-box, a vacuum pump, and sensors of air temperature, relative humidity, and pressure. The pressure leakage in the low pressure chamber was greatly affected by the material and connection method of tubes. The leakage rate in the low pressure chamber with the welding of the stainless tubes and a plate decreased by $0.21kPa{\cdot}h^{-1}$, whereas the leakage in the low pressure chamber with teflon tube and rubber O-ring was given by $1.03kPa{\cdot}h^{-1}$. Pressure in the low pressure chamber was sensitively fluctuated by the air temperature inside the chamber. An elastomer pressure controller was installed to keep the pressure in the low pressure chamber at a setting value. However, inside relative humidity at dark period increased to saturation level.. Two levels (25 and 50kPa) of pressure and two levels (500 and 1,000sccm) of mass flow rate were provided to investigate the effect of low pressure and mass flow rate on relative humidity inside the chamber. It was concluded that low setting value of pressure and high mass flow rate of mixed gas were the effective methods to control the pressure and to suppress the excessive rise of relative humidity inside the chamber.

• Journal of Biosystems Engineering
• /
• v.32 no.4
• /
• pp.247-255
• /
• 2007

During the winter season in Korea, the relative humidity of greenhouse at night often exceeds 90% because air temperature inside the greenhouse is usually controlled using a heater with all of windows closed to minimize heat loss, thereby requiring the use of a dehumidifier that can maintain optimum humidity levels of $70{\sim}80%$ to provide a good growth condition of crops. Also, such a high humid condition can cause the development of a pest, such as insects, fungi or diseases. However, the use of most conventional dehumidifiers for low temperature dehumidification is limited because their performance is degraded due to frost accumulation on the evaporator coil. This study was carried out to develop a refrigeratory-based dehumidifier suitable for low temperature dehumidification in greenhouse cultivation. The developed dehumidifier consists of a condenser and an evaporator installed separately so that relative and absolute humidity levels can be reduced when air passed through the condenser and evaporator, respectively. The prototype dehumidifier showed a dehumidification capacity of $5{\sim}7kg/h$ when air with a temperature of $15{\sim}25^{\circ}C$ and a relative humidity of $70{\sim}95%$ came into the dehumidifier. Under the condition that either temperature or relative humidity was fixed, the amount of condensed water was proportional to the levels of both temperature and relative humidity.

• Korean Journal of Environmental Biology
• /
• v.21 no.2
• /
• pp.120-125
• /
• 2003

For this study grasp coverage condition and forest stratification to various green space, observed air temperature and relative humidity. With this data, coverage condition and air temperature, relative humidity distribution, analyzed relationship of forest rate and air temperature or relative humidity, tree numbers and green volume and humidity by revolution analysis. In this result, higher none is formed artificiality and barren area, lower zone did fores and water area. Relative humidity have corresponding type of air temperature distribution. lower Tone was higher humidity. Different of Idlest type or water area, surround of forest showed relatively higher humidity. Increasing tree numbers or green volume effect higher humidity and this efficiency order of an arbor, subarbor, shrub.

• KOREAN JOURNAL OF PACKAGING SCIENCE & TECHNOLOGY
• /
• v.7 no.2
• /
• pp.43-51
• /
• 2001

This study was carried out to analyze changes of the physical properties of corrugated fiberboard boxes for fruits packaging by various moisture and temperature changes. There were significant decrease in burst strength with increased relative humidity. And also compressive strength(ring crush test) of corrugated fiberboard and box were reduced with moisture content. The decreasing amounts of single wall(SW) corrugated fiberboard was bigger than that of double wall(DW). The physical properties reductions of corrugated fiberboard and box were mainly affected by relative humidity. Therefore, it is suggested that development of the water-resistant corrugated fiberboard and box be useful under the condition of low temperature and high relative humidity such as the cold chain system.

• Journal of the Korean Society of Tobacco Science
• /
• v.26 no.1
• /
• pp.43-49
• /
• 2004

This study was carried out to investigate moisture sorption and desorption characteristics followed by tobacco type. Experiments were performed at various temperature(5, 15, 25, 40 $^{\circ}C$) and relative humidity range (11～84 %) controlled by saturated salt solution. Regression equation was obtained to predict equilibrium moisture according to various relative humidity, temperature and tobacco types. The obtained regression equation showed high $R^2$(above 0.95) and predicted accurate equilibrium moisture. Equilibrium moisture contents declines in the following order when a relative humidity is 50 % or above: expanded stem, flue-cured, expanded tobacco, reconstituted tobacco, USA flue-cured, orient, burley. To maintain 13 % moisture of each tobacco type in the range of 5～40 $^{\circ}C$ it is recommendable to control relative humidity 49～56 % for expanded stem, 50～57 % for flue-cured, 54～61 % for USA flue-cured, 56～60 % for reconstituted tobacco, 57～62 % for expanded tobacco, 58～64 % for orient and 58～65 % for burley, respectively. It means that the relative humidity of each tobacco type should be differently controlled to maintain the same moisture under the same temperature. In the range of 5～25 $^{\circ}C$, the lower temperature showed the higher equilibrium moisture content.

• KIEAE Journal
• /
• v.1 no.2
• /
• pp.29-36
• /
• 2001

The main procedure of this study is to compare temperature and relative humidity between Korean traditional house and apartment house. So, the experiments of measuring temperature and humidity were carried out in 6 Korean traditional houses and 2 apartment houses which are located in Honam district. The Korean traditional house has good conservation properties on temperature and much better effective than apartment house on humidity conservation. The results of this study may be used for basic material in revitalizing traditional construction method.

• Architectural research
• /
• v.9 no.2
• /
• pp.37-45
• /
• 2007

The proliferation of the House Dust Mite(HDM) is affected by temperature, humidity, ventilation, etc. Measuring temperature and humidity was performed at the very location where dust samplings take place and where they live in reality together with temperature and humidity of the ambient of the room. There has been discussion over the key environment factor of HDM survival; absolute humidity or relative humidity. It seems that relative humidity is the more important determinant for the mite's survival through the analysis of previous studies. Temperature, humidity, ventilation rate and Der P1 were measured in 4 flats in London. Mite allergen was detected in every house. Levels of Der P1 varied between <100ng/g and 22,778ng/g. Flats with high relative humidity(>50%) and poor ventilation(<0.5ach) showed higher levels of mite allergen than flats with lower humidity and adequate air change rate. Questionnaire survey was conducted and the result helped to confirm the findings from monitoring of environmental factors and the dust sampling.